Having problems with your Dishwashers ?

Our Maytag dishwasher arms in the middle and bottom of the washer won't spin during wash cycle? What do we do to fix this problem? The washer has been stored for 1 year. Thank you.


Answers :

Does it sound like the motor is runnig??? just no water circulating??? if so sounds like a bad impeller/ seal kit.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our Maytag dishwasher arms in the middle and bottom of the washer won't spin during wash cycle? What do we do to fix this problem? The washer has been stored for 1 year. Thank you.


Does it sound like the motor is runnig??? just no water circulating??? if so sounds like a bad impeller/ seal kit. ... Dishwashers

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi


... Maytag Dishwashers

I recently purchases a KitchenAid dishwasher model kudsosfrss from a thrift store (I know, silly me). On intallation I learnd why it was in the thrift store. The Normal and Start/Resume buttons are dead on the keypad, and the washer will not run. I don't want to throw good money after bad, but if I can buy parts and fix it myself I figure it might be worth it. Any suggestions?


8574143 is the part number for the black console control panel which is the part i believe u want,, u may look at it or purchase it at repairclinic.com, searspartsdirect.com, hope this helps let me know ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

I have just bought a cid60b10 dishwasher and it won't work! I completed the first wash putting water in the salt dispenser as instructed and when it had finished the wash there was still water in the bottom of the washer. Now when I turn the machine on all the buttons light up and then go off and I cannot select a function. Does anyone know how I can fix it without having to send for a technician?


... Dishwashers

Hello I'm looking for advise on my 11 year old dishwasher. It's a kenmore ultra wash model # 15812. The problem is that when you push the wash button nothing happens. The drain funtion still works and all the lights on the front panel work but no water is flowimg into the washer. Do I try to fix this or just buy a new one?


Hello there:To be honest with you i would first try these solutions and see if they work cause a new machine would cost a lot of money.But if you can fix yours it would cost a lot less so plese try these solutions that i have provid ... Dishwashers

Bosch SHU43 makes loud 'grinding' noise while washing. Noise is not made while washer is draining, only when filling and washing. I am quite handy with appliances, can probably fix myself with a bit of guidance and good parts source. What is expected cost? Thanks


Hi menuet, welcome to fixya.\015\012\015\012Based on your description you likely have something down in the sump area or the pump impeller or motor itself is worn.\015\012\015\012Post back with your e ... Bosch 24 in. SHU43 Built-in Dishwasher

My Powercraft 9686 pressure washer has always been stored in my garden shed. It is 4 years old and when I used it last September the power washer had lost considerable pressure, as it was leaking water. Can I fix it for a reasonable price? Thank You. John O D


Put some silicon spray in inlet/outlet then reattach hoses then run it will proform after a while do this everytime you store it pryer to sroring away........... ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

I have a Whirlpool ADP 5777 WH dishwasher I need to know if I can reset the dish washer, it is the timer which is stuck, so you can change the dial on the left for the various washes, eco, etc. but the time of the wash does not change!! Stuck at 2 hours 47 minutes!! I have tried turning the machine off at the powerpoint and turning it back on but that has not fixed it


... Whirlpool Dishwashers

Our Whilpool GU1200XT "Quiet Partner III", (Apr. 9, 2003) ran very quietly until about 18-24 months ago when a frying pan lid, that had been washed many times, had lost about 1/2 of it's paint when it came out of the washer. We thought that the paint would soon get ground up & disappear, but we are still plagued with the niose during the wash cycle. Can we take this thing apart ourselves & fix it and if so, how?


... Whirlpool 24 in. GU1200XT Built-in Dishwasher

I have a dishlex global 300 on which I removed the front cover a black wire came loose and I didn't know where it came from thanks to jyackle5 I have fixed that issue. The problem I have now is the eco light flashes and that's it (nothing else functions). I removed the front panel as the bottom door seal had blown and junk oosed behind the front panels I washed the junk out and cleaned the hole washer while I was at it the bottom of the washer (where the heating element is) over filled so I tipp


Easy fix, Use a bit of force and pull the dishwasher out.Get a few towels and tilt to the left. Water will drain out. Push back in. wait 10 mins and turn on.\015\012\015\012\015\012\015\012Regards ... Dishwashers

11 hp honda motor on landa cold water pressure washer runs good except when trying to pressure wash the motor & pressure go up & down pulsating bbruummmmmbbbbrrruummmmbbbrruuummmmwhats the problem and how to fix it?


... Honda Landa PG 3500 PSI Pressure Washer

Looking fo a manual for my dish washer. It is a ( Kenmore Quiet Guard Ultra wash) My model # is 16791790 and my serial # is FG 3607465. Could you please guide me in the right direction so i can fix my problems. Thank You,


Heres the sight in which you can place you COMPLETE model number in and look for parts or request a manual.\015\012\015\012http://www.sears ... Dishwashers

I have a single draw Fisher and Paykel dishwasher. I stupidly put washing up liquid in the dishwasher which resulted in a F1 problem. Water started leaking under the draw and onto my floor. I turned the dishwasher off at the power point and have cleaned up the leak. Have I damaged my dish washer? How do I fix it?


Ok , F1 means your flood switch has activated, which is underneath the drawer. now they show the F1 fault because of 2 reasons.1st there is still water underneath drawer causing switch to activate. 2nd your activator board which has the flood switch ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Dishwasher won't drain completely. we have washed some waterbottles with paper on it and I found some paper on the bottom of the washer. could some paper have gotten plugged into the drain hose? if so how can I fix it?


It is possible that is has been clogged...can you see where the water drains....if so can you get to it ...if you can. then you may need to remove some screws...of there may be a reservoir...that has water in it or is related to the drain ...take a ... GE 24 in. GSD6660GSS Built-in Dishwasher

Dish washer will no wash dishes it seems that all the holes are filled with calcium is their a fix for this


Hello Mohawk,\015\012\015\012If it's just the small holes in the rotating spray arms that are blocked, they can be easily unblocked\015\012with a pin or cocktail stick by simply poking through the holes. The calcium/limescale can be ... Maytag Dishwashers

I have a GSD2800P35, about 1992 vintage. It keeps stopping on washer arm blockage fault every 2 or 3 minutes during the wash cycle but they are clear and clean inside. what else may be wrong and how can it be fixed?


The sensor responds to the lower ( main ) wash arm. If the spray holes in it are clear, and there are no objects sticking down through the rack which might block it, check to see how much water is in the tub. Low water level would cause the spray a ... GE Dishwashers

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"


... Kenmore Dishwashers

I have a Kenmore 665.16039401. The 3 right hand buttons on the keypad; Delay Hours, Cancel/Drain and Start/Resume do not respond and I cannot start the washer. Doing the self-diagnostic test by pressing "Heated Dry - Normal Wash - Heated Dry - Normal Wash" results in all of the LED's lighting and the washer starting a full 20 minute self-test cycle in which all functions seems to work properly. Opening and closing the door during this testing stops and then re-starts the washer appropriately


... Dishwashers

My dish washer is not washing the dishes on the top shelf and leaves a sand like residue on top of the cups and glasses. I have washed out the top spraying arm and washed the dish washer out with vinegar.


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Zanussi 24 in. DA6141 Built-in Dishwasher

My kenmore dishwasher will run part way thru the wash cycle, stop and the hi temp and heat dry lights will flash back and forth and not do anything else. When you open the washer it will have water in it that has not pumper out. It seems that the light wash cycle will work after trying the regular or heavy wash. The washer is 1 1/2 years old. model # 587.15259402


First cut power for ten minutes by unplugging power cord or tripping circuit breaker.If that does not work try the following reset.Press in succession:High temp-air dry-high temp-air dry - High temp-air dry-high te ... Dishwashers

The spray arm, above the top rack, keeps unscrewing during the wash cycle. Just the arm comes off leaving a round plastic part attached to the top. This can be unscrewed and inside is a white 'washer'. The arm can be clipped back but comes off again in the next wash. The plastic 'washer' has to be turned over to allow re-attachment. Is a washer missing from inside?


Could the arm be mounted upside down and rotating the wrong way? Just an idea... Some of these can fit either way and the retainer will fit either side of the arm. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

We have been using this model since Sept. 2007.When new, it worked very well. It has over time, performed less then we would expect. Not only do we have to scrub dishes by hand before placing them into washer,they some times require hand washing after being washed by machine. Not only are they dirty, the glasses are covered with a cloudy white film. We have not done any maintenance or service to this dish washer. Does this washer require some sort of service or attention. Please advise. Thanks


... Jenn-Air 24 in. JDB1250 Built-in Dishwasher

Maytag MDBH985AWS...control panel button to turn on the washer does not work...wash cycle and delay lights will light when pushed but washer will not come on. Have tried pushing normal wash and heated dry in sequence, flipped circuit breaker, open and close door, pushed buttons while door is closed


... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0976 seconds