Having problems with your Dishwashers ?

Nautilus F&P dishwasher comes up with error code u1 and it stops and then beeps. Turn it off and it empties and when start it up again it does the same


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Nautilus F&P dishwasher comes up with error code u1 and it stops and then beeps. Turn it off and it empties and when start it up again it does the same


... Dishwashers

I have a General Electric pdw7880J03ss dishwasher. Tonight, I went to start a load of dishes and the Heated Dry option wouldn't turn off without the lights going to RINSE ONLY. Then the 1hr setting started coming on. Then was able to get the load to start but then it stopped somewhere in the cycle. Now, no lights will come on the panel though I can hear the beeping. Dishes appear to have washed...


Hi\015\012\015\012Press and hold the heated dry button for 15 seconds to reset\015\012the control, if this wont work then it means that the control board is bad and\015\012should be replaced. Hope this helps...please post back for further ... Dishwashers

Our dishwasher seems to have stopped working over night. The power button comes on and the unit beeps to acknowledge start, but then there is only a very light hum & the unit does not start. No water comes through the unit and it just hangs at the light hum. We have not turned off any water but just checking if there is a simple solution? Adam Hdw100sst


Suspect pump.on start the pump will activate to remove condense water from drying the last load.if the pump does not start then the next step of adding water to start wash cycle will not happen.ensure pump is not blocked ... Dishwashers

I have an LG dishwasher Model LD-O5AW2 Benchtop. IT has been going perfectly until now. I push the button in and then the start button, when the wash cycle has finnished it wont empty until I push the stop button off and then on again. Then it empties and goes to rinse but wont come out of the rinse cycle, just keeps rinsing, until I turn it off and on again.Up until now its been a great little dishwasher. JOAN


... LG Dishwashers

I have a Hoover dishwashe HND 6515. I put it on the universal 65c programme this afternoon and sfter 5 mins it started a continual beep beep beep noise and the red light on the universal button was flashing, I then notices it was emtying water all over the kitchen floor, seeming to come from under the bottom of the door. I turned it off and when it finished pouring out water opened it up and the bottom of it is full of water which will not drain away. I have checked the filters and they are all


... Hoover Dishwashers

I have a Teka DW6 55 FI Dishwasher which as the following fault, The frist 4 cycle indicator lights are on and it beeps about 6 or 7 times and the water pump is running,It then starts beeping again, all the time the pump is running.It dose empty the water.I tried holding down the program key and turning on but that didnt clear the error. Many Thanks Paul Luhman


... Dishwashers

Hi my whirlpool dishwasher adg 450 won't work, I turn it on an it makes a noise asif its working but then it starts beeping then starts them stops an beeps.so on, then a red light comes on with a picture of like a sun.there no water and the blades have not moved


... Whirlpool Dishwashers

My Baumatic BDW15 won't start - you push the power button, all the lights come on for second, it beeps and then goes dead. You can't program it or anything.rnThis started yesterday when we came to empty it, it was full of water and the detergent tablet holder hadn't opened. I've tried turning it off and on again at the wall but it makes no difference - any ideas?


... Baumatic 23 in. BDW14 Built-in Dishwasher

Hi. I have a smeg slimline DF140 BA dishwasher. It will not start any program. The lights come on but it just makes beeps and doesnt start. Have tried turning off and trying to cancel the cycle all to no avail. Please help


... Smeg 18 in. DWF409WH Slim-Line Free-standing Dishwasher

Dacor MDV24 dishwasher. I press cancel to turn it off and it works but after approx 10 seconds the start and normal button comes back on and beeps. I tried shutting the breaker and holding the cancel button for a long time but it still always comes back on. Got any suggestions?Motherboard or faulty buttons?


Hello &\015\012Welcome to FixYa\015\012\015\012If you have\015\012also checked the door lock-latch assembly and that is fine then yes it is the\015\012control board that is bad and needs replacement. Please get back to ... Dacor Millenia MDV24 Built-in Dishwasher

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

We have a Blomberg dishwasher. We came to a finished cycle to find water in the bottom. We have removed the water by hand, cleaned the filter and the hose. The lights come on, but it doesn't respond when trying to run a cycle. It will do it's ''finished cycle beep sequence'' at the end of the cycle that it didn't actually run. We have reset it by holding down the start button. Turned it off and on, etc.


I am curious what the repair guy found. We have the same problem. ... Dishwashers

Dishwasher does not wash simply beeps continously and wont start the rinse cycle with green flashing pre rinse light. Have tried turning off at power and have checked all connecting pipes. Have emptied dishawasher also all to no avail.


If your dishwasher is a whirlpool or IKEA then maybe the answer given by emmanuelr in "Whirlpool dishwasher ADP5962 F7 error code" may do the trick. It certainly worked for me. Bit technical but if you are happy taking the sidepanels off the thing th ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

My dishwasher will start any program, it drains, fills, empties & beeps continually within a few minutes. The rinse light stays on until the machine is turned off & re-set. Aditonally, the ater heating has been hit & miss for some time! A service guy cleaned the water sensor with hot water fro a ketle + tooth brush, but the problem came back after a couple of weeks. Having removed item he cleaned, it looks fine and appears to switch OK. Not sure if its actually faulty. Is the themperature sensor


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

We have a Nautilus dishwasher which we kept during our kitchen renovation. When the dishwasher was installed back in it was tested and all was okay. However when the guys left and we started the machine it was for 98 minutes as against the usual 90 minutes. We were happy with this but now we find that at the end of the full cycle it does not turn off and continually beeps. It will not turn off by pressing the off button and you have to open the door. When you start again it immediately starts wi


Hi\015\012\015\012To reset you can leave the unit unplugged for 1hr, then plug\015\012it back in, you can also reset the controls by pressing the AIR DRY/RINSE\015\012ONLY/HEAT DRY button for 15 seconds. If the issue returns then the circ ... Fisher and Paykel Dishwashers

Hello, I have a beko 2341 fs dishwasher and I have a problem with it. When i turn it on to wash the red light above the "salt" part comes on. Ive filled it up with salt twice now and its still coming on when i turn on the dishwasher. My cutlery is starting to rot and glasses and coming out very cloudy . what could the problem be?


... Beko Dishwashers

I have a LG LD-14AW2 dishwasher, today I set it to run and came in and although the lights were still lit up the tome was not moving, I turned the unit off and waited a while then turned it back on. The power turns on and I set the type of wash but when I press start it beeps twice and won't start. Can you help, I have had nothing but trouble with this dishwasher since it was installed!


V\\:* {behavior:url(#default#VML);}\015\012o\\:* {behavior:url(#default#VML);}\015\012w\\:* {behavior:url(#default#VML);}\015\012.shape {behavior:url(#default#VML);}\015\012\015\012\015\012 \015\012 Normal\015\012 0\015\012 \015\012 \015\012 fal ... Dishwashers

Ge triton dishwasher model # gsd5560g01ss when trying to start push start button unit will not start but instead drying light comes on and beeps


... GE 24 in. GSD6660GSS Built-in Dishwasher

My daughter accidentally turned on our GE GLDA690 dishwasher. I can't seem to cancel it out without actually starting the cycle. I opened the door before the cycle started but now it is sitting there beeping. The obvious thing is to load it with dishes and run it. But it is just the two of us and we don't really have a load full. Owner's manual is no help. Even turning off the circuit breaker will not stop this infernal beeping. How do I cancel it? Why isn't there a cancel button?


... GE GLDA690MWW / GLDA690MBB Built-in Dishwasher

Hi. Our DS603I dishwasher starts on the Rinse cycle on its own - it beeps, red light flashing and no water entering the tub. It does this even if it is open. Similarly, when we try to turn it on to do a normal or heavy cycle, it starts (making quiet a loud noise) and then goes to the Rinse cycle, beeping, red light flashing, no water going into the tub. The pump wheel is turning. We can't find any blockages in the tubes. We have power-cycled it many times. Please help!


Dishwasher Repair Guide: How To Fix a Dishwasher - ACME HOW TO.com\015\012\015\012\015\012\015\012 ... Fisher DS603W / DS603B / DS603I Dishwasher

I have a Triton dishwasher. Last cycle, it completed washing then started drying and started beeping and the drying light is flashing. When I finally opened the latch, the beeping stopped, but the drying light is still flashing. The dishes were clean and warm - they air dried the rest of the way. I have not been able to get the drying light to go off. I have turned the breaker off over night, and flipped back on. The dishwasher goes back to flashing washing, and then clicks to drying and th


Hi,\015\012Make sure the salt level is ok - add 1Kg of salt if you have not done it in a while, and check rinse-aid level if apliccable.\015\012\015\012If this does nothing, then remove the lower kick panel for access to a data shee ... GE Dishwashers

Hotpoint BC145 Dishwasher not cleaning starts to kick in but then just sticks on the "R" light flashing and cannot reset even after turning off. Itbeeps when pressing the select button sound weaker and shorter than they used to and the light does not move from the "R". On a couple of times I have tried it has reset and then the dishwasher starts but after about 3 minutes there is a low beep(not the usual beep when a programme finishes) and the washer stops and the light is flashing on the "R" ag


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

The GE Profile Dishwasher will not allow me to start without the heated drying light coming on. I want to wash without this headed drying at the end of the wash. When I try to turn it off it turns the start cycle off. This happend over and over again when I want to turn on the machine, It finally lets me get an unheated dry wash started to complete. A problem every night. PDW7800N15CC. Serial MM8243388


... GE 24 in. Profile PDW9800J Built-in Dishwasher

Whirlpool Dishwasher ADG 450. Start as normal and it keeps intermittentlly stopping and starting. Washs / drains fine, but sometimes cycle seams to last for a couple of hours. I think it is four beeps when it is stopping and then immediately starts again. We had a problem months ago where as the sink was draining into the dishwasher out pipe, so dishwasher wasn't draining / filling up. Fixed the problem by turning the pipe the other way so water couldn't flow that way - but I don't know if that


... Dishwashers

I have F&P DD603 with problem with bottom draw. Once a programme is selected and door is closed, the dishwasher beeps three times then tries to start itys cycle. It then starts but stops every 1-2 minutes (like pause botton has been pressed). If you press start again it starts for 1-2 mins then stops again. I have tried turning off the power and totally cleaned out the dishwasher but no change? Any suggestions?


Hi \015\012When you pull out the drawer, pay attention to the bottom near the bottom front panel, you will see a little tab. this tab is at both sides of the drawer, press these tabs in and pull the drawer fur ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2187 seconds