Having problems with your Dishwashers ?

The Bosch plastic push button (AP2804452) has broken on my SHU9950 dishwasher. The switch itself is still good. I have removed the broken pieces of the bad button from the unit and am now depressing the switch without the button. When I get the new push button, what is the proper way to remove the control panel cover to put the new button in place? Thanks!


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The Bosch plastic push button (AP2804452) has broken on my SHU9950 dishwasher. The switch itself is still good. I have removed the broken pieces of the bad button from the unit and am now depressing the switch without the button. When I get the new push button, what is the proper way to remove the control panel cover to put the new button in place? Thanks!


... Dishwashers

Hello I recentley repaired a broken door latch on chef electronic diswasher the push button type not the rotary switch style. i had to disconnect the circuit board I wrote down the were the wires connected i have discovered that when I reconnected everything i had not got all the wires in the right place is there any way I can get a wiring diagram so I can connect the wires correctly thank you


Unfortunately as i know it is difficult to find a wiring diagram. Better try an authorized service station where they may have similar appliances. ... Dishwashers

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

I've tried to use this new machine 3 times. Each time it was never turned off until I pushed the cancel/drain button. Once I let it run for 2 hours before turning it off. This evening I tried the rinse only button and when I checked on it,it had switched to the normal wash cycle. Then I pushed the cancel/drain button.


If this is a new machine and it's under warranty, Have a technician come out and repair it as soon as possible. then fully test it's operation after he is done fixing it . It sounds to me as though it ... Whirlpool Gold GU2275XTV Builtin Dishwasher

I have a magtag quiet 100 series that has a broken handle but still shuts tight and seems to lock yet. Problem seems to be that the rinse only light will stay on for quite a long time and won't let me hit the wash button. When the rinse only light does go off, if I hit the wash button it starts but then switches to rinse only. Sometimes I can get lucky and get it to stay on wash after the rinse button is off for some time. Any suggestions?


... Maytag 24 in. DWD1500A Built-in Dishwasher

I have a bosch SHV43A03GB dishwasher. It has a problem when it cut out water flow in. the guy who repairs it seem s only to have to push a button or switch under the machine to get it to work again, cant find switch/ button- please help!


Programmer not working ... Bosch 24 in. SHU53 Built-in Dishwasher

The on off selector switch on my Blanco d/washer BFDW 670S no longer works unless I stand with my finger on the button at which point the light comes on and the dishwasher swings into action. Apparently I need a new selector switch at some considerable cost and delay (not in stock from my supplier). Any other suggestions? Once the light is on, everything works as normal but the button just won't stay depressed. Thanks, Jan


... Dishwashers

Start Button doesn't light. Tried to get it lit by opening and closing door and pushing all other button options. All other buttons light and seem to depress or click when pressed - the start button doesn't.


Does the dishwasher work as normal? If so, most likely that LED burnt out. ... Dishwashers

Hi i have a smeg df 410 sdx 450 wide dishwasher that is coming up to three years old ,the fault it has developed is that it wont switch on ,press the button and nothing happens,no lights or the normal beep.240v is getting to the button and when the button is pushed on 240v comes out the other side and goes to the various pcb's but the appliance wont do any thing,can you please give me some ideas.


... Dishwashers

Hi, I have the Bosch Logixx Dishwasher . BOSCH SGS0922gb /06 .. aged about 6 years old .... When I press the on/off button 'on' the led display only shows the 'not started' message. When I press the on/off button 'off' the led display lights up momentarily with 'start' etc just before I have fully released the button. I have tried a new switch and the same happens so not that. ALSO i can sometimes see S1....> on the top panel and get the machine to show on the top panel the close door


... Dishwashers

Model mdb7601awb diswasher . Nothing works , no buttons torn on or work when pushed, no action. 1.Have checked power to unit and is ok 2.checked door switches (2) and both work properly. 3. no visual discoloration on circuit board. There is a blue dot on the wiring harness from control board to button panel.When evaluating with magnifing glass I believe this to be blue ink droplet and not any burnning of harness. Need a Guru.


I have had the board replaced 5 times and the entire dishwasher replaced once. It was necessary to go to the state attorney general to get Maytag to extend the warranty. Just called the service center for the sixth time, after this the warranty will ... Maytag 24 in. MDB7601AWS Stainless Steel Built-in Dishwasher

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

I have a Whirlpool dishwasher mod. number GU2400XTP6 the clean light flashes then stoppes when the start button is pushed. the light on the start button flashes three times and stoppes then the clean light starts flashing again the machine dosen't start. I've checked the micro switches in the handle release and they are working fine. will I have to replace the main computer module? If so were do I get it and how much dose it cost?Thanks


... Whirlpool Dishwashers

I have an Asko 1805 Dishwasher. I've looked at some of the other responses and have this sinking feeling after tonight's series of unfortunate events. Tonight, I pushed on the On/Off switch on the left and it appears to have broken. The dishwasher no longer turns on. If you push in and hold the button, the lights come on, but when you let go, they turn off. This appears to be Part 763255 on RepairClinic.com. I also need the overlay/decor insert across the top of the control panel which app


Hello Rick,\015\012 \015\012Welcome to FixYa.\015\012 \015\012The "very instructive, but poor resolution" info you've referred to in your post was indeed a previous solutio ... Asko 24 in. 1805 Built-in Dishwasher

Hi! We have a GE Profile PDW9280J0SS with electronic control malfunctions. I can't get it out of the ADDED HEAT mode and many of the other button lights won't light up. I've flipped the breaker several times, and this does (usually) reset the controls to "Normal" and "Heat Dry", but when you push "Start" it switches back to the ADDED HEAT mode. When it goes through this cycle the soap dispenser doesn't open so the dishes don't get clean. I can't use the arrows to select different types of w


Not a specific fix, but I can tell you I have this same exact model dishwasher, since 2005, and it has been services for touch pad button problems at least a dozen times. I am in fact on the phone now with service scheduling another visit because i ... Dishwashers

Kenmore Ultra Wash Quiet Guard 4 Dishwasher model 665160344000 normal wash light keeps flashing. I have done all of the push this button and that button combinations I can find on the internet. I unplugged and repluged the 14 pin ribbon with power and without power --no joy. Looks like I need a new part - which part?


Hi\015\012\015\012Open the door. Within 3 seconds press the following sequence\015\012--Try pressing normal wash, heated dry, normal wash, heated dry, normal wash,\015\012heated dry three times within 6 seconds and then press cancel to re ... Dishwashers

Maytag MDB 8600 AWB dishwasher Wouldn''t start... just a Heated Dry light. Replaced (already broken) door handle with complete latch assembly. Still, Heated Dry flashes. Tried various suggested combos of 5 or 6 quick button pushes followed by Start. Only get a 50-=countdown that repeats endlessly. Sometimes alternates with the letter L. Once by luck I guess it went into Heavy Wash mode, or at least the diagnostic for it. Completed this fine, then back to the stubborn Heated Dry light.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a 6th sense dishwasher purchased new October 2004. It has been working properly and then has just stopped the next time I tried to use it - it will not turn on no matter what buttons I push - no response. I have checked the power out let with another appliance and that works so it is not the power supply from the power point. I can only think it must be a fuse or the controller. Can you please advise best course of action? Thanks Helen


I rang the appliance man to fix the problem.\015\012\015\012Thanks anyway Helen ... Westinghouse Dishwashers

I have a kitchen aid dishwasher that is stuck on the clean cycle. It will drain water, but no water seems to be getting into the washer. If i push the start button, cycle will not start. The clean light is the only light that will stay on. the other lights will go on, but they eventually go off without starting the cycle. Is this the thermal fuse???


... KitchenAid Dishwashers

Unit will not start after pushing the selectin buttons and makes a clicking sound. Also it kicks the switch panel rocker off; and you can get an electrical shock from touching the unit.


I bought a new dishwasher and got rid of this LEMON. And the new one is NOT A KITCHENAID! ... KitchenAid KUDS24SE Built-in Dishwasher

Can i get a replacement switch for a bosch exxcel sgs45eogb56 also can you buy a new front panel .the panel that covers the control buttons , thanks


There is a wqebsite called www.appliacneart.com that makes many different options for your dishwasher replacement panels. I know they have black, white, and stainless, but they also have a ton of other options like fireplaces, and paintings. Check ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Normal wash cycle- tub fills (?), then comes a loud hummmm and nothing happens. I noticed water level didn't reach heater coil and added water until limiter switch clicked. Still just a loud hummmm. Machine was well into its regular cycle when this first occurred, but now, won't even get past initial fill. Pushing the "Cancel/drain" button activates motor and pump: they work fine.


You are an expert enough reading this. But with a terrible complicated dishwasher. First clear the waterlevel problem.\015\012Rest is a result. You do not need me, join us. Next time buy something more plain. ... Dishwashers

Maytag dishwasher mdb7601aww program not working right. Lights on display not lighting. Push button and it reads 2 hour delay. Cannot get it to run without delay. Thanks, Bill


... Maytag Dishwashers

How do you get the child lock off? New Bosch dishwasher The active, Rinse Agent and Wash light are red, but when you push the start button the Child Lock light come on.


... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1626 seconds