Having problems with your Dishwashers ?

Looking for a door assembly manual for Diplomat HJA8630, (hinge / tension spring faulty)


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Looking for a door assembly manual for Diplomat HJA8630, (hinge / tension spring faulty)


... Dishwashers

Hello! I have a Kenmore Dishwasher Model # 665.15805890. The dishwasher came with the house and I'm guessing it is around 10 years old. My toddler was having a great time flipping the door to the soap dispenser back and forth until he pulled the door off of the pin. Now, I can't seem to position the spring in a way so that the door will spring back. I never looked closely at the hinge before, so I don't know if that is the only reason the door will not release the detergent, or if something


Hi.Please see if the diagram here can help you. Check if the spring is that indicated with nr ten in diagram. ... Kenmore Dishwashers

Hello,I hope you can answer the question below for me. My dishwasher is a Hotpoint model BFI680 - integrated. I want to replace the old interlocking assembly with a new one as the spring has broken and I can not close the dishwasher door. I have trouble removing the old interlocking assembly though. I can not see any screws that keep it into place as with other models. Instead, it looks like that it is "clipped" to the dishwasher door via the two inner side round holes at the bottom. Tried to re


... Hotpoint 23 in. BFI68 Built-in Dishwasher

I have a GE dishwasher (purchased in1992) the door falls open I suspect a broken spring. I looked all over the door hinge and cannot locate a spring(s). Where are they located. Also because of the age would I be better off to just replace the washer?


... Maytag Dishwasher

LG Model LD-14AW2 - loud bang and door dropped open as if a door hinge or spring snapped. Are both sides of door normally supported. Are parts available to repair. Where do I get a manual. Colin


Hello- Parts are available locally at app. parts store. Need complete model #. Usually have to pull out unit to install. Replace both sides. There will be a spring, sometimes with a cord to pull door up. Either part can break, so get both. Not easy, ... LG Dishwashers

Tension spring on Frigidaire Gallery Series door broke.


... Hobart 41 in. AM14-255 Free-standing Dishwasher

My KitchenAid dishwashers door will not stay shut. I have replaced both hinges, the plastic rollers for the tension lines that atached to the spring. Still no luck. Could it be that the locking (?) switch has worn out?


Sure thing. \015\012Our dishwasher is one that we put our own "Door on it" in our case, it matches the cabinet. It is designed for that. \015\012I went on-line and ordered the replacement parts. I can't recall the site but I will look thr ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Bosch dishwasher SHU3032 UC/14. The soap dispenser does not open. In the past I've used dishwasher magic or similar to clean the dishwasher of hardwater deposits and that solved the problem. The cover opens and closes manually. The springs seem fine. I removed the door skin and the linkages look good. I checked the resistance on the Wax motor and it is with in spec, approximately 2150ohms. I 've watched the cycle and the wax motor never seems to actuate. I put my meter on th


... Bosch Dishwashers

I am looking for a repair manual for a Kitchen Aid KUDL02FRSS1. The spring broke on the door.


... KitchenAid Dishwashers

How replace door hinges and spring assembly blanco dishwasher bdw 206


... Dishwashers

I found the problem with my dishwasher, a spring in the handle (154556703 Frigidaire Dishwasher Door Latch) had broken. All I need is the spring, not an entire door latch assembly. Is there any way I can get the part number for the individual spring? V/r Matthew Quirk


... Dishwashers

I have an Indesit DV62WHUK dishwasher and the last night the door made a banging sound when it was opened and now it won't close and will fall back under it's own weight. I suspect either a spring, spring cable or a hinge has broken. How do I check this? Is the spring mechanism in the door or main unit?


There is a plastic unit behind the door handle which houses a spring under tension. This latches the door closed and makes the electrical connection to allow the machine to work properly. You need to buy a new unit (\302\24315) which is a bit fiddly ... Indesit 23 in. DV62 IX Built-in Dishwasher

Door wont close - I have taken off hinges and they look ok. Is it possible that the hinge opening on the inner door has been stretched when I overextended the door with heavy turkey pot


It is very likely the control lock has been set on the oven. This means the door latch is unable to enagage with the oven lock. If you have turned off the power at the circuit breaker and there is no change, then you may try the Cancel button on the ... KitchenAid 24 in. Built-In Superba Series Dishwasher w/ ProScrub Built-in Dishwasher

Door dropped Opened door on my FDB421RFR and a loud cracking noise occurred - now the door drops quickly. I guess the spring(s) have broken - does anyone know if the spring is on the rhs looking at the front? I sure hope so, I can probably access that side without pulling the unit out! Is it good to spray these with WD-40 or do they just age anyway?


... Frigidaire 24 in. FDB421RF Built-in Dishwasher

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

How to replace door springs on Whirlpool Diplomat dishwasher ADP8630


... Dishwashers

The spring or balance in the door on my dishwasher Zanussi DW917 is no longer working, so that the door just drops unless held manually. How do I get to it to replace or where can I get a service manual with this information please?


... Dishwashers

Opening and closing the dishwasher door makes a very load squeaking noise, as if a spring inside the door hinge is rusted and needs lubricating. All the lubrication I have done at the hinge and sides' has not helped. Can you help? Thanks Steve


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I fell on to the dishwasher door when it was open and now the door will not close properly,therefore can't use it. hinge seems to be bent need to see what the hinge looks like before attempting repair


You'll have to pull the dishwasher out from under the cabinet to get to them. ... Dishwashers

Granddughter stood on dishwasher door and now it goes down too far when opening. Spring assembly (pulley type) is FINE...but door goes so far down bottom shelf nearly breaks dishes when pulling out


This happens when people leave the door down, I've seen it many, many times, sometimes the door/hinge assembly can be replaced or even bent back, sometimes it totals out the unit...Good luck !\015\012\015\012RMK...\015\012Retired GE ... Dishwashers

I have a Maytag DWU8250BAX and the thing leaks like crazy. I just replaced the door gasket, but that is not the problem. When I took a closer look at the door it seems as though the water is getting up and into the door through a space in the bottom of the door. It seems to me like there should be another door seal to fill a gap that sits between the door hinges. If anyone knows if there should be a seal here and then what the part number might be that would be great. Thanks!


There is an airgap under the door..it should spray up and run down the door not spray up under it..look for crack or hole in spray arm..if there is the wrong soap in it it will flood out with lots of bubbles..just have to flush it out. lastly, if you ... Dishwashers

ARISTON ARISTELLA LS 603 A Faulty door


... Ariston Technologies L63 Free-Standing Dishwasher

16 year old GE built-in dishwasher, model GSD900. Springs that prevent front door from falling disconnected. ALL parts APPEAR to be in good condition. I say appear in good condition because I don't know what they are supposed to look like. But I see nothing obviously broken. The 2 springs appear intact. The connecting cable is good. However one of the 2 springs is shorter than the other. It may be shorter because one is supposed to stretch to the other side of the dw? So number 1


... GE Dishwashers

Door interlock appears faulty on my whirlpool awm 321 . It wont allow program start when door closes . Needs a lot of coaxing , banging with palm of hand , knee etc .Door itself appears fine , catch looks ok , finishes and runs ok once we finaly get it started .Hve tried pressing the interlock slider in with a pencil , but cannot succeed in pushing the contacts into place and starting the program . HELP PLEASE


Only solution is to replace the interlock - it is just held in by 2 screws ... Dishwashers

Dishwasher door When I opened the door I heard a pop and now the door drops to the fully open position. It used to stay as open as I pulled it, but now there is no tension as if a spring broke.


You're right a spring has either snapped or come off of it's anchor point. Should be 2 ...one on each side of the door. you can order parts on line at several appliance replacement part suppliers... have your make and model so you'll get the right pa ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0930 seconds