Having problems with your Dishwashers ?

I have a kenmore ultra wash model # 1571591 and this blue long thing came out i cant figure out where it goes into ?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a kenmore ultra wash model # 1571591 and this blue long thing came out i cant figure out where it goes into ?


... Dishwashers

I was replacing the hose and a little spring popped out of somewhere. The spring has a clear plastic end also. The whole thing is about an inch and half long. I believe it goes with the yellow trigger handle but cant find where it goes


... Karcher K2.26 Electric Power Washer

My dishwasher is apart (bottom and all tubes, pump looking things) but I'm having trouble remembering where all the tubes connect to. There are three wide diameter tubes (short, medium and long) and two really thin tubes. I need help figuring out which tube goes to which opening.


You have one tube from pump to agitator, one to the sink and one coming into the washer for fresh water. If you are wondering about the supply tubes into the tank from the pump, the pressure is the same for all hoses. ... Dishwashers

Water tower The water tower came off of my Kenmore Ultra Wash III dishwasher. I cannot figure out how to get it back on. There is a gasket on the water arm. Does the water tower actually go on top of the bottom rack? And if so, then how?


I had the same problem finding a Water Tower laying in the bottom of the dishwasher. Solution is to simply lift the bottom rack and insert the tower into the center-most square hole. Twist the tower with the large lip on the bottom of the rack and th ... Kenmore 17439 Built-in Dishwasher

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

I have a Kenmore ultra wash sensor quiet guard plus. I am not sure of the year. My problme is this: I came home and the lock light is on. The door opens and closes, but I can not wah the dishes. No other lights will turn it on or off. The no heat dry button has the lock symbol on it, but I can not figure out how to turn off the lock. HELP!


The manual will tell you how to rest and take off lock. ... Dishwashers

I have a kenmore dishwasher model #655.1374 or 655.1384 which is only about a year old. I am having a problem with the controls. It will not allow me to use smartwash. The only control that can be used is quick rinse. I reset it by pushing Sani rinse and heated dry. All the lights come on and it seems to do a test. But after that still the same thing except if I push start resume it goes to normal wash which stays on a long time and periodically the cancel drain light comes on as well as the 4


... Dishwashers

Kenmore My dishwasher was in my home when I purchased my home. It is a Kenmore Ultra wash 2, I am not sure which settings to use for basic dishwashing. When I run it it runs for over 1 hour. I don't want it to run that long.


Make sure you run water in your sink until it is hot before you start the dishwasher. On the newer dishwashers they will fill and drain until the water is hot enough so it takes longer if it starts with cold water. Normal time for a basic wash coul ... Kenmore 15129 Built-in Dishwasher

My dishwasher's lower and upper blades won't spin and i found a little plasitc ball looking thing in the bottom when i unclogged a few jets. I can't figure out where it goes though? need help on both things.


... Dishwashers

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

Kenmore Elite Ultra Wash QuietGuard 7 skipping washing cycle.


... Kenmore Dishwashers

I have a kenmore ultra wash dishwasher mdl nbr 665.1304 that wont close. the lock appears to be stuck but the door is open and i cant get it to close. any help would be appreciated. i am a single m


... Kenmore Dishwashers

Same problem I have a Kenmore model 665.13572K700. The spring has come loose, I can see the spring but can't figure out how to get it back in place or where it goes. Anyone have any ideas?


Spring is probably to the door or to the frame. This is usually what gives the tension for the door to snap back in place. There will be a series of holes on the bottom of the frame where the spring locks in. Remove the kick plate and shine with a ... Kenmore 15762 Dishwasher

Kenmore Limited Edition Ultra-Wash + QuietGuard dishwasher. Model number 665.110729521. Purchased from Sears Canada about 10 yrs ago. Symptoms: Cycle really long. Takes about 2.5 hours. Sensing light stays on all the time during cycle.


... Kenmore Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Help - the screws holding the dishwasher under the counter came loose & fell down the drain... how do I disassemble the interior to retrieve them? Kenmore Elite Ultra Wash Dishwasher, model 665.16269402


Yes remove the baskets and the spray arms and the flowplate assy get the screws and reassmble. good luck ... Kenmore Dishwashers

Why do dishwashers have SO much longer run times today than those of the past? Our new Kenmore ''Ultr-Wash'' has extremely long run-times. How can that possibly be a good thing in terms of saving energy?


The latest models all pride themselves in doing a perfect job, almost silently, using much less water than the older models [thus the energy savings] as the most costly part of a dishwasher wash used to be the cost of the hot water. Your dishwasher ... Dishwashers

I have a kenmore ultra wash mod# 665.13492k600 dishwasher that in the last couple of days will not drain the last cycle . If you push the cancel /Drain button after the cycle is finished it will then drain but all the dishes have soap spots on them and are very wet .I have checked for clogs but cant find any I have also run a lot of water throug our waste disposla because the dishwasher drains into it help ??


... Kenmore Dishwashers

We have a Kenmore Ultra Wash Dishwasher Model number 665-13859K601. The Normal wash and the Cancel (drain) buttons are flashing red on the control panel. No matter what we have tried, we have been unable to correct this problem. Obviously the dishwasher does not function. When you close the door the lights keep flashing and no button combinations seem to do anything. I have looked at the troubleshooting guide that came with the dishwasher, however there is no


... Dishwashers

I have a frigidaire dishwasher model fdb750rcc1. The wires somehow came loose while trying to fix the handle. I found a place for each wire via the wire diagram, however there is a green wire loose and I cannot figure where this wire goes.


... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

Have a kenmore ultra wash dishwasher model #15779, the lock button is lit at all times, we can't figure out how to turn it off, have tried holding the no heat dry button for the required 4 seconds doesn't work???


... Kenmore Dishwashers

I have a hotpoint i found a blue rubber band laying in bottom of dw then wks later a clear rubber band thing laying in bottom. my dw still works fine just can't figure out where they came from


... GE Nautilus 24" Built-in Dishwasher

I have a kenmore ultra wash dishwasher model 15951 and mid cycle the timer goes to 2 minutes and i can't get the dishes to go through a whole cycle. any help will be greatly appreciated . thanks so much


... Kenmore 24 in. 15689 Built-in Dishwasher

My Kenmore ultra wash dishwasher model 665.1374 will only work if I press the restart button. When I do it goes to pots and pans with the drying cycle light lit. I cannot get the smart wash, normal wash, or quick wash buttons to work.


... Kenmore Dishwashers

Kenmore elite ultra wash dishwasher #66516572,green light flashes 7 times then phases. cant clear help! lee


Look for a reset button, or manually reset it, buy unplugging it. Refer to the owner's manual or call customer support. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0636 seconds