Having problems with your Dishwashers ?

Takes a while to start. INtermittent problem with shutting off in the middle of the wwash. Leaking. Washer is 4 yrs old max. Thx, Celia


Answers :

You probably need to take off bottom cover plate and investigate either...furry critter or loose motor belt. Try to blow out all of the lines with compressed air.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Takes a while to start. INtermittent problem with shutting off in the middle of the wwash. Leaking. Washer is 4 yrs old max. Thx, Celia


You probably need to take off bottom cover plate and investigate either...furry critter or loose motor belt. Try to blow out all of the lines with compressed air. ... Dishwashers

I have a Bosch SHU43 dishwasher, about 6 years old. After starting a cycle, it will run for a while, perhaps 1/2 to 2/3 of the way through the cycle, then shut off. After 10-20 minutes it will start up again, run for a few minutes, then shut off again. It ends up taking about 12 hours for a cycle to finish. The problem started off somewhat intermittent and has gotten worse over the last few weeks. I've checked the electrical box in the front right bottom, and the connection is good. I've even


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`m not sure since you didn`t mention it or perhaps I just interpreted it this way, but is it consistent at the same time or approximately or is ... Bosch 24 in. SHU43 Built-in Dishwasher

Our dishwasher came with our house. Brand new. It is 2 yrs old now, warranty gone. The problem is when you shut the door the machine starts running immediately and keeps running and running and running. You can push the stop button, delay button and it still runs. Also, doesn't clean. model# FDB1050REC4


... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Have a 4 year old Kenmore Dishwasher Model # 74382. No problems at all until last week I went to start it and it would not turn on. Lights on the control panel were on with exception to the start light. I opened and shut the door to make sure it clicked and pressed the start button again and nothing. I tapped around the panel with the side of my fist and pressed it again and it began working. Well today different story I went to start it and it did the same thing. I tapped all over front of the


The problem is more likely the door switch is failing or out of adjustment/loose. You will need to remove the door panel. This is easy to do. There is a video at ... Kenmore 24 in. 74382 / 74384 / 74389 Built-in Dishwasher

I have a Whirlpool model DU1055KJVQ1, Type 575-0 under-counter dishwasher which is less than 2 years old. In the last couple of weeks, it wouldn't start intermittently, and I would need to hit cancel on the keypad, and then restart. Now that doesn't work. When I try and start the dishwasher, it doesn't work. I press Normal for the cycle, heated dry for the Option, and then hit Start. The buttons light up for 20 seconds or so, nothing happens and then they go out. Any ideas?


... Whirlpool Dishwashers

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers

Hi I have a Zanussi ZDF501 dishwasher that stopped heating up intermittently. It got worse and I fitted a new heater and all was ok for a few months. Then the intermittent failure started again. Note that I tested the old heater and it is actually OK without a short circuit so I don't think it was the problem adn can be re-used. Could it be the thermostat or heat sensor? I am concerned it might be the PCB since the failure was intermittent. Thanks Dave


In my case, although the solder joints on the relay looked poor, improving them didn't help. I had to replace the relay. Fortunately, Maplin stock a compatible one, JM67X for 1.99. See ... Zanussi Dishwashers

Kenmore Dishwasher- Console panel not working right , sometimes it starts and then shuts off in the middle of the cycle. Sometimes multible function lights are flashing but dish washer won't start


... Kenmore Dishwashers

When starting wash cycle the dishwasher cda cw447 doesnt appear to be getting enough water in and is making a droning / whirring / electrical ? noise. pipes all connected ok inc aquastop water supply unit, no kinks etc. machine 3 1/2 yrs old, just started making this noise. appears to complete rapid cycle but still making unusual sound. water drains away fine from this cycle, dont believe pipes / hoses are blocked.


Try removing the inlet pipe, and refitting, might fix it, else likely that the \015\012Inlet water soleniod failing/failed or tiny mesh filter (it does come out for cleaning) behind the inlet hose clogged. Temporaily bypass the aquastop water s ... Dishwashers

I have a 1 year old ridgid 3300psi 3.0gpm 7hp subaru fuel injected EX21FI engine. Once warm the engine will periodically surge for 30s to 2minutes. Wondering what i can do to fix the problem, it has done that since new. Also, once it is warm and you shut it off, you have to wait at least 30m to start it again...almost like it floods itself when it is shut down? Thanks


... Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered

My dishwasher will not start. I push the green start button and it stays solid and I hear "clicking" intermittently for about a minute....then it cancels itself off (led turns red) and shuts itself o


... Amana ADB1400PYS Tall Tub Full Console Energy Star Dishwasher in Stainless

My TDK795 (not 3, 13yrs old!) starts beeping constantly at the start of any cycle or in the middle (I guess before the rinse) then stops without finishing. There is no water left at that point, so I guess there are no water blockages or any other visible faults. I wonder if it is an electronic fault?


... Tecnik 24 in. TKD795/3 Built-in Dishwasher

Hi there,i have a brand new but 3 year old,diplomat 8332,just fitted it,it does the pre was ok,pumps out the water,goes to next stage,you can hear water entering the machine,shortly after it has started the main wash,it starts to cut out intermittantly,then F2 code appears,and a bleep.i have taken the lower panel off and checked for leaks and to see if the valve was free,all ok,also relay click in front panel,safety cut out ? any ideas please.


... Dishwashers

Our GE dishwasher (5 yrs old, Model GLD4250L00CS) only fills with water half way when the unit is started. The inlet valve was replaced with a new one, but that did not solve the problem. When started, the dishwasher fill cycle runs for 41 seconds before the wash cycle begins. Repair workers told us we probably need a new ECU (Electronic Computer Unit). My questions are: Is 41 seconds the correct time for the fill cycle for our model? What else could be the reason for the unit not filling pr


Hello &\015\012Welcome to FixYa\015\012\015\012Check this\015\012 ... Dishwashers

Miele Advanta G2170 working fine 2 yrs, suddenly starts popping breakers and won't run (on any outlet) Electrical system in home is about 3 yrs old only.


Hi dear.If the washer is tripping circuit breaker,as long as you plug in,there is a Interference filter capacitor inside of the machine.Main power gets connect there first.It should be faulty & needs to be replaced.I hope that helps Thanks. ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

My Kenmore 16533 dishwasher all of sudden started running really loud on the wash cycle. I stopped the cycle, drained the unit, and looked for something obstructing--found nothing. Started it up, and the problem persists. The dishes do come out clean, however. The dishwasher is 6 yrs old. Is this a problem I could fix, or do I need a repairman? Is it worth the expense of a repairman, or is it time for a new unit?


... Kenmore 24 in. 16533 Stainless Steel Built-in Dishwasher

When I turn on the shop force 1750 electric power washer I get water pressure in intermittent time frames. For example, it may run for a second then stop for ten seconds, then start again for three seconds then stop for 3 seconds then start for a half a second then stop for five seconds etc. until ?. This type of pattern continues for at least ten minutes, which is when I give up. I have tried adjusting the the water hose pressure, high, low. middle, nothing changes. This happen when I have the


The usual cause of this is sticky Orings in the water admitance valve.\015\012\015\012Take the valve apart and clean the bore with crocus cloth wrapped around a rod and replace the Orings and lube with a bit of plumber's grease and reasse ... NIB Shop Force Universal Pressure Washer Accessoriesnib

Dishwasher shuts off in the middle of a cycle and shuts off as soon as you try to start a cycle. Any Idea if this is the main control board or what this could be?


... Dacor ED24 Built-in Dishwasher

Less that 2 yrs old..door wont latch. As a consequence machine won't start.


It is possible the door latch is faulty or the springs at base of dishwasher are soft and need adjusting. the springs keep the door in position. refer ... KitchenAid KUDS30IXBL Builtin Dishwasher

Mdbh979aww2 wont start. 3 yrs old


... Maytag Dishwashers

Cloudy Dishes This condition suddenly started after couple of years. Water heater is 7 yrs old, never drained, therefore I think this could be the problem. I am going to drain it and report. I do have a whole-house water filter which I change out monthly or every other month. My guess is that without it, this problem would have surfaced long ago.


The problem is hard water. Go to www.dishwasherfilter.com and get their new product. It filters the water and takes out the hard minerals that cause spots and clog di ... Amana 24 in. ADB2200AW Built-In Dishwasher

My Maytag mdb8600awq (7 yrs. old) will start , dispense soap and then just hum, no movement or cleaning action. the timer counts down, but nothing wlse...


There is a capacitor in the motor winding that fails and causes the motor to not start, just hum. It will need to be replace. You will have to get into the machine and get to the capacitor and remove it, it will be right nest to the motor. The cap ha ... Maytag 24 in. MDB8600AWS Jetclean II Built-in Dishwasher

Detergent sticks in main wash compartment. We use cascade complete with bleach (hydroclean action). When this problem started, I switched to cascade complete (liquid) and still same thing happens. The dishwasher is only 3 1/2 yrs old. Have used cascade complete since day one. Only difference is that this one is the one with the bleach. Could this be the prob? We have noticed that it is thicker that just the cascade complete. But thought the liquid would of fixed that prob. Agh frustrated. We hav


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

CMA-180 Dishmachine-4 years old, used up to a maximum of 5 times a month. After 10-12 loads it shuts down, alto the lights are on, it won't start for about 30 minutes. Is it possible there is a heating element in the machine that needs replacement, or our water heater is not keeping up?


... Cma Dishmachines CMA 180 Free-Standing Dishwasher

I have an older (appx 20 yrs old)GE model 2200 dishwasher and recently started getting a C5 error. I understand the water input valve may be plugged. I don't have the owners manual. Where can I get one to locate the valve and strainer so I can trouble shoot this problem


Go to marcone.com, enter your model # and it will give you a full breakdown of the unit ... GE Nautilus 24" Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1300 seconds