Having problems with your Dishwashers ?

I cant figure out how to operate my simpson cascade 52 021 dishwasher it seems simple but it wnt work i dont know if its broken or if it just wont work


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I cant figure out how to operate my simpson cascade 52 021 dishwasher it seems simple but it wnt work i dont know if its broken or if it just wont work


... Dishwashers

I think I am finding small pieces of the wrap from the tablets in the small holes in the spray arms, one wont move anymore??? This is about 10 yr old maytag machine. I tried to clean out the spray arms but dont really know what I am doing. Bought a new diswasher, dont want to use the tablets if they will clog up the works. please advise.


Just prime the sink before you start the dish washer ... Maytag Jetclean II MDB8551A Dishwasher

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

Dishwasher wont work - starts but then stops and the light flashes. Have tried cleaning it out but dont know what else to look for?


Hello, Try this Crack the door open and then hit the following botton combination high temp wash - heated dry - high temp wash - heated dry then close the door and hit the cancel button. wait for the pump to stop. Hope this helps! Mike ... Whirlpool Dishwashers

Water wont drain from the bottom, removed hose and not stopped up. float switch is working but dont know how to test the discharge valve that controls where the water goes, either out drain or back into sprayers


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Bosch dishwasher the string on the door tensioner has broken I have the new part but dont know how to got out the lower part. Do I have to take off the hole door or is there an easy way to change it? It seems odd that as its string and must be prone to breaking that there is not a simple way to fix it.


You have to remove the entire dishwasher from under the counter. Then locate the broken cable. There is a panel you need to remove to access it. It attaches to a spring which goes to the underside of the dishwasher. Not an easy repair. Need alot ... LG 24 in. LDF 7811 Built-in Dishwasher

I have a karcher 650m, when assemlbed the off on switch wont work, when dismantled the switch seems to work, tried greasing the switch, anybody know how to fix this problem??


... Pressure Washers

Top arm does not turn in most of gibson amana an frigidaire this is done by ball in bottom of pump .it is clean.spray arm are clean .bottom arm move all the time.timer works it hesitates every so often and so ball will move an water should go up to upper arm but doesnt.common problem on these units but dont know how to cure?change ball.didnt work..on one unit changed pump cure problem for 4 months then returned....also does anyone know were u can buy the plastic they used to sell for dishwashers


Can yo give me the make and model number sol I can look at the service manual for you? ... Dishwashers

Broken dishwasher idl350 dishwasher fitted a new element but it still wont heat the water what coud the problem be. have checked on everything i can think of but it stil wont work. would it be eney broken wires it the door?


IF your dishwasher is a 220 volt unit find and reset BOTH breakers for it. Also make sure someone hasn't inadvertantly hit the"heat dry" button to off. ... Dishwashers

I have a John Deere AC2600Gh power washer and I can't get the soap to work everything else works great it just won't **** the soap up when I am pressure washing I know that it must be something simple to get it to work any help would be greatful. Thank You


Soap will only siphon into hose if there isnt any pressure in the hose attached to the wand.Remove tip from wand and see if it draws soap into hose,back pressure in wand hose will cause the spring and ball to seat/close off the inlet line for the soa ... Karcher 2500 PSI Pressure Washer

We have a Quiet series 200 Maytag Legacy Series about 2 years old. Some of the buttons on the push pad button panel won't work including the start button. Some will work and some some the lights are green so I know there is power. It seems maybe some of the buttons are broken down so as not to engage. Can the front button panel be replaced assuming that is the problem? Thanks, [email protected]


Hi\015\012\015\012You are right.... if there is power to the unit so the power\015\012board seems to be working fine and the control panel should be replaced. Hope\015\012this helps...please post back for further assistance.\015\012 ... Maytag Dishwashers

Dishwasher fdw60g fault lights i have the eco and prewash light flashing. i know that this means the filter is blocked. i have cleaned the filters and checked the hoses for blockages and they are all clear and kink free. i have tipped the machine on its side and checked the pump , which is clear aswel. i dont know what to try next to get the machine working and the lights to stop. thanks


... Dishwashers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

The wash cycle seems to take hours. the water wont drain away and i get a little blinky light on the front. i dont have the manual either so i dont even know what the arrow buttons mean on the front of the machine


... Zanussi 24 in. IZZI ALU Built-In Dishwasher

Probe and swich is not working properly.There is four cable, 2 black..its working.other 2 cables Red not connecting.When i short the cable system is working. My hobart dish washer is old I dont know the correct model no.But the part no. is 00-271621 pls replay me as soon as possible I bought a new probe and switch that also same condition.


... Hobart AM15-6 Dishwasher

Cycle buttons work, option buttons dont, Cant deselect heated dry, Wont start


I had the same symptoms and the front panel was the fixthe part with the buttons on it ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

How does the soap dispenser work. We dont know how to hook it up


Just hook one end of the tube up to the pump connection, sometimes just a barbed nipple...\015\012Then just stick the other end in the magic juice container and it will syphon it out. Just take out when ready to rinse. ... Pressure Washers

My aeg electrolux favorit sensorlogic dishwasher stopped working. It starts the program. Fills itself with water and then quits. Then it starts to beep constantly. I dont know what to do.. anybody that can help me?


... Electrolux Dishwashers

Have a dw8w kleenmaid brandt dish washer, lost all warning lights on front paneal. dish washer still works ok but dont know what sical its on


... Dishwashers

Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help


... Dishwashers

Dishwasher is just less than 1 year old. it doesn't respond to attempts to turn on. I turned off the power at the box and back on after 10 minutes. it worked. then the same problem returned. now it wont turn on at all. I checked all the connections I could and they seem fine. I know it is getting power. My guess is that something is wrong with the computer system. any ideas?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. This issue can be either due to a faulty door latch or\015\012door lock switch which is not engaging its ... Maytag 24 in. MDBH950AW Built-in Dishwasher

KENMORE MODEL 665.749622 BUILT IN TYPE 577-0 WATER, HEAT, SOAP RELEASE WORKS. DONT KNOW ABOUT UPPER ARM. DISHES SUDDENLY NOT COMING CLEAN(PARTIAL)


... Kenmore Dishwashers

The door handle is broken which enables the opening of the door. Therefor we can't open the door and need to replace the handle but dont know how . The handle is situated inside the door and there are no screws around it to to take it apart. It is an Indiset DG5000 model. There are screws at the edges of the door.


I had a similar problem with a similar model.\015\012Insert a fine screwdriver into the small space immediately abive the handle. Press the inside end down firmly and the lock should release.\015\012I ran mine for about 3 weeks, this wa ... Dishwashers

Hotpoint Auqarius dishwasher. I have resentley moved house and reconnected the machine. it works through programme fine but is sometimes leaving dishes gritty and not quite clean. I have cleaned filters, arms etc dont know what else to do?


It sounds like there could be a gritty deposit in the bottom of the system. At the start of the cycle the unit takes in a set amount of water and recycles it around to the drying phase.\015\012\015\012Try and run the diswasher a few time ... Dishwashers

Door mechanism door has 2 springs on each side, on the right the spring works on its own. But come to the left side and it has a long belt type piece of metal,the spring and a hook type piece that makes up how the door opens and closes.this left side has come apart and dont know how it goes together,therefore the door just drops very sharply to the dismay of my partner.plz reply to [email protected]


Wind metal strap around plastic bush and hook above hinge ... Candy 24 in. CD622 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1273 seconds