Having problems with your Dishwashers ?

Get E17 error which bosch tells me is due to too much water pressure. Have reduced pressure by closing off inlet tap as recommended but now can't seem to RESET the dishwasher. Held down START button for over 3 sec, but nothing happens.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Get E17 error which bosch tells me is due to too much water pressure. Have reduced pressure by closing off inlet tap as recommended but now can't seem to RESET the dishwasher. Held down START button for over 3 sec, but nothing happens.


... Dishwashers

I have a kitchen aid dishwasher. The upper spray arm is getting water and getting enough water pressure but wont seem to spin. Ive ran a lot of tests but nothing. ive cleaned out the spray arm and port that gets water to the spray arm. Cant seem to fix it. Any ideas?


Hi,When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher Spray Arms not Spinning ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

I have a Dewalt 3800 pressure washer fitted with a 67DX39G11 pump. Started unit up for the first this year, has pressure for 15 seconds then nothing. Water is flowing through okay, everything seems in order but no pressure. Unit is 2 years old but has only 15 hours of total running time. I think the pump has failed, is it normal for a pump to fail with only 15 hours on the clock?


... Dewalt 3800 PSI Pressure Washer

Honda gas powered pressure washer--runs great and I get pressure throughout the system but nothing comes out of the wand itself. There seems to be no clog throughout the system . I have cleaned all parts. When the unit isn't started I can get flow throughout the system


... Pressure Washers

Husky 2200 - water will run through when engine not running, once running nothing, like the water isn't on. Does seem to build pressure and release through pressure valve underneath.


What kind of oil goes in a power washer ... Pressure Washers

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

Indesit d41 dishwasher overfilling, pressure switch seems ok(checked with multimeter) ,when pressure switch is manually operated the electro fill valve remains open. only time fill vave shuts is when power is off or door is open. can someone please help as i cant find wiring diagram or service guide online


Possible faulty pressure switch or a faulty drain pump ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

I have a coleman 3500 powermate. It is running fine, but has very little pressure at the gun end. ??...We don't have the operaters manual for it. There is a handle that turs right at the outlet for the hose, that has + and - symbles on it. It turns, but seems to do nothing ?.Is that a pressure valve ?..Any diagrams might be helpful.


I would think it is calcium or iron buildup in the line. Get some small wire and stick it in the end to see if you can clean and or some CLR to help dissolve. Then give it another go. let us know ... Coleman Pressure Washers

It does not seem that my dishwasher arms are putting out enough water pressure. the top arm does not spin at all the water just spits out of them. my water pressure has not changed in the house and it does this with nothing loaded in it.


Sounds like the water pump is clogged,remove hose and **** out with shop vac,thanks-mike ... Kenmore Dishwashers

My disposal has quit working Whirlpool GC2000. I have unplugged - Unclogged - and pressed the reset button.....still nothing? I have also repeated this process and now the reset button seems to be missing (or just shoved to far in)....do you have any ideas what it is that i should do? Thank you so much in advance!


... Dishwashers

Dishwasher does not seem to have power. I have a Kitchen Aid, under counter unit, 9 years old, model KUDS01I. I used it 2 nights ago with no problem. When I push a button, nothing happens, no lights show, etc. It is plugged into the lower half of a duplex socket with disposal plugged into the top. Disposal works, so the problem seems to be with the dishwasher. That also eliminates any issues related to breakers or ground fault indicators, etc. Is there a reset button on the dishwasher? Is there


... KitchenAid Dishwashers

Siemens SE25M280 dishwasher (4 years old) currently started flashing C4 on the front panel. Nothing else seems to work eg. resetting it does nothing nor unplugging completely. still only C4 shows up.


... Dishwashers

Sporadic pressure The pressure on my washer cuts in and out continuously, two seconds of power followed by two seconds of nothing. I have tried to take the lance off to see if it is blocked, but it seems to be stuck fast. Any help would be welcome, thanks in advance.


OK. Pulsing on and off is quite common. Unfortunately, it can have several possible causes.\015\012\015\012If the  machine pulses while you are squeezing the trigger, and there is water coming out of the jet, then most probably the jet is ... Karcher K2.26 Electric Power Washer

I have a kenmore elite dishwasher, right now it seems to be stuck on the clean cycle the green light blinks on clean,, i pressed start and nothing happens i also press cancelle and nothing happens is there away to reset this or would something be broke


Hi,\015\012\015\012You can also pres "normal wash" and "heated dry" buttons back and forth till all lignts comes on, and it will reset the dishwasher and work normal again..\015\012\015\012But if you get this problem frequent ... Kenmore Dishwashers

My Kenmore model 665-16919001 control panel stopped lighting up, nothing will come on. I can't seem to find reset codes anywhwere. Can you help?


... Kenmore Dishwashers

I have a neff dishwasher that is maybe 5 years old. im pretty sure there is nothing wrong with it as it was working perfectly fine before i had a plumbing problem a few days ago. after the plumbing problem was fixed the dishwasher doesnt seem to want to fill any longer. it sounds like it wants to work but its just not filling and going thru the cycle. does it just need to be reset or something? im not sure of the model number as ive misplaced the directions for it. could you please help? by the


Look for the connection from the valve to the inlet of diswasher. Check the hot water valve to be on. It is probably closed when anyone working on the plumping. Good luck. ... Neff 24 in. S5443X2 Built-in Dishwasher

I have a Kitchen Aid Superba KUDS24SEBS1. The inlet water pressure is good and the dishwasher fills and starts the wash cycle, however, after the initial spray of water, it seems that all of the water drains out and there is nothing left to continue the cycle and wash the dishes. It's like it's not able to fill up enough to wash the dishes.


When "full" of water, the normal height of level is about 1/2 below the heater assy(large blackish grey coil below he spray arm).. if theres enough water in the unit nad its still not "spraying",its quite possible that your filter/chopper assy is cl ... Dishwashers

Simoniz 2600 pressure relief valve? seems to be stuck in open position. Can it be reset, or does it have to be replaced?


... Pressure Washers

Whirlpool Quiet Partner II. Does nothing at all when you try to start it. Seems latched tightly and I double-checked and reset the circuit breaker. Thoughts?


CHECK THAT THERE IS VOLTAGE AT THE CONNECTION TO THE D/W. CHECK WALL SWITCHES, GFI OUTLETS FOR TRIPPED, THAT THE WATER TO D/W US ON. IF IT TRIPPED CIRCUIT BREAKER. MAY BE SHORTED INTERNALLY. ... Dishwashers

I have a KitchenAid drawer dishwasher model kudd01dppa and it has a mind of its own starting and stopping in the middle of the night/day and chiming all different beeps and sounds like its computer is glitching out. We had a service person out and they changed the main computer board and it seemed to fix it for a few days then started again. They gave up. They also tried some sort of reset or reboot but nothing has fixed this intermitten but long term problem. Any ideas?


"it seemed to fix it for a few days then started again" (sic) OK, well if this is so, then in my experience you are getting some, sort of Power Bourne Spike, Surge, or Transient, problem. If there is nothing else it can possibly be. Use a Pow ... Dishwashers

I require a karcher hds745 pressure washer as i cant seem to get the chemical to work


Hi, this can be a problem with the hds745 machine, there are a few different versions on the market.\015\012you first need to put a piece of pipe direct to the pump and bypass the chem valve and filter.\015\012if still no look then you wi ... Karcher Pressure Washers

Kenmore Elite Drawer Dishwasher model 465.13329600 Normal Wash and High Temp Wash buttons stay lit, as does green Lock button. The Start/Resume button and the red button on the front of the drawer keep flashing. I've tried key combos suggested above, but nothing seems to work. Even tried shutting it off at the circuit breaker to reset it, and that didn't work either. This ****** was purchased in 2006 or 2007, and hasn't been used very much. WTF?


... Kenmore Dishwashers

Hi!, my Ariston L64 dishwasger refuses to start. It seems to reset OK when the dial is turned fully to the left. After the beeps I select a cycle and nothing happens for some time, then eventually the first two lights begin flashing together.That is as far as it goes. Can you help me fix this problem please? Donna


... Dishwashers

I turned on the pressure washer and it started up for just a short time. Then nothing. I checked the reset and it's fine. Now it won't even turn on. Help?


\015\012you need to check that you reseving power to the motor\015\012motor my be locked up\015\012unloader is stuck burnt motor\015\012bad reseat cord\015\01 ... Karcher PSI Electric Pressure Washer

My dishwasher just stopped working in the middle of the wash cycle. It seems to have no power to it. I have checked all the circuit breakers and reset them all and still nothing. Any ideas?


Your hard wiring maybe bad, or a wire nut came off call electritian or someone who knows electricity ... Whirlpool 24 in. GU980SCG Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0819 seconds