Having problems with your Dishwashers ?

Dishwasher was on...while on I noticed a small banging noise..then it seemed the door wasnt shut tightly so I pushed it in...the washer stopped ..it wont restart and I cant open the door


Answers :

Most door catches also incorporate a switch that stops the machine when you open the door. In "over closing" the door you may have "gone past" the switch which would likely make the controler think that the door was open. Try giving the door a firm but steady pull to release the mechanism.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher was on...while on I noticed a small banging noise..then it seemed the door wasnt shut tightly so I pushed it in...the washer stopped ..it wont restart and I cant open the door


Most door catches also incorporate a switch that stops the machine when you open the door. In "over closing" the door you may have "gone past" the switch which would likely make the controler think that the door was open. Try giving the door a firm b ... Dishwashers

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

Dishwasher has stopped during programme - door may have been opened during cycle??!! - although cycle had only just started. bottom of washer has water in but cant seem to restart on ANY programme - pls help!!! have turned off at power and back on etc - no joy :(


... AEG 24 in. Favorit 80860iW Built-in Dishwasher

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have an electronic operating Kitcheaid Dishwasher. It has a tendency to stop in the middle of a cycle without warning. This can happen at different times of the day and at different stages of washing. We open the door, make sure the racks are pushed in tight and close and hold the door tight for a few moments. The dishwaser comes back on, but this can repeat in the course of one wash.


I would try adjusting the strike which is a little metal piece coming off of the tub that goes into the door when you close it. the strike may not me latching properly ... Dishwashers

The door wont stay shut on frigidaire 4300. I have cleaned all around including gasket. Halfway through the wash cycle, cycle stops and we get CL code for open door. If we push on door, it goes for another few minutes.


Something is wrong with the door latch. Replace or make adjustment. ... Frigidaire Dishwashers

I have a fridgidaire dishwasher model # FDB 1450chc2 andon the control panel the red lights are flashing and washer wont start ?? when I open the door the lights go out but when I close the door and push start the washing lights start to blink but doesnt start to work ?? Need help thanks [email protected] Brian


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have an asko D3450 dishwasher. Washer makes buzzing/humming noise at start of cycle and then randomly through cycle. I checked the sump and pump appears to be clean and impeller spins freely. The cycle seems to work ok. Water is pumping out ok. If you open the door to stop the cycle, the buzzing will continue for a few minutes then stop. If the cycle is restart, the buzzing starts again. The vibrations seem to originate from under the lower spin arm.


If the sound is a bussing - it is the capacitor mounted to the pump. It is failing.Shown here (big white cylinder on right of pic).. ... Asko 24 in. D3450 Dishwasher

Fridgidaire FDB834RFS0 cycle will not start unless washer door is pushed in tightly, if I let go cycle stops.


The "Open" door sensor, isn't "Connecting" Unless it is close enough, IE: The door pushed in so that the sensor & activator are close enough to work., .The sensor has to be adjusted, or replaced if that's at all possible. ... Dishwashers

Mistaking put a bowl with a little regular dish soap in the machine, It was on light wash and stopped at 61mins. Opened he door and it was full of bubbles and had water in the bottom of washer. Took bubbles and water out and tried to restart. Did many things and still would go.


Check the drain filter. Hope the bowl has not got stuck elsewhere! ... Maytag MDB7100AWB Dishwasher

Maytag MDBH985AWS...control panel button to turn on the washer does not work...wash cycle and delay lights will light when pushed but washer will not come on. Have tried pushing normal wash and heated dry in sequence, flipped circuit breaker, open and close door, pushed buttons while door is closed


... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

Bosch dishwasher smu7056 stops in wash cycle. Opening door for a few minutes willallow me to restart the dishwasher but it will stop again. I repete this sequence for 3 or 4 times and then the dishwa


... Dishwashers

My top drawer of my Fisher and Paykel dish washer wont close tight. It seemed to be jammed and not closing unless it was pushed closed hard and then it jumped a bit now wont close tight and has no resistance at all. If I hold it closed and start it it will run but I think the lids not closing tight?


Make sure the unit is level. Remove drawer. On the inside of the cabnet there are the drawer runners on iether side. Behind these there are a pair catches. If one or both of these are latched back when they shouldn't be, ie. when the drawer is open, ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

My maytag dishwasher model PDB2600AWX wont start and wont latch properly unless you push hard on the door I cant tell if the latch over the tub is bad or the latch in the door is bad or both


The latch on the door is held by two screws loosen these adjust and then tighten, until you get it right, good luck. ... Dishwashers

The dishwasher has the normal and economy wash lights flashing and after we hold the start button down for 4 seconds the stop and then return to flashing? The washer motor runs when the door is closed and no water comes out and the system doens't stop trunning until the door is opened. The system ran for over 4 hours yesterday. Viking Professional


Hello, welcome to ... Viking 24 in. Professional Series VUD040 Stainless Steel (Premium) Built-in Dishwasher

Hi i recently started to have issue with my dishwasher. The issue is that the washer stops in the middle of the washing cycle. More specific, once i start, it stops about 20 second latter. Once i push the door of the washer it start to work again for another few seconds any ideas?


There is some mechanical problem.Check water flow. Free rotation of spray arms. Refer user guide. ... Dishwashers

Detergent dispenser door Whirlpool DU7400 won't open. I tested 300109 ACTUATOR resistance and it is closed. I ran washer and saw the actuator receives a current several times during the complete wash cycle. How else can I test? I notice the lever on the Acutator is quite floppy. Should it be stiff? Also the dispenser door does pop open if pushed from behind so that seems OK? Does anyone have the actual testing procedure for this problem? Thanks for anyone's help!


... Whirlpool 300109 ACTUATOR

I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi


... Maytag Dishwashers

Machine stops Dishwasher stops in the middle of the wash.  When the door is pushed it will restart.  Hence there is a loose connection in the door latch.  How do I fix this?


The door switch need some ajusting. ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher

Whirlpool ADG993, door fault: Hi, a few weeks ago soemthing broke on the door to my diswasher and it falls open wide with no stopping half way as usual. That was fine as the machine could still work, but now the door won't close. All seems fine until you get all but closed and then the door raises slightly from the bottom right corner, preventing it from closing. It looks like something may be jammed in there which pushes the door up at the last minute. There's a man coming out on Friday,


... Whirlpool Dishwashers

IDW450 dishwasher starts working then after about 7 minutes stops - beeps about 6 times and stops completely - the dishes are wet but the dish washer tablet door is not open . - can anyone help - then on the odd occasion it works perfectly without stopping but this is getting less frequent . Can anyone help please .


There is probably a leak under the tub., Water drips into a catch pan and sets off the beeping. Take the kick panel off the bottom front and see if there is any water in the pan. If there is you can drain it or blot it. BUT this is an indication of a ... Dishwashers

I have a Kenmore 665.16039401. The 3 right hand buttons on the keypad; Delay Hours, Cancel/Drain and Start/Resume do not respond and I cannot start the washer. Doing the self-diagnostic test by pressing "Heated Dry - Normal Wash - Heated Dry - Normal Wash" results in all of the LED's lighting and the washer starting a full 20 minute self-test cycle in which all functions seems to work properly. Opening and closing the door during this testing stops and then re-starts the washer appropriately


... Dishwashers

Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help


... Dishwashers

GSD2200G00WW. When starting washer, part of the time the machine will not start, other times if machine has been running for a while and you open the door and try to restart the machine it will not restart. You can hear the motor humming as if it wants to go but it will only restart if you turn the motor shaft even just a little. I am wondering if the electric motor is dying??


... GE GSD2200G Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1800 seconds