Having problems with your Dishwashers ?

Hi i have a zanussi electrolux zdf601k dishwasher and the anti flood keeps kicking in, it happened after the inlet water pipe froze but it now ok and works fine when i tip the water out of the overflow tray, the machine then runs fine but i am having to tip it everytime i go to use it to reset the anti flood


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi i have a zanussi electrolux zdf601k dishwasher and the anti flood keeps kicking in, it happened after the inlet water pipe froze but it now ok and works fine when i tip the water out of the overflow tray, the machine then runs fine but i am having to tip it everytime i go to use it to reset the anti flood


... Dishwashers

I have a slimline dishwasher from Ikea. The model is Whirlpool DWH C10 W manual. Everything worked fine up until the other day when I switched the machine on and it made a noise as if it was working but nothing happens. No water comes into the washer although inlet pip looks fine. I have poured water in and it is drained okay but the dishwasher is not cleaning dishes. After checking through numerous forum and reading about a flood prevention switch which can be sorted by tipping the d


Ok so slow down and lets look at the d/w problem and don't take the kitchen apart.. in the tank there is a float in the front corner. lift the float and listen for the click that would be the float sw . if no click th ... Dishwashers

Bosch shx dishwasher that leaks from the bottom. When I hit the cancel and drain it drains just fine. I have taken off the front of the door and see the water starting to overflow on the front tray when I run the cycle. Before it starts to overflow I hit the cancel drain and the water does drain


... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Hi I have a Neff built in dishwasher s5453X1GB/70 about 4 years old. Never had a problem before. Came downstairs last night to find the kitchen floor flooded. Water also still in machine. But must have been near end of cycle as plates all clean. I have read other links and opened pump compartment in centre of machine and syringed out all water and cleaned fan. When i switch on machine it is still making odd humming noise (emptying cycle?) I have read about anti -flood valve etc. Any more tip


... Dishwashers

I have a Hotpoint FDW80 Dishwasher. The drain pump runs continuously, even though there is no water inside, I poured water in with a kettle and it does drain correctly. After a short while fault code AL01 appears. I have removed the base tray to check the "anti-flood" swithch and that is OK, even with the switch disconnected, I still get AL01. Any ideas?


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a 2 drawer system - the bottom one is working fine. The top one does not turn off the water, so water keeps flowing into the unit and ultimately creates an overflow and flood condition.


You have to gain access to the fill valve see if it is opening or closing properly. You can test that by starting up the unit without the water. It should open on its own and close on its own. If it is unclear if it does it then you may want to ch ... Dishwashers

I'm having problems with the drain pump constantly running. I understand so far that it'll be the anti-flood device that is causing this. I've taken the dishwasher out and tipped it backwards to drain as much water out as possible but nothing comes out from anywhere ! It appears to be a sealed unit so how do I get to the appropriate part and fix it ? Cheers !


... Neff 24 in. S5453X1 Built-in Dishwasher

I have a AEG favorit 44070 vi i ahd a problem with it not heating up and i replaced the heating element and it was filling up ok, then i had a small leak. It operated the anti flood switch, i have tilted the machine and drained all the water out. When i switch the maching on it will not fill up and the drain valve is operating Any tips


... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

BOSCH SGS 5602 Dishwasher It got stuck on 45 mins and the pump was working overtime but there was no water in the machine. Looked it up on the internet and found similar problems caused by the machine getting the message that it was flooding. Emptied the overflow and everything was fine until it reached the same stage in the programme. I assume there is a leak somwhere but how do I find it


... Bosch 24 in. SGS56A72 Built-in Dishwasher

Ok, after a year, I've figured out the problem. I changed a bunch of parts, but never until now figured out that what it is doing is, water is running out the hole behind the door, where the overflow dripguard sits, if the front three panels are on. when those panels are on, water, just before position 6, pours down that plastic dripguard piece, into the big tray. eventually the tray overflows. when you take off the panels, then water just pours onto the floor. if you open the DW, the basin is t


It could be as simple as the float switch inside the wash tub. Usually they are located just inside the bottom front edge of the dishwasher. Some of these are loose and others are enclosed inside another cover. \015\012\015\012You may hav ... Asko Dishwashers

I HAVE A MIELE G646 SC DISH WASHER AND IT KEEPS LEAKING WATER INTO THE LOWER TRAY AND CUTTING OUT BECAUSE THE FLOOD SYSTEM KICKS IN.I HAVE THE MACHINE IN THE GARAGE WORKING UP ON TWO WORK MATE WITH THE UNDER TRAY OFF FOR THE FIRST FEW CYCLES THERE WAS NO LEAKING THEN WE FOUND IT LEAKING DOWN THE FILL PIPE.THE WATER IS LEAKING FROM AROUND THE AREA THE FILL PIPE FITS TO THE WATER SOFTNER BUT NOT ALL THE TIME.AN ENGINEER FROM MIELE SUGESTED IT COULD BE THE VENT INSIDE THE SIDE OF THE MACHINE BUT EV


Have you made sure the water sofener filler neck locknut is tight to the bottom of the dishwasher?i have had experience with one machine where spilled salt was not rinsed away after the softener was filled and this corroded a very small pin *** ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Dishwasher flooding Hi my Asko D1716 Super Cleaning System Dishwasher has started to have a flooding problem. When the cycle finished last night it seemed fine then in the morning the machine was full of water, I scooped out the water and by this evening the machine had flooded onto the kitchen floor. I tried other solutions I found on this website but they didn't suit my dishwasher as it doesn't have the appropriate buttons. Any suggestions would be appreciated!


When you say that you tried other solutions.. it's hard to know which you've tried and which you haven't so I will suggest some basics first.. ( if you've tried them, then disregard)...\015\012Have you checked or addressed the following:\ ... Asko D1716 Built-in Dishwasher

My bosch dishwasher runs fine, cleans fine, drains fine....but after it has been just sitting for a while, the bottom very slowly fills up with water. Each time we run the machine the water level drains back to the normal amount in the bottom of the washer after the cycle is complete. The problem is if we are away for a few days, the bottom fills up and overflows onto the floor.


Water inlet valve isn't closing all the way closed. Need a new one ... Bosch 24 in. SHU53 Built-in Dishwasher

Reset anti flood device


... Zanussi 23 in. ZDT6255 Built-In Dishwasher

Resetting Zanussi Anti Flood Device without removing built-in dishwasher


... Zanussi 23 in. ZDT6255 Built-In Dishwasher

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

Hi can you help me please I have a Zanussi DX6453 dishwasher which has stopped working. Having used the diagnostic facility it has come up with anti flood device, I have done the usual rocking the machine back and forth no sign of water. I have taken the machine apart and looked at the anti flood switch and this is bone dry and by lifting the float you can hear the switch clicking on and off. When I reassemble the fault is still there I'm begining to think the switch is faulty but not sure, do


... Zanussi 23 in. ZDT6255 Built-In Dishwasher

I've had a Miele G892 SCU PLUS dishwasher for a long time. Today a problem started that results in a flooded floor. Water keeps flowing into the dishwasher - even when the unit is turned off. It seeps in very slowly, but within15 minutes there is enough to overflow & flood the floor. My guess is that there must be some kind of sensor that isn't working, or the coresponding mechanical switch that shuts off the water is worn or slightly stuck open a bit? Anything I can do / check, short of the re


... Miele Touchtronic G892 Built-in Dishwasher

Bosch SMS4012GB dishwasher. Refused to fill. Found tray full of water in base of unit. Mopped up water about 2 litres. Machine works but lower reservoir on the side of the machine with float switch overfills and overflow leaks about an eggcup full each cycle. What is causing the overflow please?


An electric switch activated by air pressure. This device detects air pressure exerted on it through a flexible tube connecting it to part of a water tub. \015\012When activated, this switch then opens an e ... Dishwashers

I cant get me dishwasher to start i have tested the overflow switch and its fine i have also tested the water inlet valve and its is fine. but it will not fill the dishwasher with water i have even removed the hose to see if there was any blockage in the line come out from the what inlet valve. the button light up on dishwasher and the cycles work a long with the start button, i have left the door open to see if the door senor could possibly bee an issue and it tested good and function correctly


Hi.If there is no voltage to valve, then parts that can be responsible are only and all the following:Overfill switch or overfill device.Door switch.Electronic control Wiring.If the overfill switc ... Dishwashers

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

My Bosch SHX46A dishwasher keeps filling up with water and won't stop. The water just keeps coming up through the bottom. It will drain fine, but after the cancel drain sequence, water just keeps coming up, overflowing the tub onto the floor. I had to shut off the water.


... Bosch Dishwashers

How can I shut off the water supply to the dishwasher? It fills slowly with water from the top (while not running), and then water spills out over the kitchen floor. By pressing the 'Drain' button, the water will drain out, but I have to get to it before it floods. It takes about 4 hours for it to get to the overflow stage. It is a Jennair model, about 9 years old. We have a lot of limescale, it is probably time to replace it, but for the moment my main concern is to stop the leak. Thank you for


Most water supply lines are attached to the hot water supply under the kitchen sink. If not it may be accessible from the basement somewhere under where the dishwasher is located. Regarding the issue with the dishwasher, the inlet water v ... Sears 24 in. 14181 Built-in Dishwasher

I have an electrolux slimline dishwasher model number esl 4115.On every cycle it starts with pumping out any excess water but will go no further.I have tried putting water in and all it does is pump out the water and continues with a humming noise.once opened the humming noise continues and the programme light continues to flash.there is another simble which is -] but with an arrow rather then a line that flashes 3 times.It seems to be stuck on empty.In the handbook it states that the anti-flood


... Electrolux 18 in. ESL4114 Slim-Line Built-in Dishwasher

I have a honda 2600 pressure washer. After running fine for a couple of seconds the water will stop flowing out the tip. It is receiving water,but will not flow it to the pressure hose. I even disconnected the pressure hose and no wate was flowing out. When I shut the pressure washer off it would then flow water to the hose again. Please help


This is a symptom caused by a sticking Unloader valve. The Unloader valve is inside the pump outlet body under the large black knob. \015\012Example picture : ... Honda Black Max 2600 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1449 seconds