Having problems with your Dishwashers ?

I need new upper and lower racks for my Maytag jetclean EQ+ MDB7100AWW. How much and how can I get them, Need to determine if it is worth the cost, or buy new DW.


Answers :

Sorry to read about your problem, I hope this helps you out.

upper rack is #99002037 $108.40
lower rack is # 99002034 $187.36
Try getting your parts here, www.aplusapplianceparts.com and use this coupon code 1051 for a discount.

I tried to help you. Please help me and Rate/Vote on my response. We take the time to answer your question. take the time to rate us.Thanks and good luck

4 Thumbs - Very Helpful
3 Thumbs - Helpful
2 Thumbs - Somewhat Helpful

Hi,
\012


That is not that hard to fix and you can easily buy the parts yourself online...

Here is a tip that will help you with the online buying...

How to Buy
Appliance Parts Online

heatman101

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need new upper and lower racks for my Maytag jetclean EQ+ MDB7100AWW. How much and how can I get them, Need to determine if it is worth the cost, or buy new DW.


Sorry to read about your problem, I hope this helps you out.upper rack is #99002037 $108.40lower rack is # 99002034 $187.36Try getting your parts here, www. ... Dishwashers

I have a 4,000 psi, 4.5 gpm 45G cat pump powered by a 13 hp honda engine I can not seem to be able to adjust the unloader valve to give me pressure over 950 psi and even at lower pressures, the pump will not deliver consistant pressure without bouncing off to the relief stage and back into the tank Are unloader valves worth repairing, or should i look at just buying a new one my current thought is to buy an EZ start Pulsar


I would just purchase a new unloader valve, they usually aren't worth rebuilding. I would like to have a picture of the set up that you have, if you can send me a picture of the unloader region of the pump I can get you are price on a new one. email ... Honda Pressure Washer PSI 3000

We hav a aMaytag MJD 2000 AAW dishwashing machine displaying E3 which according to the manual means the water element does not work properly or th efilter mesh is blocked. The macine is not warming at all so we suspect the heater element is the problem. We where wondering how expensive this is to repair. Is it worth repairing or would buying a new appliance be a similar cost?


... Maytag Dishwashers

Upper and lower racks of Beaumark dishwasher purchased in mid-1990s (model and serial number available) need replacing. Coating on metal racks has worn away and resulting rust is getting on dishes. Replacement racks (new) cost more than the dishwasher itself (figure that!). Can anybody help out with a suggestion?


... Dishwashers

Motor removal Our dishwasher (Model LDS 5811WW) has LE come up when you turn it on. We were told by LG that it needs a new motor...so how do we get one? Also do you have any instructions as to properly getting it out? The clsest repair person suggested is 1 hr. from us and it would cost 3/4 of what the diswasher cost originally.


I am having a same problem. You can open dishwasher sump assembly from inside the dishwasher and check if something is blocking white impeller. I tried to open impeller and sheared screw head as I did't realized it is left handed screw. Even after cl ... LG 24 in. LDS 5811 Built-in Dishwasher

Hi my nearly 9yr old neff S5555 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Thanks Su


... Dishwashers

Hi my nearly 9yr old neff S5555XOGB/40 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Th


... Neff 24 in. S5543X2 Built-in Dishwasher

10 year old Kenmore Ultra is leaking early in the washing cycle. Wondering if this is worth fixing or need to bite the wallet and buying a new one. I am worried about affecting the new cabinets even though the dishes seemed to be clean on the two occasions that the dishwasher has leaked. Only need a somewhat simple machine- I'd appreciate any suggestions as to what brands I should research if buy is the conclusion. Thanks.


At 10 years old I wouldn't put much if any money into it. Do check the water connections as it may be something simple that just needs to be tightened or a washer replacement. Replacing the valve is a simple and inexpensive fix but don't bother going ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

The circuit board on our Miele G646 dishwasher has failed. do we 1) see if we can get another one second hand and in which case what other models have a compatible circuit board 2) try and get the board repaired and who do you recommend 3) bite the bullet and pay an exorbitant amount for a new board or 4) give up and just buy a new machine Thanks


What is the dwasher doing or not doing and how do you know it's the board. More information required please. ... Dishwashers

The top level is not getting clean. We think the passage to the top water jet is clogged. There are two holes in the back that the washing arm fits into, depending on what level the top rack is set at, and one of them is stuck open. We have not been happy with this dishwasher from the start and are trying to decide if we should get it fixed or just buy a new one.


Sometimes it is not worth the headache.dishwashers are a dime a dozen,if you want to happy,just replace it,most dishwashers are unrepairable.no matter what the maytag man says. ... Dishwashers

I am not happy with the racks in my new Bosch dishwasher! The bottom rack is not right! The silverware basket is in the back right corner and the silverware catches on the seal on door and it is hard to get to. The tongs are two close together and point the wrong way? The upper rack's tongs are also to close together also. I don't seem to be able to get larger dishes in with these tongs in the way. Having never used the mdl 9000359119 Rev B I had no idea. Buying a Bosch ment quality to me


... Bosch Dishwashers

Classique Dishwasher I have classique dishwasher its the biggest load of rubbish i have ever used - i have had 2 new ones due to buying new houses - they dont wash properly and the tablets either stay in the dispenser or smear everywhere - cant wait to get rid of it


... Jenn-Air 24 in. JDB8910 Built-in Dishwasher

Have a whirlpool gold dishwasher.The problem is that the clean lite on the control panel flashes not allowing the unit to work.I installed a new disposal and forgot to remove the plug for the dishwasher drain hose.When the flood happened I opened the door in order to stop the dishwasher.Now the unit will not work.The lite flashes 7 time ,then it pauses and flashes 7 times etc.Is there a reset procedure to run in order to get the unit to work or do I need to buy a new control panel?


HI,Can you please give the make and the model no. so that i can give you the manual.Waiting for your reply ... Dishwashers

I have a Danby Dishwasher model # 67638 18052. There is a slight crack in one of the parts underneath that is allowing water to leak out. The part is located in the back corner and it is a pale yellowish elbow shaped connector. Can I get some some kind of glue to seal it, or do I need to get it replaced? It that going to cost a lot? Is it going to be worth it?Thank you for your time.


... Danby DDW1805W Designer Series Free-Standing Dishwasher

What will a new pump for my dishwasher cost me? Or should I just buy a new one?


Hi,\015\012you can check out the prices of new pumps very easily by following this tip.\015\012\015\012http://www.fixya.com/support/r3907570 ... AEG 24 in. Favorit 80800 Free-standing Dishwasher

The thermostat seams to have given up in my bosh dishwasher and it is taking over2 hours to do a load I was wondering if I could buy a thermostat and get some Instructions and diagrams on who to instal the new one . Must be 8 to10 years old. No one in my are fixes or can buy Bosh parts I was hoping you could help. Kind Regards Anthony Lee


Hello Anthony. Yes. For Bosch parts and parts diagrams go to this link RepairClinic.com\015\012\015\012Enter your model number and you will have access to 500 Bosch parts and more. I use this site daily and it is excellent. The part will c ... Bosch Dishwashers

DU1100xtpt6 stopped working - blinking clean light. Reapir tech says needs new logic board and heating element. Says logic board is under warrenty... can I get board from whirpool with out tech? Where I can buy correct heater? thanks!


If you have "good hands" and a technical orientation, you can manage it by yourself\015\012(board and heating element).\015\012In any case, before buying a new heating element, check element's resistance with a multi-meter, maybe there is no problem ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Where can I get the instruction manual for a Bosch Classixx Dishwasher SGS53C12UK? I have bought a second hand dishwasher that has only been used for 6 months. The programme works fine but when I go to use it again - check water shows on the display. I have to tilt the machine back as water is stored at the base of the machine, surely this is not normal? It there a simple solution to this or alot of cost involved with a new part? Any help would be much appreciated. Thank you.


... Bosch Dishwashers

Pressure is probably low cause the upper shelf is not cleaning or getting wet. Possible causes? Is it less expensive to just buy new? It is not older then 6 years?


Check the harness to the motorCheck start capacitor on the left side of the wash motor ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My DD603 was leaking (both top and bottom) and I went to this web site and the person recommended changing the Lid Actuators which stopped the leaking for about one month. Now each time I run the dishwasher I get about 1-2 quarts of water on the floor. After reading the number of dissatisfied customers should I just buy a new dishwasher or keep chasing the all the problems associated with the DD-603?


In my honest opinion I would just buy a new one. I would say the same thing to change the lid actuators agian. Iam sure it would stop like before and then return later. It may be more cost effective time wise to just replace the unit. Sorry bbest of ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The dishwasher is making a horrible noise. Could it be the motor? Tried running both drawers and same noise each time. About how much would it cost to replace motors? Would I be better off getting a new dishwasher?


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I have chronic problems with this dishwasher leaving a milky film on my glasses and dishes where I have to handwash them to get them clean. Any suggestions to prevent this from happening...as I ready to buy a new and different brand of dishwasher.


Use regular green powdered soap and keep the rinse agent dispencer full. is it draining all the water out are all the the holes open in the spray arms is the water temp ok (too cold or too hot) ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My GE trash compactor just quit working. A little over 1 year old. I opened it and found inside the motor frame a magnetic contact that is burned up. Nothing else is wrong. This part shouldn't cost more than $10 . I can't find it anywhere. Do I have to buy a new motor for $180 to replace a perfect motor with a burned up $10 contact?


Parts sadly, aren't as inexpensive as they used to be. Hopefully, you can get away with the $25 part.\015\012\015\012http://www.repair ... GE Dishwashers

Smeg Allegra We start our Smeg Allegra with a 'dial' control. It has started to get stuck, and unless nudged forward, will stay on the same wash cycle permanently. never switching itself off. Is there an easy remedy to this, or do we have to bin it and buy a new one?


... Smeg 24 in. DWF1 2 Free-standing Dishwasher

My Kenmore dishwasher, about 5 years old, is not cleaning well any more. Glasses look cloudy,and I assume the bowls and plates are not clean also, but that's harder to detect unless I hold them up to light. I use a rinse agent. What's the problem? Is it worth having a service person look at it or should I just get a new one? It's a Kenmore Elite ultra wash dishwasher.


Although I used my credit card to pay for the live chat, it bounced me out before the service person could respond. So I tried another service and two people who do home repair told me what the problem was and what it would cost to fix it. Since the ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0962 seconds