Having problems with your Dishwashers ?

I have a new dishwasher and have lost the instructions and I have 2 lights flashing on the dishwasher and it is not washing what is the problem


Answers :

It would be helpful to know the make and model number of the dishwasher. It is a new dishwasher then it might be covered by manufacturer warranty. Have you tried calling the customer support line of the dishwasher manufacturer?
\015\012
\015\012Which 2 lights are flashing?
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a new dishwasher and have lost the instructions and I have 2 lights flashing on the dishwasher and it is not washing what is the problem


It would be helpful to know the make and model number of the dishwasher. It is a new dishwasher then it might be covered by manufacturer warranty. Have you tried calling the customer support line of the dishwasher manufacturer?\015\012\01 ... Dishwashers

I have a Hotpoint Dishwasher model no BFV620,hope anyone can help,the problem is 1(listed as pre wash) and 2(listed as wash) flashes rapidly when system starts to drain ,and the system does not drain completly ,still dirty water in bottom of the dishwasher,checked instruction manual and this lists any other forms of lights flashing but not the 2 mentioned,any advice would be greatly appreciated


... Hotpoint 23 in. BFV62 Built-in Dishwasher

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher

FDW60 dishwasher Hi My dishwasher is about 15 months old and the problem I have is that it seems to stay on pump and the Ecco45 light is flashing.  A repair company looked at the machine and said that the motor looked like it was leaking and water was getting in the bottom setting off the micro-switch.  He contacted Hotpoint who fitted a new motor today at a cost of £89.85.  Went to use dishwasher tonight and we still have the same problem.  The dishwasher started the washing programme for about


I've just (as of 10 minutes ago) had the same problem. I followed the advice given elsewhere in this forum and removed the bottom cover - water running out so needed a big towel to mop it up. I stood the machine upright and restarted it - no problem! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.


... Beko Dishwashers

Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. There are two bar codes down the side: 8542 347 15810 and 33 0451 014488. It's been in for about 3 years and have had no problems with it. Can't find instruction manual.


... Whirlpool Dishwashers

Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. It's been in for about 5 years and have had no problems with it. Can't find instruction manual.


... Dishwashers

We have a Kenmore Ultra Wash Dishwasher Model number 665-13859K601. The Normal wash and the Cancel (drain) buttons are flashing red on the control panel. No matter what we have tried, we have been unable to correct this problem. Obviously the dishwasher does not function. When you close the door the lights keep flashing and no button combinations seem to do anything. I have looked at the troubleshooting guide that came with the dishwasher, however there is no


... Dishwashers

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

My dishwasher won't start (Series 300 purchased 14 months ago). The following lights are on: light wash,hi temp wash,sanitize, locked and the start /resume light is flashing put goes out when pushed and the machine does not start when closed. there has been an on going problem with the regular wash light not coming on when pushed.


Hi\015\012\015\012It may be an issue with heater circuit, door switch or wash pump. If yes then please reset the power to the dishwasher. After, 5 minutes check if you are still getting t ... Maytag 24 in. MDB9750AW Dishwasher

Bendix bdw55 dishwasher problem Put on as usual as a 'normal wash' program 2, and they to find it not filling up and the start light flashing along with the end light flashing 3 times in between???? Anyone know why? And what the problems are? Plz help asap Thank u xxxx


... Dishwashers

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

My Bosch Dishwasher will not fill with water, it is a model SHE43F02UC/48. Follow ing the diagnostic instructions, caused the following: Cycle count-PO,Quick wash continuious light, Rinse Hold-flash. after pressing power scrub and regular wash agin; count down-off, regular wash off amd a quick wash-flash


Hi\015\012 \015\012 \015\012When the Dishwasher is not filling in, you'll need to check for the water inlet valve, the filter screen and the float switch/assembly. Also check for the float asse ... Dishwashers

Model: Whirlpool ADP 4501/5 (4 years old) Problem: Dishwasher won't start wash cycle. Green light flashes 11 times. After adding a bucket of water to the dishwasher it runs normally. Checked the inlet valve and it appears to be fine. Filled the salt container and it solved the problem for a while but having the same problem again. Any suggestions would be appreciated.


... Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

FDW60 Fault Hi, I have exactly the same problem. My dishwasher starts and washes ok but appears to get very hot during the drying phase and then the two lights fast and eco flash warning of a heater problem. I suspect either the heater, thermostat or control PCB. As the rest of the cycle seems of and the water gets hot then I'm assuming the heater and thermostat are OK. When the dishwasher attempts to dry is when the problem starts. Did anyone find out what there fault was? Thanks


Hold down the start key and you will re- set the D/W. Please Rate This !!! Thank YOU !!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Plumbed in new dishwasher wash light and pre wash light flashing nothing happening ! manual says longer inlet time possible cause -faucets not opened?


Hello lozjojo,\015\012Based on your problem description, you either have no water pressure at the inlet valve or the inlet valve isn't operating and allowing water in. Prior to installation, did you make sure you removed ALL the packing materia ... Dishwashers

I have a 4yr old Smeg freestanding dishwasher. Model is DF612SDX. The problem is that a wash cycle will start but about 15 mins in it stops and 2 of the programme option lights (on the left hand side of the programme options), start flashing. If you open the machine the soap dispenser has failed to open. This problem has been a bit of a slow deterioration as we've had a number of washed that have managed to finish and then noticed that although the dispenser has opened it must have been to


... Smeg 24 in. DWF612SS Free-standing Dishwasher

Frigidaire Dishwasher Hi, I have installed a new model GLD2250RDC0 Frigidaire dishwasher and it will not start. Power and water supply is connected. When I push the cycle button for Normal the light comes on but when I push Start nothing happens except the "hi-temp wash" and "no heat dry" lights flash. I assume this is some kind of troubleshooting code but the manual does not cover this and I am in Honduras so service is non existent. Any ideas? By the way, I was a builder in the States for 25 y


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

The green clean light is flashing on my Kenmore Elite Ultra Wash dishwasher. After the reset sequence, the washer will run only 1 part of it's washing/drying cycle, then flash the clean light again... I have only owned it about 14 months, and this is the first problem I have had.


You may just need to reset your control board. Go to the link and it will explain how to reset the control board as well as explain what might cause the issue and how to fix it.http://www.appliancerepairlesson.com/dishwasher-2/dishwasher ... Kenmore 24 in. 17032 Built-in Dishwasher

Matsui MF160 integrated dishwasher: Had problems for a while now with the buttons on the control panel ie: on button needed to be pressed down hard for it to connect and sometimes the wash cycle programme buttons would just keep flashing between the three of them and then they would settle down, for the past few days the on button light has stayed on and wont go off and now all the lights on the control panel have gone off and the dishwasher wont work at all, we have tried dis-connecting it, che


... Dishwashers

The eco light is flashing constantly on my Dishlex Global 300 dishwasher, it is making a noise like a pump is running continously, but the unit will not operate. Can you give me some possible faults and solutions. Regards Dave I have the same problem. The Eco light flashes and there is some sort of noise, not sure if it is a pump or a solenoid, but thats as far as it goes. A friend gave me the machine after aservice tech told him the main washer motor was gone. i have fitted a new motor, but


Its an overflow of water into the base of the machine.There is a float switch in the base of the machine in a small plastic dish.There is a metal cover with 2 small bolts that have to be removed to get to it.get the overflow c ... Dishwashers

I just installed a brand new Haier ESD210 Dishwasher. When i press the Power button, the lights above the Normal Wash and Light Wash buttons flash and it beeps. Any ideas on what to look for? Thanks.


... Haier ESD210 / ESD211 Built-in Dishwasher

Flashing LEDs All indiactor lights on the control panel are flashing and no response to the keypad. Unresponsive to keypad, random LED's flashing, unplugged dishwasher repeatedly, sometimes random flashing returned, now just "normal wash" flashing, tried suggestion of pushing "off" after reconnecting power, no change in problem yet.


Hi,- If the cause is a "dead not working" dishwasher, ensure that the wiring is properly located and attached to the PCB assembly. Check the door switches, check the main wire harness coming into the d/w. On some assemblies a jumper wire with d ... Maytag 24 in. MDB6100A Built-in Dishwasher

Hi In the middle of a wash cycle, my dishwasher tripped the circuit breaker on the wall. I diagnosed this by unpluggin dishwasher, plugging in a different appliance and switching circuit breaker back on. new appliance worked OK. When dishwasher had cooled, I tried it again on same circuit (which I knew was working properly). The lights came on for about three seconds, and then the circuit breaker cut back in again, so I knew it was the dishwasher that was causing the problem. Is there anyt


Ck the connections where the cord hooks to the wiring harness. look for hot or shorted wiring . also ck the contro panel for the same . generaly if you have a power draw like you are saying then you can see t ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2521 seconds