Having problems with your Dishwashers ?

How do I remove the drain screen from my Whirlpool, dish washer. model DU850SWPB0


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I remove the drain screen from my Whirlpool, dish washer. model DU850SWPB0


... Dishwashers

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

I have a whirlpool GU2700XTSQ1 dishwasher. I have the typical top rack not cleaning problem. I have removed the rear washer tube that leads to the top sprayer, no clogs. Upper arm is clear, lower arm is clear. I also removed the lower cover, checked the chopper screen and inlet, no clogs. There is a screen inside that I cannot get to. It appears to have some sort of paper or cloth sticking through the screen with a 50% block. Perhaps a sticker or label from a dish. I see this screen when looking


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

GU2400 whirlpool gold quiet partner iii. Won't clean dishes. Dishes don't get wet. Water seems to accumulate at the bottom but no spraying sound during cycle. Cancel causes the system to drain completely. Possibly plastic utensil under the filter screen at bottom. Can't figure out how to remove it or the filter screen. Might be preventing impeller blades from rotating.


... Whirlpool GU2400XTP Built-in Dishwasher

I have a kenmore dishwasher, model 587-1625. Noticing that are dishes didn't seem to be getting very clean. I removed the drain screen and cleaned, noticing a lot of hard water deposit. yet, it still drain. Now after cleaning it doesn't drain now what?


Check for a plugged air gap (on top of the sink) ... Kenmore Dishwashers

Drain Clogged I have a Kenmore Quiet Guard Plus dish washer. The water will not drain from the unti. I believe the drian in the dish washer is pluged. I removed the 8 screws from the pump/strainer unit at the bottom of the unit I removed the top that the screws were holding donw, but can't figre out how to get to the drain to unplug it. The center metal unit is exposed and nut head is exposed. What do I do next to get to the drain hose to unplug it?


You might try pouring liquid plummer in the drain part and jet it set it shouold eat through whatever is in there ... Dishwashers

I have a slimline dishwasher from Ikea. The model is Whirlpool DWH C10 W manual. Everything worked fine up until the other day when I switched the machine on and it made a noise as if it was working but nothing happens. No water comes into the washer although inlet pip looks fine. I have poured water in and it is drained okay but the dishwasher is not cleaning dishes. After checking through numerous forum and reading about a flood prevention switch which can be sorted by tipping the d


Ok so slow down and lets look at the d/w problem and don't take the kitchen apart.. in the tank there is a float in the front corner. lift the float and listen for the click that would be the float sw . if no click th ... Dishwashers

I have model DU810SWPU3 Whirlpool dishwasher that is 1 yr old. Plastic dishes appear to have a film on them when cycle is complete. The water also seems to drain slowly. I assume that what appears to be the filter needs to cleaned but I'm not sure how to remove it to clean it. Is the plastic area with all of the square holes on the bottom of the appliance the filter? That part is what seems to be clogged. Thanks!


The problem is hard water. There is a new product out called the dishwasher filtration system. It filters the water before it enters your dishwasher. It works amazing and has a money back guarantee. You will love the ... Tappan 18 in. MDR251RE Built-in Dishwasher

Sears kenmore dishwasher; model: 665.13763K600 (made by Whirlpool). Dishes have debris after washing in all cycles. Arms spin, water is running, dishwasher drains, and I removed the sump assembly to clean the chopper inlet. How do I diagnose it. I put it into diagnostics cycle and am unable to identify the issue.


... Kenmore 24 in. 16012 Built-in Dishwasher

I have a GE dish washer ( model GSD4930Z044WW) that does not drain after the rinse cycle. I have taken off ths hose up to the dispenser and removed the pump. All clear.


Check to make sure which style d/w you have as outlined above. The direct drive dishwashers have a drain solenoid attached to the motor and p ... GE Nautilus 24" Built-in Dishwasher

We have a Whirlpool dish washer; model#: DU810SWPQ0. It starts, water goes in and it heats up but doesn't wash anything. The spiral jet sprayer doesn't do anything. It sounds like the motor just clicks but doesn't do anything either. Water is not draining at the end of cycle either.


... Whirlpool Dishwashers

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

The disk washer doesn't drain at the end of the rinse cycle. There is a humming sound but no water is forced through the hose to the sink/garbabe disposal. At the end of the wash, there is a large amount of dirty water in the bottom of the washer. I removed the spray arms, the spray arm holder and the screen and then removed the water, and found a couple of pieces of plastic. But I don't see how I can remove additional parts from the washer bottom. What could the problem be? Is there a fi


Is the dishwasher drain hooked to the garbage disposer? If so is it new? If so did you knockout the plug in the disposer? If so then you either have something clogging the drain or pump. Or the pump motor is bad. ... Dishwashers

I have a hotpoint dishwasher model# HDA1000G00WH. until recently never noticed rinsed water not drained after washing/rinse cycle completed. water level just above the drain cover. i removed the cover to see if i might find something clogging the drain screen but found nothing. i removed the plastic water "return" line & it was not plugged. thinking about pulling the dishwasher out, disconnect the plastic line connected to the bottom of the dishwasher, then remove the "bowel-like" container wher


Take out the pump. You should find a broken rubber flapper indide blocking the outlet tube. Cheap to repair. ... Hotpoint 24 in. HDA3740G Stainless Steel Built-in Dishwasher

I have a Quiet Guard Standard model #587.151524 that is not cleaning the dishes. I took the bottom spray arm and screens out and cleaned them, (they had a heavy buildup of what I would say is calcium. The arm cleaned up fine but the screen still has some areas that will not allow the water to drain. I tried CLR and it helped but the screen is still probably 60% clogged. Do you think this is the problem getting the dishes clean and if so do you have any suggestions about how to clean the screen?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Kenmore 24 in. 15689 Built-in Dishwasher

After putting too much down the garbage disposal, the sink will not drain and the dish washer (Whirlpool Quiet Wash) will not drain. I have disconnected all sink drain pipes and snaked the main line to be sure lines are clean. The drain hose from the disposal to the washer seems clear. What should I try next?


You need a longer snake had one on friday that wa about 40 feet out it took two trys to get it good luck ... Dishwashers

I have whirlpool Dish washer model GU 120 ES (bought in 2001). When we start the dish washer cycle the unit starts for a minute, then the "start indicator" light flashes. As indicated in the instructions, we press the "start button" for five (5) seconds, at this time the washer clears the water out and stops. If you can assist this would be greatly appreciated. Thanks Jeff


I called the service tech.... ... Whirlpool Dishwashers

Model number 66515632000 Kenmore Ultra wash with quite guard about 8 years old Washer stopped near end of rinse cylce, dishes look clean, water in washer did not drain and looks clean. All attempts to restart washer, or hit drain etc result in attempt to start and then it stops. sounds like trying to start a car with a very weak battery.


Unfortunately it sounds like you have one of two possibilities. A) You have something like a piece of glass or food ect. that has worked its way down into your pump and is tying up the impeller or pump as its trying to start. -To op ... Dishwashers

I have a Whirlpool dishwasher model #DP840DWGX2 I need to remove the filter screen, but it's either stuck or has a screw holding it down. I don't want to break the filter screen by muscling it off if it is being held in place by a screw. My owners manual does not explain how to remove this screen. Thank you


From what I can see in the service prints, it just snaps into place. I see the screen as a round screen on the bottom of the unit. If it doesn't come out fairly easily, just use an old toothbrush to scrub the crud loose. It will go through the dra ... Dishwashers

Won't drain I'm helping my daughter long distance,their dishwasher won't drain. I had her remove the course strainer to check the well for debris. She said she cannot get in it because the sprayer is in the way. How is the sprayer removed to access the drain well in the Maytag DWU dish washer?


In most cases the blockage is at the end of the drainhose, where it connects th the "peatrap", simply removing the hose clamp, then hose and inspecting. If no blockage found there you will need assistance. If you want, you can funnel your hand over t ... Maytag DWU9962 Dishwasher

My dish washer has started to flash Err 7 on the screen and will not work. I ahve cleaned everyhting out, put drainO down the drain, turned it off for 1 week then back on again, checked that the hoses


F7--7 Flashes--Flow meter failure. Flow meter defect. Water inlet valve defect or water inlet hose blockedmake sure water is getting to your machine, its possible that the hose is kinked and not feeding water sufficiently to the machine. ... Dishwashers

I have model KUDS301VBL2, we have noticed a build up of sludge at the lower front of the dish washer, below the door. We have to keep an eye on it and wipe it off often. could this be caused by a faulty disposal unit in the dish washer. I have double checked the level from front to back and all the drain hose and air gap. I have found no problems.


... KitchenAid Dishwashers

Whirlpool dishwasher model DU945. The dish washer


... Whirlpool Dishwashers

There is water in the bottom of dish washer after finishing. If I start another cycle, everything drains, so it's not a problem with the hose. I hear water draining. I think it is the drain time. When the machine was under warranty, the service guy came and changed the drain time to longer. He told me how to do it, via the buttons, but have now forgotten where I put such great information. I have a 1996 built in model.


We have come up on this many many times. It is not drain time. There is a flapper in the drain hose located where the hose attaches to the pump with towels remove the hose and stick you finger in. It is and angled piece of rubber so it will be dif ... Whirlpool GU2400XTP Built-in Dishwasher

I have a Bosch Dishwasher, Model SHE46C06UC. No mater what cycle I start it in, it simply activates the drain and continues to run without ever starting. Within the last week prior to the dishwasher not working, I noticed a low hum/vibration emitting from the dishwasher. I've clean out the screen and drain filter, removed the pump cover to check for any debris. I've manually added water and it does drain. Additionally, the drain cycle continues to operate even with the door open.


First thing you may want to check is the door switch. You can pull it off and measure the resistance with an ohmmeter. If you get good reading while pushed in and none while switch button is released, then it is a good start. Next, you may want ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1884 seconds