Having problems with your Dishwashers ?

Dishlex dx302 heating element - how do I find it and replace it??


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishlex dx302 heating element - how do I find it and replace it??


... Dishwashers

I need to replace the heating element and electronic control board on my Kitchenaid KUDS01DL Dishwasher. I have the parts. I have been able to find directions on how to replace the heating element, but am not finding anything on the electronic control board. I don't even know where this part goes. I am guessing somewhere in the door, but can't find any instructions. Help...


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

Dishlex Global 300 Fills and then stops. faint electrical smell after a while . Checked heating element that I replaced 8 months ago, seems OK. It has 29X? ohms resistance and looks OK. (I am not sure of the reading on my meter but the element is not fused.) Pumps water in and out OK No blockage in pump or filters Water level looks to be low on filling, only part covers the heating element. I tried instruction book on changing water level using the "Eco" button no response as indicated in


You need to open the front cover and check the wiring for any burnt wire,this happen sometimes,if that does not solve then it't either pcb or electric motor causing this smell.You would be better off with a new one then. ... Dishwashers

I have a dishlex global 270 i cant find a model no i only have a serial and manufacturers no. What i wanted to find out is does this model have an element that heats the water. I only have one hose and when i used it with cold water it didnt heat up so i am using hot water.


Hi\015\012\015\012\015\012Thanks for using FixYa. I hope you understand that no one can tell you what are the specifications of the product until you provide the model no# however, dishlex usually have element in their dishwa ... Dishwashers

Dishlex Global 310 isn't heating the water. I assume that this is the heating element. The unit is 10 years old. What would it cost to repair and is it worth repairing or time to replace.


... Dishwashers

Dishlex DX302 Hi mate, I have the smae problem with the water not heating . I have checked for the burnt out relay (as is common)but no go. You mentioned you could send the service manual and wiring diagram for this model to the previous user you helped out. If you could please send it to me that would be grate as I want to test the heating element. [email protected] Thanks Jason


... Dishwashers

Hi silverdragon, re the dishlex 302 not heating or drying Have replaced heating element but unfortunately still cold. If the control panel has not shorted which it hadn't before, do you have any suggestions. My hubby would rather wait before buying a new dishwasher, but I don't want to throw good money after bad. Is there anyone you can suggest who would be able to check out the circuit board to see if i have missed anything.


Hi\015\012\015\012Check the two thermostats located at the inside bottom front\015\012panel of the dishwasher, if any one of them goes bad it won't heat. Hope this\015\012helps...please post back for further assistance.\015\012\015\ ... Dishwashers

Dishlex dishwasher dx 302 not heating water i would like a wiring diagram so i can find & test heating element or relay switching it .Tony T.


... Electrolux Dishwashers

Trying to replace heating element in Beko dishwasher but can't find where element is, can you help


If you have already got the new heater and it looks like this, this it is an inl ... Beko 24 in. D3731F Free-standing Dishwasher

Hi all I have a Dishlex DX302 dishwasher and the dam thing wont heat, checked the heating element (its 26 ohms) was wondering if i could get the wiring diagram emailed to me. Im thinking it might be the control board. [email protected] Thanks ****


... Dishwashers

I just replaced the heating element and it was working fine for about a week. Yesterday, the soak and scour light (which I've never even used) started blinking constantly. The dishwasher, Model GU2400XTPB3, won't let me even enter the reset code. I need to know if it's something we can fix without paying for another part/service by finding a manual. Thank you.


... Whirlpool Dishwashers

I need to find the 9 inch heating element replacement for my Jenn Air electric stovetop model #CVEX4370B


... Jenn-Air Cartridge Ar141b

I need to replace the heating element thermostat on a Kenmore Ultra dishwasher, but can't find it. Have looked all over the internet for a schematic without any luck.


Hi,Yes, that is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy Appliance Parts Online ... Kenmore Dishwashers

I have an Indesit IDL500 dishwasher. It had stopped heating the water up, it looked as if it had short circuited and so i replaced it, i have power going to the element. A couple of forums state that it may be the pcb behind the timer/selector switch. Does this pcb control the program selection and heating of the element? or is there a thermostat that controls the stop and start of the heating element? Any help would be greatly appreciated


Hi\015\012\015\012The unit\015\012has two thermostats and you can test both of them for continuity before\015\012replacing, no continuity replace the thermostat. Hope\015\012this helps...please post back fo ... Indesit 24 in. IDL500 Built-In Dishwasher

No Heat Had the blinking clean light problem, reset, and it fills and runs, but element not heating. Element reads 10.6 ohms, both door switches seem to be making. What else might be causing it not to heat? Is it possible to find a wiring diagram or schematic?


Should be a tech sheet stuck to inside of the bottom toe panel.Switches may check OK with no load applied. There is also an over temperature thermostat that may be open. If all checks OK, control may have failed. ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Bosch dishwasher shx46b02uc has stopped drying. Per online comments, they seem to point to either a corroded wire or a bad heating element. We've replaced the heating element and all the wires looks fine. All other functions work - just not the heat. Open to suggestions.


Hello,Welcome to FixYa.Based on your description ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Dishlex DX302 not heating


First..make sure you turn off the power . To get to the circuit board,you must remove the screws on the inside top of the door and pull out the front panel (where the buttons are). Press the little clips and the white box containing the circuit board ... Electrolux Dishwashers

I have a dx302. its not heating the water or drying.


Hi,Based on your question, location of the heating element:\015\012\015\012in most versions, the heating element surrounds a short section of the stainless steel tube on the outlet side of pump ... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

I replaced the heating element on my Fridigdaire dishwasher, but it still does not heat up. What else can cause this problem?


You have somewhere a thermostat. Most likely that is not working or it is bypassed. ... Dishwashers

Sediment falling off heating element. Is this normal, or do I need to replace the heating element?


Hi,That is normal mineral buildup... in fact many of the element are made to flex a bit to cause the mineral to fall off of them so they don't get too insulated and burn up...heatman101 ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

I have no heat my hot water coming in is as warm as it gets and on dry it will not heat up. Is there a fuse or circut breaker for the element or do I need to replace it. Also if I could ask how hard is it to replace. Thank You Very Much Dino


Just call me on +263912639492, thta's easy.thank you.\012\012Dr. Kelson ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

My dishwasher does not do a hot wash. Why is this? If I need to replace the heating element, how do i gain access to heating element on my Bosch classixx dishwasher?


Hi, a common problem with these machines is the solder coming away from the heater relay. A simple repair if your lucky. Run a continuity test on the element with a multimeter before replacing it, as it is a massive job to change it. I just changed m ... Bosch SHU9950 Dishwasher

Indesit DI450 goes thru full cycle but no heat. replaced heating element but same problem. Is there a thermostat or fuse or switch which needs adjusting or replacing?


... Hotpoint Dishwashers

How complicated is it to replace the heating element in the whirlpool gu1500xtls1 Dishwasher? It is not drying. Can the element be replaced from inside the unit or does it does the whole dw have to be removed?


Would be easier to remove the dw form the cabinet , at least partially. Hopefully there is enough slack in the electrical line as well as water feed line. sometomes you can walk the d/w out woithout disconnecting them. the heating element can be uns ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Have Kitchen Aid Dishwasher (KUDI01 ILBL2) with a heating element that does not work. How hard is it to replace the heating element myself??


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0955 seconds