Having problems with your Dishwashers ?

My cuisina dw008 is showing E3 and not working properly. can anybody help?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My cuisina dw008 is showing E3 and not working properly. can anybody help?


... Dishwashers

Our Bosch SHU43C06UC/17 dishwasher stopped working properly today. The power scrub cycle starts at 115 and counts down to 112 and then stalls -- no sounds of water entering the unit... no further counting down The regular cycle starts and shows 97 and counts down to 94 and stalls. no sounds of water... no further counting down. We hear a constant buzzing sound. Can you help?


... Bosch Dishwashers

I have a GE Potscrubber 1230 dishwasher and the closing latch seems to close properly but unless I jam a piece of folded cardboard under the latch when it is closed, the unit will not run through cycles properly. Is there a down-loadable diagram that would show how to disassemble this mechanism and show how this works? I wish to attempt to repair. Thanks


... GE Dishwashers

Maytag Dishwasher I would like to know the proper water level after DW fills. Older Whirlpool units a quick guide was when water just covered heater. I have a new D/W and the water supply is difficult to access, there is a kink in the water line slowing the water flow. The D/W fills to bottom of heater, but because the unit is so quiet I can't determine if it is timing out or working properly. I intend to repair water line when counter work is done. Thanks for any help Gary


Newer Maytags should fill close or up to the heater not over. Sounds like your alright for now but I would get that water line fixed. ... Maytag 24 in. MDB8951AWS Stainless Steel Built-in Dishwasher

Need help my oven is not working, the self cleaning works fine, the broiler also works, but the oven will not heat. what can i do? Our Kenmore gas range will not heat to the proper temp. The oven ready beeper goes off in about 3 minutes and displays 350 which the internal temperature is not. There also seems to be excess heat coming from the vents under the top of the stove, (under the timer, clock etc.). This could be something I just never noticed.


Hi, The ignitor is not working right and is going bad....have the repair man replace the ignitor, or DIY....Check out this tip about your problem...Oven not Working or ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a dishwasher model number FGHD2433KWI...I have no display showing but I do have power. It is not coming on and am wondering if the button to start is not working properly. Needing to know how t


... Frigidaire Dishwashers

Some times it works properly but still it doesn't clean 100%, And it has a noise in the middle of wash, Thank you for yor help!!!. It's a big help!!!


Hi\015\012 \015\012 \015\012If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it\015 ... Dishwashers

The dishwashers does not wash properly,the water does not come out of the top spinner.If i use a hose to help it it starts working but it will not work on its own.


Check that the upper spinner arm is not clogged with particles if it is take it off and clean it out ... Siemens 24 in. SE25T250 Free-Standing Dishwasher

I have ge nautilus...it has been working great but last time i turned it on it worked for app 3 mins then just got quiet. its not making any noise. wondering if anybody has suggestions as to what might be problem. i checked the breaker..it wasn't tripped. any ideas would be helpful. thanks


Sometimes the door switches go bad. If you are handy you can break it apart and clean the contacts. ... GE Nautilus 24" Built-in Dishwasher

Hello, I have a SMEG ST997 and the display shows no errrors, just P0, but I do not get it to work. The only digit working is the timer which is stock on 23. Can someone help? Thank Maurice


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Disconnect the Dishwasher\015\012from the power socket and mains and let it sit without power for more than ten ... Dishwashers

I have a bosch shv99a13uc. i rescued this from a thrift store so i am not sure of the history . i have installed it . all the controls work . it fills and trys to work it dosen't spray much and grinds like a very loud timer what tests should i do and can i get a manual that shows me ho to get the pump out. I think it sounds like something in the pump any help would be great Thanks


Hello &\015\012Welcome to FixYa\015\012\015\012Please check\015\012this video on how to clean the pump filter:\015\012\015\012 ... Bosch 24 in. SHV99A13UC Dishwasher

My Thermador dishwasher DWHD64EP/54 does not get the dishes clean. We checked all the usual things--water to the dishwasher is hot, filters clean, spray arms working and not clogged, detergent cups working, proper amts of detergent etc. We find that no steam is produced during the cycles, we find that the when choosing a cycle and power boost incorrect cycle times are now displayed compared to previous usage when the dishwasher ran normal. Some of the longer cycles now show only 24 min


... Thermador DWHD64EP Built-in Dishwasher

The detergent compartment on my Candy CD242 isn't working properly. The door to the detergent holder opens but the dishwasher tablet isn't released properly and/or doesn't dissolve. (I have tried different brands of dishwasher tablet just in case)....any help?


... Candy DFI Plan Built-In Dishwasher

Hello my dishwasher seems to only do half a job at a time (and the timings for the programmes have increased dramatically). It will do a programme, but not drain, leave a puddle and leave everything dripping wet (no drying) then if I press reset the machine will drain (so the pump is working) but after resetting the problem remains and the programmes continue to not work properly. Can I solve this myself, or is this a problem with the 'computer'? Please help.......!


... Siemens Dishwashers

My kitchenaid dishwasher model KUDS01IJWHO electronic panel shows flashing lights. I unplugged the machine to try to reset and it worked for two loads then stopped again. Help.


... KitchenAid 24 in. KUDI02FRSS Stainless Steel Built-in Dishwasher

I have a dishwasher Midea WQP12-9242 wich is not working properly it shows the E3 error code. What action should i take to fix this?


Midea dishwasher instructions:-------\015\012E1 :---Cause:---- Water supply switched off.---- Remedy: Switch off appliance. Turn on water supply. Reset the cycle.------\015\012 ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

My aeg electrolux favorit sensorlogic dishwasher stopped working. It starts the program. Fills itself with water and then quits. Then it starts to beep constantly. I dont know what to do.. anybody that can help me?


... Electrolux Dishwashers

My Prima LPR600 dishwasher will not work properly. I can here it but it seems to make a gringing noise and very little water is coming out of the side. I have descaled it on several occasions but nothing happens. I seem to have black soot in the filters. HELP


... Dishwashers

The dishwasher did not drain properly a couple of washes ago. Then the next washing cycle is did drain. Now the machine does not work on any cylce and there appears to be a leak from the bottom of the machine. Can you help?


Hi \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons. Usually, th ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

I have a Bosch SHU8805UC/14 dishwasher. I took the front door panel off to install it better but ended up with two extra pieces that look like either part 935400 Door Guard, or 935526 Support. I cannot seem to find any place on the inside of the door where these pieces would fit. The dishwasher works fine but seems like it got noisier after I put it back together without these two parts. Can you help me locate the proper place for these 2 plastic parts?


Hello, \015\012\015\012Welcome to FixYa.\015\012\015\012I believe the parts you are referring to are likely the blocks in each corner of the outer door panel. These have been a sticking point for many I tech over ... Bosch Dishwashers

Boiler relieve valve always releave water .I put gage and gage shows me that preassure is more then 30 at time of valve releave it.But rest of the time it is 18-19 psi.Something is not working in this system.Please help


Hello, the water feed valve. also called the pressure reducing valve is leaking by...this slowly adds water to your system. You need to repace that and then also the relief valve.\015\012\015\012This tip will help also...\015\012 ... Pressure Washers

I have a dishwasher that hasn't been draining properly. For a while I could hit cancel drain cycle again and it would clear 1/2-1 of water out. But now that doesn't always do it. Someone told me to take filter out and see if it needs to be cleaned. Otherwise we have no other sink/plumbing problems with other kitchen areas. Please help! one handyman told me no use to work on dishwashers they are just throwaway with parts/service being so expensive.


The advise you recieved is correct. You will need to pull the unit out of the cabinet and disconnect the drain hose from the rear. Then remove the cover, There is a filter inside. If its clean then its time for a replacement unit. You could have a ... Whirlpool Dishwashers

Where can I get the instruction manual for a Bosch Classixx Dishwasher SGS53C12UK? I have bought a second hand dishwasher that has only been used for 6 months. The programme works fine but when I go to use it again - check water shows on the display. I have to tilt the machine back as water is stored at the base of the machine, surely this is not normal? It there a simple solution to this or alot of cost involved with a new part? Any help would be much appreciated. Thank you.


... Bosch Dishwashers

I have an LG LDS5811 dishwasher. It stopped working. There is power to the appliance, but no lights show. I have tried the child safety unlock and programing reset. The LG rep on the phone couldn't help me.


You could have a bad door switch or power switch, but that is rare. If you are sure you have power at the dishwasher there should be a red LED lit up on the control board. (only visible if you take the door apart) Switches test good and mentioned a ... Dishwashers

I HAVE KENMORE DISHWASER MOD.#665.16034400 SERIAL#FR4603273 THE GREEN (CLEAN) LIGHT IS FLASHING AND UNIT WILL NOT RUN. CAN YOU HELP PLEASE? I have tried making sure door is shut and latched properly. I have tried cleaning contacts on heater coil. We bought unit new in Dec. 20004 but was not used untill this mo. It worked fine for about 3 wks. THANK YOU


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1183 seconds