Having problems with your Dishwashers ?

I own a BOSCH SGS 6942 (LOGIXX Automatic) Dishwasher which I purchased in Singapore. The water does not drain out after the wash. I checked the outlet , but there are noblockages. I am unable to locate any service center in Chennai, India to address the problem Pl help!


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I own a BOSCH SGS 6942 (LOGIXX Automatic) Dishwasher which I purchased in Singapore. The water does not drain out after the wash. I checked the outlet , but there are noblockages. I am unable to locate any service center in Chennai, India to address the problem Pl help!


... Dishwashers

I have a bosch dishwasher classixx its less than a year old, the 'check water' light comes on and it doesn't complete the cycle. Water is left in the bottom unable to drain away. I have checked pipes as best i could, but couldn't locate filters or remove hose from m/c. unfortunately i have no instruction manual.. help please..


If its less than a year old why dont you contact the manufacturers service team it will still be under guarantee as the bosch guarantee is 24 months you can dowload a copy of the instruction maual free of charge from the bosch or bsh home appli ... Bosch 24 in. SRS43C12 Classixx Slim-Line Free-standing Dishwasher

Sgv43a03GB hi i need a service manual with electrical schematic thanks - my machine is dead, main switch ok, but i do not know wehere to check for voltage, continuity etc to locate fault


... Bosch 24 in. SGV43A03 Built-In Dishwasher

Hi I have a bosch diswahser smu 7000. No power when I push button. Manual says its could either be fuse or circuit breaker. Checked breaker its ok. My manual does not say anything about location fuse. Called bosch. And they said they cant tell me. I nee to have a service call. Any help. Thanks.


... Dishwashers

Overfilling fault I have an Asko D3530 reporting an overfilling fault. I checked the outlet hose and found a blockage. I cleared the blockage and the unit pumped the water clear. The unit however continues to opperate the pump with the message "Overfilling" diplayed. The manual indicates "call for service" Does anyone have any idear how to clear the fault? Thanks Steve


I believe the washer has had a flood type situation.there is normally a flood switch in the very bottom of the dishwasher right at the very floor,if water get into the bottom tray it floats a piece polystyrene foam wich triggers a little micro switch ... Asko 24 in. D3530FI Built-in Dishwasher

My dishwasher quit running. There is water in bottom. I am unable to turn it back on. I have checked latch, electric coming into dishwasher and the breaker to the outlet.


Sounds like the thermal coupler has blown. It si located near the main control board. That can be easily replaced and easy to test. ... Whirlpool 24 in. DU915PWP Built-in Dishwasher

We have a service contract with Broward Factory Service. My GE dishwaher went out with eater in it, no power. Checked the panel box flipped switch, nothing. The service tech. said the rinse aid cup leaked and ate thru the wiring, and he had read a recall about this. I am checking to see if Model #GSD3610Z00AA, Serial #ZS782757B is on the recall list.


I was trying to find out if the dishwasher was on a recall list, and I did by calling GE direct. It was not, so the service I have is replacing the rinse aid box.\015\012Thank you, ... GE Dishwashers

Water will not drain from bottom of GE Profile PDW7300 dishwasher. I checked the service mode feature by depressing the cookware and the heated dry keypad simultaneously for 3 seconds and did not hear any activity from the dishwasher when I activated the drain pump and when I activated the main pump. Other service mode features did activate when I checked them (i.e. activate water valve, open active vent, etc.).


... GE 24 in. Profile PDW7800 Built-in Dishwasher

Whirlpool GU1500XTKT0 dishwasher has a Rinse only led blinking. No functions are responding on the control panel. Keyswitch resistance check table on Whirlpool Service Technician's Tech Sheet checks good with digital multimeter. Door switches and thermal fuse near control module check good.


If your keypad tests, door switches, and thermal fuse are all good, the only test left is to make sure you are getting 120 volts at your control board. Test for 120 volts at terminals p8 and p7, and at p2-6 and p7. You will have to activate the doo ... Dishwashers

I purchased a diswasher (Hotpoint)about 1-1.5 years ago. It's model # is HDA3400G02CC and its SS# is TH887451Y. I don't think I registered it. No Matter, Two days ago, my garbage disposal stopped working. I checked the outlet. It had power. The switch to the Disposal was next to the outlet. I assumed that the switch was wired from the outlet. It wasn't. Bottom line, the switch nut was loose. I tightened it and problem solved. When I turned on the dishwasher, nothing happened. It acts like


I purchased your service (telephone support) and the dishwasher expert contacted me. We discussed the issue, he made recommendations. I followed his advise and solved the problem. Before I could recontact him, he called to follow up on my progress. ... GE Dishwashers

Whirlpool ADG7540 approx 4 years old (maybe a bit older) I have ran diagnositic check and the start light flashes 4 times stops briefly then flashes 4 times again over and over along with a continuous bleeping. When I put the dishwasher on any program I can hear the pump running but after a few mins the same flashing and beeping occurs although it sounds as if the pump is still running. I have taken off the pump checked for blockages and also checked the outlet hoses and spiggot, there are non.


Yikes, we have just identified this exact same problem tonight. If you've had any success with fixing it, we would sure appreciate hearing how. Best of luck with your machine ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Bosch Exxcel Dishwasher (Enr SMS53E12GB/01 FD 9002) bought in July 2010. Error code 15 and "Check Water Supply" light on at same time. Have checked in-line filter in tap connection and all clear, water pressure OK, no kinks/twists in supply hose. Any help would be greatly appreciated - I'll have to call Customer Service in the end as it's outside of my problem-solving ability, but would like to check whether there's a known reset or fix I can try before I call.


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

I have a Bosch SGS66E02GB/45 that no longer completes a wash cycle. On "Auto 50C" time counts down from 2:58 to about 1:40 then goes back to the beginnnig and repeats. Spray arms are moving, it fills and drains, detergent is dispensed. I have checked the inlet and outlet pipes, the impellor and non-return-valve in the sump, checked the matrix is clear, checked to anti-flood float and switch and replaced the relays on the PCB. Selecting a rinse cycle will complete. Dishes are warm and wet rather


... Bosch Dishwashers

I have a Frigidaire FDB1100...I have no power to the dishwasher. I've checked the breakers and none of them have been tripped. Not sure where the plug actually goes to but I have checked the power cord and it's tight which means that it's still plugged in...of course Frigidaire has no customer service on the weekend.


Same problem . i will check for line voltage in box under unit and then continuity to panel. have no schematic for LV troubleshoot ... Frigidaire Dishwashers

My gas power washer will not start. I filled the gas, checked the oil, set the choke, made sure it was on, changed the spark plug, checked the air filter, and drained any water. When I pull the cord to start I don't even get a putter. Anything else I can try or do I need to take it to a service place.


Will it run if you pour a small amount of gas in the carb? If so, it's a fuel supply problem. Most likely a stuck closed float needle. ... Honda Maxus Pressure Washer MX5222

NEFF S4443 top spray bar not rotating, no water. Bottom spray bar rotates and sprays water. Checked and replaced fine/course mesh filters. Will pump to empty and refill on pre-wash (rinse). Seems the pump may have two outlets one feeding the bottom spay bar (nearest from of machine) and one just behind which feeds the upper spray bar. Running without spar bars attached (including mechanism feeding to bar, water is only being forced out of the from outlet. Any ideas before I start taking it apart


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Vulcan Dishlex Executive 14-10 Dishwasher leaking onto floor from right hand side when it was filling at start of cycle. Husband has checked the following: both pumps (main and waste) hoses, solenoid switch (inlet). Where can we find the float/level valve? Could this be the problem? What else to check? This is the second time it's happened - I don't use it that much. The previous time my husband replaced the inlet and outlet hoses. What is the proper level for water fill - never above the


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Dishwashers

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Bosch dishwasher causes short circuit trip when door closes. Plug and socket checked and ok, water outlet checked and no blockages. Panel lights come on ok when machine switched on, able to select washcycle etc ....trip happens immediately door closed.


... Bosch SHU5315UC Dishwasher

Our Bosch Classic Electronic dishwasher ( approx 2 yrs old) will not fill with the "Check water supply" light on. We did have the water turned off for a few hours prior to using the dishwasher. Have cleaned the filter - unable to check the pump.


... Dishwashers

My 3-yr old GE Profile dishwasher lost power soon after initiating wash cycle. Checked braker switch...fine. Checked outlet power...fine. Dishwasher power mysteriously came back on approximately 12 hours later. Initiated another wash cycle and lost power again after a few minutes. Water remains in bottom of tub. What's wrong????


First thing i would check is the actual wiring behind the toes kick\015\012you will seea wire box, shut the breaker off, open up the box and double check all your connections there,\015\012 the next step would be to check the voltage ac ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Inlet/outlet light keeps flashing on G641 dishwasher - have checked filter and cleared debris. Just completed a wash but dishes not washed or rinsed adequately. Anything else I can check before requesting a service?


Hi,this is a general fault light which could mean anything without a Miele Technician coming out and connecting a laptop ... Miele 24 in. Novotronic G641 Plus Built-In Dishwasher

The light of outlet,inlet keeps going on when I start the cycle.I have accidently put in normal washing up liquid and not the special dishwasher liquid . I checked the hose at back and filtrer.I think there is some scale build up .I need instructions how to check the ball bearing and pumpetc.I have no manual.


Go online to Hotpoint - I think I saw they had manuals on line when I was looking to solve my problem yesterday. Good luck. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Figidare dishwasher Upper arm not rotating, no water coming from top hole to fill upper arm.Lower arm rotates shoot water up cleaned filter screens. Check ball seems ok by pump, is there a location it (ck ball) should be? My upper arm is not rotating, things are coming out crusty, and it's definitely not getting water to the upper arm. My check ball seems to be plugging the tube the water goes up in.


It seems other posts were correct - The upper arm doesn't spin all the time. Once I learned that, and let the dishwasher cycle through, I saw that the upper arm does spin. So, there wasn't a problem with the upper arm afterall. That doesn't solve ... Dishwashers

No power showing on display board, checked electrical hookups it ok. Outlet has power. checked child tamper and delay no response


Its the fuse, its located under the dishwasher. take off the bottom white plate, its on the right side of the pump on a wire harness. Its in a fuse cartridge turn to the left take out fuse and replace with 15 amp fuse take it radio shack and have it ... Samsung DMR57LFS Stainless Steel Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0872 seconds