Having problems with your Dishwashers ?
Hi, I have a Bosch 53A12GB/01 which has developed a fault. It starts ok but doesn't seem to progress on the programme to the drying and final cycles althought it does do a couple of fills and empties, I think it would carry on all day if left on. Any ideas ?
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Hi, I have a Bosch 53A12GB/01 which has developed a fault. It starts ok but doesn't seem to progress on the programme to the drying and final cycles althought it does do a couple of fills and empties, I think it would carry on all day if left on. Any ideas ? regards. Mike.
I have a Kenmore dishwasher, model 665.16039. Over the past month (we were on vacation 8 days over Xmas, but I assume it would have happened then, too) it has required rebooting using the Normal Wash - Heated Dry reset about 4-6 times. It would then do a couple loads okay, then need resetting. Now, however, it's refusing to reset to a point at which the Start buton will work. When I reset it, it flashes all the lights (incl. Start), and it fills, sprays, empties, etc. just as though it works
Make sure there is no water damage. ... Kenmore 24 in. 16039 Built-in Dishwasher
It does not matter which cycle is chosen, once "start" is pushed on our Asko D3120W the drain pump comes on empties the machine, then it fills for the first time, and turns off. It happens on all cycles. We have turned off the power thinking that would re-set the machine, but it has not worked. Do we need service or is there something we can do at home?
Hello &\015\012Welcome to FixYa\015\012\015\012The problem\015\012seems to be with the frozen main pump or the pump seal/impeller gone bad. To\015\012solve this the pump and motor has to be removed and then the part rep ... Asko 24 in. D3120 Dishwasher
I have a Beko DE 2541F Slimline Dishwasher and it fills and empties the water but the cycle does not start. The water does not get to the spray arms. I have tried on pre wash cycle as well so I do not think it is the heater element. Any Ideas
If there are no problems of drain valve stuck, then the problem with the micro controller board.When the water is full in the tank, the wash cycle will start with the spray arm in action. Lastly block the drain hose and see. Here water fu ... Beko 24 in. D3731F Free-standing Dishwasher
Gaggenau GM 915-710 UC6 dishwasher will not fill and wash. Close the door, turn lever. Empties water from sump. (drain hose was not clamped above disposal outlet nipple, fixed that) Machine empties sump, but will not stop after sump is dry. Will not initiate fill and wash. Manually stop machine. Can't get control board to do the diagnostic to get an F #. Pressing button 1 and 3 at the same time. A couple of the plastic tabs on the circuit boards plastic support housing that link the
... Gaggenau GI936-760 Dishwasher
FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with
... Hotpoint 24 in. FDW60 Free-standing Dishwasher
Empties and fills but boils the water
Hi had the same problem, change the wash pump capacitor, you can get one from maplins ... Hotpoint 24 in. FDW60 Free-standing Dishwasher
Dish washer does not drain after the cycle is complete. The last few months when the dishwasher is done their would be a small amount of water left in the bottom. It didnt create any problems but would smell after a few days. So we would just run the drain cycle and it would empty. Well i got home to and the wife said the it was really full. The water was dirty and when you run the drain cycle it didnt drain. She said the dishes were clean. So i cleaned the vent, and filled the sink with
Check drain hose and drain pump.End of drain hose must be in same level with machine.Try it. ... KitchenAid KUDR01TJ Dishwasher
Kenmore Dishwasher model 665.1675592 doesn't seem to wash as well as it used to. Seems to have a low water level. Filler valve works, allows water in, but never seems to fill enough. No spray reaches top shelf, I think due to insufficient water level. It's like the timer doesn't stay on long enough for it to fill. Also cycle time seems WAY up, but if the timer is slow, how does it time out filling so fast? Looks like it would be slow all the time. Suggestions?
... Kenmore Dishwashers
Dear Sir/Madam,I have owned a Beko DW450 slimline dishwasher for 13 months and used it only twice, i wanted to use it last night but when i switched it on the drain pump activated and would not switch off. I powered down the dishwasher to see if that would reset it but unfortunately when i started it again it did the same thing - drain pump activated but would not stop running, it is impossible at the moment to carry out a wash programme. Does anyone have any idea on this problem. Thanks, Patric
... Bosch SHU5315UC Dishwasher
Constant draining my candy cs445 17" is stuck on drain, it just sucks water out and wont stop. Turning the dial to stop does nothing, if i fill it with a sacepan of water it juts empties, and when all the waters gone its just keeps emptying, would a float switch be the problem or possibly a new dial ?
I would check the float.clean it up real good.make sure it moves freely.let me know ... Candy 17 in. CS455 Built-in Dishwasher
My Fisher Paykel dishwasher is model #DD6051. After about 1 1/2 years, the top drawer is not filling with water. The fault code looks to be U1. The bottom drawer fills and runs fine. Would you have any idea what the issue might be? Thank you very much.
Hi,Unplug the Washer for Few Minutes, say 30 minutes and then Turn it ON. If the problem Persists, then read :-U1 Heavy and Rinse LEDMachine has failed to prime with water within approx. 3 minutesReason ... Fisher and Paykel Dishwashers
Bosh dishwasher dishwasher will not empty last couple of times the control was noisy now it will not empty do you think itsthe pump?
DISHWASHER ONLY RUNS 2 HOUR CYCLE? ... Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher
Electrolux dishwasher buttons show lighted up but will not turn on I would like to know if the rinse is empty would it cause the dishwasher not to turn on? I cannot think of anything else that is wrong.
Hi there.Has child lock been activated preventing buttons from working.Either turn child lock off or try unplugging for 30secs. ... Electrolux 504199 Dishwasher
I have the Kitchen aid KUDS01DL dishwasher. It was working fine until last week. When starting a cycle, the washer fills with water. Once filled, the motor makes a humming noise and does not circulate the water. I end up stopping the cycle and the discharge pump empties the water. I took apart and cleaned the basin this morning. I did find some random garbage but it did not seem blocked. Do you have any ideas?
... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher
My Bosch SMU 4000 suddenly stopped filling with water. I had a major drain backup on Thanksgiving and the dishwasher filled with debris. The I flushed the supply line and it was clear so I think perhaps the water valve is clogged or broken but I have no idea what it looks like or how to remove it.
... Bosch Dishwashers
Bosch Dishwasher hi, was thinking of buying a second hand bosch aquasensor dishwasher.. I think the model is Bosch SGS46M78AU.. anyhow thw current owner says it needs 'minor electrical repair to circuit board' and when queried further said that sometimes it washed in normal time and at other times it took up to two hours. Any idea what the prob could be, and would it be costly to fix?? Thanks!
The circut board is very costly stay away from that one ... Dishwashers
A GE triton dishwasher causes hammer noise when stops filling. The sink faucet works fine as do all the other faucets in the house. I cleaned all of the traps in the dishwasher. Because the sink works, I don't think it is a sink valve problem. I turned off the water to the house and drained the system, the air chambers should be good. Is there some component of the dishwasher that could be causing the noise? Would cleaning the pump help? If so, how would I do that?
The cause of the hammering noise, (slamming) is due to the water inlet valve on the Dishwasher (DW) shutting off abrutly once the DW reaches the proper amount of water.\015\012\015\012If this is an older DW, you might want to replace the ... GE Dishwashers
Our Maytag MJD3005 dishwasher got a couple of minutes into a cycle then displayed E4, stopped and beeped. I cleaned the filter basket out (which needed doing), powered down and up and restarted. Then a couple of minutes into the cycle E2 appeared as (I think) it doesn't enter the wash phase (fills OK). Repeated on different programs with the same outcome. Any clues?
... Maytag Dishwasher
My machine appears to start by emptying then filling and then emptying again at which point warning lights 1 & 3 start flashing. Any ideas what 's causing this?
Www.indesit.co.uk/_pdf/booklets/02/45/19504701701_UK.pdf\015\012\015\012\015\012\015\012http://home.ho ... Indesit 24 in. IDL700 Built-In Dishwasher
Hi, Dishwasher problem: When a programme starts, the machine fills with water then stops and the "check water" light comes on. To empty the machine, I used the reset programme which does empty the machine. Any ideas of about what might be causing and the solution to this? Many thanks, Richard
You will need to check the inlet valve and the water level pressure switch. It can also be a low pressure in the pump that is giving out the signal for the control board to shut off.\012So first of all check the water line throughly to confirm. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher
So, it was working fine for 4 years. Then last week it started getting louder after the initial fill cycle. Now, all it does is fill the bottom with water, clicks (where the motor used to kick in), then just hums. Nothing happens, but when I hit the cancel button, it empties the water from the bottom. Any ideas?
Your spray pump motor has become blocked or ceased - do you have the tools and skill to dis-assemble the machine? ... Whirlpool GU2455XTS Built-in Dishwasher
Cloudy Dishes This condition suddenly started after couple of years. Water heater is 7 yrs old, never drained, therefore I think this could be the problem. I am going to drain it and report. I do have a whole-house water filter which I change out monthly or every other month. My guess is that without it, this problem would have surfaced long ago.
The problem is hard water. Go to www.dishwasherfilter.com and get their new product. It filters the water and takes out the hard minerals that cause spots and clog di ... Amana 24 in. ADB2200AW Built-In Dishwasher
I borrowed my friends pressure washer and it was working when i had it but she says its not now, could u tell me what u think it could be please. Could it be a motor problem and if so can u explain how a motor would go without me touching it as i dont like the idea im being acussed of breaking it when it was working when i gave it back
The water has emptied out of the machine in transport you may have to bleed the air out of the pump ... DeVilbiss Pressure Washer Hose 25' 38" Id Rubber Has
My indesit dishwasher is filling up with water but not emptying. Seems to be sticking after a couple of clicks on the programme.
Most probable cause is that your float valve is jammed.\015\012\015\012The valve is a safety feature to stop the machine from over filling. If\015\012anything gets under the valve it will jam open and stop the machine.Look\015\012in ... Indesit 24 in. D63 Free-standing Dishwasher