Having problems with your Dishwashers ?

I have no manual in English for the Bosch Dishwasher 5600 050 352 (8207)


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have no manual in English for the Bosch Dishwasher 5600 050 352 (8207)


... Dishwashers

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

I have a Hotpoint Dishwasher model no BFV620,hope anyone can help,the problem is 1(listed as pre wash) and 2(listed as wash) flashes rapidly when system starts to drain ,and the system does not drain completly ,still dirty water in bottom of the dishwasher,checked instruction manual and this lists any other forms of lights flashing but not the 2 mentioned,any advice would be greatly appreciated


... Hotpoint 23 in. BFV62 Built-in Dishwasher

Bent leg We had tile installed and so we have to be able to adjust the legs by approx 1/2 in. to pull the dishwasher out. The timer went out and so we were going to replace the dishwasher, but the new one won't fit in our cabinet. So, while trying to put the Bosch back in, I guess the back leg hung up on something and bent ... can't screw it in, can't screw it out, dishwasher is out of level as it is. Questions as follows: 1) how important is it to have it level? 2) any suggestions on wh


It's hard to say what to do about the leg without seeing it. You should at least try to get something under it to get it level as possible. If not perfect, it is better to have it tilted slightly back than foreward. ... Bosch 24 in. SMU40 Built-in Dishwasher

My Bosch dishwasher has several problems: 1) Water doesn't completely drain out and dishwasher kind-of smells when I open it -- I do keep the filter very clean. 2) The dishwasher takes HOURS to go through one load, no matter what the time says on the display and no matter what type of cycle you choose -- quick, delicate or regular. 3) The red display often displays something that looks like "2h" at the beginning of the cycle. 4) The place where you put the detergent doesn't shut.


Hi Kathryn .I think you have a defective pressure switch. The pressure switch is located near to the drain pump, and the device is used to determine when water had been drained completely.Also check the floater switch located ... Dishwashers

2 brand new Kenmore elite dishwashers - All hookups checked and correct. Start buttons blink - cycles will not start. 1 washer ran for about 10 seconds - then the light started blinking. Troubleshooting in manual says light will blink if the door is not closed. They seem pretty closed. Dishwashers leveled and plumb. Tried it mounted, and unmounted. No Luck. Thanks


These dishwashers have a safety feature. The door has to be closed within 3 seconds of pushing the start button. If the cycle is interrupted at all by opening the door or pushing something while started you will have to push the start button to resum ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a maytag quiet series 300. When it is done with any of the cycles in leaves about 1-2 inches of water in the bottom of the dishwasher. I can manually hit the start button twice and it will go through a 2 minute cycle and pump out the water. I have cleaned the filter inside the dishwasher where it drains and have checked the hose to the disposal and it pumps out fine. It just doen't pump itself at the end of the cycle. HELP!


Here it is - Maytag Quiet Series 300 Manual ... Maytag Dishwashers

Bosch she44c dishwasher. Dishwasher times down to 1 min and continues to run until until manually turned off. After further investigation the spray arm do not rotate during cycle. We have also noticed a decline in how clean the dishes are


Hello, Welcome to Fixya.. On bosch dishwashers the "1" is actually an error code and not coincidentally the reason it runs forever ( likely doesn't dry or clean well either right ? ). Here`s the most likely reason why it has detected the error... Eve ... Dishwashers

I lost the manual for my dishwasher. I have two questions: (1) How does Light Wash differ in its cycle from Normal Wash? It seems it should be (but isn't) shorter. (2) When using the Light Wash cycle, should I put soap only in 1 of the cups for dispensing (leaving the pre-wash cup empty)?


\015\012We need the Model Number off the inside of the door to get you the manual please post this first so we can Help you Thanks ... Dishwashers

I am living in Turkey and bought a Bosch dishwasher. The Model #9000 312 856 (8907). It is a very simple dishwasher with only 2 levels of washing. How can I obtain instructions in English on how to run this machine?


... Bosch Dishwashers

SHU 5316 UC dishwasher by bosch. I think it is from about 1998 or 99. It blew a circuit breaker yesterday. I reset the circuit braker, but it won't even power on. It may have burned something out. We replaced the control board 2 years ago. Please tell us: 1. Is it worth fixing again, or just replace? 2. Any suggestios? Maybe the pump has shorted? THANKS SO MUCH!! Mark


Hi Mark -There's no internal fuse in this dishwasher, so if there's no power you may well be looking at a new control unit and probably another major component as well, depending on what caused the overload or short. The most likely ... Bosch SHU5316UC Dishwasher

Bosch Dishwasher continuous fill/drain


Have same problem with 2 second cycling. I resolder at the point of heater relay. Thought I had solved the problem of running forever on 1. Now have this "new" problem that you have described. ... Bosch SHU5315UC Dishwasher

My Bosch integrated dishwasher(model SGV56A03 GB/12) runs through the cycle but doesn't stop at the end of the cycle. It continues to heat water and it sounds like the motor is running even though the time indicator shows 0 minutes. I have to manually switch it off. Any ideas before I call out an engineer. I have checked all the filters etc included in the troubleshooter info anf there are no blockages.


... Bosch Dishwashers

Bosh dishwasher starts out with 2 hours on the timer and runs until it gets to 1 and runs and runs it has to manually shut off


... Bosch SHE43C02UC Dishwasher

Hello! My 3 yr old Bosch dishwasher (I think it is a SHE 43) is doing two things: 1) leaving a serious white film on dishes and glasses 2) leaving grit inside glasses on the top rack (always on glasses placed on the far back right of the top rack) I've tried cleaning the machine with hot washes with no dishes, vinegar only, but no luck. Any thoughts? Many thanks for your help!


Hello. Since you have already cleansed the interior of your dishwasher, we must conclude that the problem is with the water itself. If you do not have a filter on your water, you may want to consider installing a dirt/rust filter, at least on the h ... Dishwashers

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

I'm having trouble starting my ge profile dishwasher; the machine locks but then when I push the start button one of three things happen: 1) I get error C3 and I do not have a user manual) 2) nothing happens 3 I get the screen indicating that the machineis a sensing soil level, washing' but in fact nothing happens - I do not hear the motor starting and no water runs, thank you!


... GE 24 in. Profile PDW7800 Built-in Dishwasher

THERMADOR DISHWASHER MODEL # DW44ZW 1. NEED MANUAL; 2. LIGHTS GO ON WHEN THE DOOR IS OPEN; 3. NO LIGHTS ON WHEN DOOR IS CLOSED, BUT MOTOR HUMS, BUT DOESN'T DRAIN.


HiThanks for using FixYa. Please click on this link for manual of Thermador DW44ZW Dishwasher. T ... Dishwashers

Where can I get Bosch Dishwasher SRS43E22EU model user manual (English) ?


Hi\015\012\015\012The essential problem with your request is that your dishwasher is a European model rather than British. Therefore, the user manual for this washer is published in most European languages - expect for English:\015\ ... Bosch Dishwasher Glass Rack Insert SGZ2004UC

Bosch slimline dishwasher SRS560. Unit has had this fault for a while, now going a bit mouldy so keen to repair it. Displays following Symptoms 1) Firstly empty motor drains water. This appears to be fine as I can hear the gurgling of the plug. 2) Then takes water from inlet to fill internal tank. I can hear the water entering the tank, and tap pressure indicates that water is being taken in. 3) The unit then sits there and does nothing for 25 mins until programme ends. I've


... Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

I have a Bosch SHU53513UC/U12 dishwasher. My initial problem is that the washer smells bad after a cycle and I've noticed some water sitting in the bottom of the unit. After running a diagnostic test, it results in a "2" heating fault. I followed your advice and used a current coil to and attached it to the GYBK-a1-3 hot wire on the control board. After running the test again, it only gets as high as 1.15A and manual says it should reach 11A. What should I do next?


Hello,Welcome to FixYa. ... Dishwashers

NEFF S4340X0GB Dishwasher frequently stops with sump full of dirty water. Detergent dispenser has not opened. After manual draining machine is ok for 1 or 2 washes. Interior is clean. Problem occurs on all programmes. What is the problem?


... Dishwashers

Bosch SHU 5300 series Dishwasher 1. The Rinse & Hold Button is stuck in how do I fix this? 2. Water does not drain from unit after washing?


... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2363 seconds