Having problems with your Dishwashers ?

My GE Profile PDW8060G01SS Dishwasher is properly connected but is not turning on. How do I fix it?


Answers :

Hi, your door may not shut properley. Check if any obstruction in its way, check if there is power at power point by pluging in another apliance.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My GE Profile PDW8060G01SS Dishwasher is properly connected but is not turning on. How do I fix it?


Hi, your door may not shut properley. Check if any obstruction in its way, check if there is power at power point by pluging in another apliance. ... Dishwashers

Our Profile Series dishwasher is not draining. All connections are working properly and the pump comes on for 2 to 3 seconds and starts draining properly through the disposal but then shuts off. Does the pump turn on and off by a timer or sensor?


... GE 24 in. GSD5930 Built-in Dishwasher

I have a Viking dishwasher made by Asko. It is less than 6 months old. Today I had a problem with my disposal (water not draining through it and leaking under the sink) and ran the dishwasher, which cleaned/dried the dishes fine. BUT, since the water was not properly draining from the disposal, apparently the dishwasher was not draining properly either. A repairman came to fix the disposal before I knew about the dishwasher issue. Now, the dishwasher won't turn off "draining mode" - button pu


... Viking DFUD042 Built-in Dishwasher

We have had a problem with our dishwasher since "winterizing" it to close the cottage for the winter. We were told to run it for a few minutes with antifreeze in it and then turn off and let it overwinter with the antifreeze in it. Now the machine leaves everything coated with a white film, even though we have a water softener and use jetdry. How can we fix this and is this the proper way to winterize our dishwasher if we close down our cottage and turn off the heat for the winter?


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

My Maytag mdb 7 dishwasher stopped working on the same day that a Plumber came to our house to fix our toilet. He says he didn't turn off the water anywhere in the house, other than the valve beside the toilet. Yet our dishwasher all of a sudden stopped working. Can the 2 problems be connected? Or is it a coincidence or am i stuck replacing my dishwasher?


If he indeed only accessed the toiled shut off valve, then that would not affect the dishwasher.\015\012\015\012Even if dirt/sediment got into the line to the washer somehow, it should be able to be cleared at the inlet valve to the washe ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

I have a newly installed Kitchenaide dishwasher. The copper pipe is secure under the sink and appears connected properly to the dishwasher. When I turn the shut off valve on, water begans to run from underneath the dishwasher. There is no water under the sink. The plastic hose does not seem to be the problem.


You should be able to remove the panel below the door and see where water inlet hose is connected to the solenoid valve. I'd bet that's where it's leaking since you say it's newly installed. ... Dishwashers

My kitchenaid dishwasher is not working properly. The light above the button that says "Rinse Only" is flashing and there is no way to stop it or turn the dishwasher on. How can I fix it?


... KitchenAid KUDI01TBK Dishwasher

Dishlex global 450 _ how do i fix fill level time fault? displaying oF? Hi There, I have the above dishwasher and saw your advice on fixing fill levels - my display is showing the oF message and the pump to drain remains on whilst mains is connected. turning off mains does not clear message. holding eco button down does not clear message? is there anything else i should do in terms of removing parts to assist the process? I have cleaned out all of the drainage bowl and all is clear. i would pref


... Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

My dishwasher won't turn on. It has done this once before. The tech came and fixed it. There is no connection. Thanks


On newer homes it is a requirement that a disconnecting means be provided for dishwashers. This disconnecting means is usually a GFCI outlet located under the sink. Look for this outlet, make sure the plug is in all the way, and make sure that the GF ... Dishwashers

My dishwasher won't turn on and makes a high-pichted ringing noise. The problem began when our power went out during a storm. The circuit breaker works as the disposal is connected to the same breaker and still works. The nosie stops when I trip the breaker. The unit is almost 6 years old and is a Profile.


... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Hi. I have a "Dishdrawer" F & P dishwasher DS603 range. I cannot start it to ceommence running a wash. There is no error code flashing, the power is on, and the door is closed properly. Whan i press start, it makes 3-beeps and simply does not start. I have tried turning it off, but this did not fix it


... Fisher and Paykel Dishwashers

Due to the my Indesit IDL 530 dishwasher not draining properly, I turned it onto it's left side, removed the base plate and pump and checked for blockages in the pump and associated hoses, which were all clear. However in re-assembling it I have forgotten which way round to connect the twin wire plug to the base plate. I cannot find a relevant wiring diagram online and therefore cannot tell which is the correct way around. I then guessed and re-assembled it anyway, and as you might have g


Hi.There is more than one wire going from control board to the tub. If the connector can be plugged either way without forcing it, then usually does not make any difference the way you plug this determined connector. It will be usef ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Leaky Tub our dishwasher was leaking quite a bit. i checked all the hoses, and connections, it turns out that there were two screws from underneath protruding into the tub, near the rear on either side. If any one knows if the tub could be fixed or replaced could you let me know? Also if this was a manufacturing problem shouldn't sears be responsible?


Are you sure that water leaking out from these two points.\015\012If this is the reason for the leaking, it's absolutely a manufacturing problem and you should forward your problem to Sears to take care fot it !!\015\012Generally,this problem could b ... Kenmore 24 in. 17019 Built-in Dishwasher

IAG dishwasher IDI6IE2 when turned on does not spray properly so that the soap does not dissolve. I have noticed that there is an outlet inside the unit at the back left hand side that the water pools out of like a tap, is there an easy fix for this? Thanks, Michael


... AEG Dishwashers

Electric Problem I pulled out my dishwasher to fix a leak. Now it won't turn on. I have checked all wires and it appears that they are all connected.


Go back to the electrical connections and retighten the wire nuts ... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

My Maytag dishwasher goes for long stretches when it won't turn on even though I push the proper buttons. The buttons won't light either. It turns on by itself after a couple of weeks of sitting idle. Some of the lights may blink on the start panel while the dishwasher doesn't work, but only on occasion will it fully operate. I have turned off the power and turned it back on, hoping to reset the computer part of the dishwasher. It didn't work.


The Control Touch Panels like to fail on may brands - especially Maytag. They are sensitive to humidity - and a lot have the vents out the front - right by the control panel.Please reply using "continue with this expert ... Maytag Dishwashers

We came home from holidays a few years ago and the dishwasher (Westinghouse 905) just didn't turn on. We've tried it repeatedly since then and are unable to get it to turn on. The power point works for other appliances. Should we replace it or could someone fix it? And is it a plumber or electrician you get to fix dishwashers?


Appliances that sit without use, usually have more problems than just the original problem.\015\012\015\012In your case I would first check the power conection on the dishwasher. located under the machine\015\012\015\012If thi ... Dishwashers

Hi threr I have the following problem with my Haier DW12-EFM dishwasher: The dishwasher seems to operate properly for the first several minutes untill program selector knob stops betwin position 2 and 3. After I turn it manually it keeps on turning and than it stops again after I turn it again it operates till the end of the program but the dishes are not clean enough to be used. I also noticed that the heater does not operate (water is cold). Do you know wht the problem might be. Reg


... Haier 24 in. ESD100 Built-in Dishwasher

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except with no water going into it. The water runs find at the facet. There is separate water supply underneath the sink for the faucet and the diswasher. I wonder if there is a mechanism with the dishwasher that stop the water from going into the dishwasher after the water supply been turn off. I did


FRIDG... EXPERT HERE \012\012\012Welcome to fixya\012\012Hello\012\012 \012\012 ... Frigidaire FDB956RB Built-in Dishwasher

I have a GE dishwasher with the following model number: GSD3230F00WW. Last night, while the dishwasher was in the clean cycle, a buzzing/grinding sound came from underneath the dishwasher. I removed the access panel to try to isolate the sound. It appeared to come from a solenoid that was connected to an arm that opened and closed something. I am not sure if the solenoid is bad or if there was something that was preventing it from operating properly. I moved the arm to which it was connected


The part you are referring to is the pump out solenoid. ( part # WD21X10071) When the dishwasher is suppose to pump out, power is applied to the solenoid and it swings a flap inside the pump assembly to divert the pumped water out the ... GE Dishwashers

Bosch dishwasher model shx36l fails to stop pumping. The drain was clogged. I cleared the drain. Dishasher backed up, water overflowed. Clog has been fixed. Dishwasher will not stop trying to pump water out. There is NO water inside dishwasher. I wish to run another load however unit fails to respond. Pump is operating even when front door to doshwasher is open. Turning the power button to OFF is the only remedy to stop drain pump from operating. How to fix?


... Bosch Integra® 500 SHX46A0 Dishwasher

Sears Kenmore dishwasher 665-15632000 dishwasher will not turn on. Little green lights never come on. Nothing happens--dead silence. How to fix or manual as to how to fix or how to take out dishwasher--remove front door, etc.


... Kenmore Dishwashers

I have a Whirlpoos Dishwasher DU8000XR-1. The arm on the bottom of the dishwasher is loose and you can lift it up and down. It does not turn with a smooth action. In fact, when the dishwasher is running you can hear this arm clattering. It must be wobbling up and down rather than turning smoothly. Can this be fixed?


Https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a4 ... Whirlpool Dishwashers

Have a 9 month old Smeg Dishwasher D612SDX. Disconnected water feed and re-connected. Problem is that dishwasher panel now flashes 4 & 5 when turned on, as if dishwasher is running. It isn't running! but can't reset by turning on/off, pressing program key or start key. Any ideas?


Looks like it is either a fault with pump/ inlet valve or with the control panel, let me check the code. Is the appliance running or not? ... Smeg Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2355 seconds