Having problems with your Dishwashers ?
My quiet clean 1 will not drain as of today. hasnt been cleaning the dishes very well for about a month. seems like there may b grease stuck in it. not sure. any help u could give would be appreciated. thanx.
I don't know what a quiet clean 1 is, but I had a dishwasher that would not drain. It turned out that a popsicle stick or something had gotten lodged between the plastic piece covering the drain and the drain itself. You might want to check to see if anything is clogging the drain in the center of the bottom of your dishwasher.
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
My quiet clean 1 will not drain as of today. hasnt been cleaning the dishes very well for about a month. seems like there may b grease stuck in it. not sure. any help u could give would be appreciated. thanx. beth howard
I don't know what a quiet clean 1 is, but I had a dishwasher that would not drain. It turned out that a popsicle stick or something had gotten lodged between the plastic piece covering the drain and the drain itself. You might want to check to see ... Dishwashers
My Frigidaire Dishwasher is stuck on the 3 second hold and I can't get it to turn off or to turn it on to wash the dishes. It is the Gallery Series...what can I do to get it to work? Thanks for any help you may give me.
Have you tried ot unplug it for 10 minutes then plugging it back in? ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
Hi I have a mdb6601awb maytag dishwasher. Sometimes when it starts the wash cycle it will make a loud squelling noise. Then if you pull on the handle and stop it, the machine will start and sometimes the noise will be gone. Or you may have to do this 3 or 4 times before it will stop making the squelling noise. I do notice when I pull up on the handle to stop the machine it makes some clicking noises and then the noise goes away. Thank You for any help you may be able to give me!!!
I don't have a solution however I have the same problem with that same model. ... Maytag 24 in. MDB6601AWS Stainless Steel Dishwasher
The key lock light stays on. I held the heated dry button for 4 seconds and the light still stays on. I think it may be the control board, but I am not sure. Can anyone help me please?
If the light is blinking, it is definately a stuck button and the console will need to be replaced. If it is on steady, it could be a console or control board problem. There are no troubleshooting tips to figure out which one is faulty, the manual sa ... Whirlpool GU2400XTP Built-in Dishwasher
My dishwasher gets stuck in the wash cycle and the dial does not progress. Thanks for any help you can give.
... Danby DDW1805W Designer Series Free-Standing Dishwasher
My GE dishwasher seems like water does not have enough pressure, soap not dissolved and specs of dirt stuck on all dishes. Took apart insides and cleaned and not sure what to try now. Any help would be greatly appreciated. Thanks, Monique
If you cannot spin the wash arms freely by hand, you will need a wash arm repair kit. ... GE Dishwashers
I have a Siemens Dishwasher. I'm not sure of the model but it is built in, has concealed controls and was purchased about 6 years ago at Best Buy. It sort of looks like the SL85. When started, it runs for a few minutes and then starts to make a horrible sound. ALmost a grinding sound but may also be like water trying to get through a small opening. The sound does not stop even after turning off the DW and even the power to it. Only turning off the water supply does it stop. Help?
... Siemens SL85A705UC 24 in. Built-in Dishwasher
I have a ge dishwasher model GSD5211 purchased in may 2006. Water appears to be dripping from under the front ss panel to the bottom of thepanel. I cannot open it to check the source of the leak. Alo found that the leak occurs midway of the washing complete cycle. It also seems that the leak during a particular cycle. Not sure which as just two indicator lights stay on thepots and pans and heated dry. Please help
You may want to inspect the seal around the door to make sure it's not worn out or has some foreign material stuck to it causing it to not make a watertight seal during operation. If you don't see any problems there, then you should pull the machine ... Dishwashers
Bosch SHX46A02Uc/21 My bosch diswasher runs continuously (stuck in some cycle). Not sure which cycle it is, but it does fill with water. Can you help me torubleshoot?
It is likely a control module issue. I will take mine apart this weekend to verify what others have said: solder joint on circuitboard burns out from possible overheating, and DW doesnt go into rinse cycle. Try rinse and hold cycle to see if it sto ... Dishwashers
Conia CDW0305W dishwasher. Gets stuck on the cycle and has be clicked along to finish. Doesn't appear to be heating as it first sticks at a point I'd expect hot water wash and dishes come out with grease residue and still wet. I live in the middle of nowhere, to a professional will cost me a fortune. Is this the metal element and can I fix it myself? Please help, I'm sick of hand washing!!
I have a Twenty-Eight Hundred dishwasher that is giving me a constant Blocked Wash Arm error. I've reached in and freed it, made sure it was as free as possible - have only stopped short of physically crawling into the dishwasher to fix it. I can't get it to work, despite nothing really blocking. Can someone help me out?
... GE Dishwashers
We cannot keep temperature of our Jackson Tempstar dishwasher at a constant temp. One time the rinse will be down a bit and then the wash. We have replaced the gauges, thermostats, motor and element of the diswasher. It is kept constantly clean, and we have tried everything we can think of. Would there be a wire that could be coming loose every once in awhile that may cause this? Thank you for any help you can give us.
... Jackson 25 in. TempStar HH Free-standing Dishwasher
My 13 year old Frigidair dishwasher (model FDB221RFR2) is not disolving the soap tab that drops in during the later cycles. We sometimes find the soap sitting on dishes or on the bottom. It appears that there may not be enough water but I'm sure of how much there actually should be. It also appears that the soap may be dropping late but again I'm not sure of when it should normally drop. I checked the inlet value and it appears to be ok. I also checked the timer (to the best of my ability) and i
CHECK YOUR WATER TEMP, IF ITS NOT HOT ENOUGH SOAP WILL NOT DISOLVE. I HAVE ALSO SEEN INTAKE VALVES DROP OUT LATER IN CYCLE. THAT MAY BE YOUR PROBLEM. GOOD LUCK! ... Dishwashers
My GE dishwasher's door is stuck shut ~ I'm assuming a broken latch. I was told to fix the latch, the dishwasher has to be taken out from under the counter top (in order to get the door open). My problem is: with the dishwasher door stuck shut, it's impossible to unscrew the dishwasher from the countertop... Any helpful hints? Pleeeeeeeease (all of my silverware is stuck INSIDE the locked dishwasher - LOL!)
Well I'll try to help you get this opened. I don't know how much space you have at the top side edge of the dishwasher. You need a long stiff rod like a metal clothes hanger straightened so it can reach from the side to a little past the dishwasher m ... GE Profile PDW9880NSS Stainless Steel Dishwasher
The problem with our Hobart LT1 dishwasher is the drain dump valve. The solinoid works fine. The rod that pushes up the plunger gets stuck. If we grease the rod it works for a few loads then when the grease wears off it hangs up again. The rod will hang up whether the plunger is in place or not. Our only remidy so far has been the grease.
... Hobart LT1-1 Dishwasher
I have a GE Monagram dishwasher 1999 /- model ZBD 5900/5700 It is stuck on Heated Dry cycle. Would not drain for along time, than it finally drained but still stuck on Heated Dry. Turned breaker off and on several times did not help. Still stuck on Heated Dry no other buttons work
Maytag dishwasher quiet series 400. Dishes have hard stuck on grit and food particles after rinsed and dried.
Very common problem is soap build up in these machines. Try putting it into a wash cycle with no dishes, and no soap. Let it wash for about 5 minutes, and then open the door. If you see alot of soap suds, then soap build up is the problem. Try do ... Dishwashers
THe door suddenly won't shut all the way. I made sure there was nothing physically in the way--duh--then realize it has to do with the door itself. I made sure the inside of the latch (I guess that it would be called the feamle side) wasn't gunked up. The male side is free of gunk, dose not seem to be damaged. HELP!!!
Hi,\015\012\015\012Usually the only reason a dishwasher door will not close is if either someone has fallen on the door and stretched the door hinges which would then require a service call to replace them or if the unit is not level. if ... Dishwashers
Our bosch dishwasher runs but no water is spraying on the inside. Is there a water filter clean out or is there a water pump that might be broken? I checked the line coming in and it isn't plugged. I made sure where the stainless line goes into the electric valve that it wasn't plugged to that point. I could see anywhere else to check if it was plugged. I figure there has to be a water pump, but I guess I'm not sure of that either. Thanks for any help..
Hi, welcome to Fixya. \015\012 \015\012By the description you've provided, it sound's like the wash motor is either seized or just stuck, let's hope it's the later. \015\012 \015\012Bosch had issued a service tip about this ... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher
Our hot water supply to the kitchen sink became disconnected and flooded the kitchen. Since then it appears that we are not getting any water INTO the dishwaher (just makes a terrible grinding sound..solenoid stuck ?? ). I did put 3 or 4 quarts of water inand it drained alright. Also tried cancelling the cycles but that hasn't helped. We also discoonected the power for a day but still no luck. Please help Ron
... Bosch SHX55M02UC Built-in Dishwasher
I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi
... Maytag Dishwashers
We have BOSH DISHWASHAR SRS3009. The water electrical pump is working, but remains on the bottom of cabinet dirty water. I have clean filters in the cabinet and put all pieces of food that may harm to the pump. May be i have to clean some additional filters? I will appreciate your help Michael Yachnis [email protected]
To remove object from trap/cylinder assembly\015\0121. Remove bottom rack.\015\0122.Graspthe assembly and turn it a1/4 turnclockwise.\015\0123.Lift outthe assembly\015\0124. Carefully examinethe assembly.If you find debris in ... Dishwashers
Hello - our GE triton dishwasher door latch will no longer ''latch''. It gets stuck about 1/4 of the way. I took off the panel and looked at the latch. Seems one piece of it gets ''stuck'' with another lever. Not sure how to fix it?
I am not familier with the Triton however on many under counter dishmachines with a front door such as the CMA L1X one or both latch or catch is bolted or screwed to the frame in a manner that can be adjusted by loosening the fasteners and realigning ... GE Dishwashers
I have a Fisher and Paykel dishdrawer model ds603. Not sure eactly what happened but my son says that the cycle stopped last evening (and only tells me this morning!). Dishes though appeared to be clean and there was a small amount of water at the bottom. I tried opeing the washer and it was hard to open as though the drawer was stuck on something. I removed the drawer and checked the rollers and they are fine. I realised then that the drawer is getting stuck on the inside lid that provides the
The best thing to do is to remove the rack,drawer completly,and close it up,see if it will come on,and run all threw the cycle.If it does,then put the rack,drawer on the track.The rollers could be,well,not snapped all the way on.It will be in that ar ... Fisher Dishwashers
Whirlpool dishwasher Clean light is flashing, we just bought it last week and after the third wash, the Clean light started flashing and it won't go off, which stops it from doing anything else. User manul says to have it serviced, but that seems unneccessary. It doesn't seem to be draining completely, so there may be a knk in the pipe, which may be related, just not sure
The blinking clean light is an interruption in the dishwasher program that either indicates a malfunction, or a simple program glitch. The following link explains how you may be able to clear the blinking clean light problem: ... Dishwashers