Having problems with your Dishwashers ?
Dishwasher fdw60g fault lights
i have the eco and prewash light flashing.
i know that this means the filter is blocked.
i have cleaned the filters and checked the hoses for blockages and they are all clear and kink free.
i have tipped the machine on its side and checked the pump , which is clear aswel.
i dont know what to try next to get the machine working and the lights to stop. thanks
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Dishwasher fdw60g fault lights i have the eco and prewash light flashing. i know that this means the filter is blocked. i have cleaned the filters and checked the hoses for blockages and they are all clear and kink free. i have tipped the machine on its side and checked the pump , which is clear aswel. i dont know what to try next to get the machine working and the lights to stop. thanks
I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!
How to diagnose? My Kenmore won't run. First it was flashing the clean light 7 times, so I figured out how to reset ("High Temp Scrub"/"Air Dry"/"High Temp Scrub"/"Air Dry"), but when I try to run a wash, it sounds like it's not getting water into the tub. When I checked it several minutes later, it was in "Cancel" mode, making a sound like it was draining (or trying to drain), then the clean light started flashing 7 times again. Clearly, the machine has something wrong but I don't know where to
Once this code goes off, it is not going to run. The module has picked up ths issue as you said. I would check the sensor first. You can make sure it is getting current by testing the circuit. ... Kenmore Dishwashers
Westpoint Dishwasher I have a Westpoint Dishwasher. As soon as I press the start button the Machine goes on sound like it is working then all of a suddon it stops. Now it have 5 red lights burning and beeping when I switch it on. Do you know what the problem can be? Checke the water checked the filter everything is clean and working.
I put the mahcine on as normal but it does not go past the first cycle of the red flashing light? ... Dishwashers
Hi, we have an Asko D3122 dish washer, pump runs continuously and light 2 flashes(cup and saucer) have removed machine and tipped out water, checked pump hose and removed pump is clear, we have
... Asko D3122XL 24 in Builtin Dishwasher
My Bosch dishwasaher model SGS53 has stopped working and has water in the bottom of it , i have cleared this and checked the small impeller for blockages - this is ok. i have also checked the water inlet filters and the drain tube is clear . I have the top and left sid panel of and when i lift the red rod it allows watrer to come in but stops if i release the rod thr lever in the base of the machine int which the red rod fits appears th be at its lowse level and therefore the red rod cannot be p
Kitchenaid kudc03fvss0 dishwasher stopped mid cycle without drying dishes last week and then stopped altogether with lights flashing and full basin. I disassembled filter/pump cover in bottom and cleared several plastic pieces and cleaned chopping blade and screen. After unplugging/plugging and pressing cancel button the pump runs for about 10 seconds and stops with normal and heavy duty lights flashing. What should I check next?
I have the Whirlpool DU 1100 dishwasher and the clean light kept blinking. I did the heated dry, normal combination and got it to run through the diagnostic check and sure enough it cleared the lights and appeared ready to run. When I would start it up again it would run the water and then get to the soad wash cycle and stop. No more lights it just stopped. I have been through the diagnostic process 3 times and still same problem. HELP
... Whirlpool Dishwashers
White knight dishwasher dw1260WA will not power up. The light doesn't come on either. Machine was in the middle of a programme but stopped with water left in it. at that time the light was working but even the light doesn't come on now. I also removed all the excess water out of the machine...I've also checked the fuse and it is fine. Any suggestions?
Water inlet light on. have checked filter and the stop **** is open. Water getting through stop **** and filter is clear. Have followed all the instructions, but light still on an dishwasher turns itself off.
... Miele 24 in. Novotronic G698SC Plus Free-Standing Dishwasher
We have a Katcher HDS 3.5/30-4 M Ea. Was using it, stopped using it briefly in the middle of a job, pulled trigger again, and there was a lack of pressure. Went to the machine to troubleshoot. The "engine indicator light" is on. Checked the temperature of machine: fine. Water intake: fine. We have not been running it at high temperatures, but about 50 degrees C. The pressure was at about 2300 PSI before it stopped. Any ideas?
... Karcher Pressure Washers
I have a whirlpool DWH B10W. Last week the main drain outside blocked and none of my service machines were working (not draining). The main drain has now been unblocked and every machine except the dishwasher are now working fine. The plumber has checked the drainpipes again and says all are now clear. When I try to use the dishwasher, after the initial drain it stops and starts beeping at me. I have also noticed that no water is going into the machine. What's happening?
The error most likely indicates a Long Drain Sequence (Drain Exceeds 8 Minutes) - Select 'cancel' twice to clear error code. \015\012 \015\012 \015 ... Dishwashers
Neff dishwasher will not switch on , checked fuses etc and positive that power is going to the machine but will not switch on,is there any safety feature such as blockage or otherwise stopping machine from switching on, red lights not coming on, machine 4 years old and very little use? can u help
Just went through this myself. It could be a latch switch. Open the door undo the screws that holds on the inside door panel remove the latch. The 2 black boxes with wires attached are the switches. Take them out (use your camera so you know how to p ... Neff 24 in. S4443 Built-in Dishwasher
We have a problem with our Miele G851 SC Plus dishwasher. We have not operated it for over three months as we were away on vacation and also because there were other issues in the kitchen due to some water flooding . Yesterday we switched on the machine and notice that the machine flashes the intake / drain light after a few minutes into the cycle and stops working. we have checked the drain pipe for blockages and also the water pressure is good. I disconnected the machine drain from the
Www.miele.ca/miele/canada/OperatingInstructions/.../G851%2005431311.pdf\015\012\015\012\015\012\015\012 ... Dishwashers
Hi there There appears to be no water entering the machine. Have checked the inline filter + the main machine filters, all clear. Machine all lights up as normal but will not start cycle
... AEG 24 in. Favorit 44050 Built-in Dishwasher
Hi, Dishwasher problem: When a programme starts, the machine fills with water then stops and the "check water" light comes on. To empty the machine, I used the reset programme which does empty the machine. Any ideas of about what might be causing and the solution to this? Many thanks, Richard
You will need to check the inlet valve and the water level pressure switch. It can also be a low pressure in the pump that is giving out the signal for the control board to shut off.\012So first of all check the water line throughly to confirm. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher
The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find
... Whirlpool DU912 Dishwasher
Maytag MDB6600AWW Unit is approx 3 years old it was finishing a load and stopped part way through sticking on heated dry. I don't know if it was there in the cycle or if the diagnostics on the board sent the message there. The light now will not shut off or move from the heated dry. I have disconnected 120 volts, removed the panel to check wiring, removed board and reassembled nothing resets the heated dry light and nothing works. I have gone through manual function test, sales floor demo test,
Have you tried pushing heated wash, heated dry, heated wash then heated dry? Sometimes this will reset it. ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher
Stopped Working Hi, My Zanussi Aquapulse Dishwasher (DE6744S)has just stopped working. The red on/off switch still lights up when I try to start off a wash but nothing else happens. I know this is probably just a case of "call out a repair guy" but, even though I've had the machine a few years, I'm I bit miffed on the thought of coughing-up to have the thing repaired because I very rarely use it. Any suggestions? Many thanks
The problem is with the PCB, this is the board behind the buttons, you can buy this for £120 or you can get it fixed by QEA for about £45 link below. I am not an engineer but I replaced mine in 10 minutes.\015\012 ... Zanussi 24 in. DE6744S Free-standing Dishwasher
The machine seems to circulate dirty water and stops with the 'check water' red light on. does not show the "end" e ed light
... Bosch SHU9915UC Dishwasher
|Can't seem to get any response or panel lights from my built in Kenmore Ultra Wash Quietguard 4. I stopped the machine mid cycle, started it again, I do believe it started but when I checked a bit later no indicator lights at all, and still has water in bottom of dishwasher???
Hi \015\012\015\012Thanks for using FixYa. The issue seems to be with water not draining. To\015\012start with check all\015\012the hoses for blockages, after you have checked the drain hose and can't locate\015\012t ... Kenmore Dishwashers
The machine stopped during the cycle leaving some water in the bottom The power light is on but the machine is showing the check water light.Can you help?
... Bosch 24 in. SGS43C02 Classixx Built-in Dishwasher
The Intake/ Drain light is on. It appears that the machine is not draining and that possibly the pump is not working properly. The drain line appears to be clear though I haven't pulled out the unit to check the drain line at the machine. Any suggestions?
... Miele Touchtronic G832SC Built-in Dishwasher
Bosch Dishwasher 8502. Disconnected and laid up for six months. Now reconnected but 'check water' light comes on. Have removed filter in tap end of hose and checked for no kinks. Plenty of water pressure at entry point of hose to machine. Ant thoughts?
... Bosch Dishwashers
My cda dishwasher cw448 is 18 months old, and has recently begun to stop before the end of the cycle. When I open the machine, 3 lights flash, (one of them the rinse button), and the machine bleeps repeatedly. Why doesn't the cycle complete? I've checked the filters, the spray arms, all the dispensers, and manual doesn't give any answer. This doesn't happen all the time, but is occuring more often now.