Having problems with your Dishwashers ?

How do I replace the bottom Door gasket on a Frigidaire dish washer Model # PLDB998CCB?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I replace the bottom Door gasket on a Frigidaire dish washer Model # PLDB998CCB?


... Dishwashers

Frigidaire dishwasher model GLD2250RDC0 leaks from the bottom of the door. Just replaced the bottom gasket. Not helping. Noticed that the foam insulation on the bottom of the door is soaked. So, if it's not coming through from the gasket, what's causing the leaking on the inside of the door and through the foam insulation? Thanks for any help you can provide.


You may want to check the door alignment itself. Many people open and close the door improperly and when they load it sometimes they put pressure on the door in one corner or the other. Check to make sure the door is completely shut and shut proper ... Dishwashers

I have a Frigidaire dishwasher, FDB-1100RHC, that is not cleaning dishes. My fiance cleaned the trap at the bottom of the washer, removing both the small basket and the larger mesh grid. After replacing both, the washer doesn't seem to have enough water pressure to spin the lower and/or upper arms. If I interrupt a cycle and open the door, water is dribbling out of the upper arms, but they are not rotating and do not move from whatever position you place them in. Both arms are completely uno


Hello :)don't feel bad, I run into this kind of problem at least once a week.\015\012It does sound like the pressure isn't there so you're not getting water to the upper spray arm. What you need to do is take the pump apart, which i ... Frigidaire Dishwashers

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

Model # PLD2850RDC2 has a leak at the bottom of the door. i have replaced the gasket in the vent. Had to remove door cover and seal at bottom of door. Had difficulty replacing bottom seal. How do I replace seal correctly? It is still leaking. Could it be something else?


The side baffels are bad. look on each side on the bottom in the corners and that is were their at just pull them out and get new ones ... Dishwashers

I have a Frigidaire Dishwasher, model #FDB635rfs It is not that old, but appears to have quit working. It sounds like it runs the water gets pushed in by the tube on the side but goes straight to the bottom of the washer. It looks like the spray arms are not spinning. Water is not circulating. Element still heats up. Detergent just runs down the inside of the door and doesn't dissolve since water is not circulating through arms. I have just replaced the water inlet valve and it did not hel


Don't know about yours but many of the rotating spray-heads are turned only by waterpressure, not a separate motor.\015\012The rotator is normally pretty loose and should turn willingly by hand; if it seems stiff and your water pressure is normally l ... LG LDF6810 Built-in Dishwasher

Frigidaire dishwasher bottom door gasket replacement


Thank you so much for this information it was a god send ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Frigidaire built in dishwasher model PLD2855RFC1. Have to wash dishes pretty much spotless prior to using dishwaser. Glasses come out with what appears to be soap residue regardless if powder or liquid. Did not use a gauge but water pressure in rest of house is good, recently replaced water heater, pressure regulator and just replaced the dish washer water source valve. Washer is about 18 months old, has never worked really well.


Hi, \012\012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and ins ... Frigidaire PLD2855RFC Dishwasher

Kenmore Model Ultra Wash Model 665- 45955 Problem: Dish washer leaks at bottom intitially during sudding cycle only...first 5-10 min... then no leaks/drips thereafter thru balance of clean/rise cycle. Whats up....Thought possible seak around washer door is bad but no leaks at bottom or elsewhere after the sudding cycle is completed. Please provide complete resolution reply if possible Tx


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is causing too much suds. Cut ... Kenmore Dishwashers

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Bottom door gasket is caked with gunk of 1996 Miele dishwaher model G 880. Is this the gasket getting old and disintergrating, or is it just debris build up? Is it advisable to replace gasket on older models? No sign of leakage, yet.


Hello,\015\012This does sound like debris build up.You can try and clean it off but be careful you dont damage the rubber.If after cleaning it still looks pliable and does not leak then it will be ok.\015\012\015\012Hope this helps. ... Dishwashers

Hello, I have a Frigidaire FDB510, after a few minutes of running water starts pouring out of the bottom of the door.I have replaced the wiper or sweep seal at the bottom of the door, the gasket does not seem to be bad, (it actually does not wrap around the bottom of the door anyway). Am I not draining correctly i.e. float,pump, etc. I sure could use some advice. Thanks


Ckd spray arm be sure it is not binding on something also ck for possible split in spray arm look close some are almost invisable ..when water is pushed through spray arm the seam will sometimes separate..also watch for oversuds ... Frigidaire Dishwashers

Dishwasher leaking I have a white westinghouse dish washer and it is leaking on the bottom of door. The model # is 3322ED2 serial # 851100699. I have the rubber of the bottom of the door and can't figure out how to reinstall. Can you help me.


... Westinghouse Dishwashers

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps. ... Kenmore Dishwashers

The cable to the door of my GE Potscrubber 900 dish washer (model GSD900L-02) broke. I purchase the replacement cable and now need to know how to reinstall this new cable. The replacement parts include two cables and two springs. Can you provide a "visual" of how this cable connects to the lower left corner of the door???


Question, my cable just broke yesterday. Where did you buy the part? ... Maytag Dishwasher

Dishes bottom rack are marginally clean. upper rack is never clean anymore. The dish washer cycles through NORMAL and Dries dishes OK. Motor is running, and rinsing can be heard as well as washing cycles. Water temperature is HOT. Different detergents (liquid and powder) were used. Frigidaire model FDbb2040FB1


Just fixed my Frigidaire. The outboard o-ring on the main pump became distorted and stretched. Check your local hardware store as Frigidaire wants $17.50 + shipping. Good luck ... Dishwashers

Kitchenaid dish washer kuds24sewh4 door leaks but does not seam to be gasket ! water drips from inside of door bottom? possibly rinse aid leaking in door?


Remove the inner door panel and ck for leakage . there should be water tracks . / there is a bottom seal. that may be failing / ch to see if its in proper possion .. its on the tank under the door / open the door all the way and l ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Frigidaire model FBD2400KB2A dishwasher is not cleaning dishes and liquid detergent is all over the door and the dishes on the bottom rack.


... Maytag Dishwashers

The dishwasher is not working. When the cycle is finished the dishes are still dirty and the soap is lying in a pile at the bottom of the washer still dry. It is a GE Medallion 850 Model#GMB8240KD119. how old is this model? Do you recommend fixing or replace?


The float switch may be the problem so open it up and clean it. Debris can cause the float to stick in the raised position, which prevents the tub from filling which appears to be your problem. If the water doesn’t reach the right level ( ... Dishwashers

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

My frigidaire dishwasher leaks from the bottom right of the door. It forms a puddle while running a load of dishes. Looks like the seal is gone underneath the door on the right side. Any idea how to replace this seal? Thanks.


One possible solution to your problem could be as follows... Could have been little regular soap or something put in that made it suds up causing it to leak out of the front and sometimes not to drain all water out. Pouring vegetable oil into the dis ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

I have a kenmore model 587.15193400 dishwasher and I need to replace the bottom door gasket. Do I need to take the door apart to get to it?


... Dishwashers

Frigidaire microcycle ; part no: f3885m Can you please explaine where the dish washer powder goes in on this model? It is an older model which has 2 large plastic circle domes and a scew top clear bung on the inside of the door but dos not explain where to fill with powder!!! Look forward to response pls


... Frigidaire Dishwashers

I have a Frigidaire model GLDB957AS. The soap door won't open automatically so we are now doing it manually when the cycle gets to "wash". We know it's not being blocked by dishes in the washer. What else can cause this? Purchase date was 12-6-2002.


Be sure that the door is not restricted by the dish tray being installed backwards and holding door closed. ... Frigidaire Dishwashers

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1843 seconds