Having problems with your Dishwashers ?

I've got a Smeg DI612CA9 D/wahser. When I turn it on it pumps down as normal but won't stop pumpimg down even when the door is opened. If I leave it for +hrs it will allow me to start a wash cycle, but again goes into the same 'loop' at the pumpdown point. Any ideas?


Answers :

Take fuse out and put back in. it might reset the timeing on it.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I've got a Smeg DI612CA9 D/wahser. When I turn it on it pumps down as normal but won't stop pumpimg down even when the door is opened. If I leave it for +hrs it will allow me to start a wash cycle, but again goes into the same 'loop' at the pumpdown point. Any ideas?


Take fuse out and put back in. it might reset the timeing on it. ... Dishwashers

I have a maytag dishwasher mdb5601awb. when I hit the start button nothing happens. I have found the instructions to do a manual test which is hitting the heated dry button 5 times and then the start button. Thinking it will run some test which I have no idea what to look for, it actually runs the machine's wash cycles and clean, dries and tells me it clean with the green light goes on. How do I reset/reboot the machine so it starts by just hitting the start button again?


... Maytag Dishwashers

Kenmore model 16579200 is stuck on wash cycle. starts at 81 minutes goes to 73 minutes and stays there. any ideas?????????


Timer is bad and will need to be replaced. ... Dishwashers

Integrated Bosch 9000 127 310 (8602) dishwasher. Problem: Although it operates correctly it has just started to make a loud hum during the washing and rinse cycles. It goes quite when draining. Any ideas?


... Dishwashers

I have an kenmore elite "ultra wash" model 665. not sure the rest.. about 7/8 years old, making loud buzzing sound during wash cycles,starts about 5 minutes into the normal wash cycle. i removed the inlet protector and the chopper area and all was clear.clean...it's running now and seems to be pumping the water, but can live with this buzzing noise,,, any idea, is the pump on it's way out ? just stopped as it kicked into another cycle, at 42 minutes...but it will be back, any ideas ? (back alrea


Buzzing sound may be coming from a solenoid that is mounted under the dishwasher, below the tub ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Fisher & Paykel 913T soft touch dishwasher. On all types of washes when the wash cycle starts there is no 230 volts on the element & after 5 minutes the wash cycle finishes & then goes onto to the next cycle. None of the wash or rinse cycles heat the water but on the dry cycle their is 230 volts onto the element & dries the dishes OK. Is my problem the power supply PCB or could it be the Controller PCB? Does the 230 volts to the element on dry cycle come from the same cicuit on the po


Have you considered the possibility the water temperature sensor may be faulty.\015\012\015\012If the controller is getting false water temp reading then it may never turn the heater on.\015\012\015\012Generally with FP dishwa ... Dishwashers

After selecting wash cycle,I push start button. washing light comes on for a second then goes off.start light keeps on blinking. washing cycle would not start.


Check flood switch float is on(the float under the bottom rack)...also the switch under that...also you ca use a 110 volt test cord to test the inlet valve ... Dishwashers

Initially It started washing, completed the entire cycle, then while drying began re-washing the load. Then it would start washing nothing, without any buttons pressed. Then it woldn't allow any buttons to be pressed for any cycle.Then the lights would flash, but nothing would progress through the cycle.


For replacement parts - head on over to PartSelect.com or \015\012RepairClinic.com and enter in your full model number for a full parts \015\012listing.\015\012I recommend both sites because ...\015\012\015\012\015\012FixYa ha ... Whirlpool GU2300XTVQ Builtin Dishwasher

My ariston lsv 66 uk dishwasher is not starting the washing cycle. It is making the pumping noise as it normally does at the start of the cycle but will not go any further. I have tried all the washing cycles but it does the same thing for all of them. Any ideas??


Take bottom front panel off to expose the bottom tray. you will find it full of water. mop water out and machine will run. if fault reoccurs then you have a leak ... Dishwashers

Noisy dishwasher my Kenmore quietguard 4 has developed an exceptionally loud hum/buzzing noise seemingly coming from the door of the dishwasher, when closed, locked and put on either drain or wash cycle.If the unit is allowed to sit for 1-2 days, the drain cycle will empty the tub without the buzzing noise starting. If anything else is attempted afterwards, like a wash cycle, the noise immediatley starts at a low level, then becomes steadily louder, until the full volume is reached, and does not


I have aloud buzzing nose and humming what is the problem ... Dishwashers

Kenmore dishwasher model # 587.15103800 wash cycle won't start. It fills with water and stops. A few minutes go by and it drains. Motor is working. Any ideas why the wash cycle won't start?


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Gld2445rfs2 frigidaire dish washer when i start wash cycle it goes for 30 min then PF lite comes on and soap dispenser will not open.But if i open the despenser door and start the wash all over it will complete the cycle. the problem is which part is bad??


... Frigidaire Dishwashers

Kenmore dishwasher model # 587.15103800 wash cycle won't start. It fills with water and stops. A few minutes go by and it drains. Motor is working. Any ideas why the wash cycle won't start?


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

The GE Profile Dishwasher will not allow me to start without the heated drying light coming on. I want to wash without this headed drying at the end of the wash. When I try to turn it off it turns the start cycle off. This happend over and over again when I want to turn on the machine, It finally lets me get an unheated dry wash started to complete. A problem every night. PDW7800N15CC. Serial MM8243388


... GE 24 in. Profile PDW9800J Built-in Dishwasher

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

FGHD2433KFI ER Multiple lights go on when choosing the wash cycle. Quick wash is brightly lit but heavy wash is less bright along with air dry. When Start is pressed display shows delay/50/S. After 10s or so the display goes off and the dishwasher doesn't start. The same thing happens if I try Quick wash again.


... Frigidaire Dishwashers

Upon selecting a wash cycle and closing the door the machine starts normally (heating water stage) but never clicks to allow water in and wash the dishes. Fails to advance to the wash cycle and just runs without doing dishes. There was water in the bottom after the last wash, filters are clean?


... Bosch SHV46C03 Built-in Dishwasher

Model Number 87378918 TD Soft Touch ( 12 years old ) no previous problems. Dishwasher will not complete normal wash cycle or any other fast wash cycle etc. The electronics may be the issue, as the cycle appears to start , then stops and goes to an end beep to advise cycle complete.However, nothing has actually happened. Dishwasher in very good condition otherwise. Will an on site visit be necssary? Cannot locate original guide at present, so cannot refer to any troubleshooting issues. Any a


Hi\015\012\015\012Terry...as the motor works fine then you are right the issue\015\012is with the main board of the unit also known as the electronic control board.\015\012Please check this link and enter your zip code in order to locate ... Fisher and Paykel Dishwashers

I have a kitchenaid dishwasher model kuds24se with a problem. I MUST hit cancel before I hit start. Note that it doesn't matter how long it's been since the last cycle. It could be a few minutes or a day or more. I have to hit start to get a complete wash cycle. If I don't hit cancel, the washer goes through some sort of cycle and stops. It seems like a normal cycle but of course it is not because I don't hear any water and, upon completion, when I open the door there is heat but the soap dispen


... KitchenAid KUDS24SE Built-in Dishwasher

I have a Maytag Quiet Series 300 dishwasher model number MDBH955AWW. When I press the wash cycle button it starts and then automatically jumps to the rinse cycle. After going thru the rinse cycle for a couple of minutes, it shuts off. After that,I can push the wash cycle agin and it works. Any idea what could be wrong?


HI. This will be a basic logic chip fault. It could possibly be solved by simply preforming a hard reset. You can do this by shutting down the power to the unit for five minutes. This shutdown will force the logic sector of your electronic control bo ... Maytag 24 in. MDB9750AW Dishwasher

Frigidaire Dishwasher won't start (lights cycle but no water/motor) Model Number: FDB1050REB2 Brand: Frigidaire Our dishwasher is 1.25 years old and already not working (grrr!). When it is turned on, the lights cycle through like a normal wash cycle, but the motor isn't engaged nor does any water cycle through. This happened about a month ago and I took everything apart to make sure all of the connections were secure and it started working again...not this time. Any ideas?


... Frigidaire Dishwashers

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

Have Kenmore ultra wash model 665.1604, purchased in 2004. no problems until yesterday. Push start button after selected wash cycle/drying options. Cycle does not start, and start button just keeps flashing. Tried different wash/dry options all with same result. I am guessing the touchpad is shot, or problem/short in control module. any ideas would be appreciated. thank you.


Unplug the unit for 1 min then plug back in then test unit pcb controller should reboot its self. if this fails you'll need to send the complete model # on the inside of tub area ... Kenmore Dishwashers

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501


The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

My dishwasher starts no matter what cycle on a 2 hr hold, it doesn't hold it goes ahead with the wash cycle. And it won't shut off when the cycle is finished. Sometimes it starts like it's supposed to but most of the time it just has a mind of it's own.


... Bosch SHU5307UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1459 seconds