Having problems with your Dishwashers ?

Kenmore Elite stainless steal dishwasher not working, the clean light flashes 6 times and one more have a few secs. Any help to reset?


Answers :

Hi


\015\012\015\012If clean light\015\012is blinking 7 times then it may be an issue with heater circuit, door switch or\015\012wash pump. If yes then please reset the power to the dishwasher. After, 5\015\012minutes check if you are still getting the same error. If yes, then it is a\015\012water heating fault. To resolve this error try pressing this reset sequence--\015\012Heat Dry - Normal - Heat Dry - Normal or High Temp - Air Dry - High Temp - Air\015\012Dry or Hi Temp Scrub, energy saver dry, Hi Temp Scrub, energy saver dry. \015\012Now let the unit run for 2-3 minutes and then you press the Cancel/Drain button\015\012and allow it to completely drain and reset.
\015\012If this doesn't work then it's an issue with the wash pump not pumping the\015\012water past the heater efficiently or due to lack of water to heat. Please make\015\012sure that heater is not open circuited and is heating the water efficiently.\015\012You'll have to check the heater using a multimeter; the meter should read\015\012between 3000 to 3300 ohms (Use multimeter on Rx1 ohm setting). If heater is\015\012fine then make sure water pressure is optimum and fill valve is working fine.



Hope this helps... Please post back for further assistance.
\015\012\015\012Daniel
\015\012\015\012

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Elite stainless steal dishwasher not working, the clean light flashes 6 times and one more have a few secs. Any help to reset?


Hi\015\012\015\012If clean light\015\012is blinking 7 times then it may be an issue with heater circuit, door switch or\015\012wash pump. If yes then please reset the power to the dishwasher. After, 5\015\012minut ... Dishwashers

Haier dishwasher CDW300SS beeping 10 times and 4 lights flashing,,, help The dishwasher will work, it fills, it washes and it empties, BUT will not start now, and the 10 beeps and the four lights flashing,, so wont restart and go throught the program... Is there some way of resetting the dishwasher to restart. help thanks. glenn


... Haier Dishwashers

Quiet Partner II Whirlpool Dishwasher 2 years old, used about 6 times in 2 years. Panel LED's flashing like a Christmas tree: Pots / Normal / Sani / Cancel lights all flashing Tried different resets as found on web but none work. Dishwasher was NOT being used when the flashing started. Need reset sequence if there is one.


Unusual LED or\015\012Display Readouts\015\012Open ID diodes and/or LED\015\012circuit(s) in keypad, or open\015\012ci ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

CLEAN LIGHT IS FLASHING SEQ OF 7 FLASHES THE LAST TIME TECH CAME OUT AND RESETUNIT, WE TRIED TO RESET AGAIN BUT NO HELP. ANY IDEAS


The cause of the problem is an insufficient rise in water temperature during a pre-set time period. The heater fault-detection program that was added to the electronic control is designed to shut down the dishwasher if the board-test for proper water ... Whirlpool Dishwashers

I have the Whirlpool Quiet Partner 1 the wash cycle starts and about 20 Min.'s into it the clean light starts flashing or the the start light, one or the other each time and it wont dry the dish's anymore we have already replaced the panel once and it has always popped when it is filling with water or changing cycles. HELP!!!! I hate washing dish's and I am beginning to hate all Whirlpool Appliances.


If the clean light blinks 7 times thats you heating circuit. Test the heater with an ohm meeting to see if it has open. If so order the heater kit and it comes with the control board. ... Whirlpool GU2400XTP Built-in Dishwasher

My kenmore dishwasher 665.17052400 clean light is flashing 7 times. I cannot locate the tech sheet to find out what is wrong. I have reset the panel and it will run then blink again after 15 mins or so. I have also done a hard reset and looked at the heating element, but it looks fine. Please help.


... Kenmore Dishwashers

Hi, we have a Hoover HEDS668-80 dishwasher at work. The first problem we had was none of the programs would run this turned out to be a broken door lock. After replacement we managed to get one pre wash and one wash program to run, now when we try it, it starts but after 2 minutes the pre-wash and wash lights flash and the machine beeps 8 times. Can anyone help?


... LG LDF6810 Built-in Dishwasher

Kenmore 665 17033400 Elite dishwasher clean light flashes 7 times and it wont run. i used the reset combination, all lights lit and stayed lit until i pressed reset. Then it started a wash. now the wash seems to be finished, though i am not sure and the clean light is flashing 7 times, pause, 7 times, etc.


That signals an issue with a faulty heater &/or heater drive circuit.(that info comes from their troubleshooting guide)I ran into it this weekend and discovered that the heater coil in the bottom of the washer was broken. ... Kenmore 24 in. 17032 Built-in Dishwasher

Hi!, my Ariston L64 dishwasger refuses to start. It seems to reset OK when the dial is turned fully to the left. After the beeps I select a cycle and nothing happens for some time, then eventually the first two lights begin flashing together.That is as far as it goes. Can you help me fix this problem please? Donna


... Dishwashers

Viking dishwasher ddb200ss will not reset...the pots & pans light flashes 3 times and then the normal wash light flashes 1 time...How do I reset this type of dishwasher


... Viking Dishwashers

On KUDS01IL Kitchen-aid dishwasher, 'Normal' and'Rinse only' lights flashing, and 2 horizontal bars on time display, won't reset and won't run. Please help.


... KitchenAid 24 in. KUDS01ILWH Built-in Dishwasher

ADG 6340 WH light flashes 8 times. Programmer knob jumps from one programe to another once the tablet is dispenced. Please help


... Whirlpool 24 in. ADG6340 Built-in Dishwasher

My one month old dishwasher keeps flashing the red light that indicates inlet/drain problems. I have tried what they suggest in the manual and I have rung miele and was told to reset the machine, but I am about to pull it out and leave it on the side of the road. Please help!!!


You have not mentioned Model of mechine. by the way,\015\012you can visit following website which helps you to find out exact problem.\015\012 ... Dishwashers

I have a Whirlpool GU2700XTSB1 dushwasher. It stopped one day and cleanning light was blinking. I was able to reset the dishwasher by pressing two of the button 3 times. Now when I run the dishwasher it fills the bottom with water, heats the water and then buzzes. The wash motor does not spin. Any help?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

The washing, heated dry, and normal wash light just flash. I have unplugged and plugged it back in several time, i tried restting it by holding down the Rinse only button for 15 seconds. I pressed the high temp ater, heated dry, high temp water, heated dry buttons to try to reset. I also ran the hot water line that feeds the dishwasher until the water was hot. Nothing has helped. The machine is18 months old and therefor no longer under warranty.


Please provide the make and model number of the dishwasher.\015\012do you hear pumps running? what was the last cycle it was at when the flashing started. was there water left at the base of the dishwasher from the cycle that stopped? ... Dishwashers

My bosch dishwasher, one month old, has the active light flashing and the reset button won't reset it when I push it. A friend that was over opened the door when it was running because she can with hers, but ever since then, I had to take the water out and the active light is flashing and the wash light is lite. I hold the reset button for 5 seconds and then I shut it off for about 5 minutes, but when I turn it back on, the same things are happening


It sounds like the float is stuck. There is a float that stops the water from coming out when you open the door. It sounds like your friend stoped it in mid cycle and it jammed in the open position. Look on the inside of the machine for a plastic pie ... Bosch Dishwashers

Hotpoint BC145 Dishwasher not cleaning starts to kick in but then just sticks on the "R" light flashing and cannot reset even after turning off. Itbeeps when pressing the select button sound weaker and shorter than they used to and the light does not move from the "R". On a couple of times I have tried it has reset and then the dishwasher starts but after about 3 minutes there is a low beep(not the usual beep when a programme finishes) and the washer stops and the light is flashing on the "R" ag


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

GCD4800LBB GE dishwasher won't reset. One of the Cycle lights and one of the Options lights continues to flash and the washer beeps. Tried pushing the reset button but to no avail.


... GE Dishwashers

She6af02uc bosch dishwasher Light is flashing, but won't start. I used it earlier today and it worked fine. Like I said the time light is flashing, but I cannot change settings nor will it start. Turned it on and off a few times to no avail. Did I lock it or something? How does one unlock it? Hardly used and only a couple of months old... Never had this problem before!


... Bosch Dishwashers

How to diagnose? My Kenmore won't run. First it was flashing the clean light 7 times, so I figured out how to reset ("High Temp Scrub"/"Air Dry"/"High Temp Scrub"/"Air Dry"), but when I try to run a wash, it sounds like it's not getting water into the tub. When I checked it several minutes later, it was in "Cancel" mode, making a sound like it was draining (or trying to drain), then the clean light started flashing 7 times again. Clearly, the machine has something wrong but I don't know where to


Once this code goes off, it is not going to run. The module has picked up ths issue as you said. I would check the sensor first. You can make sure it is getting current by testing the circuit. ... Kenmore Dishwashers

She6af02uc bosch dishwasher Light is flashing but won't start. I used it earlier today and it worked fine. Like I said the time light is flashing but I cannot change settings nor will it start. Turned it on and off a few times to no avail. Did I lock it or something? How does one unlock it? Hardly used and only a couple of months old... Never had this problem before!


... Dishwashers

Light flashing light clean flash seven times what i should do please help gu2500xtb1 blinks 7 times how do i diagnose and fix


Reset the dishwasher by touching heated dry and normal let it run through that cycle then through a normal cycle got the error blink again. Reset dishwasher by touching heated dry and normal, ran the test cycle, next ran a normal cycle but turne ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Re: Whirlpool Dishwasher When I press the ON button it goes green for a few seconds and I hear the dishwasher starting but doesn't fill. Then the green light ON Light flashes 6 times, stops, and flashes again 6 times and so on until I turn it off. Dishwasher will not fill. Please help


... Whirlpool Dishwashers

Flashing lights My GE model # GHDA455L00CS Quiet Power a dishwasher's lights are flashing when I start it, will not reset or in-take water. I've tried unplugging it and restarting. Nothing. Tried removing door door screws and press down door latch. Still nothing. HELP!!!!!!! IT WILL NOT PROGRAM. IT HAS A FLASHING LIGHT. WE HAVE BOUGHT EVERYTHING BUT STILL DOES THE SAME THING


It mite be the circut board problem..just  re-soldered a few of the pins in it and things will be back in working order. ... GE Profile PDW8400J Built-in Dishwasher

Leak from a De Dietrich Integrated Dishwasher has caused 3 red lights on the left of the Control Panel to flash and also a Blue Light on the right hand side of the Control Panel to flash. On resetting the Appliance Controls, the machine starts pumping out and then closes down, with the Control Panel lights flashing again. Help


Pull the built in unit out and tilt towards the rear right leg and the water will drain on to the floor. The Dishwasher then restarts but the anti flood sensor will reactivate after 2-3 more washes. Do not know final fix yet. ... De Dietrich Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1586 seconds