Having problems with your Dishwashers ?

Kenmore model 665, cleaned around control panel with a brush and now only left side will flash now showing quick rinse flashing only and is locked can't change and seems as if right side of panel will not do anything


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore model 665, cleaned around control panel with a brush and now only left side will flash now showing quick rinse flashing only and is locked can't change and seems as if right side of panel will not do anything


... Dishwashers

Model #PLD4555RFC0 The control panel lights on the front are all flashing and start cancel button will not change anything. flashing Er with wash, dry, clean, and and S showing. Top controls have China/Crystal light flashing and Low rinse agent light flashing. Nothing seems to work


... Frigidaire Dishwashers

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you


Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

I have a Whirlpool Gold Quiet Partner III (Model GU1200XTKB0). I have used it previously on "Normal" cycle and I always keep it on Air Dry. Last night I used the "Pots and Pans" cycle and it seemed to work fine. But this morning the Air Dry light is flashing and if I press a cycle key the Rinse Only light starts to flash as well. Nothing works. I have made sure that the console is not locked. Any suggestions? I do not have a Heated Dry button, only Air Dry. Thank you.


... Dishwashers

My Whirlpool Quiet Partner IV dishwasher model number GU3600XTRY1 has stopped working. The normal light on the top panel is flashing and one lighted bar is showing in the start touch circle. Upon throwing the breaker in fuse box panel seems cleared but when you try to press any buttons it makes a starting noise for a few seconds then goes quiet and returns to the state above.. My buttons on top are Accusense, pots&pans, normal, light, glass express, rinse only Soak and scour Hi temp wash


I think I just responded to this problem. Please accept both if you are happy with the solution. ... Dishwashers

Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. There are two bar codes down the side: 8542 347 15810 and 33 0451 014488. It's been in for about 3 years and have had no problems with it. Can't find instruction manual.


... Whirlpool Dishwashers

I have a Frigidaire dishwasher (FDB2810LDC1) and a Er code appears in the display with the sensing, rinsing agent low, sanitized, and clean lights all flashing as is the child lock light. After seeing the Er code, I opened the dishwasher and thought I heard the detergent tray open but most of the detergent was gone with a little remaining. This has happened before and we have had the electronic panel replaced twice. Could it be something else like something blocking the detergent tray from op


... Frigidaire Dishwashers

My karcher 645 has three lights on the right side of the control panel. The bottom one that looks like a heater temprature warning light keep flashing when im using the machine. Is this normal or do i have a problem. The machine seems to be working ok.


I'm not a karcher dealer, but I'll comment. I'm assuming you've misplaced your owner's manual -- so the only way you'll know for sure is to contact karcher.com..... or a dealer. That said, I'm pretty sure your blinking light is just bells a ... Karcher Pressure Washers

I own a Maytag MDB5100AWB three lights are flashing on the panel, the clean button, rinse only and heavy wash. I've tried turning off the breaker for 20 minutes, pushing the buttons in sequence, holding them down, nothing seems to work. It's done this before and a repairman pushed the buttons and it worked. Is there anything I can do to avoid another service call?


... Dishwashers

Leaking from underneath. Water appears from under basboard to the right of dishwasher, not from directly in front. Only seems to leak during rinse cycle and has just started recently. Removed front panels and noticed the bottom of cabinets on both sides have water damage as if water has been leaking for some time. Never have seen any water until now. GE model GSD500X-66WB. Came with house, approx. 15 yrs old.[


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012,fhjsuj ... GE 24 in. GSD500X Built-in Dishwasher

Leak from a De Dietrich Integrated Dishwasher has caused 3 red lights on the left of the Control Panel to flash and also a Blue Light on the right hand side of the Control Panel to flash. On resetting the Appliance Controls, the machine starts pumping out and then closes down, with the Control Panel lights flashing again. Help


Pull the built in unit out and tilt towards the rear right leg and the water will drain on to the floor. The Dishwasher then restarts but the anti flood sensor will reactivate after 2-3 more washes. Do not know final fix yet. ... De Dietrich Dishwashers

I have a magtag quiet 100 series that has a broken handle but still shuts tight and seems to lock yet. Problem seems to be that the rinse only light will stay on for quite a long time and won't let me hit the wash button. When the rinse only light does go off, if I hit the wash button it starts but then switches to rinse only. Sometimes I can get lucky and get it to stay on wash after the rinse button is off for some time. Any suggestions?


... Maytag 24 in. DWD1500A Built-in Dishwasher

The kitchenaid dishwasher (model KUDC25CHSS1) appears to have the 'child lock' engaged on the led display panel. The 'energy saver dry' light is flashing red and when I attempt to push 'cancel' it only flashes and never goes away. When I attempt to press a 'wash selection' the 'child lock' then flashes. Please help.


On my unit, I had the same problem (child lock LED on, or flashing.The cancel process of pushing anything was not possible, as a bad/stuck switch prevented any input from the control panel buttons.The underlying cause of the problem turne ... KitchenAid Dishwashers

Our Ikea Nutid Whirlpool dishwasher locked up recently. It started when someone was wiping off the top of the door where the control buttons are located. The dishwasher was locked on the china setting. Holding the cancel button, shutting off the breaker did not seem to clear it. Is there a way to reset the dishwasher? There was flashing on buttons but I cannot remember how many flashes or what one was flashing.


... Whirlpool GU2400XTP Built-in Dishwasher

Miele Optima Series 2470 Dishwasher sounds a beeping sound and flashes a F19 error on the control panel. Last week the beeping sounded and flashed a F13 error on the control panel. I looked in the manual and it said to clean the filter, which I did and put it back in place and locked it. Now the beeps sound and it is now showing a F19 error on the control panel. Help!!


... Dishwashers

Rinse only light is on and all of the wash rinse sanitize clean buttons come on and flash when you try to start it, if you change the setting to normal or heavy duty the wash light comes on then the rinse only light comes on and all above mentioned buttons flash until the tub is drained.


Hi\015\012 \015\012Try and reset the dishwasher by unplugging it for 5-10 minutes. Now check if you are still getting the same error you can try and press the following buttons to reset it-- \015\012Saini Rinse, He ... Dishwashers

I have a Whirlpool dishwasher model #DU920PFGQ4. The controls locked light is flashing, and when I press the air dry key for 5 seconds it won't unlock, however the cancel/drain light starts flashing. When I press the cancel key the controls lock light will stop flashing, but will resume as soon as I release the cancel key. I have tried disconnecting power for 24 hours, but as soon as I plug it back up it does the same thing. Nothing else on the control panel will work.


... Whirlpool Dishwashers

Rinse Aid dispenser seems to use a lot of product. Could almost need to be refilled daily. Is there somewhere or somehow to determine where an internal leak may be or to check that the rinse aid door is leaking or is not the problem. This seemed to happen very suddenly. This unit is approx. 6-7 years old. The rinse aid settings have not been changed.


Turn the settings down. the amountof rise aid dispenced. ... Whirlpool 24 in. GU1500XT - Multiple Color Built-in Dishwasher

RINSE AND HOLD LIGHTS ON AND IT'S SEEMS LOCKED


... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

Hi, I have a fisher and Paykel double dish drawer model DD605. A couple of days ago when we opened the top drawer all the lights flashed and beeped in sequence repeatedly and would only stop when the power was turned off or the dishdrawer closed. Today I went to turn the top dish drawer on and cannot change the cycle off rinse. I can push the eco button and the rinse cycle works no problem but I cannot change the cycle. The bottom drawer is running as I write this and appears to be fine. An


Hi\015\012\015\012\015\012Could you please let me know which all lights are blinking/lit solid in sequence from right to left. This could be an issue of drawer lock mechanism or flood switch issue. PLease post back with detai ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Whirlpool Gold "Quiet Partner III" dishwasher. On the front panel a small green light over what looks to be a "lock " symbol has come on and although the door seems to be locked in I can't get responses from any buttons on the panel. thanks, Don J.


If that didn't work. I'm trying to figure out what's wrong with my dishwasher right now, and I was looking for the product number on it. And when you open the door to the dishwasher, right on the inside on the top there is a sticker that tells you ho ... Whirlpool Dishwashers

Kenmore Ultra Wash Dishwasher Model 665.15779 LOCK ON light blinking on control panel, unable to use washer. If buttons were locked, LOCK ON light should be lit continually not flashing. If you press and hold NO HEAT DRY button to disengage lock, nothing happens. If you press the CANCEL button it begins to blink in unison with the LOCK ON light. How can I stop the light from blinking to allow button function again?


... Kenmore Dishwashers

Flashing LEDs All indiactor lights on the control panel are flashing and no response to the keypad. Unresponsive to keypad, random LED's flashing, unplugged dishwasher repeatedly, sometimes random flashing returned, now just "normal wash" flashing, tried suggestion of pushing "off" after reconnecting power, no change in problem yet.


Hi,- If the cause is a "dead not working" dishwasher, ensure that the wiring is properly located and attached to the PCB assembly. Check the door switches, check the main wire harness coming into the d/w. On some assemblies a jumper wire with d ... Maytag 24 in. MDB6100A Built-in Dishwasher

My Whirlpool Gold Quiet Partner III was DOA when I went to use it today. I unplugged/plugged it back in, at which time the "China Crystal" LED flashed a sequence of 3 flashes, then 3 more flashes, pause, 3 + 3 more, pause, 3+3 more, pause, etc., etc. And it would not run on any other cycle, but it did seem to run thru that one OK. Upon completion of the cycle, it was DOA again. Did the "Normal/Air Dry/Normal" button sequence, and now the Rinse Only button is steadily flashing. Any suggestions? I


When the rinse light is flashing steadily then the reset procedure for your model is pressing the "Normal/Air Dry/Normal" buttons.\015\012\015\012If it did not reset your dishwasher the control board must have fa ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1321 seconds