Having problems with your Dishwashers ?

My dishwasher has stoped letting in water but I can here the motor going


Answers :

Hello -
\015\012
\015\012I suspect the anti-flood protection system on your dishwasher has been activated and the motor you can hear is the drain-pump motor. It's unlikely you would be able to hear the motor (solenoid) for the water inlet valve. Please can you answer the following quick questions to assist me in solving your problem.
\015\012
\015\0121. Does the motor continue to run even with the washer door open?
\015\0122. Brand and model number of the dishwasher.
\015\012
\015\012Thanks,
\015\012BElectric
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher has stoped letting in water but I can here the motor going


Hello - \015\012\015\012I suspect the anti-flood protection system on your dishwasher has been activated and the motor you can hear is the drain-pump motor. It's unlikely you would be able to hear the motor (solenoid) for the water inlet ... Dishwashers

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

I have a ge profile quietpower 7 dishwasher. its built in.cannot find manuel and cannot find the serial number anywhere on the dishwasher..i need either your help with serial number or help with why water will not go into the dishwasher. motor runs water decided it wont go in. one day worked perfect and next day stopped working.


Hi\015\012\015\012This is often caused due to the fill valve. You can ... GE Dishwashers

Dishwasher Water is not going through upper and lower spray arms. Checked overfill protector switch, inlet valve, inlet valve screen, pump blades move freely, Pumb motor is working , Water enters into machine but does not go throught spray arms. Water heats up, Machine will go through all cycles but without water going through spray arms. 650 / 690 series gldb656jso


... Dishwashers

My Bosch dishwasher (SGV57T03GB/08) is draining and filling with water but none is being let into the main pump. I can see water going into the side reservoir but it doesnt seem to be let into the main pump area - any ideas on what is not working? Dishwasher tray is dry and float switch is not stuck.


... Bosch 24 in. SGV57T03GB Built-In Dishwasher

Water is not going into my dishwasher --worked for 13 months fine and now having a problem. When I turn it on the motor runs and rattles - louder than before, but no water is going into the dishwasher. We did nothing different and have not changed anything.


Try running a diagnostic run on the washer. Push heated dry, normal, heated dry, normal on your cycle selection panel. After you push that sequence all the lights will light up and then it will go through a test run. This fixed my washer that had the ... Whirlpool DU1055XTS Built-in Dishwasher

Dishwasher confused Dishwasher was switched off just after cycle commenced (tablet had been released). On restarting dishwasher, it wouldn't take in water and has just been going through the motions of the cycle without anything happening. Even when the power button on the machine is switched off or the door is opened, the motor continues to run but without water. Water is definitely switched on under sink. I think the computer is confused - can you please help?


I suspect this is nothing to do with switching off during the cycle.take the bottom plate off and check if there is water leaked into the bottom pan. alternatively, if you can, tilt the machine back to 45deg and see if water runs out.most ... Dishwashers

Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.


If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers

Motor problem?? The dishwasher takes in water then the water just sits in the bottom of the unit until the end of the cycle, there is no water going through the jets so the dishes are not getting cleaned. You can hear the motor but nothing is actually happening until the end of the cycle when it just pumps the water back out again


Have you checked the pump / motor belt? ... Tecnik TDW2677 Built-in Dishwasher

I have a Bosch dishwasher model #SHU3032UC/U12 It is not pulling water from the water pipe to wash the dishes the motor wants to go thru cycles. It starts to pull the water by the sounds from the sink but no water gets into the dishwasher.


Hello. When no water is entering the dishwasher, there are two parts to check. \015\012Water-inlet valve\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012The water-inlet valve lets water enter the machine. If this ... Bosch Dishwashers

My sound conditioned Whirlpool dishwasher is real old. It fills up completely with water. It looks like it will overflow, so I stop it. I thought it always started washing from the start. Do they always fill completely up with water, then start washing. I never noticed. I am afraid the water will overflow. Can it? Last time I ran this, it had a real loud motor. I used to hear the motor running from the start, but now I don't, just water filling up to what looks like overflow if I let it. I baile


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

My dishwasher only fills half way and it dosn't go through the wash cycle. It pumps the water out and then go to the rinse cycle but has the same problems with the water level. We have checked the motor, pump and the water valve. It seems to be working fine. Thought it might be the timer.


Hi,\015\012\015\012This is an issue with the wash motor..\015\012There are two motors,a wash motor and a drain pump/motor assy\015\012The wah motoe must have been the issue with the case.Changing the wash motor will solve your ... Dishwashers

I have a Bosch Dishwasher, Model Number SHX46L, Serial Number 860200524 that is no working properly. After running a cycle, it did not pump out all of the water, though the water is very clear, and the dishwasher does not display that there is any electricity going to it. I have verified the is 120 Volts AC at the appliance junction box. However the dishwasher will not turn on, and no lights will come on? Do you have any suggestions? I would appreciate it if you would let me know what you


... Bosch SHX46L1xUC Dishwasher

Hi. first my dishwasher is not filling with water. i then put water in the dishwasher and let it go thru its cycles. water will not drain now. garbage disposal is clear. any suggestions?


The easiest thing to do is check the water valve to make sure it's turned on. The water supply valve will be in a cabinet next to the dishwasher. There will be a tube that runs into the area behind/under the dishwasher. The valve will probably be ... GE Nautilus 24" Built-in Dishwasher

Hi, I have a Siemens SE44 dishwasher with Aquastop, which I bought recently. It was doing great for first 3-4 wash cycles and then it stopped functioning :( Now all it does is let the water in, and then drains it out- it doesnt do anything else. I can hear the water going in and then the machine drains the water,and this repeats. I tired resetting the dishwasher, checked the drain pipe, aquastop etc, and all seem to be in order to me. Any suggestions? Many thanks, stonerockyy


... Dishwashers

I have a haier dishwasher model WQP12 AFM, I've replaced the wash pump motor and drain pump (they had been damaged with water after last repair person didn't put widget around drain hose which split and water accumulated on bottom). It well for about two weeks, then it would not go through it's cycle and I noted water not heating up. Have checked element with meter, thats fine, I replaced timersince it wasn't going through its cycle and that has not changed anything. Any suggustions?? Cheers


... Haier Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Bosch SG145M55GB dishwasher which is not letting out teh water. The motor works because dishes are being washed, but water is staying in teh dishwasher. I assume its teh pump, but how do I get to it?


The drain outlet could be blocked. First take the drain hose off under the sink and check the spigot is clear . Then check the sump in the dishwasher for blockages. After that you will have to get inside of the base and remove the drain pump to see i ... Dishwashers

Dishwasher motor sounds like its struggeling to run. oR LIKE it's bogging down during washing cycles any and all cycles. there is water going into the washer but when washing it sounds like there is no water moving around creating the motor to work harder ........sounding like its gonna stop at any second. frigidaire d/w model#= FDB510LCS3 SERIAL==TH74378818


Try pouring water from the front. The pump has got air traps inside. This will ease your problem.Also check whether the spray arm turns freely without any obstacles. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

I have an maytag dishwasher and i can not get the water to come into the dishwasher i have everything hooked right it has power when i turn it on it just want let water go into it


You must prime all new installs on dishwashers. this means you must put about a gallon of water in the unit on the first wash.pour a gallon of water inside the dishwasher on the bottom ,close the door and run as normal.water will start to come into u ... Maytag Dishwashers

Bosch slimline dishwasher SRS560. Unit has had this fault for a while, now going a bit mouldy so keen to repair it. Displays following Symptoms 1) Firstly empty motor drains water. This appears to be fine as I can hear the gurgling of the plug. 2) Then takes water from inlet to fill internal tank. I can hear the water entering the tank, and tap pressure indicates that water is being taken in. 3) The unit then sits there and does nothing for 25 mins until programme ends. I've


... Dishwashers

Water stays in dishwasher goes through cycle but motor not going if turn propelers at back of motor pump kicks in for few seconds.is it pump motor ,is there brushes in these motors


Yes there are brushes in dishwasher motors it sounds like they are either worn out or stuck try tapping motor with the wooden end of a hammer at the rear of motor as brushes clog up as they wear hope this helps ... Tricity Bendix 24 in. BDW53 Free-standing Dishwasher

Dishwasher is not getting water. The motor runs, but there is no water going in. Was doing it once in a while, but now all the time. I ordered and replaced the water inlet solenoid / valve thinking that had to be it, but wasted $45.00...still doesn't work!


Does valve make noise . water to valve ? ck float may be stuck something under it or switch under float ... Kenmore Dishwashers

Bosch dishwasher not letting water in to the unit. I have checked the water inlet and there is water coming through. However there is a electrical smell to the uniot and seems not to be going through its cycle correctly


You need to replace the water inlet solenoid valves as a unit,you can normally do this from outside the unit,some you may need to remove rear cover to replace it ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1660 seconds