Having problems with your Dishwashers ?

Dishwasher racks are falling apart from rust. I would like to replace them, but am confused as to what parts to buy. Also, do you know where to buy them? When I searched for replacements, it seems like by the time I finish buying all the replacement parts, I should just replace the entire dishwasher!


Answers :

The racks are like 200 dollars a piece,replace the dish washer.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher racks are falling apart from rust. I would like to replace them, but am confused as to what parts to buy. Also, do you know where to buy them? When I searched for replacements, it seems like by the time I finish buying all the replacement parts, I should just replace the entire dishwasher!


The racks are like 200 dollars a piece,replace the dish washer. ... Dishwashers

The release clasp on the front of the dishwasher seems to be broken. It does not click correctly when I attempt to open the door and seems "free". For a few times, it seemed like it was hard to open but no one used a lot of force, we just tried several times and then it would open. Can this be a part I can replace myself or do I need to call a repairman?


... Maytag Dishwashers

I have a McCULLOCH 1500 psi pressure washer and it seems like I need the top part of therod where the waer comes out it no longer adjusts the water stream seems like a little plastic defkector that you adjust your stream with, snapped and broke looks like I HAVE TO REPLACE THE ENTIRE TOP PART OF THE 2 PIECE ROD on the bar it says the following max130barmax60C PA66-GF30 Where could I purchase this piece Andy Nowostawsky my adress is 15447-rue d'esterel Pierrefonds,Quebec H9H 1Y9


... McCulloch Pressure Washers

Dishwasher smoking Started cycle, everything seemed fine. Opened it to put something in and when I closed it to restart it sounded strange. Then the smoke starting pouring out of it and it smelled like something electrical burning. I immediately turned the wall switch off. It is a Kenmore, not sure of the model at this time. Is this a common occurence like if a specific part went out? Thanks for your time.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Amana dishwasher, model adb2200aws, ser #, 26650464e. history: quit running, no lights, nothing. replaced the door switch, ran for three days, replaced the switches on both sides of door switch, ran three days, quit. replaced the circuit panel , ran one time, quit. not lights, nothing. when I take it apart sometimes, that is take off inside cover on door, it might run or not. seems like the current isn't getting in as no lights will come one.


I have the same problem with mine as well but I found out that if you take a space heater to it and warm the control panel up for about 5 minutes, everything works great. This model of dishwasher seems to be problematic in any environment under 70-75 ... Amana Dishwashers

I have a Bosch SHU8805UC/14 dishwasher. I took the front door panel off to install it better but ended up with two extra pieces that look like either part 935400 Door Guard, or 935526 Support. I cannot seem to find any place on the inside of the door where these pieces would fit. The dishwasher works fine but seems like it got noisier after I put it back together without these two parts. Can you help me locate the proper place for these 2 plastic parts?


Hello, \015\012\015\012Welcome to FixYa.\015\012\015\012I believe the parts you are referring to are likely the blocks in each corner of the outer door panel. These have been a sticking point for many I tech over ... Bosch Dishwashers

Sears dishwasher 665.15882000 part #8268296 fell off and I can't find the "screw" that holds it in place...probably went down the drain. Now dishes do not "dry" on air dry. The part that matches the number for replacement parts does not look at all like the one that fell off. The one I have is round and the replacement one showing looks like some funky ninja weapon. Will this work on my machine? How easy is it to replace this part?


... Dishwashers

Kenmore Dishwasher model 665.1675592 doesn't seem to wash as well as it used to. Seems to have a low water level. Filler valve works, allows water in, but never seems to fill enough. No spray reaches top shelf, I think due to insufficient water level. It's like the timer doesn't stay on long enough for it to fill. Also cycle time seems WAY up, but if the timer is slow, how does it time out filling so fast? Looks like it would be slow all the time. Suggestions?


... Kenmore Dishwashers

Dishwasher 66513752K601 keeps blowing the thermal fuse. (Bi-Metal W10258275). I have replace the Thermal fuse several times. After i replace the fuse for some reason after a few months or less it will blow it out again. I have also replace the front panel assembly after it stopped working correctly. I would like to know how to test the dishwasher to find out the root cause of the fuse issue. I don't want to be replacing the fuse every time and don't have the $$ to buy a new dishwasher. Everythin


... Dishwashers

My dishwasher (Maytag MDBH965AWQ quiet series 300 was purchased in May 2006 (making it just a little over 4 years old). The handle broke on it initially and now the control panel has gone out including the start button. The cost of the replacement parts is right around $200, so I don't think it is worth investing that kind of money into it since it seems to be a lemon anyway. I have always been faithful to Maytag. At the time of our kitchen remodel in 2006, we chose all Maytag appliances. I


Well Kathy, you may be in luck. There has been a safety recall on your model of dishwasher and Maytag will give you a considerable allowance to replace with another Maytag. You may contact them at 1-800-544-5513 with your model and serial number and ... Maytag Dishwashers

Ge dishwasher model num.GSD2400G01.soap dispenser not opening during cycle.took it apart to replace broken handle.now i have a hard time opening and closing door.when door is closed,it wont let the soap out.dont know if gear-like parts are lineing up or not.please how can i fix this problem.


Hi\015\012If the soap dispenser door doesn't closes on your GE dishwasher then disconnet the dishwasher from power and check the spring & plastic tab under the timer. Check the plastic tab, it breaks often and will not let the soap door t ... Dishwashers

Dishwasher will not drain, replaced the pump and ran through the cycle and sounded like pump came on but water stayed in the entire time. What would be the next step?


Check the bottom of the washer the drain may be plugged if not the pump\015\012may be malfunctioning.To check it disconnect the hose where it enters\015\012the drain pipe and put it in a bucket then cycle the machine water\015\012should start filllin ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

My dishwasher is brand new Model FDB1502RGS0. I used it for the first time today. It seemed to be cleaning for a very long time. It was up to 2 hours and I had to leave so I turned it off. How long should it take. That seems like an awfully long time. I kept waiting for the drying mode to start and it sounded like it kept filling up and emptying. Does this sound right? Please advise asap.


Most DW today take a minimum of 90 minutes. Run the hot water from the\015\012sink until it gets hot, then start the DW, this will shorted the first\015\012wash cycle. It is not uncommon for the DW to run 2hrs or more based\015\012upon the water temp ... Dishwashers

I have a bosch smu 2000 series dishwasher. it has always worked well with no problems but then all of a sudden a week or so ago, the water stopped coming into the dishwasher to wash the dishes. the faucet and all other water areas continue to work w/o problems (i.e. bathroom, shower etc). in attempting to use the dishwasher, the entire cycle seems to be working, i initially hear what sounds like an initial water discharge when the cycle first starts and during the entire cycle it sounds like it


... Bosch Dishwashers

Incomplete cycle My Miele dishwasher (3 to 4 years old) finishes, leaving the dishes dirty and wet. It seems that it may only be running through part of the cycle - I'm not sure but from the time I set it going to the time it switches off, it seems shorter than usual. The dishwasher is not emptying as it has a pool of water in the bottom. I have tried various settings and have the same problem. the inlet/drain light DOES NOT come on. I have soaked up all the residue on the bottom and cleaned out


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Are the top rack adjusters on the Whirlpool GU2400XTP dishwasher an owner-serviceable item? Do most Whirlpool parts stores sell the top rack adjusters for the Adjustable 2-position top rack? My dishwasher is five years old and one of the adjusters has broken. The two-position rack seems like a good idea but the plastic part doesn't look like it was built for high-temperature durability.


... Whirlpool GU2400XTP Built-in Dishwasher

Bci450 My dishwasher has been always giving me lots of trouble. It is the BCI450 model from hotpoint. Whenever it reaches the washing stage for steam, it seems to beep alot. Many times they replaced the Circuit board but this problem comes back after 2 months. What could be the reason this is caused? Today they replaced the rubber thinking that water vapour might be reaching the circuit. I got this repaired about 7 times already and each time they replaced the circuit board.


... Hotpoint Dishwashers

I purchased a replacement lower dishwasher basket for a DU8500XB-0 Whirlpool. The replacement part is W10311986. The part fits washer as far as rolling in and out, but there are 4 extra parts that I don't know how they fit, no paper work with the part from FSP. Basket probably fits more than one machine. Would like to know how the extra parts fit the basket. Thanks


Did you get a response to your question? I have the same question. ... Whirlpool W10311986 DISHRACK

Ariston LS620A When running my dishwasher the dishwasher tablet is not disolving and entering the system. The dispenser is open but the tablet is stuck there??? I have cleaned the removable parts from the bottom of the system and put a new tablet in but the same problem happens again. This time when removing and cleaning the parts at the bottom there is water present and it hasn't drained is that normal? Or are there other parts there I have to remove....I have tried but nothing seems to budg


Hey, I experienced the same problem and I realized it happens when you block the water from the dispenser with a dish. Make sure that it is never blocked and the dishwasher is going to work fine ... Ariston Technologies LL64WNA Built-in Dishwasher

Viking dishwasher, after pressing normal cycle button, then the start button, the dishwasher begins to run (doesn't seem like there's water enters), then it runs for about 5' and shuts off by itself, the entire cycle is about 5-10min. When I open the dishwasher, it seems dry and the dish detergent door didn't open at all. What should I do to correct this or where do I troubleshoot?


... KitchenAid 24 in. KUDI01TJ - Multiple Color Built-in Dishwasher

How do I replace myself the detergent/rince aid assembly on a Maytag Jetclean dishwasher EQ plus model #MDB9150WB? I only need to replace the door, but I don't see a part for that, just the entire assembly. Please advise how to replace myself the entire assembly or can I just purchase a door from the detergent/rince assembly? Thanks, Carol


Carol,\015\012\015\012This is a simple repair. Remove the screws around the outer door edge and separate the door. The dispenser is clipped into position with several screws. Remove the screws and push the dispenser through the door.You can pur ... Dishwashers

I have a kudso1flss6 dishwasher with the clean light flashing 7 times. Can I replace just the control unit or do I have to replace the heating element also? I also need to know how to replace the part or parts. Help!


Depress cancel button. Turn off power WHILE STILLL HOLDING DOWN cancel button, turn power back on. Viola! ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

The lower spray arm came off during a dishwasher cycle and melted. The dishwasher is okay but I need a replacement spray arm for a Sears Galaxy dishwasher model number 587.15139400 I have searched google for replacement parts for this model and have not found a place where I can get a lower spray arm. Any help would be appreciated.


Sears parts dept ... Sears 24 in. 14181 Built-in Dishwasher

Maytag diswasher MDB6600AWW Sprayer arms don't spin. Dishwasher makes all the right noises, except for spraying. Water fills properly and heats up. Water drains properly. Found paper on the back of access panel. Ran Manual Function and Field Service tests, no problems indicated. Disassembled all the pieces inside the bottom of the dishwasher. No obviously damaged parts. Shaft for motor turns freely. It seems like the parts that attach from the impeller to the motor shaft don't


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

My dishwasher, a Whirlpool DWF B10, is not cleaning properly. When the cycle has finished, there is always a block of undissolved dishwasher tablet/powder left behind. My guess is that the seal to the powder door has gone and allowing the tablet to get wet too early and part dissolve before the door opens - is this likely to be right? If so, can I get a replacement seal or do I have to replace the whole powder & rinse aid containers ??


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2087 seconds