Having problems with your Dishwashers ?
I have a whirlpool ADP 4601 dishwasher and it is asking me to add salt which I have done but i'm not sure how much to pour into the salt dispenser. Also the salt dispenser is full of water - is this mant to be?
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have a whirlpool ADP 4601 dishwasher and it is asking me to add salt which I have done but i'm not sure how much to pour into the salt dispenser. Also the salt dispenser is full of water - is this mant to be? Many thanks
How much salt should we put in the dispenser?
... Kuppersbusch 23 in. IGV6435 Built-In Dishwasher
My whirlpool dishwasher adp4407 is not washing properly when i open the door thinking its finished a wash the soap tablet has not dissolved and is on the bottom of the dishwasher and sometimes its not emptied the water also the red light is constantly on i did not know you had to put salt in a compartment on the bottom of the dishwasher how much salt are you suppoosed to put in this compartment.
Waterside water softener model MC250 Dear Sir, Salt level did not go down during regeneration. I poured 2 pints of warm water to break solidified tablet salt, I found moist salt, but very little water in salt tank. I regenerated. I hear water going down the drain. Please could you tell me which pipe brings water in the salt tank, and what level of water should be visible, How is the water replenished in the salt tank? and how that level is maintained. Would you be kind enough to give me a wate
Just purchased a new Beko DFN1000X One Touch dishwasher. Plumbed in, switched on - starts up then says Call Service on LED panel? I have poured 1Ltr of water into salt dispenser as instructed.
I have a brand new Blanco dishwasher but im unsure if it is a DWF6XP, DWF4X or DWIN7 model. It does not have a salt dispenser if that helps. Last night when running for the first time i had a plumbing issue where the drain pipe was not set high enough as it states it has to be 500 to 100cm of ground height. Also had a leaking sink drain pipe. Fixed all that and turned machine back on and it pumped all the water that was inside to drain. I have cancelled the program and restarted but now it is ru
Unplug it and wait 5 minutes. Plug it back in. This will reset the machine. Put it on full cycle and allow it to do a full cycle. It should work just fine. ... Dishwashers
The salt warning light came on (red) and went to put salt in but noticed it was filled with water. I have filled it with salt now and the warning light has gone off but now when I try to select a program it wont. I have drained the water in the salt dispenser but it still wont work! Help!
What is the make and model of the item? ... Dishwashers
The water level in my Whirlpool Gold dishwasher does not seem to be high enough to clean the dishes. Also, the detergent dispenser opens but the detergent does not wash out of it. How do I increase the water level? Also, could it be something else besides the water level?
Screw fell into wash moduel. how do i remove the lower arm ect. Thank's ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher
We have an Rangemaster RDW459F1 integrated dishwasher and there is a strong taste of salt on everything.We indroduced 2 kg of salt into the dispenser after first filling with water as instructed. We live in a hard water area but even so I turned the arrow more to the - side, but it has not made any difference. It did seem alot of salt to put but it was first time being used. Can you help me please? Jackie
Stop using the tablets. they don't work in hard water areas. I think what you are dealing with is hard water deposits. Use "Lemi shine" for your main wash and the packets for your pre-wash. No one has harder water than where i live... Lemi shine work ... Dishwashers
Lately the soap remains in the dispenser, dried and caked in (I have to dig it out with a sharp object, as it becomes a solid piece). I have also tried gel soaps, but find them in the bottom of the dishwasher, partially intact. The mistery is this does not happen all the time, but most of the time! I've checked the water pressure and the water temperature: both seem to be fine. The dishwasher does run a full cycle. Is it time to buy a new one? Would you also be able to tell me what year this mod
... Frigidaire 24 in. GLD3450RD Built-in Dishwasher
The salt compartment in my dishwasher is full of water and also the compartment under the bottom set of blades is also filled with water. What can i do as the machiine is not cleaning anything properly??
... Bosch 24 in. SGS4072 Free-standing Dishwasher
My new bosch dishwasher doesen't clean the top rack of glasses, ran it 3 times, no difference. also the soap dispenser opens up but the powdered detergent won't dissolve, the same soap has been in the dispenser for 3 cycles. i turned up the water heater temp to try to fix the problem it seems to have no effect. the dishwasher is 2 weeks old. could my water supply line be too small or are they a stndard size. thanks
... Bosch Dishwashers
I have a Kenmore Ultra Dishwasher. The bottom arm spins, the top doesn't, although water drips out. The water fills up under the heating element. The top dishes aren't getting clean and the bottom aren't as clean as they used to be. I also noticed that the soap dispenser is open, some of the soap is gone, but there's still some soap in left in the dispenser. This never happened before and it happens all the time now. Thanks for any help you can give me!
Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers
Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?
You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher
I have a kitchenaid Model KUDW03CTBL2 dishwasher. It is pumping water, but the top sprayer and the one under the top rack just have a little water coming out. Not enough to make them spin. We also noticed the water in the bottom when opened is not as much and it is cool not hot. The dishes on the top rack will not clean, and the bottom is not completely clean. We have checked water pressure and water tempurature through the house, All is operating fine. This dishwasher is only 1 year and 10month
... KitchenAid Dishwashers
When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.
Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher
Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha
From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump. It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher
I have lost my manual for Teka DW640F1 dishwasher and im unsure how to put salt in, as i thought the salt was in the cleaning tablets i use but apparently i have to use salt aswell as i live in hard water area. Also as i no longer have the manual ive forgotten what all the symbols stand for.
... LG 24" Built-In Dishwasher - Black
Our Ariston LI645A dishwasher is not drying the dishes completely and whenever the cycle has finished, it always resorts back to the ECO cycle whereas we usually have it on the normal cycle? I have filled up the rinse aid but it does not seem to make a difference. The manual also says to put refined salt into the salt dispenser - i have not done that yet as was not sure exactly what 'refined' salt is and where i can get it from. thanks
... Ariston Technologies Dishwashers
My Kitchenaid ModelKUDI01TJBL0 only leaks at initial start up. Just after the water fills, the first few seconds of the wash cycle. It pours out the front door for a couple seconds than no more for the rest of the wash. It is level, no cracked arms, or loose pumps.Splash guard is in place. The float seems to be working, not too much water in the bottom. I am stumped. Although I do feel that it has something to do with the level of the water being too high, when the arm starts turning, it makes a
Is the unit level or leaning back if leaning back it is morelikey filling too much if level make sure the float moves up/down easy if not clean ... KitchenAid 24 in. KUDS25 Built-in Dishwasher
My GE Nautilus DW doesn't fully drain. When it is drained as much as it will it leaves water in the sump at the rear right. If you run the pump at that point, it sucks water out of the sump, but when you open the door and the pump stops water flows back into it. It seems like there is a check valve that isn't working. I have cleaned the sump and the screen which runs accross the rear. I also have taken the plunger out and cleaned it. Then I took the housing for the plugner off the bottom. I don'
HI. check the following areas for fualts.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... Dishwashers
Hello. My dishwasher has been pretty perfect for four years. When my house water softener ran out of salt, I added rinse aid and salt to the dishwasher for the first time. I subsequently added salt to the softener. Recently [a few weeks later] the glasses have all come out cloudy, something that never happened before. Also, the cutlery has whitish marks on it which are impossible to remove. I would love some help on this. Many thanks, Terry
Try cleaning the machine by adding white vinegar to the wash water (before the water-fill procedure finishes). Put your stained dishes and cutlery in with the wash to remove the hard water deposits. The combination of salt and rinse aid may have help ... Dishwashers
It appears that the dishwasher is not getting enough water. I have made sure that there is nothing blocking the door area so that the soap can dispense and I have reduced the amount of detergent to maybe a 1/2 Tablespoon. Have tried both powder and liquid detergents. Ran a sani clean cycle with the Jet Dry product for dishwasher used in the rural. I also run the hot water in the sink prior to starting the dishwasher to ensure the water is hot when it comes into the dishwasher. The detergent
Hello,Welcome to FixYa.Based on your description you`re experiencing the ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher
Sandy glasses The dishes on the top rack come out with a sandy residue on them....we have tried running it with the jet dry dishwasher cleaner, the vinigar and baking soda...have taken apart and checked all filters and water supply...no help with any of that. I also wonder how much water should be in there when it is running...shouldn't it cover the heating coil in the bottom? My water level is just below the coil.
A simple cleaning with any form of citric acid(tang0 on a regular basis(depending on how hard water is) will cure this "proublem"\015\012\015\012Cleans the internal filter and breaks up hard water residue(calcium) ... Whirlpool GU2400XTP Built-in Dishwasher
Water pours out the other end of the pump opposite the pressure hose connection. It has a clear plastic cap with a small **** in it. Looks like water should escape here but way too much water being pumped out.
... Pressure Washers