Having problems with your Dishwashers ?

We have a smeg SA 670 X.1 at work and the symbols for the 5 buttons on the left hand side have worn off. we wish to figure out what each do as somebody played around with them, so we can get it working properly again


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have a smeg SA 670 X.1 at work and the symbols for the 5 buttons on the left hand side have worn off. we wish to figure out what each do as somebody played around with them, so we can get it working properly again


... Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

My Bosch Classixx is not filling with water and no sound of the pump trying to work either. I fiddled around with it as it was not cleaning bowls properly on the bottom shelf - plates and cutlery were fine! Think I might have disturbed the round dome thing - is this the "float switch"? There is also about an inch in the bottom of the filter area which I have cleaned out of gunk but still with water there. Any ideas please!


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Ultra Wash Hi, When I got up this morning, I noticed the dishes were still dirty and dry??  The soap dispenser had popped open but that was about it.  I had some work done on it because it wasn't cleaning the dishes properly about a year ago and they replaced the motor.  While cleaning the kitchen last night, I heard it come on, but now that I think about it, I never actually heard the water start sloshing around. I don't have the owner's manual - I bought this house 3 years ago and I think the


Sounds like your not getting water to it. Turn on and let run for a few minutes then open door and check to see if you have water in it. If not check to be sure water to it is turned on. Check float in front corner of dishwasher to see if mo ... Kenmore 24 in. 15689 Built-in Dishwasher

I am trying to problem solve for dishwasher that is properly installed and is not working or even responding to being hooked up electrically. My husband tried to wire it and unfortunately wired it incorrectly the first time around (there were sparks and it blew the breaker.) We are thinking maybe it blew a fuse? Do they have fuses that can be replaced? I sure hope so! Help!!! -Alicia


No matter what brand it is the unit must have been hooked up power to ground to make a spark when turned on.they dont have a fuse to protect them, but what may have happend is you could have shorted out a door switch.be sure that you hae ... Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

We purchased an Electrolux Dishwasher Model #EWDW6505GBO, installed on 8/3/10, and we are very dissatisfied with it, as it just does not wash the dishes clean. We have had G.E. Dishwashers, two, since 1961, and then a Bosch, and they have all worked well. It appears that the water is not getting to the top and/or properly rinsing them. We rinse everything prior to putting the dishes in, but coffee cups come out with the ring around the top. The soap doesn't fully disolve. We have tried doub


... Electrolux Dishwashers

My dishwasher doesn't seem to be cleaning properly. I have cleaned the screen and all sprayers and they are working properly, but not sure the autoclean cycle is working properly. Is the water supposed to drain and refill before the washing cycle begins?


Hi \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure the\015\012wa ... Maytag Dishwashers

Maytag Dishwasher I would like to know the proper water level after DW fills. Older Whirlpool units a quick guide was when water just covered heater. I have a new D/W and the water supply is difficult to access, there is a kink in the water line slowing the water flow. The D/W fills to bottom of heater, but because the unit is so quiet I can't determine if it is timing out or working properly. I intend to repair water line when counter work is done. Thanks for any help Gary


Newer Maytags should fill close or up to the heater not over. Sounds like your alright for now but I would get that water line fixed. ... Maytag 24 in. MDB8951AWS Stainless Steel Built-in Dishwasher

The dishwasher was recently removed for floor refinishing and reinstalled. The bottom rotor works but the top rotor does not. I asked the re-installer, who worked for the moving company, if he had connected everything properly and he said there was just one water line going into the machine and assured me he had connected it properly. Is there something else that needs to be done to make the top rotor operational? Thanks. John M


... Jenn-Air JDB3610 Built-in Dishwasher

Problem - not work properly


Sound that the control selector if faulty try a different program if the same thing happens then the control board faulty and will need replacingThanks J ... Beko 24 in. D3421F Free-standing Dishwasher

I have had an E24 error message on my Siemens freestanding dishwasher. As well as the Error message the the little tap sign lights up too. Up until now the problem has occurred around 1 in 3 attempts and mainly at night but not in the day. When it does work the washer works perfectly and washes well. Today it will not work at all. The error always comes up 2 minutes into any cycle. I've tried turning the water feed off and on and in the past this has worked. It sounds like no water is gettin


Hi Steve\015\012\015\012E24 error normally indicates failure to drain, the first\015\012thing to check is that the water is actually being supplied to the appliance\015\012and is turned on. If it is then check the water inlet valve, if th ... Siemens 24 in. SE25T250 Free-Standing Dishwasher

The door latch on my Maytag MDB-5 isn't working properly, do I just need a new part?


... Maytag Dishwashers

Mezzo mdw012 dishwasher not working properly


... Dishwashers

Ice maker not working properly it stop working. how can i get this ice maker back working again.


I suggest you look at where the water comes into the ice tray - there probably is a small black tube. Check the tube to see if it is "frozen" - with ice. I've taken a blow dryer to the ice maker to melt all the frozen lines. ... Kenmore Coldspot Freezer Knob Part 532015 981928

Greetings! My Bosch SHE3305UC/UC12 has worked faithfully until last week when we had to pull it out of its home to retile the floor. Upon reconnecting all of the connections, it no longer works properly. The initial drain cycle works, so the flood switch is fine. But after draining, it just quietly hums. The test cycle actually seems to move to the next step for about 30 seconds, before also just humming. I'm thinking I need to check the valve, but not sure how to do it on this mod


Hi\015\012\015\012The hum sound indicates a bad motor and it should be\015\012replaced. Hope this helps...please post back for further assistance.\015\012\015\012Daniel ... Dishwashers

I have a ge dish washer model gsm1800jbb and the handle latch (WD13X10030) had to be replaced...well it took a while to get it in and now we are not sure how to wire the wires. There are 2 white and 2 black and 6 different prongs so I am not sure which way to plug them in to make it work properly. It worked fine before it got stuck closed and wouldn't open, that's why we ordered the whole assembly. The way I have it wired it sounds like its working...water goes in and drains put but the


... GE Spacemaker 18" Built In Dishwasher - GSM1800JBB

Hello, Our kitchenaid DW has stopped working. Non of the buttons cause a any of the lights to turn on. Of course, it will not start. On its last working cycle, it had a very strange washing cycle. It almost sounds like the water was not splashing around (even though I opened it while it was working and noticed water at the bottom). I checked the circuit breaker, and it is not tripped. For a couple of weeks, the DW had started making a kind of metallic noise while in the washing cycle. Also,


It is nice to see a problem described with such a depth of observations. It helps in closing on to the possible causes of the problem.\015\012\015\012For the moment let us make sure there are no remnants of the glass left in the dishwashe ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Model mdb7601awb diswasher . Nothing works , no buttons torn on or work when pushed, no action. 1.Have checked power to unit and is ok 2.checked door switches (2) and both work properly. 3. no visual discoloration on circuit board. There is a blue dot on the wiring harness from control board to button panel.When evaluating with magnifing glass I believe this to be blue ink droplet and not any burnning of harness. Need a Guru.


I have had the board replaced 5 times and the entire dishwasher replaced once. It was necessary to go to the state attorney general to get Maytag to extend the warranty. Just called the service center for the sixth time, after this the warranty will ... Maytag 24 in. MDB7601AWS Stainless Steel Built-in Dishwasher

Need help my oven is not working, the self cleaning works fine, the broiler also works, but the oven will not heat. what can i do? Our Kenmore gas range will not heat to the proper temp. The oven ready beeper goes off in about 3 minutes and displays 350 which the internal temperature is not. There also seems to be excess heat coming from the vents under the top of the stove, (under the timer, clock etc.). This could be something I just never noticed.


Hi, The ignitor is not working right and is going bad....have the repair man replace the ignitor, or DIY....Check out this tip about your problem...Oven not Working or ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

The dishwasher and chemical dispenser are 30 years old. The chemical dispenser does not work properly. I think the seals in the tubes are worn. It is an auto chlor model l3. Can I get parts for this dispenser or is there another dispenser that will work with the Hobart AMES 12 dishwasher. The dishwasher works fine.


Http://shopping.yahoo.com/s:Major%20Appliance%20Parts%20&%20Accessories:4168-Brand=Hobart\015\012\015\012\ ... Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

Kenmore Ultra Wash model #665.1374* purchased 1/26/08 electronic control pad doesn't work properly - one wash cycle works (no matter which cycle is selected, it defaults to same one - light wash) - "washing" and "drying" cycle lights don't work -


... Kenmore Dishwashers

Had recall work done on door, hasn't worked properly since repai4, now won't start at all.


My neighbor came over and found a loose wire and repaired it for me. ... Maytag 24 in. MDB4100 Built-in Dishwasher

DD602 model. while running upper washer appears that the seal/gasket around the whole upper is not working as water makes it out of basin and on to the middle shelf, then drips on floor. is there a way to test/double-check that the gasket is filling with air? any other ideas.? bottom basin works fine.


I had a air leak so that it would fail to keep a seal.To find out what was going in a made up a hose, which I could put in line and fitted in a pressure gauge.  It showed that the pump was pumping, but the exhaust valve had a small leak. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0996 seconds