Having problems with your Dishwashers ?
The Simpson Silencio 850 door does not shut properly and the dishwasher stops operating,but once you push hard on the door,the dishwasher starts again.
There are no leaks ,but the door must have a sensor registering the correct pre-load force against the door seal , which in turn,allows the machine to operate.
My machine does not work until you push hard against the closed door.
What is the problem please?
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
The Simpson Silencio 850 door does not shut properly and the dishwasher stops operating,but once you push hard on the door,the dishwasher starts again. There are no leaks ,but the door must have a sensor registering the correct pre-load force against the door seal , which in turn,allows the machine to operate. My machine does not work until you push hard against the closed door. What is the problem please?
GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but
... GE 24 in. Profile PDW7300G Built-in Dishwasher
I have a Kenmore Model 665.15955792 dishwasher. Water is leaking out the bottom of the door. I changed the door seal and the defusers but it continued. I took off the front of the door and I see the water filling into the base of the machine. When the dishwasher starts the cleam cycle, water is pushed up into the small square holes in the bottom of the door and then splashes up over the lip of the door and out onto the floor. It has never done this before, just started recently. I have had the d
... Kenmore Dishwashers
I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi
... Maytag Dishwashers
Machine stops Dishwasher stops in the middle of the wash. When the door is pushed it will restart. Hence there is a loose connection in the door latch. How do I fix this?
The door switch need some ajusting. ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher
Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk
I HAVE A 2 YEAR OLD BOSCH DISHWASHER. WATER WILL NOT PUMP INTO THE MACHINE. IF I POUR WATER IN IT PUMPS RIGHT OUT. THE DOOR WILL NOT LATCH AND CAN PUSH RED DIFFERENT CYCLE BUTTONS ONE AFTER ANOTHER. YOU USE TO HAVE TO SHUT THE MACHINE OFF TO GO TO A DIFFERENT WASHING CYCLE LEE
Hello thereThere are a couple of reasons why a dishwasher will not pump water into the machine or even work once the water is in the machine i will post the possiable reasons and some troubleshooting tips for this in 2 different post's ... Dishwashers
My maytag dishwasher model PDB2600AWX wont start and wont latch properly unless you push hard on the door I cant tell if the latch over the tub is bad or the latch in the door is bad or both
The latch on the door is held by two screws loosen these adjust and then tighten, until you get it right, good luck. ... Dishwashers
The dishwasher takes water in (not to much as when you open the door later, there is hardly water visible) and then it sounds as if it is busy heating the water. Then all of a suddden it will trip the power switch on the distribution board. My impression is that it is not takingin enough water and the heating part causes the trip failure. Your comments and advice to resolve will be aapreciated. Planning to open it up this weekend (machine not that old)
Usually ,there will be a float in the bottom of a dishwasher that shuts down the waterflow when it has received enough water. it works just like the float in a toilet tank (if you are familiar with that) you are definitely on the correct path in thin ... Indesit Dishwashers
I have KitchenAid dishwasher KUDS01FLSSD. The sani-rinse butten keep flashing and not let me start the machine. Other buttens are not working. When I push the sani-rinse butten with cancel butten with door closed, it makes sound that water is drainning, but there isn't any water in it! I tried 'sani rinse' 'energy save dry' 'sani rinse' 'energy save dry.' didn't work. Sani Rinse keeps flashing. Help me!!!
... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
My dishwasher 'start" button won't kick in. The machine seems to think it isn't locked - light wont activate, but the door IS locked. I select the cycle and option, but when i push start, it won't stay, The "clean" button keeps flashing. This is 5 years old
Hi,How many Blinks are there?Is it 7 Clean Light Blinks?Let me know, so that we could proceed.Hope i helped you.Thanks for using ' Fixya ' and have a nice day!! ... Kenmore 24 in. 17032 Built-in Dishwasher
Whirlpool Dishwasher: Dishes not clean. Don't think water is getting through to the jets. The water input component keeps popping out of the base of the machine. Hard to know really as everything stops when you open the door. Have cleared everything that is accessible.
Is dishwasher not fits in indian condition because of heavy water?\015\012is it so?\015\012http://www.ddipro.com ... Dishwashers
Countdown display is flashing saying 2:10 but dishwasher does not respond to pushing any of the buttons (light stays on Power Scrub and does not respond to selecting other wash cycles). On'Off button works but none of the other buttons responds. Machine does not begin washing when door is closed
... Bosch SHE6AP0 Builtin Dishwasher
I have a Bosch Exxcel dishwasher which runs the drain pump constantly even with the door open and despite there being now water in the machine at the cycle wont start. I have checked the warer amtrix and the ffed hose to the sump for blockages. The float switch operates OK but when the water drains down the float drops and the water is pumped in, then the float rises and water leaks out and the drain pump kicks in again and no more ater will come in unless you push the float down. Inside the bas
I am not sure about this model but most models run a drain cycle for a set period at the start of a wash cycle and then move on to normal filling and cycle of machine provided the various switches are at the low level it will carry on to its set cycl ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher
I have a stainless steel Kitchenaid dishwasher and the door drops hard when I open it instead of requiring you to push it down if you want to open it fully. Seems like a spring is broken. Any ideas?
There a good chance the springs popped\015\012or the ropes came off the pullys take off the toe kick and peek in on the edges you should see exactly whats going on ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher
I have a linea dishwasher model LDW 3SS i think it is about 3 years old , it used to start but not complete the cycle just stop halfway and then would only work if you slammed the door or pushed front of machine and now it wont work at all ???
Even though this is an old issue, I thought it would be good to close out.\015\012\015\012I had the same issue where the dishwasher would stop at two certain point in the program. If I'd manually advance past that point, it would keep goi ... Dishwashers
Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you
Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers
Hi, my dishwasher is a GE model PDW9280l00SS. Problem is water comes out of spinner arms but they dont spin, water presure is good too the sink. same hook up.I get thumping sounds from the inlet hose.I opened the door and pushed the switch in to watch the water to the arms hardely no water coming out.
... GE 24 in. PDW9280LSS Built-in Dishwasher
No matter which cycle selection in pushed, the dishwasher only starts up in the "normal" 93 min cycle. If I try other cycle options, and persist, I get an ER message and the cycle stops prior to the soap powder door opening and never completes the cycle. Only with turning off power for several minutes and receiving the PF message, and resetting ONE TIME that message can I then select any cycle, at which time the machine "defaults" to the "normal" full cycle. If I do not disturb that cycle, it wi
Looks like you are having a good deal of problems with the dishwasher.\015\012\015\012It will be helpful if you provide the make and model no. of the dishwasher.\015\012\015\012At this stage I can speculate the controller (ass ... Dishwashers
Our dishwasher came with our house. Brand new. It is 2 yrs old now, warranty gone. The problem is when you shut the door the machine starts running immediately and keeps running and running and running. You can push the stop button, delay button and it still runs. Also, doesn't clean. model# FDB1050REC4
... Frigidaire 24 in. FDB1050RE Built-in Dishwasher
My Hotpoint Aquarius FDL570 dishwasher door suddenly won't close properly. With a hard push my husband cal fully close it and it still works. Does this mean that we need a new closing catch mechanism? If so what's the approx cost?
My Bosch dishwasher is Exxcel 5 prg model no SMS50E020GB. When you first open the dishwasher door after the washing cycle finishes there is no water in the bottom of the dishwasher but about 45 minutes later water slowly appears in the bottom of the dishwasher. I scoup out the water and there is about 3 litres. The machine is just over 2 years old. I had a plumber check the machine and he couldn't find anything wrong with the machine. Another plumber came out and put on the invoice: "disma
... Bosch Dishwashers
My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This
By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher
I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate
Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers
My dishwasher SMS 448 works up to the point in the cycle when the dispenser is supposed to dislodge the Powerball detergent. It doesn't, and the machine stops. If I open the door and click the dispenser, the Powerball falls into the dishwasher unit itself. But when I close the door, the machine doesn't operate until I turn the knob a bit farther on in the cycle. Then, no water comes out, but the knob moves on in the cycle and the heating pipes heat up
... Bosch Dishwashers