Having problems with your Dishwashers ?

KUDL02FRSS kitchen aid dishwasher fills with water but does nothing else. It did go to the 7 blinking clean light routine which I was able to reset.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KUDL02FRSS kitchen aid dishwasher fills with water but does nothing else. It did go to the 7 blinking clean light routine which I was able to reset.


... Dishwashers

The "clean" light blinks 8 times, then there is a pause, then it blinks once. The dishes are clean but not dry, as if it has not completed the drying cycle. We had an engineer out to fix it who said it was the circuit board and that the blinking light code indicated "too much suds", he replaced the circuit board, but it didn't make any difference. It's an intermittent problem: sometimes the machine completes its cycle OK. I ran it with just vinegar and nothing else in (no detergent, no dishe


... Kenmore Dishwashers

I have a kenmore elite dishwasher, right now it seems to be stuck on the clean cycle the green light blinks on clean,, i pressed start and nothing happens i also press cancelle and nothing happens is there away to reset this or would something be broke


Hi,\015\012\015\012You can also pres "normal wash" and "heated dry" buttons back and forth till all lignts comes on, and it will reset the dishwasher and work normal again..\015\012\015\012But if you get this problem frequent ... Kenmore Dishwashers

Clean light blinked and was reset and now nothing


Bearing in motor rusted on mine. We are working on it right now. Already paid $70 for a service call. They said we need a new motor. Just looking for the part now. ... Whirlpool GU2400XTP Built-in Dishwasher

Clean light blinks. replaced thermister & unit will run after reset but water doesn't heat up to normal temp and unit must be reset to work again. what else can be done?


Hello,Welcome to FixYa.\015\012 ... Dishwashers

I have a Miele Dishwasher 2430 Sci. It's been not used for 5 months and when I returned it worked fine for several times (at least 6). NOW the intake/drain light keeps blinking. I have already cleaned out the drain and replaced it properly (there was nothing in there and it was clean). No water is coming into the dishwasher?however I know that the water hook-up is on (the first thing I checked). I turned the water on and off several times and AM SURE it's on now. What else could be


The usual course of events is to check and clean the filter, check and clean the water pump and well, check and clean the waste pipe and any connection to a sink or waste disposal system, then check the inlet warer pressure, then the machine level / ... Miele G2430SCi Dishwasher

I own 2 model KUDS01FLSS1 KitchenAid Superba Dishwashers. The first unit had the clean light blinking so I read the post below and reset it. I thought everything was fine but half way during the cyc


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

I have the kitchenaid dishwasher model #kudv03ctss0.the clean light stay blinking and when i hit the start it just blinks and then stops but the clean light stay blinking constantly.if i hit the cancel button i hear a um noise as if it going to turn on but nothing happens and the light stays blinking. what do you think might be the issue .


Dear friend,\015\012ngfam at you service! happy to assist!\015\012It's an electronic problem!The lights are called codes and need to be diagnoed by a factory service person!!We sell appliances for 65 years an ... Dishwashers

Clean light blinks 7 times, nothing else works


... Dishwashers

KUDI01TJWH0 kitchen aid....the clean light is blinking and wont do anything else....how do we reset or do we just need to take it in for repair?????


I have a kitchen aid 24" built in dishwasher that will not run and the clean light just keeps on blinking ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Whirlpool GU2700XTSB1 dushwasher. It stopped one day and cleanning light was blinking. I was able to reset the dishwasher by pressing two of the button 3 times. Now when I run the dishwasher it fills the bottom with water, heats the water and then buzzes. The wash motor does not spin. Any help?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

The clean light on my Kenmore Elite blinks and the washer will not do anything else--how do I reset the machine>


The blinking clean light is an interruption in the dishwasher program that indicates a component malfunction, or it can be a result of a momentary program glitch. If a component is defective, it's usually attributed to the heating cycle or thermostat ... Kenmore 24 in. 15142 Built-in Dishwasher

The clean light on my kitchen aid dish washer kept blinking and would not stop. after reseting it by pushing the buttons 2-3 times it cycles though and stops. then nothing works when i push the buttons. model : kudpo2crbl4


The electronic control looks for a temp. rise of 2-4 degrees. If no temp.rise control assumes a heater fault and blinks clean light 7 times. Bad heater. Water fill when completed can be no less than 1/2 inch below heater. If so, water valve probably. ... Dishwashers

No Heat Had the blinking clean light problem, reset, and it fills and runs, but element not heating. Element reads 10.6 ohms, both door switches seem to be making. What else might be causing it not to heat? Is it possible to find a wiring diagram or schematic?


Should be a tech sheet stuck to inside of the bottom toe panel.Switches may check OK with no load applied. There is also an over temperature thermostat that may be open. If all checks OK, control may have failed. ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

I have a kenmore dishwasher mdl#665.16022401the clean light blinks all the time and i push the cancel button and then wash and the start and the start button light blinks 3 times and nothing happens.the clean light is still blinking.


... Dishwashers

Clean light is blinking, have already killed the power, then called to whirlpool and they walked me through resetting it by pushing buttons, however when i attempted to run it after resetting it, it started to run then went right back to the flashing clean light. i tried resetting it again, and ended up with the same result.


You may a a latching issue. d/w not latching properly. How long does it take before the clean light comes on after you reset it. does it fill with water? if so, then your motor may be defective. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

The green clean lights blinks constantly, It will not allow me to cancel and when I try to start a new cycle the start light blinks a couple of times then the clean light starts again, but nothing happens.


... Whirlpool 24 in. GU2548XTP Built-in Dishwasher

Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"


... Kenmore Dishwashers

The dishwasher ligh blinks showing that its clean. when i go to load it and start it it wont reset, it blinks as if its clean. how do i reset it. ive turned the breaker off and nothing works.


... GE 24 in. GLD5500L Built-in Dishwasher

I have a whirlpool dishwasher thats a quiet partner 2. the cancel drain light keeps blinking and nothing else is happening. i try to unlock it and then the normal light starts blinking also and still nothing happens. i called a local repair shop and they said i need to change the control board so i did and its still does the same thing. can you give me an idea of where i need to start to fix my problem?


Can you here the pump running or check to make sure there is no water in the base... ... Dishwashers

I have a Whirlpool DU1048 that started out with a blinking clean light. I reset the dishwasher by pressing the heated dry and normal buttons twice. That worked the clean light stopped blinking. The problem now is the dishwasher seem to be stuck in the wash cycle. I finally have to turn it off after over an hour washing. Is this possibly a heating element problem? is that user replaceable?


... Dishwashers

Had problem with clean bilking light. I was able to reset with your help. But it keeps coming back after every cycle. Dishes are not drying as well. How can I fix this?


The flashing light indicates there is a heater issue caused by a failure of one or more of the following: (1) The heater. (2) Door switch. (3) Water high temperature limit switch. (4) Electronic control heater relay. (5) heater wire may have loosened ... Whirlpool Dishwashers

''Clean'' light is blinking, ''Cancel'' does not reset the cycle.


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light flashes 7 times, all\015\012buttons are non responsive ... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

Blinking lights My dishwasher has been blinking constantly " normal wash" and the "sanitize" option has been solid. When I try to press cancle it sounds as if it is starting to clean but then the noise stops and the light continues to blink. Is there anyway to reset it so my dishwasher can work properly again? Thank you


... Jenn-Air JDB3600AWP Dishwasher

Kenmore model 665.16049400 clean sensor blinking machine will not reset to start new load of dishes.have tried the cancel button. if i choose a cylce and hit start it just sits there with the clean sensor light blinking


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1667 seconds