Having problems with your Dishwashers ?

My aeg 44630 sensorlogic is stuck on same cycle how can I reset it or fix the problem?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My aeg 44630 sensorlogic is stuck on same cycle how can I reset it or fix the problem?


... Dishwashers

Had problem with clean bilking light. I was able to reset with your help. But it keeps coming back after every cycle. Dishes are not drying as well. How can I fix this?


The flashing light indicates there is a heater issue caused by a failure of one or more of the following: (1) The heater. (2) Door switch. (3) Water high temperature limit switch. (4) Electronic control heater relay. (5) heater wire may have loosened ... Whirlpool Dishwashers

Bosch SHU43C My Bosch SHU43C is stuck with the drain pump running. I ran the self-test and it gave me the fault code 4 wich indicates a filling fault. The washer is empty and all wash cycles display the correct number of minutes for the cycle. It counts down to 0, but the pump continues to run. Does this indicate a stuck float, or is the problem with the control board? Where is the float located? Are diagrams/pictures available on-line anywhere? I've done some searching, but haven't found any. R


My SHU43C is just over 3 years old. I had a similar problem recently. First, there were a few floods. Then, the Bosch only drained non-stop. Even when I used the Cancel Drain buttons the drain pump would run without stopping. When I ... Bosch 24 in. SHU43 Built-in Dishwasher

My SEG Favorit sensorlogic dishwasher model 54730 seems to be stuck in 70 intensive cycle, not sure if someone started this cycle by mistake. how can i reset it so i can start from scratch again?


... AEG Dishwashers

I have a miele g892sc+. The train/intake light comes on and holding the start/stop button for five seconds does not reset. I've cleaned the filters. But it appears to be stuck trying to drain. Since the reset doesn't seem to work it's hard to tell if that would 'fix' the problem or if there is actually something else wrong.


The END, START/STOP & TOP SOLO all flash at same time ... Miele G892SC SS Dishwasher

Dishwasher does not move into next cycle.......keeps running. I have tried to reset the cycle and it doesn't seem to fix the problem.


... Bosch 24 in. SHU43 Built-in Dishwasher

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays


... Siemens Dishwashers

I have a Whirlpool DU1048 that started out with a blinking clean light. I reset the dishwasher by pressing the heated dry and normal buttons twice. That worked the clean light stopped blinking. The problem now is the dishwasher seem to be stuck in the wash cycle. I finally have to turn it off after over an hour washing. Is this possibly a heating element problem? is that user replaceable?


... Dishwashers

I have an AEG favorit 50860 dishwasher that heats the water up on the 30 minute cycle but not on the 50, automatic or 70 cycle. Is this the heating element or some other problem and if so how do I go about fixing it?


... Dishwashers

I have a neff dishwasher that is maybe 5 years old. im pretty sure there is nothing wrong with it as it was working perfectly fine before i had a plumbing problem a few days ago. after the plumbing problem was fixed the dishwasher doesnt seem to want to fill any longer. it sounds like it wants to work but its just not filling and going thru the cycle. does it just need to be reset or something? im not sure of the model number as ive misplaced the directions for it. could you please help? by the


Look for the connection from the valve to the inlet of diswasher. Check the hot water valve to be on. It is probably closed when anyone working on the plumping. Good luck. ... Neff 24 in. S5443X2 Built-in Dishwasher

I have a Neff s4457n0gb/32 dishwasher that will not complete the cycle as it finishes on 0:01 minutes remaining on rinse and not moving to drying. I have to press the reset to clear the display to 0:00. If you've any idea how I can correct this problem that would be most helpful.


... Neff 24 in. S4457 Built-in Dishwasher

I have a kitchen aid dishwasher model # kudso1ij and it just blinks the rinse cycle button. if you try to push the cancel button it won't work. when you close the door it blink the 2 for just a brief second then goes back to the dashes. One night it just started on its own. Can you tell me how to reset it or fix this problem.


... KitchenAid Dishwashers

Hi, I have read all posts for fixing AEG Dishwasher not heating water problem. Most answers were about PCB heater relay. I have a Favorit 80860iW sensorlogic turbo, (turbo is car?) [IMG]http://i68.photobucket.com/albums/i29/savvaske35/AEG%20oko-favorit%2080860/JD800026-1.jpg[/IMG] and i treat it as a lady. Always best materials in, and dishes cleaned before input. Now, I removed door panel, also 2 PCBs inside, but couldn't find any relay to re-solder it. I am posting some photos


... AEG 18 in. Favorit F54850 Slim-Line Free-Standing Dishwasher

My AEG Favorit F65060 VI diswasher is rund thorugh the cycle but the contents are cold, wet and not fully washed. Is this likely to be a simple problem to fix.


... AEG 23 in. Favorit 50750Vi Built-in Dishwasher

Hi I have an AEG Oko Favorit Sensorlogic dishwasher, unable to read the numbers as it is approx 11 years old. I keep having problem with the on/off button not working. Have had a tradesman fix it twice now - can I do it myself rather than getting someone out? Thanks, G


... AEG 24 in. Favorit 60870M Free-standing Dishwasher

DISHWASHERHD98E I stopped my dishwasher a minute before the cycle had finished. Now when i try to start it up again the 1 minute number comes up but gets stuck on this so that the 1 minute does not end (fan can be heard working) and I am unable to reset the programme. What can i do to overcome the problem.


You have probably flooded the base of the machine and it now is in flood mode take side panel off and have a look and drain water away common fault ... Hoover 24 in. HD98E Built-in Dishwasher

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

Bosch dishwasher SGS45EO2GB/45 does not complete washing cycle. It stays at 1 min left with pump running. I have reset the machine twice at which stage the pump empties the machine and the display shows 0 mins. However, have tried it agin and same problem. Any ideas, please?


... Dishwashers

I have a westinghouse virtuoso 922, dishwasher. The problem I have is it is stuck on the fast cycle and will not change. How can I fix it?


... Westinghouse Dishwashers

Hi!, my Ariston L64 dishwasger refuses to start. It seems to reset OK when the dial is turned fully to the left. After the beeps I select a cycle and nothing happens for some time, then eventually the first two lights begin flashing together.That is as far as it goes. Can you help me fix this problem please? Donna


... Dishwashers

Hi, my Ge profile dishwasher model pdw9280n00ss changes wash modes on it's own. This is a new problem, it was stuck on normal wash for the last year. It screwed up right after the warranty ran out. The start button and the heat all seem to work. I've seen it jump between the wash cycles on it's own while washing . Is it worth fixing, I feel ripped off on this expensive dishwasher!! Thx


... GE PDW9280NSS Built-in Dishwasher

Am15 dishwasher problem: The pad will only turn on and off. Can't get it to cycle. Was on cycle 4 needed cycle 1. Got it to cycle 1, but now on and cycle does not work and when I push the off button it reboots to on. I put new pad on thinking it was the pad but same problem. Question: Is there a way to reset the board? should I be looking some where else? I cut the power at the breaker box to see if that might reset with no luck.


... Hobart AM15-2 Dishwasher

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

Hi i have a Simpson dishwasher EZIset 52B850wj*05 The problem is the timer that you pull out to turn on and change the cycle will turn but won't engauge into the different cycles. I have had this fixed once and it worked for maybe 1 month and then the same problem & I refuse to pay to get it fixed again especially if it is going to happen agian and again. Toni


HI. This will occur when there are issues that concern the timer motor. This mechanism is responsible for the forward advancement of the timer plate over the dial cogs. if the motor is faulty, it will cause the cycle to not advance correctly. If this ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

Several people have posted this problem with the Frigidaire Ultra Quiet 111, but I have seen no solutions. When it is set to wash without extra heat, it cycles normally. But when the extra-heat wash and extra-heat rinse are selected, then it gets stuck first mid-wash at the 7 o'clock position, and if it is manually advanced then it gets stuck again during the rinse cycle just before the 9 o'clock drying position. Both the wash and rinse thermostats have been replaced without solving the problem.


Hi,\015\012\015\012I know that you are going to think that this is dumb... but the only thing that it can really be is the timer....\015\012\015\012 ... Frigidaire 25 in. FDP750RC Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1575 seconds