Having problems with your Dishwashers ?

The door on my kenmore elite dishwasher will not close or lock


Answers :

Hi, the "latch keeper" has gotten out of alignment. You'll need to adjust it.
All you'll need is a Phillips screwdriver to fix this. Open the door and look at the "latch keeper" (it's not on the door, but on the frame). It's the thing that the door lock/latch grabs on to when you try to lock the door. There are 2 screws holding it in place. Loosen these, pull the keeper toward you a bit and tighten the screws to lock it in. Now try your door.
This may take several attempts to get it just right, because you want the door closing tight enough so as not to allow a water leak and loose enough for you to close it easily.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The door on my kenmore elite dishwasher will not close or lock


Hi, the "latch keeper" has gotten out of alignment. You'll need to adjust it.All you'll need is a Phillips screwdriver to fix this. Open the door and look at the "latch keeper" (it's not on the door, but on the frame). It's the thing that the d ... Dishwashers

Kenmore elite dishwasher model 665.17054402 will not lock when we close door and lights just blink


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 15129 Built-in Dishwasher

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate


Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers

2 brand new Kenmore elite dishwashers - All hookups checked and correct. Start buttons blink - cycles will not start. 1 washer ran for about 10 seconds - then the light started blinking. Troubleshooting in manual says light will blink if the door is not closed. They seem pretty closed. Dishwashers leveled and plumb. Tried it mounted, and unmounted. No Luck. Thanks


These dishwashers have a safety feature. The door has to be closed within 3 seconds of pushing the start button. If the cycle is interrupted at all by opening the door or pushing something while started you will have to push the start button to resum ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

The door on my Kenmore Ultra Wash Quiet Guard 575-D dishwasher will not lock. There is power to the machine, the door lock just seems to be jammed and will not close all the way.


Will the latch close all the way over when the door is open? If it will, check to see if the catch on the machine is loose not allowing the latch to seat all the way. ... Dishwashers

I have a Kenmore Elite Ultra Dishwasher and the cleaning light is flashing. I have tried pressing the start/resume button and closing the door within 3 seconds. I am not able to turn on my dishwasher. I have tried turning off the power for 20 minutes but when power was restored the green light continues to flash and the dishwasher will not work. This machine was installed in May 2008. Help!


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012buttons are non ... Dishwashers

I have a kenmore ultra wash dishwasher mdl nbr 665.1304 that wont close. the lock appears to be stuck but the door is open and i cant get it to close. any help would be appreciated. i am a single m


... Kenmore Dishwashers

I have a kenmore 15632 and my problem is that the dishwasher has power and as soon as i close the door the lock on lights up but when i go to press start it will not start. Now we tried unplugging the dishwasher and plugging it back in but we still get the same result. if any one can help it would be well appreciated.


... Kenmore 15632 Built-in Dishwasher

I have a 2006 Kenmore Elite built in dishwasher and the start light works but when I close the door the dishwasher does not start.


Check the door switch continuity and power contactor or the electronic or mechanical timer. ... Kenmore Dishwashers

Noisy dishwasher my Kenmore quietguard 4 has developed an exceptionally loud hum/buzzing noise seemingly coming from the door of the dishwasher, when closed, locked and put on either drain or wash cycle.If the unit is allowed to sit for 1-2 days, the drain cycle will empty the tub without the buzzing noise starting. If anything else is attempted afterwards, like a wash cycle, the noise immediatley starts at a low level, then becomes steadily louder, until the full volume is reached, and does not


I have aloud buzzing nose and humming what is the problem ... Dishwashers

I have kenmore elite dishwasher model 665.1312 I fell on it when the door was down and now it will not close. I need written instrustion on how to get the door or hinges off so I can see what to do


... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I've had an LG LDF6810ST dishwasher for about three years with no problems. All of a sudden it won't close. It finished the wash, I emptied it, and when I went to close the door it wouldn't close all the way. It was as if something was getting caught not allowing the door to close completely. I searched and found nothing blocking, then I looked at the door latch and it looks as if the child lock feature is engaged. So the door is locked while open. I turned the child lock on and off through the


If all else fails.... kick it! at least you will feel better! ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Our Kitchenaid dishwasher model # KUDP021R will not start. We close door, select wash and press start. The control lock light at the top which is lit flashes a few times and then stays lit. Dishwasher remains silent. An aside which may be helpful is that the door has always seemed to be not quite straight...as though it had to warp a tiny bit to close and lock.


The problem you have already identified could be the door switch is not closing when you shut the door. Please confirm your dishwasher is KUDP02I (i and not 1).\015\012\015\012One way to check is find out the door switch on the door panel ... KitchenAid Dishwashers

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

When opening and closing our kenmore elite dishwasher the door springs make an awful creaking sound, how can this be fixed


Liberally lubricate hinges, spring and any other relavant parts with WD-40.\015\012\015\012Charlie ... Dishwashers

Dishwasher will not operate. Kenmore 665 13592K600. Quick Rinse, Heavy Wash, Heated Dry, and lock lights operate. Other lights do not come on. Door is closed tightly.


Control panel ... Kenmore 24 in. 16032 Built-in Dishwasher

We have started experiencing a problem with our Kenmore Elite 655.15982 dishwasher. Each time we close the door, NoHeatDry lid would go on immediately. It would stay as is of would go flashing. If you touch any button, LockOn lid would go on. Then no other buttons would respond. And often both NoHeatDry and LockOn indicators would be flashing... We tried turning machine for an extended time on the fuse, etc. At times it would work for some time and then cycle get stuck again at the same p


These errors are due to a faulty control board and needs to be replaced. If its still underranty get it fixed before it expires as it is a costly repair to replace. ... Dishwashers

Dshep I have a kenmore elite model 665,16912 dishwasher , when i try to do normal wash a J appears in the time window i don't think the door is locking


... Kenmore Dishwashers

I have a Kenmore Elite dishwasher with electronic controls. When I set the controls press the start pad and close the door it will not start. The light on the start pad just continues to blink. This happened about six months ago and the Sears serviceman pressed two of the control pads simultaneously and this reset the controls. Everything worked after he did this. What are the two control pads that you press to reset the controls?


This is difficult to find out. Try different combinations. Otherwise get the information from the SEARS serviceman. ... Dishwashers

I Have DU890SWLUD dishwasher that the door locked before the door was closed and now I can't get the door too close how do I get the door lock to release?


... Whirlpool Dishwashers

Kenmore elite dishwasher runs until it is manually shut off by opening the door? My Kenmore Elite runs continuously until I manually drain (cancel) the cycle. Then I have to rewash with no soap to simulate the rinse and again manually drain (cancel) the cycle. This was a $650 dishwasher. I am not sure how to reset the controller or even trouble shoot for an error code. Any suggestions?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Close the Maytag dishwasher, cycle starts, but I noticed a leak! Dishwasher door can be opened by putting your fingers on the edge and pulling it open. Tried it again, door clicked, thought it was ok but still could open door with fingers. Emptied the washer, door locked. Put in a few dishes, same problem


Your problem appear to me like it come from your upper basket .\015\012pleas try 1st to ensure the basket goes inside\015\012untill the end it is important..\015\012 thank you ... GE Dishwashers

Hello! I have a Kenmore Dishwasher Model # 665.15805890. The dishwasher came with the house and I'm guessing it is around 10 years old. My toddler was having a great time flipping the door to the soap dispenser back and forth until he pulled the door off of the pin. Now, I can't seem to position the spring in a way so that the door will spring back. I never looked closely at the hinge before, so I don't know if that is the only reason the door will not release the detergent, or if something


Hi.Please see if the diagram here can help you. Check if the spring is that indicated with nr ten in diagram. ... Kenmore Dishwashers

When I close dishwasher door, I have to press hard to lock the door. Is this normal?


Check the catch where the door clips into. It might be loose. If so tighten the two phillips screws, then try to close the door. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2081 seconds