Having problems with your Dishwashers ?

Is there a way to get the water is described in the video out of this dishwasher. Kitchen aide w103111238

\015 \015

Answers :

I like the way you call the fishies in your washer! Seriously, there are three probable causes. First, pull off the spinner, bottom plate and yank the filter screens. Clean them thoroughly and look for clogs below them. Next, look for the water level sensor that detects water in the bottom and keeps the flush pump running as long as there is. Make sure it cycles up and down. Finally, make sure you hear the pump running when the draining cycle starts...
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Is there a way to get the water is described in the video out of this dishwasher. Kitchen aide w103111238


I like the way you call the fishies in your washer! Seriously, there are three probable causes. First, pull off the spinner, bottom plate and yank the filter screens. Clean them thoroughly and look for clogs below them. Next, look for the water ... Dishwashers

I have a Kitchen Aid KUDS03CTSS3 dishwasher. Dirty water is staying at the bottom and nothing comes out the drain hose during the entire cycle. The drain hose is looped above the kitchen P-trap, although for a time it wasn't. I use a wet vac to get the water out but there is still water below the fine filter. I thought if I could get the fine filter off, I could clean out the bottom as I think that it's full of crud down there that may be blocking things. I can't figure out how to get the l


Hi,Thanks for the follow up. I am glad it worked out for you. If I can Help in the future let me know. http://www.fixya.com/support/c64627-kitchen_aid ... KitchenAid 24 in. KUDP02FR Built-in Dishwasher

Is there any way to get more water or higher pressure to my Frigidaire 300 Series dishwasher? The water in the kitchen has good pressure, but we can't get enough into dishwasher. Chip


Make sure the water supply valve to the dishwasher is fully open. There may be a internal main valve trouble restricting the water flow. Disassemtle to fix.\012\012Dishwashers are typically filled by one of two methods: ( ... Frigidaire Dishwashers

I have a kitchen aid dishwasher. The upper spray arm is getting water and getting enough water pressure but wont seem to spin. Ive ran a lot of tests but nothing. ive cleaned out the spray arm and port that gets water to the spray arm. Cant seem to fix it. Any ideas?


Hi,When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher Spray Arms not Spinning ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Hello, I have a Kitchen Aid dishwasher, model KUDS30IVWH3. The dishes have not been getting as clean lately, the bottom is decent but the top rack is not getting very clean. Also, when I open the door after the cycle is done, there's a bunch of detergent at the bottom of the door and on the floor of the dishwasher, like it isn't getting sprayed all over or something. Don't know if I have to check the water intake valve or if maybe the sprayers could be partially clogged.


... KitchenAid Dishwashers

Hi, My dishwasher keeps stopping mid cycle and the door pops open. The soapy water is always gathered in the bottom and there's no way for me to get rid of the water, unless i restart the full cycle. The dishes are all getting stained with white marks, even though the salt and rinse aid is filled. Please help!


Sounds like the latch is worn out you mabe able to get a new one at appliancezone.com.... also check the drain for debris ... Baumatic 23 in. BDW9 Built-in Dishwasher

Not getting any water into the kitchen aid dishwasher


It could be the water inlet valve. that is definitely a DIY job.\015\012but first i would check out the float inside the machine. if it is stuck in the up position, no water will enter the machine. it will assume that it is already full of water. loo ... KitchenAid Dishwashers

Kitchen Aid model KUDS01FLSS3, water gets pumped into bottom of dishwasher but when the cycle needs to change to shoot the water over the dishes nothing happens. When the cancel button is pushed all the water will drain.I have cleaned out the bottom drain compartment that was jammed with calcium build up and guck. Would this be a pump /motor problem or electrical circuit board problem?


... KitchenAid Dishwashers

Kitchen Aid model KUDS01FLSS3, water gets pumped into bottom of dishwasher but when the cycle needs to change to shoot the water over the dishes nothing happens. When the cancel button is pushed all the water will drain.I have cleaned out the bottom drain compartment that was jammed with calcium build up and guck. Would this be a pump /motor problem or electrical circuit board problem?


... KitchenAid Dishwashers

My Kitchen aide dishwasher doesn't seem to be spraying water during a cycle. It fills with water but that seems to be all. also is there some where that I can go to get a trouble shooting manual


This could be due to the sprayer arms not moving. Try to get these out and clean them. If the holes are blocked these will not move. \015\012\015\012You might find the correct manual for your model at this site\015\012\015\012 ... KitchenAid Architect? II K SERIES KUDK03IT 24 in. Built-in Dishwasher

I have a kitchen aid dishwasher that is stuck on the clean cycle. It will drain water, but no water seems to be getting into the washer. If i push the start button, cycle will not start. The clean light is the only light that will stay on. the other lights will go on, but they eventually go off without starting the cycle. Is this the thermal fuse???


... KitchenAid Dishwashers

Dishes in the upper rack no longer get cleaned. I've been using this dishwasher since 2004 (purchased new), and have not changed the way I loaded the dishes or the detergent. I called the Kitchen Aid help line, and the rep simply read the owner's manual to me (e.g., stand a glass of vinegar in the dishwasher and run a cycle), which did not address the problem. Any idea what I need to do? Thank you!


It may be full of crud under screen. Remove lower spray arm, tower up to top, covers and you will see where the entrance to the impeller is full of stuff. ... KitchenAid Dishwashers

My kitchen aid kudp02cr8s dishwasher doesn't seem to be getting water to the top rack and the glasses are not getting clean. How do you clean the filter?


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Kitchen aid dishwasher kudk031twho gets water drains but will not clean


... Dishwashers

Kitchen aid dishwasher is not getting water


... Dishwashers

My Kitchen Aid KUDS01FLSS2 dishwasher does not spray water thru the wash arms nor do they seem to turn. Additionally, one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" when rotated by hand. The spray arm assembly appears true on visual examination. The unit fills, cycles and pumps out in an apparent normal way. While on this site a while back I was advised to clean the unit and referred to a downloadable repair manual that was, in fact, not


Hi.The fact that "one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" would suggest a tubing problem. However there are more faults that will result in no spray. Testing in this case can be ... KitchenAid Dishwashers

I have a Kitchen Aid dishwasher and the funnel Tube that connects from the water source to the rotary arm has rotted. How do I get a replacement?


... KitchenAid 24 in. KUDP01DLBS Free-standing Dishwasher

Water not getting in dishwasher Kitchen Aid push button - I heard there was a valve and screen, but not sure where they are


... KitchenAid KUDS301V 24 in. Built-in Dishwasher

Freezer not getting cold, dripping water - KitchenAid Kitchen Aid Superba Series Dishwasher Used Kuds011jbt0


... KitchenAid Kitchen Aid Superba Series Dishwasher Used Kuds011jbt0

We have a Kitchen Aid dishwasher model number KUDK03CTSS3. It's only about 3 years old, but the dishes on the top rack do not get clean. We thought maybe it was water not coming out the top, or food stuck somewhere, but do not know how to fix it. Any help would be greatly appreciated.


Had a simular problem, used product called dishwasher magic to clean it well and that took care of it. I got it @ walmart in the diswasher detergent area. Also be sure you are loading according to the manual. I now use lemi shine in every load fo ... Dishwashers

Each year when we get back from vacation the Kitchen Aid Dishwasher KUD J230YWH1 will run but the water won't drain out.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

Kitchen aid dishwasher kudk031twho gets water, drains, soap will not disolve, runs thru all cycles, once the clean lite flashed 7 times, after reseting code never happened again.


... KitchenAid Dishwashers

Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst


... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher

I have Kitchen Aid Dishwasher Model # KUDMOITJBLO. We began having trouble with the top rack coming out of the brackets on the upper rack track. Kitchen Aid sent me 4 parts # 8268785. The problem is that the brackets that they sent have wheels on them. I don't know how to get them into the track. A call to Kitchen Aid got me no where. They claimed that they don't sell parts so therefore they could not help me (with the parts that they sold me). The situation has gotten progressively worse.


I removed the tracks from inside the dishwasher.  Then I was able to carefully remove the endcaps (something I had not been able to do previously) carefully.  The existing broken wheels slid out and I slid two new brackets into each track. ... Dishwashers

My dishwasher was moved for kitchen rennovations. When hooked back up again it would not fill up. It will run through a cycle but no water enters. If I squeeze the rubber hose that leads from the electronic valve to the tub it gets hot indicating that I am forcing hot water through the line. If I pour water into the tub it will wash the dishes but at the final 6 minute point it will go no further, I assume because it is not getting rinse water.


Hello,\015\012Make sure that a wire did not get bumped off of the soleniod valve. It sits usually on the bottom front left hand corner of the dishwasher.\015\012If the wires are both on the valve then the valve may need ot be replaced... ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2722 seconds