Having problems with your Dishwashers ?

Hey, i have an Asko DW 20.3 dishwasher and i need a new electrical board, water dripped on mine through the soap dispenser and burned out? what is the correct part number?

\015 Need electrical board part number?!\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hey, i have an Asko DW 20.3 dishwasher and i need a new electrical board, water dripped on mine through the soap dispenser and burned out? what is the correct part number?


... Dishwashers

WHAT ARE THE THERMAL FUSE SPECIFICATIONS FOR KENMORE ELITE MODEL 66513122K701SERIAL NUMBER FY1211868 AND WHAT IS THE PART NUMBER FOR A THERMAL FUSE KIT? WE HAVE HAD TWO FUSES BLOW AND THERE DAMAGE TO THE WIRING ON THE LEFT HAND SIDE OF THE CONTROL PANEL THAT CONNECTS O THE SWITCH. THEIR IS DISCOLORATION ON THE PARTS AND WIRING. WE HAVE SEEN EXPERTS STATE THAT IN ORDER TO CORRECT OUR ISSUE WITH THE FUSE BURNING OUT WE NEED A THERMAL FUSE KIT AND WE NEED THE SWITCH AND THE WIRING THAT CONNECTS TO


Http://appliancejunk.com/ge/dishwasher/31-9137.pdf\015\012\015\012A ... Dishwashers

The soap dispenser on our Kenmore Elite dishwasher (SEARS part number 8558128) will not stay closed. The little latch mechanism appears to be working, but the spring on the lid's base keeps the lid wide open at all times. I have examined the pop-up dispenser lid to see if some sort of plastic tip held by the latch after soap is added is broken off- this may be the case but I cannot see any damage where such a lip may have broken off. Does the latch catch the lid by snapping onto a plastic lip? I


Yes its probably the little latch that holds the door closed thats worn out. ... Kenmore 15762 Dishwasher

Soap dispenser releases hardened soap from dispenser down inside of and front of dishwasher and down front of inside of door and does not clean dishes on top and bottom racks. How do I correct the problem so dishwasher dispenser will act correctly? Thsn you.


You can either change out the dispenser itself, possibly bad door not full opening, or use a different detergent. Make sure you water gets nice and hot as well. ... GE Dishwashers

My Viking DFUD042 dishwasher soap dispenser release is broken. The soap dispenser does not close. Can I replace only the latch or do I have to replace the entire soap dispenser? Where can I get the parts? Thanks, Robbie


You will need to replace the entire soap disp. You can find it at marcone.com w/ your model # ... Viking DFUD042 Built-in Dishwasher

Need new detergent cup dispenser for Model KUDI220T4. The detergent cup dispenser (Part number AP3042989) has been discontinued. Need to find the replacement part and directions on how to remove existing detergent cup dispenser and install new detergent cup dispenser.


... Kitchen and Much More Dishwashers

I have a Kenmore Ultra Dishwasher. The bottom arm spins, the top doesn't, although water drips out. The water fills up under the heating element. The top dishes aren't getting clean and the bottom aren't as clean as they used to be. I also noticed that the soap dispenser is open, some of the soap is gone, but there's still some soap in left in the dispenser. This never happened before and it happens all the time now. Thanks for any help you can give me!


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Replaced spring on inner door of dishwasher for soap dispenser. How do I connect the soap dispenser mechanism correctly to the control dial? It only runs partway through the cycle and then locks up


... Whirlpool Dishwashers

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

When I first contacted you, I couldn't get the soap door to close in my dishwasher. As suggested I got the part. I now have the door apart. When I work the soap latch I can't see what closes the door. The part I was going to replace seems to be working correctly. over


Well IF the piece, the latch, seems to be working OK, then the only other thing it can be, is the Electronic "Drive" from the controller board, or a disconnection between the Controller and the Latch, Sometimes it can be a "Sensor" not allowing the ... Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Hotpoint aquarius fdf780 dispenser solenoid part number?


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I need to replace my Frigidaire dishwasher detergent/rinse dispenser part number 154574401. How do I remove the old dispenser from the door? Are there screws or does it simply pop out of the door?


The dispenser is usually mounted by a series of screws from the INSIDE of the door panel. You need to turn the breaker off to the dishwasher, open the door, and remove the inside door panel to access the dispenser. There also should be a couple of ... Electrolux Dishwashers

I have a KitchenAid but model # KUDI24SEWH1. Can not find it on your list although another model without the last letters 'WH1' is on it. Anyway, my nephew ordered the parts he said needed to be replaced. One was the top water feed tube and bearing which he had no problem replacing when the part came in. But, he is having a very difficult time opening up the front door to replace the soap dispenser. Removed the 6 screw (three on each side) and the two at the top of the door but that is as far


You don't Use the WH2 just the first 6 letters and numbers.\015\012Jim ... KitchenAid KUDI24SE Built-in Dishwasher

I have a Frigidaire FDB125RHBO. The spray arm tower assembly is not working correctly it appears to be loose. The spray arm is not going around as near as I can tell. Water is going in the dishwasher fine. The soap dispenser is opening but there is still soap on everthing at end of cycle.


... Dishwashers

It seems we are having issues with our soap dispenser opening correctly. The last couple times there has been a solid block of detergent sitting in the dispenser when the cycle is finished. We have been keeping our detergent in the cupboard, not under the sink where it could get too moist. We then ran a cycle with a liguid detergent, and it was barely touched. There was gooey liquid all over the place when the cycle was done. A change on the settings to "Heavy Wash" left detergent residue on


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My maytag dishwasher MDBH970AWQ Quiet series 300 is more and more often not opening the soap dispenser. Also the number 9 flashes and can't seem to get it to go away. If I try to start the dishwasher over again with the hopes of the dispenser opening the dishwasher just runs for the countdown of 9 to zero. Help!


... Dishwashers

My AEG 60820 dishwasher is continually having dirty dishes, and the soap dispenser only half empties. Have cleaned filters and ensured plates are stacked correctly but am still getting dirty dishes and soap residue on crockery


Buy a new one. Whirlpool, Kenmore,or MayTag ... AEG 24 in. Favorit 60820W Free-standing Dishwasher

The dishes are not getting cleaned recently, and the soap dispenser isnt opening and closing correctly. The soap is getting hard in the dish. What can I do?


I would either replace the soap dispenser and/or make sure your water temperature is hot. If it's not hot, your heating element may not be getting the water hot enough to fully open the soap tray or clean the dishes. ... Miele Incognito G818SCVi Built-in Dishwasher

Hi, I have a Fisher Paykel DD603I (integrated) dishdrawer unit. The bottom drawer soap dispenser has water in it after it runs (and leftover soap), and there is a small amount of water sitting in the bottom of the drawer. The dishes don't get totally clean. I have removed and cleaned the spray arm, drain filter, filter plate and bottom of tub. Found nothing clogged or particularly dirty. Put all the parts back in and everything moves freely. Ran it empty, and same problem occurred.


Hi Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doe ... Fisher and Paykel Dishwashers

Model number dwu8260 AAX serial number 1308716fy bought in1/93 The soap dispenser inside the machine does not open when the wash cycle starts.


... Maytag Dishwashers

May tag jet clean model number DWU 9921. Dishes not coming clean soap dispenser opens but soap soes not come out. Disges are still wet after heat cycle


Sounds like you have the stripped emacorator and pump head..\015\012http://www.appliancepartspros.com ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

We have an older Kenmore Elite 665. Recently it the dispensing cup for liquid detergent is not opening at the correct time. At the end of the cycle the dispensing cup is open with remnants of detergent still in it and white soap stain down the door. John


It appears your timer/main controller/CCU or wax switch in the dispenser has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a three year old Whirlpool Dishwasher DU1148XTP which is making a load flickering noise when it release the soap during the wash cycle. I removed the front panel and looks like it small solinoid that had a part number 91127.00.1404504 120V 60Hz making all the racket. So my question is could it be as simple as just replacing this part or is there more to this problem?


Yes due to voltage fluctuation you need to change the fuse..... ... Whirlpool 24 in. DU1148XTP Built-in Dishwasher

The soap dispenser cover for the main wash section has broken. I think that is why the dishes are not getting clean because the soap is washing away with the first rinse. I cannot find where to get a replacement part.


... KitchenAid 24 in. KUDK02CRBS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0989 seconds