Having problems with your Dishwashers ?

Can I remove the base that came with my dryer? Mine is not a drawer?


Answers :

As long there are feet on the bottom of dryer
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can I remove the base that came with my dryer? Mine is not a drawer?


As long there are feet on the bottom of dryer ... Dishwashers

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

Kitchenaid kuddo1dppa I own a KitchenAid KUDD01DPPA, 2 drawer dishwasher. I am not a technician, however I have had a lot of experience in repairing various appliances and am savvy with electronics and mechanical technical issues. Here's the problem: I was getting rinse error codes in both drawers, pulled the bottom drawer out, removed the cover to the circuit board and used a dryer to dry up the moisture on the flood switch. Now I am getting Fill Failure error code on both drawers. I have g


Test this steps and fix it. God bless you\012 \012 Water Inlet Valve\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Miele Dishwasher Model G1040, Type HG03, NR: 32/65143704 The machine is three years old. The cycle reaches almost to the end, then all three LEDs merge together, and the pump runs continuously, even with the master switch off. I have taken the machine out and removed the base plate. When I first took the machine out of its position, I tipped it backwards and water came out of the bottom. All hoses and parts in the bottom section seem perfect in every way but the inside of the bottom plate indica


... Dishwashers

The spray arm in my single drawer dishwaSHER was not turning freely When I removed the racks I found that the little blue impeller at the centre of the base plate was jammed. How do I release the baseplate so that I can see what's going on there seem to be two locking rings round the impeller--but I cant shift them. Any advice? Or do I need a techy?


You will need a special tool to relese the 2 rings at which point the impeller will come loose. Not sure if you can purchase one over the counter. Possibly a set of snap ring pliers may do the trick but not 100% sure. I you dont have any availbale ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The top drawer in the wash cycle after starting will only run three to four minutes and it drops into pause. have to go and push the start button again for the cycle to continue a few more minutes before it drops out. and I have to do the procedure again. The cycle continues where it left off. I had an issue with a missing rubber gasket initially. The service person came out and removed the front, and this is when the problem started. It might be a coincidence. The repair person does not wish to


\015\012\015\012\015\012\015\012If the cycle doesn't complete, or pauses again n again in between then check these:\015\012\015\012\015\012Water-heating cycle\015\012\015\012Many dishwashers heat the wash and/or ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

DS603 Fisher & Paykel U1 error code ..(see our previous errors we've listed) we have now pulled out the yellow water valve that goes up behind the front panel and at the other end by removing the drawer and plastic protector thingy - we checked that there were no bedris or calcium buildup in the valves ends and filters and replaced it all. So we put it all back to gether as we could not see what would cause this error, only to find that it worked - water came into the machine but about 4 mins in


This product is total ****.\015\012Pull it out, call whoever sold the **** to you\015\012and tell the to come get it and shove it up their ***.\015\012Then buy a Bosch and live a happy life.\015\012The design is moronic. The machine is like the old\ ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

Just looking for some advice on removing the drawer from my servis washing machine, sorry I dont know what model it is. I need to clean the powder drawer but cant find any way to remove it from the machine. There is no internal part marked push that i can see and im wondering if i need to unscrew the four screws around the drawer. Help please! Cheers


Send an email to this address asking for the user guide for your model \015\012\015\[email protected] ... Servis Dishwashers

Our Fisher & Paykel single dish drawer unit (6 months old) is leaking limited water from its base down the front of bottom drawer below the unit's base onto the kitchen floor. One inspection by a technician failed to find any rectifiable problem. Unhappy, Wicks Road North Ryde


One drawer leaks can cause this problem. If you don't fix it. One day it will turn on the pumps from both units without any one touching them since the floor sensor at the bottom housing detects water and it will run for ever until you unplug the pow ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Hotpoint HDA3500N dishwasher and need to replace the base spray arm. I can not get it removed to put in the ge replacement spray arm model #WD22X10055. I'm afraid I'll break my dishwasher trying to remove the base spray arm


... GE Hotpoint HDA3500N Dishwasher

I have a Hotpoint HDA3500N dishwasher and need to replace the base spray arm. I can not get it removed to put in the GE replacement spray arm model #WD22X10055. I'm afraid I'll break my dishwasher trying to remove the base spray arm


... GE Hotpoint HDA3500N Dishwasher

I have a dishlex global 300 on which I removed the front cover a black wire came loose and I didn't know where it came from thanks to jyackle5 I have fixed that issue. The problem I have now is the eco light flashes and that's it (nothing else functions). I removed the front panel as the bottom door seal had blown and junk oosed behind the front panels I washed the junk out and cleaned the hole washer while I was at it the bottom of the washer (where the heating element is) over filled so I tipp


Easy fix, Use a bit of force and pull the dishwasher out.Get a few towels and tilt to the left. Water will drain out. Push back in. wait 10 mins and turn on.\015\012\015\012\015\012\015\012Regards ... Dishwashers

F2 code. Followed listed guidance of removing assmebly and checking...unfortunately, however, my impellar has separated from the rotor assembly and the rotor assembly is stuck in the drawer. I tried to pull up on the shaft with some pliers, but that didn't work and I didn't want to pull too hard and cause damage. Please advise as to how to remove the broken rotor assembly from the drawer. Thanks


There are no wires underneath the rotor - it is just suspended in the cavity. So you cannot do any damage except make scratches around that area. Maybe take a straightened wire coat hanger and insert from the side hole in the filter sump area. You mi ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

DD603 upper drawer pump rotor will not turn - F2 error. Was completely siezed. Removed rotor and got the shaft to turn with pliers. However it does not spin freely and still shows an F2 error. Does anyone have a repair manual so I can figure out how to remove the pump? Lower drawer had an F1 error (due to the upper leaking/F2 error) and this website helped me fix that problem.


Maybe you dont have to remove anything else.. try the rotor from the bottom drawer first. If this works just buy a new rotor.. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

We have a Fisher& Paykel dishwasher with 2 drawers -- one on top of the other. Model DD603. The bottom drawer works fine. But the top drawer is not working properly -- it repeatedly stops in the middle of the cycle and there is water left in the drawer. Previously when this happened, we called a repairman; he removed the top drawer from the machine, said it was "off track", flipped some lever, and put the drawer back. He seemed a little embarrassed by having to charge for a service call for


Are you able to provide a bit more information on what you see when the dishwasher stops in the middle of the cycle -\015\0121 - is it displaying the time remaining in the cycle and is it always the same time?\015\0122- do you get any fau ... Dishwashers

The top drawer is leaking apparently from calcium and/or lime deposits on both the top of the drawer and the rubber gasket on the lid. I need to get the drawer out but can't see where to disconnect the hoses to allow for drawer removal.


There are small tabs at the front of the drawer.. one on each side, down at the bottom of the drawer... push in on those tabs. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The upper and lower dish drawers leaves a puddle of water under each (maybe 6" in diameter) after the shortest cycle. There is a small amout of water left in the clear protective housing on the underside of the upper drawer. There is a hole at the bottom of the housing that lets the water out. Maybe there is a slightly loose hose? If so how do you get the housing off and tighten it? I presume the lower drawer may be doing the same thing, but I can't see it with out removing the drawer. How do yo


The drawers slide on a pair of rails on each side of the housing.\015\012\015\012see installation manual pag ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

How to take or remove drawers out of 2 drawer Fisher Pakel


Hi, welcome to FIx Ya...1. Unplug machine.2. Slide drawer open, remove two pegs that secure front panel to drawer (one on each side of drawer)3. Slide front panel down and out, remove green ground wire.4. Depress tabs th ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

How do you remove the drawers on a kitchen aid 2 drawer dishwasher?


... KitchenAid KUDD01DSSS Built-in Dishwasher

DD603 Double drawer dishwasher: How do you take the clear coverplate completely off the top drawer in order to replace the motor? I can't figure out how to remove the part that attaches to the front of the drawer.


I am assuming you are fully conversant with the unit and have taken out the drawer from housing rail.\015\012\015\012To get the wiring cover off you then have to..\015\012Carefully release the four wiring cover clips from the fro ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

The bottom drawer on our DSC 2 drawer built in dishwasher does not clean on any setting. The top drawer cleans just fine. It's not the removable filters as we have made sure they are clean.


... DCS DD-124PH Built-in Dishwasher

I have a mdd8000aws dishwasher. After a power outage (2 days) the power came back on, and the bottom drawer no longer works. It still make the chiming noise when the drawer is opened, but the control panel is not fully lit up and the washer will not start in any mode. The lights seem to flicker for a short moment and then they all stay very lightly lit up. Is this just a bad control panel or is there some other circuit that needs replaced? BTW, the top drawer works perfectly.


... Maytag MDD8000AWS Builtin Dishwasher

I have a Fisher and Paykel dishdrawer model ds603. Not sure eactly what happened but my son says that the cycle stopped last evening (and only tells me this morning!). Dishes though appeared to be clean and there was a small amount of water at the bottom. I tried opeing the washer and it was hard to open as though the drawer was stuck on something. I removed the drawer and checked the rollers and they are fine. I realised then that the drawer is getting stuck on the inside lid that provides the


The best thing to do is to remove the rack,drawer completly,and close it up,see if it will come on,and run all threw the cycle.If it does,then put the rack,drawer on the track.The rollers could be,well,not snapped all the way on.It will be in that ar ... Fisher Dishwashers

Fisher Paykel top drawer lid interferes with opening and closing of drawer. Have top drawer removed for inspection. What to look for?


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I bought a used 7 1/2 year old fisher paykel dd603 for my tenant, it worked fine the first time. second time she got F1 code on both drawers. water was in lower pan, we sopped it up and dried it out. also drawer was not seating level but was lower on left side, and insulation had fallen off left wall. all now corrected. but now the top drawer leaks onto floor on left side. it did not leak before repairman came out, we checked thoroughly. repairman says top lid not seating properly and i need ne


I have the same model F&P and just experienced similar problems. My top drawer was leaking due to that "not important" thin white tube. It really sounds like you called a general appliance guy and not a trained F&P repairman. The guy who fixe ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0704 seconds