Having problems with your Dishwashers ?

Zanussi zsf 2400 dishwasher stops in mid cycle

\015 Why does my dishwasher stop in mid cycle?\012it works OK for a time then it will just start to drain the water\012and if you open the door it will still be draining which it should not do as when you open the door cycle should stop\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Zanussi zsf 2400 dishwasher stops in mid cycle


... Dishwashers

Door opens mid cycle on Zanussi zsf 4126 slim line dishwasher, thus dishwasher stops running, any ideas what causes this ? Thanks.


CHANGE YOUR SWITCH ASSY (DOOR LOCK ASSY)01179512835 ... Electrolux Dishwashers

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

Kenmore Elite - 9 Year old Dishwasher - A circuit blew and the dishwasher stopped in mid-cycle and did not drain.... I reset the circuit breaker and "manually" took the water out of the dishwasher. When I push buttons to restart the "95" shows up for the normal cycle. However, when I push start the "95" becomes a "--". Suggestions???


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

KUDS30IXBL My dishwasher stops mid cycle. Technician said it was too many suds and cutting off. I use cascade and jet dry and nothing else. There has been no other soap in the dishwasher. After it cuts off on normal (soap dispensed) I restart on light/china with no detergent. Sometimes it runs through with no problem and sometimes it stops with all lights off. Any suggestions? I have already had technician out twice for other problems with this dishwasher that is only 2 years old and don


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

My Maytag dishwasher MDB6759AWS3 just stopped working. I had to stop it mid cycle and then I pushed cancel drain and now some of the buttons light up but not the start button


... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Dishwasher stops mid cycle


Hi,\015\012\015\012Do the foll. things:\015\012\015\0121)Check if there is water on the bottom pan. Remove the panel down on the backside of the machine and look. If it's water there, wipe it well up with a towel or so.\015\01 ... Asko 24 in. D3120 Dishwasher

Why does our dishwasher stop mid-cycle?


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Washing up liquid put into dishwasher, had to stop in mid cycle belling BID602 now wont stop stuck in wash cycle


... Belling Dishwashers

Our LG 6810 dishwasher has stopped cleaning. After the cycle the dishes are wet and covered in greasy clumps. We ran the test cycle and got the following: 3H/U3 11 22 33 44 55 66 04-2 32 33 0 (inlet valve) 35 36 37 38 23 (Thermistor) 3A 3A (beeped twice and showed 3A) 3A (beeped twice and showed 3A) Any advice you could give me would be appreciated. I have the service manual but have never done any type of dishwasher repair. I'd like to not have to replace this dis


1.) Take racks out of unit.2.) put both of the spray arms in the 12 o'clock position3.) Run the washer,once the washer has started wash cycle,open the door and ensure the spray arms have moved off of the 12 o'clock position. Write down re ... LG LDF6810 Built-in Dishwasher

Hello, my Frigidaire Professional Series dishwasher (AquaSurge with SpeedClean) gives me error messages; it does not allow me to use any setting other than normal wash; it stops mid-cycle; it needs to be reset - either on the appliance itself or by tripping the breaker. I am never sure that the dishwasher will complete a cycle. Thank you for your assistance.


... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Stops mid cycle often Our westinghouse 905 dishwasher often stops at the rinse part of cycle, flashing lights, water sitting in base of ...


... Westinghouse Dishwashers

Kenmore elite dishwasher stops in mid cycle w/ normal wash just blinking and the control buttons will stop responding. At times you will get lucky the cycle will finish. Also included with this problem the soap dispenser actuator overheated and burned.


... Kenmore Dishwashers

I have a Kenmore 665.1373 Ultra Wash dishwasher that will not work. In the past few weeks, it stopped mid-cycle, the the clean light began to flash. Sears sent out a technician who told us that the latch was not catching. He adjusted it, did something with a computer and the dishwasher worked for a couple of days. This time, it would not start a cycle, it would only show heated dry if you pushed the smart wash button and nothing if you press start. It looks like some of the lights are continuous


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My Frigidaire dishwasher stops in mid-cycle and the "Hi Temp" &" Air Dry" lights blink on and off together. This happens no matter what cycle i begin with. I cut the power to the dishwasher for ten minutes and rebooted, but still received the same result.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Amana Dishwasher dishwasher will fill with water, then will proceed to just hum through the wash cycle, no water is pumping through the turning blades. It will stay humming until you turn it off by hand ( dial will stop mid way through cycle)


Sounds like something is jamming your wash inpeller start at the washer arm and go down till you get to the wash impeller and see whats sticking it like broken glass small peice of bone toothpick etc ... Dishwashers

Danby Dishwasher DDW1802W stops in Mid Cycle


... Danby 17 in. DDW1802W Designer Series Built-in Dishwasher

Kenmore dishwasher stops mid cycle


... Kenmore 24 in. 16032 Built-in Dishwasher

Beko Dishwasher DW450 stopped mid cycle, not draining


... Beko Dishwashers

Tecnik SE6TIE1GB/13 dishwasher stops mid cycle and cuts the power


... Tecnik 24 in. TKD795/3 Built-in Dishwasher

My dishwasher runs 2 hours as a complete cycle. I think it is never going to finish but I have not stopped it in mid cycle. Dishes are very clean but they should when it runs this long. I hear it change cycles so I know it is not stuck on 1 cycle. It also makes a lot of noise. 2 hours of noise. HELP!!! How long it it suppose to run?


That means that the machine does not detect that one condition to continue the cycle is met.Sometimes\015\012 when this happen unesperience repairers replace the timer board , an \015\012expensive part that rarely fails. The timer b ... Whirlpool DU1055XTS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1783 seconds