Having problems with your Dishwashers ?

IDL40 dishwasher, sump slowly fills up with water during it's inactivity period

\015 IDL40 dishwasher, whilst switched off and not in use, sump slowly fills up with water during it's inactivity period and then leaks out through the door\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

IDL40 dishwasher, sump slowly fills up with water during it's inactivity period


... Dishwashers

I have a Kenmore Elite dishwasher (2004) and recently it has been leaking internally at a very slow pace. When not in use it will slowly fill until the floor of the unit is filled and then leak onto the kitchen floor unless we press the drain button and then it drains completely. The water seems to be coming from the front of the washer, potentially from the door itself. The amount of leakage is barely discernible but will fill over the course of a 24 hour period. The dishwasher otherwise wo


Hello,\015\012The water is admitted into the dishwasher through a little magnetically controlled valve underneath your dishwasher. This valve opens and shuts electrically. There is a little plunger in it that is pushed shut by a spring when no ... Kenmore Dishwashers

Dishwasher does not fill with water when started. Problem began slowly with dishes not rinsing completely. Overfill float appears to work properly. Water fills pipe leading to fill solenoid but does n


I am almost certain that your problem is the fill solenoid.If it does not work, there will be no water entering your machine.I would either remove it and test it or just replace it at this point.Tim ... Dishwashers

I have an LG dishwasher, model LDS 5811ww. The machine fills with water, then stops filling when the error code IE comes on. I have cleaned the inlet filter and the whole inside of the tub, by taking apart the sump filter. There is good water pressure filling the tank. When I turn off the power and restart any cycle, the pump will empty the tank, then begin filling the tank again...until it is stopped by the error code IE again coming on. The other thing I notice is the water level in the tub.


Sounds like you either have a dirty or faulty water level sensor or water temp sensor. Most likely a dirty or faulty water level sensor ... Dishwashers

Gaggenau GM 915-710 UC6 dishwasher will not fill and wash. Close the door, turn lever. Empties water from sump. (drain hose was not clamped above disposal outlet nipple, fixed that) Machine empties sump, but will not stop after sump is dry. Will not initiate fill and wash. Manually stop machine. Can't get control board to do the diagnostic to get an F #. Pressing button 1 and 3 at the same time. A couple of the plastic tabs on the circuit boards plastic support housing that link the


... Gaggenau GI936-760 Dishwasher

ASKO 1885 Built-in Dishwasher: The water sump fills normally, but the wash cycle does not start. Althought the timer seems to work, the wash cycle motor won't start up in any wash or rinse selection. The spray arms do not spin - no water is being pumped. At the end of the wash cycle time, the water will empty out of the sump. Thank you. TB


Hi, Welcome to FixYa. Based on your description and provided the dishwasher is indeed 1) an Asko 1885 and 2) filling ... Asko 24 in. 1885 Built-in Dishwasher

I have a lx30h dishwasher and the problem is that when i turn it on the first time,normally it should fill the sump and wait to fill after it has reached 166 deg .so whats happening now is that it fills only 2 seconds and tries to heat the water but there is not enough to water so the element gets hot and the high limit does it's job.what do you think of my problem.i have never seen that before good luck and i can't wait to have the answer best regards sylvain ouellet


Hi\015\012\015\012\015\012To correct this make sure the water inlet hose is firmly connected and is not kinked or blocked. Clean the inlet hose and inlet filter (inlet screen). If this doesn't resolve the issue then check the ... Hobart 24 in. LXIH-3 Built-in Dishwasher

When dishwasher is set to begin, sensor takes very long period of time. Cycles are longer than minutes indicated. Dishwasher fills with water but does not wash. Water then drains as though cycle is complete and moves to next cycle. Then the process continues. When cycle for drying is reached, much heat is given and occasionally it smells as though there is burning. A 82 minute procedure turns into hours.


... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher

My bosch dishwasher runs fine, cleans fine, drains fine....but after it has been just sitting for a while, the bottom very slowly fills up with water. Each time we run the machine the water level drains back to the normal amount in the bottom of the washer after the cycle is complete. The problem is if we are away for a few days, the bottom fills up and overflows onto the floor.


Water inlet valve isn't closing all the way closed. Need a new one ... Bosch 24 in. SHU53 Built-in Dishwasher

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

KUDS24SEBS5 Dishwasher. Sitting idle water slowly fills bottom of dishwasher. Have to run to rinse cycle to clear water. Please help?


Close water tap off overnight and see if water still comes into machine. If not, your water valve is defective. If it still does, it is comming from the drainage pipe.(water feeding back.)Need to raise pipe about half height of dishwasher.Some units ... KitchenAid Dishwashers

Dishwasher tub slowly fills with water after after completion


The internal parts of the valve are sticking open randomley.the diaphram/piston in the valve most likley have lime deposits on it due to poor water quality.you would need the water valve assembly but before you buy this part i would look where the wa ... Dishwashers

Dishwasher slowly fills with water


Greg, at this link you can download available manuals for your unit.http://shared.whirlpoo ... Dishwashers

Bosch dishwasher slowly fills with water after cycle is done


Replace the water fill valve, it's leaking. ... Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher

Dishwasher slowly fills up with water after wash cycle completed


Inside the bottom of the dishwasher under the lower rack to the side there is a float that regulates water level. jiggle it up and down a few times , it will be OK.\015\012Vitally ... Dishwashers

Water slowly filling cabinet when dishwasher is off.


Either\015\012leaking valve - to check, turn water off and see if it still happens\015\012or\015\012if appliance is plumbed in to a spigot on the sink trap, then when you empty sink, some of the water finds its way into the dishwash ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

How can I shut off the water supply to the dishwasher? It fills slowly with water from the top (while not running), and then water spills out over the kitchen floor. By pressing the 'Drain' button, the water will drain out, but I have to get to it before it floods. It takes about 4 hours for it to get to the overflow stage. It is a Jennair model, about 9 years old. We have a lot of limescale, it is probably time to replace it, but for the moment my main concern is to stop the leak. Thank you for


Most water supply lines are attached to the hot water supply under the kitchen sink. If not it may be accessible from the basement somewhere under where the dishwasher is located. Regarding the issue with the dishwasher, the inlet water v ... Sears 24 in. 14181 Built-in Dishwasher

Indesit dishwasher sump keeps filling up with water when turned on


I had a similar problem every time i bailed the sump out by hand and turned the machine back on it would fill the sump or just shut off.\015\012\015\012Having spent ages checking various site it boiled down to one of three things there is ... Indesit 24 in. D61 Free-standing Dishwasher

Bosch shu53 dishwasher fills slowly with water when turned off


... Bosch 24 in. SHU53 Built-in Dishwasher

When I hit the start button on my dishwasher nothing happens. It still "finishes" the cycle but nothing ever cuts on. It doesnt fill with water and the sump pump never engages to drain the water that's not there. Any ideas? I know the inlet water pump works, I've detached it and connected it with a pigtail to an outlet.


Replace the main control board ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a bosch sms46 au dishwasher and it is having problems filling with water, there is no problem with the water supply and the water is getting thru but slowly any sussestions?


... Bosch Dishwashers

Good morning! I have a hotpoint built in electronic paneled dishwasher that fills up w/ water when off. Water slowly seeps in from bottom and I have to syphon it out (yuck). Electronic panel beeps, that there is too much water. can you help me?


The water inlet valve is most likely bad and needs to be replaced, especially if it fills up over a long period of time. Easy to replace. ... Dishwashers

With the assistance of someone from this forum, I can see that my dishwasher is slowly leaking water from the opening on the left side of the dishwasher area. There appears to be a problem with the dishwasher fill valve, and I'd like to know if it is something that I can replace/fix on my own. Thanks, Nick


Yes it should be possible to replace the fill valve but I will need the make and model number of your dishwasher to provide you further suggestions. ... Dishwashers

My dishwasher nautilusgsd2200 does not fill with water. water is turned on also we do not use it for long periods of time


... GE GSD2200G Built-in Dishwasher

We have a Frigidaire dishwasher model #FDB634RF bought new. It was used for a not very long period of time but developed problems due to well water with high lime content. now with good cleaning products available it is ready for use again. The problem is the top spray arm that refuses to rotate. I have taken the arm out and thoroughly cleaned it of deposits checked the supply line from the pump and checked the sump for any obstruction. The arm turns freely by hand but water just pours out the


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDB635RF Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2574 seconds