Having problems with your Dishwashers ?

How to lower the rear foot - Dishwashers


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to lower the rear foot - Dishwashers


... Dishwashers

I have a whirlpool GU2700XTSQ1 dishwasher. I have the typical top rack not cleaning problem. I have removed the rear washer tube that leads to the top sprayer, no clogs. Upper arm is clear, lower arm is clear. I also removed the lower cover, checked the chopper screen and inlet, no clogs. There is a screen inside that I cannot get to. It appears to have some sort of paper or cloth sticking through the screen with a 50% block. Perhaps a sticker or label from a dish. I see this screen when looking


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

GE Triton model Dishwasher does not drain fully, there is always some water (1") left in the bottom. I have removed the cap over the air gap to see if it was blocked - it does not appear to be. I removed the fileter housing immediately to the rear of the lower spinner and cleared all the junk out. no improvement


Check entire drain including the pump. The pump may have a little debris lodge in it. ... Dishwashers

Dishwasher Problem... Hey, I'm sorry I can't seem to find this information anywhere else. I'm having a similar problem with my dishwasher (also a kenmore quiet guard) and I wanted to try to clean the filter. I'm not sure how to remove the lower arm of the dishwasher. There is a kind of plastic-screw in the middle of the lower arm, is that what holds it on? I'm afraid to try twisting it because I don't want to break it. How did you get it off of yours? I hope I'm not bothering you! Thank you, Je


You are right. The plastic screw needs to be removed. I have a Quiet Guard 4. My procedure is as follows:\015\0121. Remove baskets. Need to pop off the 'keepers' at the ends of the top slidding shelf supports.\015\0122. Remove bott ... Dishwashers

I have a fisher & Pakel dishwasher and it appears to have brown a fuse inside the machine which means it does not work at all and the problem occurred during the wash cycle. This means the seal (which is a top piece that's lifted and lowered by two motors. When the seal is in the lowered position it creates a complete seal but it also locks the drawer (single drawer dishwasher) so it cannot be pulled out. I repaired the dishwasher two years ago. One of the lifter motors didn't work. I replaced t


According to the service manual there is no problem in manually forcing open the drawer in the situation where the power has failed part way through the diswasher cycle.\015\012\015\012The problem is that once you force the lid open, you ... Fisher and Paykel Dishwashers

The lower spray arm came off during a dishwasher cycle and melted. The dishwasher is okay but I need a replacement spray arm for a Sears Galaxy dishwasher model number 587.15139400 I have searched google for replacement parts for this model and have not found a place where I can get a lower spray arm. Any help would be appreciated.


Sears parts dept ... Sears 24 in. 14181 Built-in Dishwasher

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

LG Dishwasher - lower spray arm gets stuck


... LG 24 in. LDS 5811 Built-in Dishwasher

There are three legs on the underside of the dishwasher. the front two screw in and out the back one does not. we need the dishwasher to be lower so it will slide into under the counter. what do we do? how can we lower the back leg? it is quite high.


... Bosch Dishwashers

I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher

Ge pdw7880j10ss dishwasher lower roller fell off and melted on lower heating element. need to know part number of lower roller and plastic clip that affixes the lower roller to lower rack?


(http://www.geappliances.com/service_and_support/parts/)the correct # for your unit is pdw7880n10ssjust enter your model #(under repair or replacment parts)the site will walk you thru the rest.when you get to the parts list make sure you ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Need lower dishwasher rack for VUD 140 Viking dishwasher


... Viking Dishwashers

GE Potscrubber 650 Dishwasher, 13 years old. We want to take the front lower panel off to move the motor fan by hand, as you described for glideston'es post, but we can't figure out how to get the panel off. A repairman told us to remove the three screws at the top of the lower panel -- but they are too close to the upper door panel. The space between the two panels is not big enough to fit a screwdriver or any other tool we can think of. How do we remove the lower panel?


Homeowner with this model:\012I believe you would need to take the door loose by removing the screw on each side of the door near the bottom on the outside. \012\012I would recommend removing the unit whole instead. That way you don't n ... GE Dishwashers

On a GE Dishwasher Model GSD5200G00BB what is the procedure to remove the lower spray arm? I need to remove it so I can remove the screen covering the entire bottom of the dishwasher. There is a tremendous amout of mineral build-up in the dishwasher (under the referenced screen) that I want to remove.


... GE Dishwashers

Our church (St Philip's) has a Jackson Faspray commercial conveyor dishwasher system. The current height of our conveyor table is 40". We would like to reduce the height to a standard 36". The entire conveyor and dishwashing unit has adjustable legs. Can the dishwasher unit be lowered and is their a Jackson field technician available in the Detroit area?


... Jackson Dishwashers

Hobart AM14/1 free standing dishwasher with booster. Booster will not heat up beyond 41C. All three heating elements check ok with Ohm meter. High limit not tripped. Temperature screw up at maximum, when you turn the screw, you can hear thermostat click at lower temperature on and off. When turning on main power for dishwasher, heater in dishwasher works fine, but no relays click in the booster tank area. Have not checked for power at booster, have checked all fuses with meter and are ok. Ple


... Hobart AM14-253 Free-standing Dishwasher

Bosch dishwasher S10R1B Hi, we have a small but important problem with our Bosch dishwasher; there are some wheels missing from the lower rack/trolley. Please can you advise how much replacement items will be? The dishwasher works perfectly otherwise. Many thanks in advance. Regards, Mark


... Dishwashers

Dishwasher does not seem to have power. I have a Kitchen Aid, under counter unit, 9 years old, model KUDS01I. I used it 2 nights ago with no problem. When I push a button, nothing happens, no lights show, etc. It is plugged into the lower half of a duplex socket with disposal plugged into the top. Disposal works, so the problem seems to be with the dishwasher. That also eliminates any issues related to breakers or ground fault indicators, etc. Is there a reset button on the dishwasher? Is there


... KitchenAid Dishwashers

Dishwasher We have a space in our kitchen to fit a dishwasher its about 6 foot away from the drain and water supply, how can we fit a drainage pipe from this distance as all dishwashers have a short hose, is this possible to do?


You can buy the drainage hose ( B&Q) by the per / m if you can not install a drainage pipe closer. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Top arm of dishwasher does not spin or spray. it is a 7 yr old frigidaire dishwasher, model #gldb957ab. The dishes on the lower rack also do not get clean. this just started recently. the mid level sprayer will turn by hand but doesn't move during cycles. seems like it would be there is no water coming to the top of dishwasher while it is running.


... Frigidaire 24 in. GLDB957A - Multiple Color Energy Star® Built-in Dishwasher

I have a samsung dishwasher model # dmr77lhs. Their is water at the bottom of the dishwasher. Now the dishwasher will notstart. I have checked the upper lower and middle nozzles and they were all cleared. What should I do next?


Most common faults with dishwashers is a drain fault. Check for any kinked hoses and check the drain spigot under the sink where the drain hose connects into the u bend. Usually this is where food gets trapped due to the spigot not being drille ... Dishwashers

DISHWASHER NOISE I HAVE A HOTPOINT DISHWASHER MODEL HDA3420Z02BB SERIAL # TT813162Y. IT IS ABOUT 10 YEARS OLD AND JUST TONIGHT DEVELOPED A CLICKING/ GRINDING NOISE AT THE BOTTOM OF THE DISHWASHER. I REMOVED THE LOWER COVERS AND IT APPEARS TO BE COMONG FROM THE MOTOR AREA OR I GUESS THAT IS THE PUMP ATTACHED TO IT. JUST WONDERED IF THERE IS A PATTERN FAILURE WITH THIS MODEL AND IF SO IS IT FAIRLY EASY REPAIRED?


A noise could be created by something getting down into the motor-pump assembly piece of glass, piece of bone, wire tie anything really. If this is the case and you can remove it before it causes further damage problem solved. At ten years old the ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Dishwasher fix water does not go through the spray,. the upper hand an lower hand are clean , the pump does operate to empty the dishwasher . I do smell like some burning smell when I turn the dishwaher on, the water start running for 1 minute or 2 than stop shortly and doesn t reach the arm then the dishwasher becomes hot inside . Thank you


Something has gotten passed the screen and is jamming your pump impeller pull lower spray arm pull screen and see if you can find what is jamming the impeller and remove it drain pump is separate ... Maytag MDB7100AWB Dishwasher

Dishwasher hey! i have a frigidaire dishwasher. turns on, fills up with a little water and just sits there for about 10 mins doing nothing. starts to clean then nothing some more. it drys everything but leaves the dishes totally filthy even though they are well rinsed prior. after they are dry, the dishwasher then pushes out the remaining water like it is supposed to and on into the disposal. any ideas? i cleaned the pan out completely and replaced the lower parts. thanks!


DEAR FRIEND,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam1 here for you!\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\0 ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

We need to remove the AEG Favorit dishwasher from the housing but the back feet need to be adjusted to lower the machine. Which way do we need to turn the front scews to lower the machine. It is not clear whether the screws lower the feet or the machine.


... AEG 23 in. Favorit 50750Vi Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1720 seconds