Having problems with your Dishwashers ?

Machine is blocked, water will not go out. OKO favorit 6060

\015 Machine is blocked, Can anyone tell me how to unblock it? Thank you.\015

Answers :

Try www.manualowl.com Best of luck. Jimmy
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

AEG OKO_FAVORIT 6281i dishwasher - error code 20 (Siphon blocked). Out of the blue after 6 years of reliable once-a-day family use, my AEG OKO_FAVORIT 6281i dishwasher started OK but about 3 minutes into the cycle began flashing error code 20. At which point there was a litre or two of cloudy water sitting at the bottom of the machine. Since then I've tried redirecting the drain hose into a bucket, after disconnecting it from the kitchen drain. Same symptom, and no outflow except what was al


... AEG 23 in. Favorit 50750Vi Built-in Dishwasher

Aeg favorit 50860 dishwasher and the dishes are not cleaning properly. Filter has been cleaned; Finish dishwasher cleaner has been run through machine; dishes are stacked properly.. any ideas? I suspect it might be to do with water inlet valve??? but am reluctant to tackle this myself. Water is heating properly, arms are spinning and the holes are not blocked on them.


... AEG Dishwashers

Machine is blocked, water will not go out. OKO favorit 6060


Try www.manualowl.com Best of luck. Jimmy ... Dishwashers

FDB105OREC4 My dishwasher is not cleaning my dishes. I push the start button and water seems to be trickling in then it stops and no sounds protrude from the machine for several minutes. Eventually another loud motor seems to turn on and drain the water out of the machine. The soap dispenser usually opens and the soap block that usually dissolves is setting on the bottom of the machine. It seems the water is plenty hot but the rotating washer arms might not be moving. Please help me find the par


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

AEG Diswasher Model / Favorit 44080IM PNC 911925601/01 (located in UK) Wash cycle finish light flashes 5 times in sequence then starts again - please advise the meaning of this error signal ? History Machine started running immediately door was closed before any programme selected filled with water and main was motor runs and circulates water Water is not heated and detergent door has not opened Machine will continue to circuluate water until turned off If reset used then


1 blink is machine is having major power supply problem.the power supply board needs replacement.\015\012-----------\015\0122 blink is CCU error.that control board problem.\015\012-----------------\015\0123 blink is the CT error.that is ... Dishwashers

Our machine sounded wierd last night and we found out that the water is no longer coming in. And we found a melted plastic medicine cup in the machine. Where do I look to see if plastic is blocking the entrance for the water? Our machine is 10.5 years old, but I don't know which model.


Are you sure it is a medicine cup and not the float cup that controls the water level ? The float is a cup with a rod in the center that goes into a tube sticking up in the bottom of the machine. The rod reaches through the tub and sits on a sw ... Maytag Dishwashers

Zanussi dw927 not filling inlet valve changed,supply to machine ok, calls for water solinoid activates for about 30secs shuts off and machine does no more. cleaned out two blue plastic pipes situated under a plastic cover which were both blocked, and put a hose jet wash thru where they were situated to clean housing out, put blue channels back still not filling up and now the inlet solinoid wont switch off when when it should and programme advances heater now comes on with no water in.manually


... Dishwashers

Hi there I have a Miele G663 scvi dishwasher. The inlet/outlet light is flashing. I have cleaned the non return valve and filter at the bottom of the machine. I have also removed the water inlet pipe which has a large filter on at the end where it attaches to the water pipe. I have blown through this pipe and it is quite difficult to get air through. Do you think it is a filter that is blocked? If this is the case are they easy to attach to the bottom or the machine or would I have to get


... Miele 24 in. Incognito G663 SCVi Built-in Dishwasher

Last couple of days bottom rack of dishwasher not been clean on 65o wash, having emptied and run the machine empty etc it seems that whilst there is water being pumped through the roof mounted vents and to the "spinner" attached to the upper tray, the spinner attached to the base of the machine is not getting a) any / b) sufficent water pressure to make it spin...im guessing the feed is blocked?


... Bosch 24 in. SGS43C02 Classixx Built-in Dishwasher

Problem with AEG 24in Favorit 40630 Free-Standing Dishwasher When I'm turn on the machine the top and middle signal light are flashing and the pump working for some time and stop. I know this device detects water leaks and is a polystireene float / micro switch that puts the machine in pump out mode. But there are no water under the float! Alex


... AEG 24 in. Favorit 40630 Free-Standing Dishwasher

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

My dishwasher AEG favorit 525 worked perfectly but has been out of action for over a year. yesterday when I tried to use it, the on button is on continuously and no water is pumped into the machine. yes the water is on. the program button is also rotating as the programs change but no water comes in and I am not sure whether it will pump water out as I have not yet got there. please help.


Hi\015\012\015\012The issue seems to with the pressure switch that is bad and\015\012so won't allow the water to flow inside the unit. You can take it apart to\015\012check this. Hope this helps...please post back for further assistance. ... Dishwashers

My dishwasher has stopped cleaning plates properly. It makes everything wet but at the end of the cycle the detergent block is half dissolved at the bottom. I have just run a cycle and opened the door during this. The bottom is full of soap suds and water and the top spray bar is dripping water after I open the door but when I close and then reopen a few secs later the top spray bar has definetly not rotated. The water is also not hot, this dishwasher is a cold fed only machine so I guess the el


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Zanussi 18 in. ZSF4123 Slim-Line Free-standing Dishwasher

When starting wash cycle the dishwasher cda cw447 doesnt appear to be getting enough water in and is making a droning / whirring / electrical ? noise. pipes all connected ok inc aquastop water supply unit, no kinks etc. machine 3 1/2 yrs old, just started making this noise. appears to complete rapid cycle but still making unusual sound. water drains away fine from this cycle, dont believe pipes / hoses are blocked.


Try removing the inlet pipe, and refitting, might fix it, else likely that the \015\012Inlet water soleniod failing/failed or tiny mesh filter (it does come out for cleaning) behind the inlet hose clogged. Temporaily bypass the aquastop water s ... Dishwashers

I have a whirlpool DWH B10W. Last week the main drain outside blocked and none of my service machines were working (not draining). The main drain has now been unblocked and every machine except the dishwasher are now working fine. The plumber has checked the drainpipes again and says all are now clear. When I try to use the dishwasher, after the initial drain it stops and starts beeping at me. I have also noticed that no water is going into the machine. What's happening?


The error most likely indicates a Long Drain Sequence (Drain Exceeds 8 Minutes) - Select 'cancel' twice to clear error code. \015\012 \015\012 \015 ... Dishwashers

Bauknecht gsx7551 dishwasher was blocked, took pipes out, blockage seemed to have gone, successfully did a rinse cycle, tried to start a wash and makes noises but no water going into machine, then machine constantly beeps + cycle will not start


... Bauknecht 24 in. GSX7551 Built-in Dishwasher

My AEG Favorit Sensorlogic Turbodry dishwasher is making 3 short continuous beeps which I understand means the leak prevention system has kicked in. Is there something I can do to reset or must I call a repair man/ There is no water in the machine it has all drained.The machine no is actually a F86050VI


Open the left metal panel, if the white plastic tank is black at the bottom or is not clean: remove it, open it, clean it (make sure the water flows through properly) and put it back in. ... AEG 24 in. Favorit 80860iW Built-in Dishwasher

Hi my machine flashes up with ared light and says 'drain blocked' nothing happens and there is water in the bottom of the machine.


You need to pull out the machine, disconnect the drain hose running out the back of the machine from where it connects to..... (may be the sink trap or into the plastic waste pipe).\012Check the hose for a blockage and also where the hose connects t ... AEG 24 in. Favorit 80850 Free-Standing Dishwasher

The check water supply indicator is alight. I have checked the incoming supply and this is ok, the filter is not blocked. If I try to run the dishwasher I just end up with water at the bottom of the machine and the programm will not progress any farther.


My phone has frized and i forgot the pasword ... Neff 24 in. S5555X0GB Built-in Dishwasher

Bosch Dishwasher SGS45E02GB/45 partially fills then empties repeatedly. Have replaced flow rate meter; still the same. Water matrix; pressure chamber and hoses clear, not blocked; float valves operating. Control module has no sign of burnt joints. LED does not countdown; water level inside machine does not reach correct level. Any suggestions?


... Bosch Dishwashers

I have a De Dietrich DV640JE1 built in 45cm Dishwasher, working fine for over 3 years. After replacing the connection under the sink to fix a leak it has stopped working. But I dont think this is related. I run a cycle and it fills water in the bottom of the machine, it drains it out in the end but the 2 arms are not rotating and no water comes out. I checked the arms and they are not blocked. A faint clunking sound can be heard at some part of the cycle. I did also run a cycle with the dr


Hello Benny,\015\012\015\012It's highly unlikely that replacing the connection under the sink is related to this problem.\015\012\015\012From the symptoms you describe, it's almost certain that the circulation pump motor has f ... Dishwashers

My dishwasher starts as usual by pumping the remaining water away. Than it starts taking in clean water ... and stops. The arms don't start to turn and the machine just remains blocked. No beeping or anything, just silence. Can I adjust this myslef? Evert from Bologna in Italy


This is the wash motor not running. You will need a engineer to fix this for you. ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Asea d3530 dishwasher is showing the overfilling but there is not water in the machine. I have had a blocked sink and while trying to unblock the siink water was backing up into the dishwasher


... Dishwashers

Aeg favorit 40320 dishwasher: water does not enter machine


... Dishwashers

My AEG Favorit 35085 VI dishwasher is not working properly. The manual says to turn water tap off and on but I don't know where it is. O assume they mean a tap to the machine and not to the proper


... AEG Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1505 seconds