Having problems with your Dishwashers ?

Smeg dI112-9 dishwasher water standing

\015 Hi all, first post here, I have a smeg di112-9 integrated dishwasher and it's not pumping out the water, i'm guessing it's the drain pump? Does anyone know if it's an easy job to change this or could it be something else? Thanks.\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Smeg dI112-9 dishwasher water standing


... Dishwashers

Water not draining away electrics ok - Smeg 18 in. DWF410SS Slim-Line Free-standing Dishwasher


When you say electrics ok i assume water pump ok if so check drain hose for blockage possibly at sink cheers ... Smeg 18 in. DWF410SS Slim-Line Free-standing Dishwasher

Error e5 checked all pipes and water running - Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher


... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

Water does not drain in dishwasher - Smeg 24 in. DWF612WH Free-standing Dishwasher


... Smeg 24 in. DWF612WH Free-standing Dishwasher

Hey, I have an 18 inch free standing SMEG dishwasher that has stopped working. The power and water feeds are fine. None of the cycle buttons are lit up or responsive, however two buttons next to each other are. They are not flashing just permanantly on. Lauren


... Dishwashers

After I run the dishwasher, water stands at the bottom and it smells. I have had the dishwasher for five years. The washer seems to be working properly it's just that water stands at the base of the washer. Is it normal for water to always stand there?


No it's not normal, you are probably having some cloge in the drain pipe, you could try with a pice of wire to pick it up or hose it down, or use some comercial unplaguners like mr. muscle or something like that, i think that this would do the trick ... GE Nautilus 24" Built-in Dishwasher

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

While on vacation our house had been checked at one week later &again 2 weeks later, @ 3 weeks check, floor in front of dish washer & entire kitchen had standing water , as DW door was opened bottom of DW had water standing up to bottom of door . Water supply to house was shut off before we left. , Since we returned home we have used DW daily with no indication of where this water came from. Any ideas ? Thanks, Bob


Take a long shot. Say your mains leak a little, quite possible, and you machine's inlet solenoid valve leaks a bit, say about a litre a day - you probably would not notice it during the normal course of events, in a week it would leak a ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I noticed water leaking underneath my dishwasher through the floor joists to my basement. It was a small but steady drip through the joists. I turned off the water to the dishwasher and the leak stopped. I looked inside the dishwasher and there is still some standing water inside the dishwasher, but I cannot see anywhere that water is standing under the dishwasher. I am wondering if the leak is at the pump or at the door? But I see no evidence of the seal leaking.


This is probably the line that goes from the water inlet valve on the bottom of the dishwasher up to the valve leading into the dishwasher itself. It is probably a black corrugated rubber line. This is an extremely bad design, but the solution is s ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Smeg e2 error (water level tripped). Filter is clean and no rubbish below filter on inside of dishwasher. I have taken the front panel off but am not sure where the float device is located - I am wondering if it is just to the left of what looks like a solenoid. There is no water in the base of the unit in the front panel so would rule out any leaks. Reset program and turned off power at socket but still not using hot water. Possible PCB issue ? Any advice appreciated. Smeg DI612C Dishwasher.


... Dishwashers

My G E Profile dishwasher PDW988ONOOSS has water standing, it appears to run ok, bit leaves water standing? Had a appliance person out who looked inside, and determined it needs a impel or motor?


... Dishwashers

Had standing gray water under house got the water out and fixed the drain problem but still have the smell How do we get rid of the smell of the stagnent water its bad. Thanks


Many commercial cleansers are good for neutralizing odors, but several common household products can be used as well. Vinegar is an extremely versatile grocery item that neutralizes many odors, including those left behind by pet accidents and skunk s ... Dishwashers

I have a GE PDW 8200 Dishwasher and there is standing water in the bottom of the tube. Why is there standing water after a complete cycle?


If it is older, the pump may not be draining the machine completely. The impellers, which is what acually moves the water could be clogged with yuck and could be cleaned if you can take the machine apart. If you call the repairman, he will likely rep ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Standing Water After running our dishwasher we have standing water in the bottom, it won't completely drain out. Thanks, ---Joe


Are you leaving it long enough to finish it's programme or are you opening it when the drying light is on as some dishwashers leave a bit of water in the bottom to help with the drying programme ... Dishwashers

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

Smeg Dishwasher DWD 63.1 SS, not heating; I have Smeg dishwasher that is sticking in its cycle (wash phase), water was cold, so I assumed the element had failed (or tank termostat), so I have replaced both element and tank thermostat in turn. No change, water still cold and dishwasher sticks in the wash cycle. Any ideas? (Note, no diagnostic leds on this model)


... Dishwashers

Got standing water in bottom of dishwasher model #GSD5500GWW/CC/BB. We found some plastic cake decorating tips in the standing water, and hear crunching like more tips when we turn the machine on. How do we take remove the spinning thing in the middle, or anything else, that would allow us to clean out all th plastic tips?


... GE Dishwashers

Standing Water There is an abundance of standing water in the bottom of my dishwasher. Is this normal???


Hi,Here is a tip that I wrote that will help you with your problem...Dishwasher Problems - Water will not drain outhttp: ... Dishwashers

This is the 2nd time I've had problems with my dish drawer. After I cleaned the filter and replaced it, I had standing water on the bottom of the drawer. The last time this happened, I had someone come to repair it - ended up it was me. I didn't put it together properly. This time I did the same thing I was told to do. I still have the standing water. What should I do. By the way, the coils are not kinked in the back either. Can you please give me some advice? Please respond to me at F


Unfortunately I have to respond to you through this post per policy of fixya.com. This s to ensure we have a visibility on the quality of the solution and also allow other consultants to help if necessary.\015\012\015\012Water standing a ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Water standing the is water standing in the dishwasher when its done.


Heool Isharpbailbo,ngfam1 At your service!Sounds like it may be one of a few problems,1.The drain may be clogged going out to your kitchen sink2.There may be some food or debris at the bottom of the inside of the dishwa ... Dishwashers

D3121 has standing water in bottom of diswasher; have cleaned filers stil ge t standing water


Check that the outlet hose is not blocked. or maybe there might be somethink stuck in the pump. ... Asko Dishwashers

Smeg dishwasher my smeg dwf409 dishwasher pump keeps on running will not stop after washing cycle and there is water leaking from the bottom of it i can not see any leaks around the pump does the tray on the bottom always have water in it


My hotpoint dish washer aquarius is 4 years old leaves a sandy grit all over dishes water not spraying the top,done all the usual stuff run out of ideas ... Dishwashers

Brand new dishwasher, installed last week. When it is done there is quite a lot of water standing in the bottom of the tub. It has only been run 2 times since installed and both times several inches of water were left standing. Is this something we could check or do I need to have the installer come back, which will probably take a week at least. Oh-KitchenAid #KUDC031VWH


First was a new garbage disposal also installed? There is a knockout on the garbage disposal where the drain hose connects to.\015\012If that is not the problem make sure it has the correct high loop or also called air gap. If that is not right ... KitchenAid KUDC03IVWH Builtin Dishwasher

Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?


You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Magic Chef DU4K is not draining all the water. There's at least a gallon of water standing in the bottom. I have cleaned the air gap assembly and drain line completely. They were even sanitized in hot water. I do not hear the water draining like it use to. When it worked properly you could always hear water draining into the GD. Now I can hear any draining. Again, there is no clogging anywhere in the drain line assembly. Is it a bad pump. I don't know where to go next with this.


... Magic Chef Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0830 seconds