Having problems with your Dishwashers ?

Potscrubber 580 not draining

\015 Even after running the dishwasher all of the way through, the water is standing in the bottom.\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

My GE Potscrubber 640 isn't draining. The bottom of the tub is completely full. I know there is supposed to be a little water but this is way too much. How can I access the drain? Which setting drains any water in the tub? Is there a site I can go to, to see videos of this type of repair?


... Dishwashers

Bosch D/W model # SHU9955UC. The drain motor will not stop running. Ran the reset sequence on the panel. Display reset to "0" minutes. Power cycled the D/W and when powered back on the drain motor started up again. What do I do ?


Hi ....This is a common problem. Remove the kick plate you will see the white base which also is a tray to collect leaks or backups. Reach your fingers over the top of tray and feel for water/wetness,if so safety switch has been activated and pump wi ... Bosch SHU9955UC Built-in Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Dishwasher cycles through all programs but will not drain or turn off at the end of cycle. I do not know if it drains inbetween. It just continues to run on 0 minutes and when I turn it off and open there is standing water


Underneath the machine there is a donute shaped styrofoam item called a flood safty switch .makke sure there is no debri underneath..mice will drag animal food or chew on this and will lodge it leaving debri under it causing it to trigger a false flo ... Bosch 24 in. SHU43 Built-in Dishwasher

GE potscrubber 640 dishwasher is not draining water. there is nothing blocking the grilled drain in bottom what else should we look for? thanks


... Dishwashers

I also have a GE Potscrubber 1200 but mine is the portable model. It's not draining and it's full of H2O. I've looked around to see if something is blocking it from draining and there's nothing in the way. How do I get all of the H2O out? I'm going on vacation in about 9 hours and I have 2 small kids. HELP!


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Dishwashers

Potscrubber 900 Dishwasher won't drain


HI. check the following areas for faults.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... Dishwashers

The water in my GE potscrubber 700 wont drain


... Dishwashers

Ge potscrubber 830 fills and immediately drains


... Dishwashers

GE dishwasher Potscrubber 1150 wont drain


... GE Dishwashers

GE Potscrubber 800 Water leaking from motor housing during drain


... Whirlpool GU2400XTP Built-in Dishwasher

GE Potscrubber 650 does not drain and top rack not washed


Your not draining the washed dirty water out. its leaving crud on dishes. check drain pump and drain line for restrictions ... Dishwashers

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

Potscrubber dishwasher leaks water at the drain pump valve shaft opening at the metal plate holding the solonoid


... GE 24 in. GSD2120C Built-in Dishwasher

C3 error on a 2230 ge potscrubber dishwasher. Reset it, turned it back on, then get C4 error. Continue to get errors and dishwasher won't drain


... Dishwashers

My GE Potscrubber dishwasher will not drain properly but works good on other aspects


Hello,\015\012Here is a tip I wrote that will help[ you with your problem..\015\012\015\012http://www.fixya.com/support/r40787 ... GE Dishwashers

Doesn't appear to be washing the dishes like the spray arms are not working. I can hear water filling and it does drain but soap is still on the door and in the bottom of dishwasher itself. Ran diag on it and it came back clear (0). I have a Bosch SHU5315U6.


Sounds as if the pump motor has gone out in the machine. What happens is once the water reaches a certain level the machine goes into clean mode. This means the pump the forces the water into the machine isn't working. The timer actuates this pump ... Dishwashers

GE Potscrubber will not drain or cycle.


Hi,Here is a tip that I wrote that will help you with your problem...Dishwasher ... Dishwashers

My dishwasher makes a banging noise whenever the water supply shuts off & it drains. It has been doing this for a long time. I finally bought a hammer arrester & soldered it on the line after the tee for tap & dishwasher & it sits about 1 foot up.this did not solve the problem. It still bangs loudly & I'm worried about damaging my pipes since they are old copper pipes. can you give me some advise it is a ge Potscrubber mod. #SSD539PS1181 Dave


... Dishwashers

Ge potscrubber 650 Dishwasher is humming when turned on and will fill but not wash and drain


This happens when the DW goes unused for a while. The motor is stuck. Open up the lower panels and move the Motor Fan by hand until it moves freely. This worked for me until a seal broke.Freeing the motor may break the seal between the ... Dishwashers

Ge potscrubber dishwasher will not drain properly


Had the same problem with my dishwasher. Took it appart thinking that something was plugging the drain but there wasn't anything. Turns out the cylinoid that has the hook coming out of it to control the flap for the ejection of the water is broken. ... Dishwashers

I have a General Electric Potscrubber dishwasher. When the cycle is finished, the water does not drain into the sink.I turned the unit upside down to look into the bottom. The motor turns freely. The instruction sheet I found in the bottom of the unit said to remove the filter screen and check the piston valve. I looked at what I thought was the piston valve, but I'm not sure how to check it. The line to the sink seems to be clear. The model of my unit is GSC3230Z03WW. The serial number is AZ627


... GE Dishwashers

I have the potscrubber 720 GE and it will not drain the water from it


... GE 24 in. GSD2600GBB Built-in Dishwasher

I have the GE 206c1513p001 Potscrubber and recently found a black seal or rubber band in the dishwasher. Since then, it has been making a continuous clicking noise when it is run and does not clean the dishes thoroughly. I am trying to find a manual or something that may tell me where this seal belongs so that I can fix this issue. The bottom of the dishwasher is also not draining completely. Please help! Thanks!


I have the exact same problem!!! Found 2 loose rubber bands, the bottom doesn't drain completely, and the dishes are left either dirty with a white film on them. Please help! ... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0533 seconds