Having problems with your Dishwashers ?

GE Profile Dishwasher Will Not Drain Model PDW7880J00SS

\015 My dishwasher will not drain after any cycle is run, it is left with an inch or so of dirty water. I have replaced the drain hose, the motor, the drain pump, and the sump inlet. All of those items had a lot of \342\200\234goop\342\200\235 inside them, but of course all are clean now. I have cleaned out the gooped-up drain hose connection on the garbage disposal, and cleaned out the sump filter and cover. The panel seems to be working just fine, the cycles seem to work ok, it\342\200\231s just not draining. \012\012Any idea what else I can do? I understand there is a way to do a diagnostic test from the panel\342\200\246any idea how I would do this? Any idea how I can manually do a drain cycle, to make sure that function even works?\012\012Below is the URL for the dishwasher schematic:\012http://www.partselect.com/ModelFrames.aspx?ModelID=426803&ModelNum=PDW7880J00SS&mfgModelNum=&ManufactureID=2&Selected=00111846i05&Position=4&mfg=GE&Type=&Mark=4\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The ge profile dishwasher model PDW8280J10SS was purchased about 2 yrs ago. It was working fine up until Jan. 2009. It ran fine but the water stopped draining. I read were you should run the garbage disposal prior to running the dishwasher. I drained the water and did this. It worked fine for a while then the problem was back. Once again, Drained all the water, sucked it out with a turkey baister, moved the dishwasher and checked hoses etc. Once again, it worked fine for about 10-14 runs. It now


It is probably clogged at the pump or before. See if you can get outlet hose off the bottom before the pump. ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

The GE Profile Dishwasher does not drain completely. The bottom drain shows no obvious clog and the screens are clear. The overflow drain in the back of the washers the only reason the dishwasher does not overflow. Any suggestions......The washer is about 10 years old...


Uncouple the drain hose connection under the sink and use a wet/dry vacuum to **** out the drain hose and the stub on the sink drain plumbing to clear any possible clogs. There may be a blocked check valve near the pump that might have to be cleaned ... GE Profile PDW8400J Built-in Dishwasher

Hello, I just installed a GE profile dishwasher (pwd9280n00ss) into my kitchen. I connected a hose to the valve water inlet, I connected the drain tube from my garbage disposal to the check valve flapper and then the the drain pump asm. When the dishwasher finishes washing the dishes, all the water doesnt drain out. Any ideas how I can correct this?


... GE Dishwashers

Water will not drain from bottom of GE Profile PDW7300 dishwasher. I checked the service mode feature by depressing the cookware and the heated dry keypad simultaneously for 3 seconds and did not hear any activity from the dishwasher when I activated the drain pump and when I activated the main pump. Other service mode features did activate when I checked them (i.e. activate water valve, open active vent, etc.).


... GE 24 in. Profile PDW7800 Built-in Dishwasher

GE profile dishwasher won't drain - GE 24 in. Profile PDW7800 Built-in Dishwasher


Common cause of this problem is a partially blocked drain line. Disconnect drain line and make sure entire path is clear, including where it connects to the sink drain or garbage disposal. Also, make sure all screens and the drain area at the bottom ... GE 24 in. Profile PDW7800 Built-in Dishwasher

My ge Profile dishwasher will not drain - GE 24 in. Profile PDW7800 Built-in Dishwasher


HI. check the following areas for fualts.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Ge profile dishwasher not draining Model no. pdw9280n20ss I checked the drain line at the garbage disposal. No blockage. Line is clear. The back flow loop is high and not kinked. Only a small trickle of water comes out of the disposal drain at the end of cycle. No forceful pressure of water like before. I removed the smaller grill drain area and cannot feel any objects down in there. I do not know how to remove the larger fine mesh grill on bottom. Any suggestions?


Did you ever figure out how to remove that large mesh bit? I am stuck at the same spot and would love a hint. ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Profile dishwasher not draining at end of cycle.


It would have helped if you provided the model no. \015\012\015\012Check this GE website for possible causes. If you do not have the user manual then you can also download it from here, But you will need the model number. (should be etche ... Dishwashers

We have a GE profile dishwasher that will not drain. We have replaced the keypad control and control module and it still will not drain. When we put it in service mode, we can get it to drain that way but when it is taken out of service mode, it goes right back to the same problem.


Its the timer issue:--\015\012what the timer does is control the motor and drain valve. If the timer doesn't work properly, the water may not drain and you need to replace the timer. This problem is common. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Our GE Profile dishwasher makes a growling noise when it is draining. It seems to get louder as the water drains and stops completely once the drain function stops.


... GE 24 in. Profile PDW7800 Built-in Dishwasher

Ge profile dishwasher wont drain. i have already replaced the drain motor. Why wont it drain completely


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... GE Dishwashers

GE Profile Dishwasher Will Not Drain Model PDW7880J00SS


... Dishwashers

GE Profile Dishwasher not draining


I would think that either the solenoid/valve or the drain pump went bad. Try replacing the solenoid first. Does it sound like the pump is working at all while in the last cycle? ... GE Profile PDW8400J Built-in Dishwasher

GE profile dishwasher does not drain out aat end of cycle


I just fixed the very same problem by replacing the piston and nut (part # WD24X10018). ... GE Dishwashers

GE Profile Dishwasher does not drain. model #


I had a similar problem with a GE GSD5811 model. The hoses were clear, and the auxiliary pump worked fine. It turns out that it was the "piston" assembly that had basically disintegrated over time. This part diverts water to the pump during the drain ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

The pump on my GE Profile dishwasher is not draining.


If it is the last cycle only it is not the pump. It is a wiring or timer issue. Most likely the timer. ... GE Profile PDW8400J Built-in Dishwasher

Dishwasher won't drain after cycle completes - GE 24 in. Profile PDW7300G Built-in Dishwasher


HI. check the following areas for faults.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... GE 24 in. Profile PDW7300G Built-in Dishwasher

GE Profile Dishwasher with water in bottom, won't drain Cloudy water remains in bottom of washer and won't drain.


Hi and welcome to FixYa,Your described problem almost always indicate a faulty drainage system. Unless there are defective components, cleaning (although messy) would be corrective. Normally, there would be a filter/screen that cou ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Dishwasher will not fully drain - GE Profile PDW8400J Built-in Dishwasher


Dishwashers are made to keep small amount of water in bottom so the pump will not lose prime ... GE Profile PDW8400J Built-in Dishwasher

Dishwasher ge profile pdw8000 not draining. I have used wett vac to **** out the water and drain hose. Still no luck. I am trying to remove the washer arm and strainer. I can't see any screws. Any ideas?


... GE Profile PDW8000G Built-in Dishwasher

Dishwasher not draining - GE 24 in. Profile PDW7800 Built-in Dishwasher


If you acn hear a humming noise, then that is the problem due to pump .The pump gets energised but not rotating probably due to something stuck in the impellor. Check for that impellor unit and try to replace it. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

On my GE Profile Dishwasher model GSD4320Y72BB, water is leaking during the rinse cycle for a about 10-15 seconds from the bottom of the drain solenoid (GE part WD21X802). The water does not seen appear to be coming from another source. Are drain solenoids known to leak water? Thanks, Bud


They can leak if there is a bad seal or they do not have a tight connection. ... Dishwashers

Our Profile Series dishwasher is not draining. All connections are working properly and the pump comes on for 2 to 3 seconds and starts draining properly through the disposal but then shuts off. Does the pump turn on and off by a timer or sensor?


... GE 24 in. GSD5930 Built-in Dishwasher

My GE Profile Dishwasher circa mid 1990s will not completely drain. I took the drain cage off and found pieces of broken glass and old food remnants in it. I used a shop vac to **** it all out. Unfortunately, this did not correct the problem. I wonder if their is glass in the pump itself that is impeding drainage flow to the tailpiece.


Sounds like there is. It is common to find objects or small pieces of cloth stuck in the water pump. Remove the water pump and disassemble it and reinstall it. Or purchase a new water pump and replace the old pump. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

GE profile dishwasher (2004) will not drain properly. Is the drain clogged? If so, how do I open and clean it?


Check the hose first alot of times the hose canbe clogged . disconnect the hose hit the drain on the machine and normally the clog will be seen. if that doesnt work then its the drain pump thats clogged. ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1299 seconds