Having problems with your Dishwashers ?

Adp 6600 flashes four times - Dishwashers


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool adp 5550 Dishwasher wont complete a cycle. The light in the start button flashes four times in a continuous pattern. Have pressed the start button for 3 -5 seconds to reset after which the machine seems to operate ok then it stops and the start button returns to flashing. Have cleaned the filter and checked the sullage pipe for blockages What do I do next?


... Dishwashers

Adp 6600 flashes four times - Dishwashers


... Dishwashers

My Whirlpool ADP 5406 runs for about a minute and then the light flashes four times, repeatedly. What can I do to fix this? (I can still get the machine to run its cycle by holding down the start button, but the light will flash four times again on completion).


Hi and welcome to FixYa. I am Kelly. \012 Usually this symptom also shows an F7 error code. You will need to remove the lower wash arm (NOTE INSTALLED POSITION) Also you will need to remove the metal grate under the wash arm to ... Dishwashers

Haier dishwasher CDW300SS beeping 10 times and 4 lights flashing,,, help The dishwasher will work, it fills, it washes and it empties, BUT will not start now, and the 10 beeps and the four lights flashing,, so wont restart and go throught the program... Is there some way of resetting the dishwasher to restart. help thanks. glenn


... Haier Dishwashers

I have a GE Quiet Power 3 dishwasher that was working fine last week. Over the weekend I ran it and we could hear a banging noise, so my boyfriend opened it three or four times in a row (during the cycle) to figure out what it was. The fourth time, it went dead. I checked and it had tripped the breaker. I reset the breaker and the dishwasher seemed to be working again, however the lights on the front were flashing (they hadn't previously), and now it will run for about 10 minutes but no water ru


Were you able to figure this out? We have the same problem here! ... Maytag Dishwasher

Whirlpool ADP 5500 dishwasher stops - light flashes 7 times.


It's a heating issue either a bad heater or bad sensor. ... Whirlpool GU2400XTP Built-in Dishwasher

Baumatic (BKD62SS or BKD62W .3) Dishwasher will not do a normal load but will run in a strange start up mode I found. When I press the power button, select a cycle, then press start the dishwasher will no longer do anything. 5 seconds after pressing start it will make a light hum noise, a little like heating water. After about a minute the dishwasher won't have done anything. It will then beep 30 times with the third led on the set of four (don't know what it means) will flash a lot. The beeps t


... Dishwashers

My Whirlpool dishwasher ADP 5340 stops after 5-10 minutes, Start button flashes 8 times. After I press it works for about a minute and starts flashing again


... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

Whirlpool Dishwasher ADP 2652 WH at the end of a clean cycle, the pre rinse button remanins on, the "end" light flashes constantly and the on/off button flashes 4 times in a repeating manner.


... Whirlpool Dishwashers

Our whirlpool ADP 6565 dishwasher stops very close to but short of the end of the cycle, with the on-button flashing. If we press that button for a few seconds, it starts again and completes the cycle. I have cleared the filter on the inlet hose because we use tank water which does have particles in it frm time to time, but this made no difference.


It appears that you have a timer malfunction. at the point that the timer stop, you need to listen closely to any sound from the timer. if no sounds emerges, repalce timer ... Whirlpool Dishwashers

Whirlpool adp 4400 dishwasher fault light flashes 6 times(twice) then7 times (repeatedly) ?


... Dishwashers

Whirlpool dishwasher ADP 4400. green light light flashes 5 times pause 5 times when trying to start wash


... Whirlpool Dishwashers

Model: Whirlpool ADP 4501/5 (4 years old) Problem: Dishwasher won't start wash cycle. Green light flashes 11 times. After adding a bucket of water to the dishwasher it runs normally. Checked the inlet valve and it appears to be fine. Filled the salt container and it solved the problem for a while but having the same problem again. Any suggestions would be appreciated.


... Dishwashers

Phillips Whirlpool Dishwasher ADP 4400. Cycle stops and start light flashes 4 times repeatedly


... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

Whirlpool ADP 4542 dishwasher: green LED light is flashing 4 times thank you


... Dishwashers

My dishwasher wont drain and it only does cylce 1 of four then stops and all the cycle lights flash at the same time.


Your board needs to be replaced sorry. ... Dishwashers

Whirlpool dishwasher adp 4608....start light flashing 6 times...any ideas??


... Dishwashers

Hi i have a Candy CDI 1012/B Intergrated dishwasher and 4 lights are flashing during the first programme then system drains and stops showing four lights lit. We have no instruction manual or service manual this would be good to get hold of as we have serveral of these machines. any idea what the problem is to save us time investigating it. Thanks Paul


Hi. The four leds flashing quickly at start of the cycle means that there is an inlet problem. Check that the inlet hose is not bent, blocked or kinked, ensure that water has sufficient pressure. The inlet valve can be tested reading Ohms at valve te ... Dishwashers

Whirlpool dishwasher adp 6600 dial control. green light flashes 7 times.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the green light flashes 7 times, pauses, repeats and the\015\012dishwasher doesn't sense a water temp ... Dishwashers

Dishwasher 6 ADP 5540 WH Whirlpool goes through a cycle then flashes three times, after reset does same thing. Solution to repair?


... Dishwashers

Hi, ihave a miele dishwashe type G7856. the machine starts, then after a short period of time the light for filling/draining flashes and the alarm F 0 S appears. i have checked filters for water supply and that pressure is present.


... Dishwashers

Dishwasher Whirlpool ADP 4542 WHM, green LED flashes 7 times, what's the errorcode?


... Dishwashers

Dishwasher green light flashing four times contiuously


... Whirlpool Dishwashers

Whirlpool dishwasher ADP 5406 start light flashes 4 times and machine doesn't start cycle. Had this fixed 6 months ago but can't remember what the technician did although I know it was very simple.


You need to clean the drain hose . 4 blinks indicate you have problem in drainage . Drain lines will be clogged with dirts . So cleaning will solve your problem . ... Whirlpool Dishwashers

Adp 4601 dishwasher not draining and there is a light flashing 4 times i guess an error code thanks


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2035 seconds