Having problems with your Dishwashers ?

Dishlex Global 310 dishwasher fills then stops with flashing "fast" light


Answers :

HI,

1)Unplug it for 30min and then plug it back on.After this go for a fast cycle.See if this helps to clear the error.

2)You cant try turning the tap on faster.I believe it is not getting enough water.

3)If you still face the problem then you will have to replace the electronic valve (the thing the hose goes into) which requires a physical presence of a tech.

Please don't forget to rate or accept the solution.

Goodluck..
Try this one:
\015\012turn it off at the wall
turn it on
press and hold the start and program buttons at the same time until it beeps
\015\012
\015\012Hope that helps.......
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishlex Global 310 dishwasher fills then stops with flashing "fast" light


HI,1)Unplug it for 30min and then plug it back on.After this go for a fast cycle.See if this helps to clear the error.2)You cant try turning the tap on faster.I believe it is not getting enough water.3)If you still ... Dishwashers

Dishlex Global 310. Any cycle I run starts...drains the water, fills up the bottom of the dishwasher... then it stops and the "fast" light is flashing. I've tried every cycle but the same thing happens. Can you please tell me what the problem is? Thanks


... Dishwashers

Dishlex dishwasher global 300. Dishwasher continues to drain with ECO light flashing. Service manual says it is due to an incorrect fill level or fill line.


Some diswashers have a sump in the bottom with a float switch. If the water level overflows the float will activate the switch which will kill the machine and run the drain pump continuously. ... Dishwashers

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph


The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

Hi. I have a Dishlex global 300 series and it starts going through the cycle ok but after about 5 minutes it starts to fill up again and the eco light starts to flash and it won't stop filling up and draining. can you please help me.


The operating manual says under problem solver thatin such a situation it has an incorrect fill level or fill time and recommends then the need for a service agent.\015\012\015\012Try holding the start and programme buttons down at the sa ... Dishwashers

Hi have a Dishlex Global 450 dishwasher which stops after about 15 minutes into the cycle. The is nothing flashing and no lights it just go off totally. There is water in the bottom of the dishwasher. help please


... Dishwashers

Re: Whirlpool Dishwasher When I press the ON button it goes green for a few seconds and I hear the dishwasher starting but doesn't fill. Then the green light ON Light flashes 6 times, stops, and flashes again 6 times and so on until I turn it off. Dishwasher will not fill. Please help


... Whirlpool Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dishlex Global 2000 starts makes a constant noise tries to start up then stops. Bit of water in the bottom of the dishwasher. Lights flash but does nothing


Have you checked that your outlet pipe is not blocked. if it is blocked machines are designed to stop to prevent flooding. this may explain why there is water in bottom ... Dishwashers

Hi I have a Dishlex Global 300 that seems to stop at the end of a cycle and the red rinse light is flashing and there is still water in the bottom of the dishwasher, it doesn?t seem o be draining.


Since\015\012 the drain pump will pump the water out using the "cancel/drain" \015\012button, if it did not work then your problem is likely to be in the drain hose system or the \015\012garbage disposal downstream from ... Dishwashers

Dishlex Global 310 model. My dishwasher has water sitting on the bottom of it and it wont drain. I noticed it after I did a cycle of dirty dishes and the 'fast' light was flashing when I went to open it. Which shouldnt have been because it was on a normal wash. The water has been sitting at the bottom for 2 days now and still wont drain! I've taken out all the parts on the bottom which come out and cleaned them. Still no change however.


Just ran another cycle and it was fine ... Dishwashers

My Dishlex Global 300 dishwasher stops mid cycle and the rinse light keeps flashing ?


Hi,I think I had the same problem. I don't know much about dishwashers, but the "Flashing Rinse" has something to do with the drain, or the drain pump (which is why the water doesn't drain).My dishwasher stopped its cycle, after hav ... Dishwashers

My dishwasher dwt 10 fills up then stops, two lights flash on the front, the eco and fast wash cycle leds. also makes a humming noise but nothing else happens


Your wash motor is jambed or the motor capacitor is faulty ... Hotpoint Dishwashers

Hotpoint FDW60 Dishwasher stops and fast and delicate light flash


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Flashing lights I have a hotpoint dwf40p ser no ls12-ev03 it pumps fills then the wash light and the drying lights flash and dishwasher stops with no further progress


... Hotpoint 24 in. DWF32P Free-standing Dishwasher

Fast flashing dishwasher starts ok, then stops after a few minutes with the ''fast'' light flashing. It does not matter what cycle its on, the same result occurs.


The outlet pump could be triggered because the "anti flood device" polystireen float and micro switch at the base of the washer has detected a water leak from a leaky hose or water spil) This device automatically puts the pump out motor on and stops ... Dishwashers

Asko D3450, Stops with flashing "auto" and "pot", all the water has been drained. If I poor more water into the dishwasher and restart the flush program it will empty the water before it starts to fill water.after the program has flushed it stops with the flashing "auto and casserole" lights.


Water level switch is no operative..i have same problem 5,6 months ago ...\015\012regards Peter ... Asko 24 in. D3250 Built-in Dishwasher

Dishwasher will not finish/start a cycle. The washer filled with water and during the cycle I heard a pop like someone knocked something over in the kitchen. I smelled an electrical burning smell. All the lights and the buttons work on the front panel, but when I try to start I hear an electrical buzz like it is trying to start, but nothing happens and after 3 seconds the electrical buzzing stops and the lights on the panel flash. I removed the dishwasher and found that when I hit the start butt


... GE 24 in. GSD3960LSS Stainless Steel Built-in Dishwasher

My GSD3600 GE Dishwasher will not finish/start a cycle. The washer filled with water and during the cycle I heard a pop like someone knocked something over in the kitchen. I smelled an electrical burning smell. All the lights and the buttons work on the front panel, but when I try to start I hear an electrical buzz like it is trying to start, but nothing happens and after 3 seconds the electrical buzzing stops and the lights on the panel flash. I removed the dishwasher and found that when I hit


Hello Greg,\015\012\015\012Your diagnosis is pretty good, but the buzzing suggests it may be the capacitor for the pump motor that has failed rather than the pump motor itself. The capacitor phase-shifts the AC current for starting the mo ... GE 24 in. GSD3960LSS Stainless Steel Built-in Dishwasher

The eco light is flashing constantly on my Dishlex Global 300 dishwasher, it is making a noise like a pump is running continously, but the unit will not operate. Can you give me some possible faults and solutions. Regards Dave I have the same problem. The Eco light flashes and there is some sort of noise, not sure if it is a pump or a solenoid, but thats as far as it goes. A friend gave me the machine after aservice tech told him the main washer motor was gone. i have fitted a new motor, but


Its an overflow of water into the base of the machine.There is a float switch in the base of the machine in a small plastic dish.There is a metal cover with 2 small bolts that have to be removed to get to it.get the overflow c ... Dishwashers

Hello, my slimline, Hoover, HEDS 668, AAA class, dishwasher is playing up. During a wash cycle, my meter tripped. When I put the power back on, all the light were flashing and beeping. The beeping stops after a while and all the lights stay on. It sounds like it is trying to fill up or drain or something too, but that soon stops. The filters are clean. What could be the problem? Hazel Stenson-Pickles


... Hoover Dishwashers

Dishlex global 300 flashing eco light. i took the front of to fix broken handle while dishwasher was still plugged in. blew circuit breaker in house and now only the light labelled 'eco' flashes and no buttons respond. have I stuffed it?


I have a ge dishwasher that wont let water out like its supposed to. this morning i got up to water on the floor and water still in the bottom of the chamber what do i do to solve this problem ... Dishwashers

My Hoover dishwasher HFI 3015 is not working. When you turn it on, the P1 and 'out of salt' light is flashing and bleeping constantly. I believe that it may have run out of salt yesterday, but I have filled it this morning and there is plenty of Dishwasher salt in the compartment now and it is overflowing with water. I have tried turning the machine on and off, but each time I turn it on I get this bleeping and flashing and can't stop it. Any ideas?


... Hoover Dishwashers

Hi our nemo dishwasher starts a cycle and fills but does not start cleaning cycle. Light under start button flashes. If start button is held on it resets and pumps out. We live in an area with high clacium in water. At first the machine only pumped out and did not start filling. I have cleaned the level sensor ( membrane switch filled with calcium) and it at least stopped pumping and started to fill. It does not proceed from here. I checked the level switch it seems to be working OK (NO and NC c


Hi.You need to move the appliance and check the height of the drain hose. If there is water in the tub you may have a syphoning problem (water refluxing in the tub) because of incorrect height of the drain hose elbow.The led t ... Fisher and Paykel Dishwashers

Ihave a servis M4605s dishwasher it starts to fill then stops the programme lights all light up then go out leaving the programme 5 light flashing can you help please???


... Servis Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2501 seconds