Having problems with your Dishwashers ?

Whirlpool DWH B10W not working

\015 Machine will run the test cycle with no errors but will not complete a full cycle on any program.\012\012It seems like the circulating pump is not working.\012\012Any ideas? Does the pressure switch in the base of the unit have to be made to enable the circulating pump tio run??\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a whirlpool DWH B10W. Last week the main drain outside blocked and none of my service machines were working (not draining). The main drain has now been unblocked and every machine except the dishwasher are now working fine. The plumber has checked the drainpipes again and says all are now clear. When I try to use the dishwasher, after the initial drain it stops and starts beeping at me. I have also noticed that no water is going into the machine. What's happening?


The error most likely indicates a Long Drain Sequence (Drain Exceeds 8 Minutes) - Select 'cancel' twice to clear error code. \015\012 \015\012 \015 ... Dishwashers

Whirlpool DWH B10W not working


... Dishwashers

I have a slimline dishwasher from Ikea. The model is Whirlpool DWH C10 W manual. Everything worked fine up until the other day when I switched the machine on and it made a noise as if it was working but nothing happens. No water comes into the washer although inlet pip looks fine. I have poured water in and it is drained okay but the dishwasher is not cleaning dishes. After checking through numerous forum and reading about a flood prevention switch which can be sorted by tipping the d


Ok so slow down and lets look at the d/w problem and don't take the kitchen apart.. in the tank there is a float in the front corner. lift the float and listen for the click that would be the float sw . if no click th ... Dishwashers

Whirlpool dwh b10.yesterday had problem with water not going anywhere,had to bail it out.today cleaned all filters,now can hear pump working but doesnt appear to be taking water in.i press start button for two seconds,re-programme,and it does the above.then start button flashes and there is a continual beep the programme indicator changes from a wash to rinse during this process.any help ? thanks pete.


... Whirlpool 24 in. DU1148XTP Built-in Dishwasher

Dishwasher whirlpool dwh b10w start button flashes and alarm sounds


... Whirlpool Dishwashers

Whirlpool dishwasher dwh b10 . stopped working, only flashing green light


... Whirlpool Dishwashers

I have Whirlpool dishwasher DWH B00. Now it starts as normal filling water for a couple of minutes. Then it suddenly starts beeping and pumps out all the water and just contiunes to beep. This will happen in all programs. We have studied the users manual and cleansed the filters as suggested in the manual, but this doesn't help. There are now problems with the water supply. The dishwasher is not used very much, may be just twenty times. In the start it worked normally, this problem suddenly


Hello & Welcome to FixYa If the sound is coming from the bottom panel then it is the motor that has gone bad and needs replacement. However, if you hear the sound from the control then it can be due t ... Dishwashers

Whirlpool gu2400xtpt3 Green light flashes, doesn't run, how can I repair this myself? "Normal" light keeps blinking; tripping breaker didn't work; all the "sequencing" suggestions (hi temp, heated dry, etc) didn't work. I'm at my wits end. Any ideas? I have a Whirlpool GU258xtpq3


... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


THE TECH WHO CAME TO FIX MY DISHWASHER FROM Y=THIS EXACT PROBLEM TOLD ME THAT IT IS CAUSED BY THE WATER THAT TAKES TOO MUCH TIME TO GET WARM, SO YOU HAVE TO MAKE SURE THE WATER IS NOT GOING TO BE COLD BEFORE YOU TURN THE DISHWASHER ON. AS TO FIXING I ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


Hi there,\015\012\015\012your problem is intermittent and before you start replacing parts, i would recommend that you do these checks:\015\012\015\012unplug the dishwasher from the wall\015\012check the connection betwe ... Dishwashers

Whirlpool Quiet Partner II: Was making loud noises while working. Then stopped working and cleaning light blinking only. Did the push buttons thingy - stopped blinking. Now just fills up, makes a humm


... Dishwashers

Whirlpool dishwasher DU1015XTXBO Stopped working during cycle, acts like don't getting any power. Checked the plugin and it works. No lights or anything coming on the dishwasher. Its like it just


... Whirlpool Dishwashers

Whirlpool dishwasher model #DU1100XTPSB wont work and the clean button flashes 7 times and pauses, any idea? I shut the power off to it at the breaker to see if it would reset, didnt work


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Whirlpool dishwasher dwh b80 will not fill goes to rinse cycle green light flashes


... Whirlpool DWH B80

My whirlpool DU930PWSQO dishwasher won't start. Drain will work, other control panel lights work . Tried shutting power off/on and the heat dry - normal reset sequence but that didn't work. Any ideas?


... Dishwashers

AS PER DIRECTIONS FROM TECH, I PURCHASED AND INSTALLED A NEW CONTROL UNIT. THIS WAS BECAUSE MY WHIRLPOOL DISHWASHER GOLD GU2300XTLB3 QUIT WORKING IN ALL CYCLES EXCEPT SHORT CYCLE. PUT EVERYTHING BACK TOGETHER AND TRIED TO GET THE DIFFERENT CYCLES TO WORK. NOTHING WORKED EXCEPT THE CLEAN LITE FLASHED A CODE 7.(FLASHED 7 TIMES THEN QUIT. THEN IT WOULD FLASHED 7 MORE TIMES THEN QUIT) iT HS BEEN DOING THIS FOR WELL OVER 24 HOURS. WHAT MUST I DO TO GET BY THIS ERROR CODE AND GET IT TO START W


Hi,This is a common problem with Whirlpool washers.If\015\012the clean light is the one flashing then your dishwasher could have a\015\012heater circuit problem (depending on the age) or this could simply just\015\012be water colder ... Dishwashers

Whirlpool "Quietflight II" - Will not start. The button for "Delay" works, and the button for "Cancel/Drain" works. Pressing this button will drain the unit. No other buttons will work, however, and the unit will not start. Ideas? I've taken the control panel off and looked at it's guts, as far as I can tell everything looked ok (not burnt and no loose wires), although I am no electrician....


Have you tried testing the control panel with an VOM meter? You can press a button and test the wiring that would go to that particular circuit. See if you get a reading on the specific wire when that particular wire is pushed. Does sound like a cont ... Dishwashers

I have a Whirlpool GU1500XTLS2 dishwasher that worked just fine on noemal cycle the other day. Now none of the cycle keys will work except the cancel key which starts a 2 minute countdown and you can hear the motor running. After the countdown ends the other keys still won't work. Please help!


DID you get a solution? ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a whirlpool GU1200 that I purchased on Craig's List. The unit worked fine for a few months. Then, I removed it to replace the floor. When I reinstalled it a few days later, it only works in quick wash and pots and pans modes. Some of the other panel options don't seem to work any longer either. Any ideas?


... Whirlpool GU1200XTKS Dishwasher

Good afternoon - I have a Whirlpool model LSR7233EQ0 washer. The washer works fine in regards to draining, filling, lower agitator works...however, the top agitator does not engage and almost sounds like grinding. However (I know you are not supposed to do this), when the machine is in the wash cycle, I push sideways on the top of the agitator and it then does engage and agitate. When I release pressure, the top agitator does not work. Thanks for your help, Michael


Whirlpool uses a split agitator design. The upper portion is called the auger, while the bottom is called the agitator. Between these components is a agitator cam assembly. This problem is commonly caused by worn agitator dogs or the agitator cam ass ... Dishwashers

I have a Whirlpool GU1500XTLS2 dishwasher that worked just fine on noemal cycle the other day. Now none of the cycle keys will work except the cancel key which starts a 2 minute countdown and you can hear the motor running. After the countdown ends the other keys still won't work. Please help!


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Dishwasher: Whirlpool Gold Quiet Partner. Has worked fine until had a house plumbing blockage which made water pool in the bottom of the dishwasher as well as kitchen sink. Tried to get it to drain at first using keypad. Drain light clicked on and then off because there was nowhere for water to do. Manually emptied most of the water, then "Cancel/Drain" worked if I held it down quite a while. House plumbing is now fixed. However the keypad only works sporadically now. Some buttons do so


\015\012Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My Whirlpool Gold Quiet Partner III dishwasher will not start. I have installed a replacement control board that worked for awhile. When it quit I put the old control board back and it worked for awhile with a portion of the lights on the control panel lighting up. After switching control boards back and forth, it will not work at all now. It will run through the diagnostic program (Normal, Heated Dry, Normal, Heated Dry) but after that the start button plus other buttons are not lit so it will


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Hello expert, We are having a new kitchen floor laid and the contractor moved the Whirlpool dishwasher out to lay the floor under. Since it was replaced into it's normal under the counter spot, green "clean" light flashing in succession with a brief stop then starts again. Not really bothered as long as it worked, but of course it doesn't work - What do you suggest?? P.S. Had a problem app. 2 years ago when someone backed into the control panel, also ceased working and repairman charged ex


Someone grabbed the control panel and knocked it around or flexed it whist moving it in and out of your counter.\015\012\015\012Either the PCB board behind the little buttons flexed and cracked, or the ribbon cable that connects the PCB b ... Dishwashers

Whirlpool dishwasher gu2400xtpb6 will not start. only a few buttons work. cancel drain button will work for 2min everytime i push it


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0625 seconds