Having problems with your Dishwashers ?

Neff S4430W0GB/08 dishwasher is not removing tea/coffee stains for mugs both china and ware also stainless cultery is coming out with bluey colour as if they had been heated with a gas torch. Pallywal

\015 Filter has been cleaned and salt containe is full. Finish tablets used\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Neff S4430W0GB/08 dishwasher is not removing tea/coffee stains for mugs both china and ware also stainless cultery is coming out with bluey colour as if they had been heated with a gas torch. Pallywal


... Dishwashers

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

I purchased a thermos gas grill without the manual. It did not come with a gas tank or instructions on how to use. Can I see a manual for this model 461630007. Thanks.


What is the make? Is it Thermador? If so, you can get the manual here;http://www.thermador.com/SupportCenter/DocumentDisplay.aspx ... Thermador DWU244 Dishwasher

I have a 2300 psi gas pressure washer, campbell hausfeld, runs fine but water comes out the nozzle like a hose , no high pressure. inlet filter is clean and when you pull the trigger on the nozzle water comes out like a hose but no pressure


If you no longer have High Pressure coming out while machine is running, it's a pump issue. ... Campbell Hausfeld PW2575 Pressure Washer

Water not coming in. Been seen twice by British Gas engineer (British Gas Homecare appliance cover) and have been told its not fixable, not safe and must be replaced. I would rather repair it.


Hello,\015\012This is difficult to diagnose especially as it has been condemmed by your Insurance cover.The normal cause for these dishwashers to not let in water is an airlock.Now if you know a bit about DIY you could have a go.Firstly remove ... Electrolux 23 in. ESI602X Built-in Dishwasher

I have an almost brand new husky pressure washer (one of the big ones). It has been a life saver so far. just the other day it shut its self off. its gas powered so of course i checked the gas and oil. then tried to start it back up. but when I try to pull the pull string it wont come out more than about 3 inches. i payed 400$ cash for it to use on the trucks. does anybody know how to fix that? thanks


IT SOUNDS LIKE YOUR FLY WHEEL IS BAD OR NEEDS TO BE ADJUSTED ... Pressure Washers

Hello! I have a Frigidaire (made by Electrolux) Gallery Professional Series gas range/electric oven, model #FGF379WJCA (manufactured in 1998). The appliance came with the house we moved into 2 years ago. I have the owner's manual and gone through the book but can't resolve two questions. 1) One of the burners will not light. When I try to turn it on, the other three burners' electrodes will flash, but the 4th one will not. I can light the burner with a lighter, so there is gas coming throu


\012The front controll pannel lights and clock are not on. \012There is power to the unit. \012Is there a reset botton somewhere? ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

I have a Troy-Bilt pressure washer that's about four years old. I noticed the gas tank was completely empty and as I poured new gas into the tank it comes out of the primer bulb. Any suggestions.


... Briggs & Stratton Pressure Washers

Won't start Fresh gas, good spark, shear pin good, exhaust comes OUT of the carb mixed with gas. I suspect a valve is stuck open inside. Does this sound correct?


Yes your moving in the right direction if over head valve remove the valve cover and check the rocker arms and for bent push rods if a flat head remove the head and check the valves ... Briggs & Stratton Pressure Washers

Gas is not coming in fagor oven


... Fagor LFA-65 Stainless Steel Built-in Dishwasher

I have gas in the oil fill and oil coming out of the exhaust of my Ridgid pressure washer. I lent it to my father who isnt mechanical at all so anything could have happened while he was using it. He has since passed away so he cant tell me if he did anything wrong to it. Its a Ridgid with a Subaru SP170 OHC Engine. Any help would be appreciated. Scot


Check to see if the oil is overfilled first.If the oil is at a normal level, the engine was probably overheated or ran low on oil.It is also possible that the machine was tipped over and oil ran into the cylinder. ... Pressure Washers

Gas motor run good but no pressure coming to the nozzle


On most there is a soap hose small tube make sure its not sucking any air into the pump which will make the pump not have pressure.then if thats not it the packing in the head on the pump is in need of replacement .reason for this would be the unload ... Karcher 2500 PSI Pressure Washer

I have an Asko 1606 dishwasher. I had a new hot water tank installed in my house, it seems that with the water being turned back on that the black hose from the outlet side of the solenoid has come adrift (not from the solenoid but the other end), it seems that it has to be reconnected to an opaque coloured tank on the side of the machine, is that correct? re Wayne


Yes. ... Dishwashers

Engine starts easy. engine revs up and down but does not maintain a constant. Preasure tries to come up and then quits. the governor eeps moving back and forth. I have cleaned everything including the unloader. I used lithium grease on the o rings and still it does the same. Could this be caused by bad gas, even though it starts and runs very easy


Hi And welcome to FixYa. I am Kelly I doubt that it is caused by bad gas.-It can be caused by a dirty float bowl nut or a restricted orifice in the bottom of the carburetor venturi. - Also a broken or very worn governo ... Karcher 2500 PSI Pressure Washer

Water flows from pump head continously and the last time I used it oil was all over pump.is this normal ? The washer is northstar,gas driven and is not to old. the water comes from two openings in the bottom of the brass head plate.


... Pressure Washers

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

Gas motor runs but very little pressure comes out of nozzle. The 2200psi washer has only about 10 hrs running.I keep it in a warm garage all winter..thanks..rick


... Campbell Hausfeld PW2102 Gas Pressure Washer

Need help my oven is not working, the self cleaning works fine, the broiler also works, but the oven will not heat. what can i do? Our Kenmore gas range will not heat to the proper temp. The oven ready beeper goes off in about 3 minutes and displays 350 which the internal temperature is not. There also seems to be excess heat coming from the vents under the top of the stove, (under the timer, clock etc.). This could be something I just never noticed.


Hi, The ignitor is not working right and is going bad....have the repair man replace the ignitor, or DIY....Check out this tip about your problem...Oven not Working or ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Briggs and Stratton Troy Bilt gas pressure washer one year old. I can get water thru pressure washer and bleed the air, water comes out the hose just fine until I start the pump. Then, I lose all water flow. Pump runs fine but when it's running, no water goes through.


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Gas is coming out of hole in float bowl - Honda Pressure Washers


There shouldnt be a hole in the float..if there is, the float is shot...the gas can never shut off if its filled with gas ... Honda Pressure Washers

Hi I have a brand new Honda Power washer GC 160,2600 psi 2.3 GPM my husband taught me how to use it last night and I think I have followed all of steps: 1. hose free of kinks 2. connected to machine 3. purged pw handle of air and made sure water from house coming through 4. pulled out choke 5. turned red button to "ON" position 5. pulled T handle enging starter and it sounds like it will start but doesnt what am I doing wrong??? yes it does have gas in the fuel tank.


... Karcher 2500 PSI Pressure Washer

Gas Husky 2200 No pressure Confirmed water coming through pump and wand. When trigger pulled water discharging out rear of manifold.


... Pressure Washers

Constant Failure Bought the unit along with other LG products to furnish new home. Problem 1: After first few loads, noticed that the dishes were always wet, the repairman came and said he would try replacing some kind of sensor and that we should run it on the "Sanitary" cycle. Have done this ever since, but should you have to run on sanitary to prevent your dishes from coming out soaking wet? Problem 2: Noticed the inside of the door on the adjacent cabinet was changing colour, found out throu


Problem #1 solution.  Make sure that you are using a rinse aid.  All dishwashers require a rinse aid to assist in drying the dishes.\015\012\015\012Problem #2 and #3 suggestion.  Possible that the door is either warped or not clo ... LG 24 in. LDS 5811 Built-in Dishwasher

Smell?? My dishwasher has had a funky smell since we started running it. It almost smells like it is not draining properly or sewer gas is coming back into the dishwasher. Any ideas?


Check to make sure that the drain hose loops as high as possible before coming back down to the disposer or branch tailpiece drain. If the drain hose just goes straight up to the drain connection, dirty water can seep back ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Honda gas powered pressure washer--runs great and I get pressure throughout the system but nothing comes out of the wand itself. There seems to be no clog throughout the system . I have cleaned all parts. When the unit isn't started I can get flow throughout the system


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0820 seconds