Having problems with your Dishwashers ?

I need to remove water supply hose from lg D1454BF dishwasher


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need to remove water supply hose from lg D1454BF dishwasher


... Dishwashers

Our dishwasher had to be removed. In reconnecting it to the water supply under the sink, the plumber could not keep it from leaking. I think there was a rubber washer that got lost during the disconnect/connect procedure. He then proceeded to gut off the end of the PEX hose which has a ridge and the last 1/2 inch is a little smaller than the hose. Now he says we need to order a new PEX hose from the factory. The PEX hose is too big to fit into the fitting. Cannot a normnal flex hose for thi


... Dishwashers

Not getting enough water flow into the dishwasher, suspect that a filter is clogged due to recent work on the waterline in the kitchen sink. Need to know where the filter might be located (on the dishwasher or on the intake valve before the connection to the dishwasher hose)? Also would I need to disconnect the water supply to pull out the dishwasher for access to such a filter.


You didn't specify a brand but most dishwashers don't have a water "filter." They may have an inlet screen at the water valve, which is typically located under the dishwasher. Generally, the lower front panel will have to be removed and you should ... Dishwashers

Zanussi DW908 dishwasher will not fill with water, when filled manually completes cycle untill fill time again. when filled continues on until water needed again. Only cold supply to machine. Water coming to valve, removed valve and freed it up as it was stuck, water flows through the valve when disconected from the dishwasher at filler pipe which leads up the side of washing chamber. When all connected up water will not enter the dishwasher. I,m beaten as I cannot access this area without maj


\012\012Hi,\012Here\012is a tip that will help you to find out why water will not come into\012the dishwasher... Dishwasher Trouble ... Zanussi Dishwashers

I need to repalce the elctrical supply cord and water supply line to my Fisher & Paykel DD603 dishwasher, but I'm unsure as to how to remove the terminal box cover. Could you please help? Thanks.


THIS IS SIMALAR TO THE BOSCH UNIT, IF THERE IS NO BOTTOM COVER TO REMOVE YOU NEED TO TAKE THE SCREWS OUT OR THE TOP INSIDE THAT HOLD IT TO THE COUNTER TOP, PULL THE UNIT OUT SLOWLY, TURN OFF THE WATER SUPPLY SHOULD COME OFF THE HOT SIDE OF YOUR FEED ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I need to winterize the built-in Kenmore dishwasher in a mountain cabin where winter temperatures will drop below freezing. The unit is at least 10-15 years old, but I don't have the model number handy. My approach to the cabin water pipes in general will be to gravity-drain them and then blow out remaining water by adding and releasing air pressure. RV antifreeze will go into all P-traps. When it comes to the dishwasher, my plan is to remove the drain hose from the P-trap and drain it as mu


In order to get the water out the best thing to use is a wet dry shop vac and attch it to the end of the drain hose on either your dishwasher or clothes washer this will remove any water in the drain pumps.As far as RV anti freeze being added not sur ... Kenmore Dishwashers

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

No water is getting inside my Bosch dishwasher compartment. Water supply to dishwasher is ok. Checked hose at input of dish washer and water supply is ok. Could pump have packed in? Model 004 920 378. Dishwasher used daily since 1999.


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bosch Dishwashers

Dishwasher i need help either installing for troubleshooting my 18' portable frigidare dishwasher. when the dishwasher is turned opn and it starts to fill the water flows out of the bottom of the machine what is the problem and how dod i fix it is it the hoses ? it also hooks up to the sink it isnot a built in dishwasher so is the hose for the draining need to go in the sink or does it hook up somewhere under the sink?


I would put the dishwasher on its back so you can see underneath to check the fill and drain hose to make sure there not damaged in any way to cause it to leak. if it all looks good under there return it upright and remove the front lower kick panel ... Frigidaire 18 in. FDR252RB Built-in Dishwasher

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

I have an LG dishwasher that keeps giving an 1E error code. The code means water inlet trouble and recommends the following. Check clogging of water inlet hose(or hose twist or freezing) Check if it's suspension of water supply The problem doesn't seem to be either. ?


Try replacing the water inlet solenoid valve (it may have an open coil). The water line goes directly to it. ... LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher

Hi, I have a Miele dishwasher G2150 that after 7-10 minutes on any cycle the rinse, dry, and end lights flash amber. I called the 800 number and they walked me through the diagnostic sequence and they said it was an error code 12 something to do with water restriction. I removed and checked the bottom "L" filter(clean), the wheel (moves freely, not dirty), and the grey in line filter screen on the intake hose,( clean also). I can feel the water coming through the intake hose, water comes in thro


... Miele G2150SC Dishwasher

We have a Siemens dishwasher SE25M851. It had the check water light on, so we have checked all water flows which seem fine. There is what I think is an Aquastop connected to the water hose, which I have no idea if the problem is there, but when I now put the dishwasher on there is a burning smell coming out of it, so have had to turn off power supply. Can you shed any light to the problem?


... Siemens Dishwashers

I have a portable Sears dishwasher model # 66517769k600. It makes grinding noises when empying out the water, then stops. Sounds like maybe something is jaming the inpeller blades on the pump that removes the water as Water is left in dishwasher. It will restart in about 15 mins , run for 15 to 20 sec and stop again with same noises. What needs to be done to fix this issue? Approximate cost of part? Thanks in Advance, Chris


Hello &\015\012Welcome to FixYa\015\012\015\012It's a simple\015\012fix as the ... Dishwashers

I cant get me dishwasher to start i have tested the overflow switch and its fine i have also tested the water inlet valve and its is fine. but it will not fill the dishwasher with water i have even removed the hose to see if there was any blockage in the line come out from the what inlet valve. the button light up on dishwasher and the cycles work a long with the start button, i have left the door open to see if the door senor could possibly bee an issue and it tested good and function correctly


Hi.If there is no voltage to valve, then parts that can be responsible are only and all the following:Overfill switch or overfill device.Door switch.Electronic control Wiring.If the overfill switc ... Dishwashers

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

Hi: I have reviewed the forums and tried to fix this issue. Have a Miele G2120 dishwasher that at the end of the cycle - the three (rinsing, drying and end) orange lights begin blinking in harmony. I have removed the triple filter, and two plastic parts to the impeller and made sure all was free of obstruction. I then pulled it out removed the drain hose from in-sinkerator; removed the water line and checked for obstruction. When it gets into this condition - the majority of water drain


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Miele Inspira Series Dishwasher w/ 6 Programs and 5 Temperatures - G2120 / G2120BL - Blac 24 in. Built-in Dishwasher

G661 SC My Dishwasher wouldn't take the water, and I had a Technician come by. He opened the right side of the dishwasher and said that I need to replace the  large White Plastic Part that transfers the water from the hose to the inside of the dishwasher. Does anybody know the name of it, or where I can find one for this model?


It's called the water intake. They usually dont give too much trouble. Can you give more info on the symptoms please?\015\012Any lights flashing on the machine? If so which ones?\015\012Is any water at all coming in? or is the machine tot ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

The Water inlet valve # 8531325 let water run outside the dishwasher. After removing the valve I found a small ball of contamination inside and removed it. It now works with out spilling water. Do I still need a new valve?


IF the valve stops and starts water flow correctly, no you would not necessarily have to replace it. The valve should have an inlet screen to keep this from happening again.. ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Need help removing my GE Potscrubber 1130 dishwasher. This is an old unit, I have removed the front base board and disconnected the wiring but need to know how to get to the water line to disconnect that. Do I need to do it before I pull the unit out?


... GE Dishwashers

The check water supply display comes on and the dishwasher does not go to wash cycles. The tap is turned on and the water supply is okay. There aren't anyblockages or kinks in the hose. What can be the problem?


Have you checked your float at the inside back of the machine to see that it is not sticing in the upper position see if ther is a utensil or something caught under it pull racks out and look under it ... Dishwashers

Bosch Dishwasher 8502. Disconnected and laid up for six months. Now reconnected but 'check water' light comes on. Have removed filter in tap end of hose and checked for no kinks. Plenty of water pressure at entry point of hose to machine. Ant thoughts?


... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2700 seconds