Having problems with your Dishwashers ?
Asking to check water - Dishwashers
There is usually a "float" on the bottom of the dishwasher, if its stuck it will give you that error....look for that and see if it moves freely. If not, see why (duh) If its hard water, or soap built up around it, clean it off. Then run some vinigar threw a wash every now and then to keep it free. hope this works!!
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Fagor lf-017s Hi, my fagor dish washer is showing an f3 alarm. f3 shows as a flood or not draining alarm in my booklet. However there is no remaining water inside the dishwasher. I have removed the dishwasher and checked the pump which is fine. The pump is running at the start of each cycle until thr f3 alarm steps in. Any ideas why the machine is still asking to drain when there is no water inside?
The water level float is stuck in the "UP" position ... Fagor Dishwashers
Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst
... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher
My dishwasher is not quite 2yrs. old and has always worked great until now. Top rack cups and mugs still are dirty inside from coffee, lipstick, etc., glasses have spots and are cloudy, and silverware seems to have streaks and become darker. I always turn hot water on at faucet prior to running dishwasher. I have check the water faucet and it is 120 degrees. After starting the dishwasher I checked and the water is not even 100. After about 20 mins. the water was aprrox. 117 degrees. The
Hello,Welcome to FixYa,Based on your description I`d suspect a plugged wash pump.The place to start for that is to pull the pump filter, spray arm and check for food deposit, broken glass, undesolved detergent and ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher
My LG LDF7810ST dishwasher does not spray water from the middle or upper spray arms, therefore the dishes don't wash properly. Even when I ask for a top load only, the bottom spray arm is the only one moving (which I would expect that it shouldn't move at all since I've requested a top load only) I checked the spray arms as best I can to make sure that they're not clogged.
... LG 24 in. LDF7810 Built-in Dishwasher
Asking to check water - Dishwashers
There is usually a "float" on the bottom of the dishwasher, if its stuck it will give you that error....look for that and see if it moves freely. If not, see why (duh) If its hard water, or soap built up around it, clean it off. Then run some vinigar ... Dishwashers
The dishwasher is not letting water in....it sounds like the pump is trying as per normal, but no water is coming in. it is very difficult to pull the dishwasher out to check the water tap, however,tap is on and was working last night. is there a check that i can do within the dishwasher that i do not need to haul it out from the worksurface? i do not have the model, but it is 8 years old, integrated.
Suspect you can hear the drain pump running and the reason is that there is water in the bottom tray - ie you have a leak.for a tempory repair, remove the kick plate at the bottom front and mop out the water from the bottom tray then see if app ... Neff Dishwashers
Hotpoint HDA3400g dishwasher is not running. I have checked to make sure it has power. Took the washer apart, checked that it had power through the door switch to the timer control, all is well. Still not running or getting water into the dishwasher. Any ideas besides replacing the water inlet valve? Will this dishwasher cycle through if it does not have water?
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check for the following if your dishwasher\015\012is not working-- ... Hotpoint 24 in. HDA3400G Built-in Dishwasher
Dishwasher Leak I found water on the floor in front of my dishwasher one morning so I removed the panel and ran the dishwasher to check for leaks and found none. I did check all the gaskets on the inside and they appeared okay. I again ran the dishwasher and had no leaks at that time, however, the last two mornings after I have found water in front of the dishwasher.
Hi,Here is a tip that I wrote about leaking dishwashers...There also is a link in there to another tip on how to buy parts online fo ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher
Hello, We have sample LL64 dishwasher. Dishwasher not draining the water, no noise operation of the pump. We ask you for advice.
... Ariston Technologies LL64WNA Built-in Dishwasher
Asko diswasher Dishwasher will not get water. Lines all checked, water on. Pump runs even when in off. Problem started when there was a water clog in the sink next to the dishwasher, and the dishwasher backfilled with water. We used a shop vac to get the dirty water out. Next day tried to use dishwasher, runs, but no water and empying pump will not stop running. Ideas?
Check for water leaks or not draining/overfilling fault ... Asko D1776 Stainless Steel Built-in Dishwasher
We have a Siemens dishwasher SE25M851. It had the check water light on, so we have checked all water flows which seem fine. There is what I think is an Aquastop connected to the water hose, which I have no idea if the problem is there, but when I now put the dishwasher on there is a burning smell coming out of it, so have had to turn off power supply. Can you shed any light to the problem?
... Siemens Dishwashers
G.E. GSD5130 When the dishwasher is pumping out the water a small amount comes in the rotating sprayer head. At the end of the cycle the dishwasher still has water in the bottom. The amount of water varies from just a little to over an inch. I replaced the spring loaded check valve a couple of months earlier and everything worked fine until now. What should I check? Thankyou.
Mike, I just ran into the same problem. I found a second check valve located in the outlet hose of the ELECTRIC drain motor. This motor is located at the right rear underside of d/w and is used only for backflush of the filter. When the unit goes th ... GE GSD5130 Dishwasher
Hello everybody, I hope that you gona a give me some tips for repairing my dishwasher mashine. A few days ago, the error F2 appears on my dishwasher machine (Baucknecht GSI 5894) I checked the pump for the waste water is ok. the tap water is not taking in,I checked the hoses they are ok as well I turned off and on and same time pressed the button reset and choosing the programm on the dishwasher few seconds trying to start and again apperas F2 . Hopefully someone can help me. Best regard
Possible the inlet valve has given up and is not allowing water in.\012Also possible there is a slight leak enough to shut the water off (safety feature) - Check underneath for a float mechanism and any water there. ... Bauknecht Dishwashers
I bought this dishwasher 5 years ago and was kept in the box until last month. I installed it, turned on the water and no water is being pumped into the unit from the water release valve in the dishwasher. I then checked all the cycles and everything works except for the pump. Then I checked to see if any power/volts was going to the pump and there is none. Could it be a wiring problem or could it be the circuit board?? please help. thanks
You will have to check all the connections visually. Since you know how to use a meter, see where the current stops. See if there is current coming from the control board to the pump. the water inlet solenoid valve should "free flow" water into the m ... GE 24 in. Profile PDW7800 Built-in Dishwasher
I HAVE A BOSCH SHU5305 DISHWASHER THAT WHEN IT IS TURNED ON IT WILL NOT DRAW WATER FOR THE WASH. IT JUST SITS THERE AND HUMS. HAD A BIT OF WATER FROM THE SINK BACK UP IN THE DISHWASHER AND SPILL OVER ONTO THE FLOOR YESTERDAY. I CLEANED THE DISHWASHER FILTER WHICH WAS COMPLETELY CLOGGED. I THINK THE DISHWASHER WORKED FINE PRIOR TO THIS INCIDENT BUT THIS COULD ALL BE COINCIDENCE. I DON'T KNOW IF I HAVE A PLUMMING PROBLEM OR A WASHER PROBLEM. THE SINK WATER WORKS FINE. I CHECKED THE ON/OFF WATER VA
If the solenoid valve is humming and calling for water, you probably have a plugged screen in the valve, some you can get to and clean, some you have to replace. ... Dishwashers
Balay dishwasher Hi My dishwasher is broken.When I switch it on nothing happens.I have checked that the dishwasher is plugged in and the water is turned on.I used some hot water to try and get the dishwasher going.It mamaged to activate the sprayers and drain the remaining water.I suspect the water inlet solenoid is faulty! Can you please help me? Thanks, I look forward to hearing from you soon! Regards Alan
My Bosch dishwasher is Exxcel 5 prg model no SMS50E020GB. When you first open the dishwasher door after the washing cycle finishes there is no water in the bottom of the dishwasher but about 45 minutes later water slowly appears in the bottom of the dishwasher. I scoup out the water and there is about 3 litres. The machine is just over 2 years old. I had a plumber check the machine and he couldn't find anything wrong with the machine. Another plumber came out and put on the invoice: "disma
... Bosch Dishwashers
My bosch excel dishwasher has the following fault: start the cycle, water starts to fill but then check water light comes on and it then starts to empty again. Pump then keeps going. I have checked the hose and even swapped it round with my washing machine one but this makes no difference. I have cleaned all the filters and taken off the cover to check the 'propeller' as sugested in the instruction manual. But no joy - check water light still illuminated and willnot continue with cycle. - Help!!
This unit im sure has a water flowmeter that measures the water intake.. if this cannot read then the unit shuts down to avoid flooding.. \015\012it needs replacing... it is attached between the valve and the side tank or attached to the tank d ... Bosch Dishwashers
Water will not drain from bottom of GE Profile PDW7300 dishwasher. I checked the service mode feature by depressing the cookware and the heated dry keypad simultaneously for 3 seconds and did not hear any activity from the dishwasher when I activated the drain pump and when I activated the main pump. Other service mode features did activate when I checked them (i.e. activate water valve, open active vent, etc.).
... GE 24 in. Profile PDW7800 Built-in Dishwasher
Hi, we have a Neff dishwasher and noticed a couple of days ago that it took hours longer than usual for the dishwasher to complete its cycle. Last night after the machine had been on for about 4 hours we checked and although there was some water at the bottom of the machine it had not started to wash the dishes although we had heard noises coming from the machine. On opening the integrated door notice that the "check water supply" indicator was lit up. Do you have any suggestions as to what
... Neff 24 in. S5443X2 Built-in Dishwasher
Dishwasher model: se6 tie1 Fitted under kitchen work-top. Problem: After setting a program & switching on & closing door ? there is a normal sound from within but if door is opened there is no evidence of water being pumped in. I previously cleared food debris from the drainage pump area (including under the pump cover), checked the spray arms and checked the water supply was getting as far as the long in-take pipe. As it seems problematic to remove the (screwed in) dishwasher, I have not che
Hotpoint hda3440g02sa leaves a little water at the bottom of the dishwasher I have checked the check valve have even replaced I have put a high loop in the drain hose and still no help it leaves just a little water I hate to put a new pump because I have on this type of dishwasher before and still no help
Hi\015\012\015\012 \015\012\015\012When the dishwasher leaves just a little water and drains\015\012maximum then I would say that it is fine & the drain pump is also working\015\012fine. These units are designed in such a way tha ... Dishwashers
Our Bosch Classic Electronic dishwasher ( approx 2 yrs old) will not fill with the "Check water supply" light on. We did have the water turned off for a few hours prior to using the dishwasher. Have cleaned the filter - unable to check the pump.
My Miele Dishwasher (Excella Series G 2630 SCi) fails to fill. I get the message "Water inlet - Open the stopcock". I checked the water inlet filter and looked for hose kinks to no avail. I even checked the non-return valve. When I start the dishwasher I can hear a low hum (Not the pump) for a few second before the error message displays.
... Miele 24 in. Incognito G843SCVi Built-In Dishwasher