Having problems with your Dishwashers ?

L g dishwasher handle not working - Dishwashers

\015 \015

Answers :

Check hingees on eather side
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a maytag mdb6650 aww dishwasher. The dishwasher just stopped. The light on the control panel is on. If I push the buttons to try a different cycle, the light over light wash remains lit, so the buttons don't seem to respond. I was wondering if it is the control assembly, or if the door switch is not working. The handle cracked a while ago, but if the dishwasher still worked even though the handle had cracked in half.


... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Model HDA2000G02WW. Won't work now. Locking handle "feels" funny but it latches. Power switch to dishwasher is on. Circuit breaker on and functioning. No sounds from the dishwasher at all! Was working fine day before yesterday. No usual noises or problems noted? Any help on what the problem is would be appreciated.


Hi,\015\012\015\012Look at parts numbered 803, 805, and 861 on this ... Whirlpool Dishwashers

Dishwasher handle The handle that opens and closes the dishwasher door still works but is very loose. quit


There should be a slot for an allen rench on the under side of the handle that will tighten the handle up. ... Dishwashers

Electronicals not working; stopped in the middle of the cycle and didn't not drain. A few weeks prior to that, the dishwasher was not recognizing when the door was closed and would not start. It started to work on it's own but, it stopped again and it's more than the handle, the electronics are completely shutdown. Would it be a fuze?


Have drain pump tested ...take it out ... test ... Kenmore Dishwashers

I have a Miele G896 dishwasher. Drain light on. Washer won't work. Water clogged in drain area. Trying to remove triple filter system to clean it per owner"s manual, but handle stuck. Tried pressing down, turning both directions, technical taps to free handle, but no luck. How do you get triple filter system out to clean it?


... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

I have a Bosch SMU2042UC/14 dishwasher. The door will not latch. I have replaced the door latch and handle and still have the same problem. The dishwasher still works, will a little leaking, even though the door does not latch.


Is the latch adjustable? Have you checked your seals and your hinges? One of these has to be the cause. If you do not have the expertise to troubleshoot this problem yourself I would recommend a professional servicing the machine. If you need any oth ... Bosch Dishwashers

L g dishwasher handle not working - Dishwashers


Check hingees on eather side ... Dishwashers

I have a Whirlpool dishwasher mod. number GU2400XTP6 the clean light flashes then stoppes when the start button is pushed. the light on the start button flashes three times and stoppes then the clean light starts flashing again the machine dosen't start. I've checked the micro switches in the handle release and they are working fine. will I have to replace the main computer module? If so were do I get it and how much dose it cost?Thanks


... Whirlpool Dishwashers

I have a Nobel dishwasher. After a wash this morning the door handle now does not work and I cannot gain access to empty. Any suggestions as to how I get into the machine!


... Jenn-Air 24 in. JDB1090AWS Stainless Steel Built-in Dishwasher

I brought a new face plate for the handle of my F&P dishwasher but can't work out how to remove the old one?


Pull the plastic screw on each side of the drawer with a nose plier. This will loosen the front cover and allow you to lift the top plate along with the handle. Replace the handle and put back the front plate and the front cover. Finally put the 2 s ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


THE TECH WHO CAME TO FIX MY DISHWASHER FROM Y=THIS EXACT PROBLEM TOLD ME THAT IT IS CAUSED BY THE WATER THAT TAKES TOO MUCH TIME TO GET WARM, SO YOU HAVE TO MAKE SURE THE WATER IS NOT GOING TO BE COLD BEFORE YOU TURN THE DISHWASHER ON. AS TO FIXING I ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


Hi there,\015\012\015\012your problem is intermittent and before you start replacing parts, i would recommend that you do these checks:\015\012\015\012unplug the dishwasher from the wall\015\012check the connection betwe ... Dishwashers

Should knives/forks/spoons be loaded with blades, tines,bowls down or up in dishwasher? When ready to load knives/forks/spoons in the dishwasher, should you load the utensils with the handles at the top, or should the handles be at the bottom with the blades of knives, tines of forks, and eating portions of spoons be placed face down in the dishwasher? Simply put, should the handles of the utensils be placed up or or down when you load them in the dishwasher?


I find they come cleaner with the handles down, but if you have kids they come clean enough and are safer loaded with handles up, with spoons though, always load handles down so they can get the clean water to the whole spoon. ... Frigidaire FGHD2433KF Builtin Dishwasher

I have a bosch smu 2000 series dishwasher. it has always worked well with no problems but then all of a sudden a week or so ago, the water stopped coming into the dishwasher to wash the dishes. the faucet and all other water areas continue to work w/o problems (i.e. bathroom, shower etc). in attempting to use the dishwasher, the entire cycle seems to be working, i initially hear what sounds like an initial water discharge when the cycle first starts and during the entire cycle it sounds like it


... Bosch Dishwashers

The ge profile dishwasher model PDW8280J10SS was purchased about 2 yrs ago. It was working fine up until Jan. 2009. It ran fine but the water stopped draining. I read were you should run the garbage disposal prior to running the dishwasher. I drained the water and did this. It worked fine for a while then the problem was back. Once again, Drained all the water, sucked it out with a turkey baister, moved the dishwasher and checked hoses etc. Once again, it worked fine for about 10-14 runs. It now


It is probably clogged at the pump or before. See if you can get outlet hose off the bottom before the pump. ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Re:dishwasher My dishwasher was working perfect. Now, everytime the cycle is done, the detergent door is open but the detergent is sitting right there. I was using the electrosol gel pack which was working great. Now, the gel pack is sitting there when i open it. On the bottom is of the dishwasher is a lot of sand-like particles. I clean this out everytime. I haven't changed anything and am wondering why, all of a sudden, it stopped working. I've had this less than a year. Thanks.


Ginga, first of all it's still under warranty so I would call for service. Here's a few things to consider; first, I would switch back to the powdered detergent like Cascade. You want to make sure that the water entering the dishwasher is at least 12 ... Kenmore 24 in. 16182 / 16189 Built-in Dishwasher

My 2-year-old LG Dishwasher doesn't clean the dishes well any more. It used to work great, I was very happy with it. For some unknown reason it doesn't work that way any more. The dishes come out dirtier then they were before I put them in. I had three guys come in and look at it and they all said that there is nothing wrong with my dishwasher. My water heater is 1 year old, works great everywhere else in the house, the dishwasher is hooked up the right way, by a professional, I don't have hard


The heater does not heat the water it keeps it hot check there first id say the heater or thermal is bad if both check good replace control ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

The dishwasher and chemical dispenser are 30 years old. The chemical dispenser does not work properly. I think the seals in the tubes are worn. It is an auto chlor model l3. Can I get parts for this dispenser or is there another dispenser that will work with the Hobart AMES 12 dishwasher. The dishwasher works fine.


Http://shopping.yahoo.com/s:Major%20Appliance%20Parts%20&%20Accessories:4168-Brand=Hobart\015\012\015\012\ ... Dishwashers

LD-14AT3 Dishwasher Locker Handle won't release


... LG LDF6810ST Stainless Steel Built-in Dishwasher

Indesit DG6100W dishwasher will not work


It sounds as though the micro-switch inside the lock mechanism is displaced.\015\012\015\012Undo the 6 screws at the top of the door (on the inside) and remove the outer pane. This will give you access to the lock mechanism. Please s ... Dishwashers

Hi In the middle of a wash cycle, my dishwasher tripped the circuit breaker on the wall. I diagnosed this by unpluggin dishwasher, plugging in a different appliance and switching circuit breaker back on. new appliance worked OK. When dishwasher had cooled, I tried it again on same circuit (which I knew was working properly). The lights came on for about three seconds, and then the circuit breaker cut back in again, so I knew it was the dishwasher that was causing the problem. Is there anyt


Ck the connections where the cord hooks to the wiring harness. look for hot or shorted wiring . also ck the contro panel for the same . generaly if you have a power draw like you are saying then you can see t ... Dishwashers

After the last wash I noticed the bottom of my dishwasher (Whirlpool quiet partner 2) was filled with water. After unloading the dishes I closed the dishwasher and pushed the Cancel/Drain button but the button didn't work. None of the buttons work. It's as if the dishwasher became unplugged. I looked at the nearest outlet beneath the sink, but did not find anything unplugged. I wasn't able to drag the dishwasher out of its area beneath the counter by myself and figured I better ask first be


1.Check the drain filter for clogging. 2. Check the drain hose. Remove carefully to avoid water spill.3. Check whether flows freely from the hose.4. Check the drain valve if possible for you. ... Dishwashers

I have a SHU3032UC BOSH Dishwasher for a couple of years now. Always worked as expected. Latetly, the dishwasher never stops. It looks stuck on an "unknown cycle"... The cycle dial stays at the "bottom" cycle (there's nothing written). If I turn it 1-2 "clicks", the dishwasher continues its work and ultimatly finishes with very good cleaning results. Once, I open the dishwasher when it was stuck in the "bottom" position, and there was hot watter at the bottom. Here's what I've tried so


Hello, welcome to FixYa.\015\012\015\012Based on you description of the timer not advancing I suspect the thermostat isn't satisfied when heating the water.\015\012\015\012The SHU 30** unit`s with a mechanical timer have very few if any, issues with ... Dishwashers

Kenmore dishwasher Food particles left on dishes and inside of dishwasher. All functions appear to be working normally. Water pressure OK, drain OK, water temp OK, Etc. Operating dishwasher though a normal cycle without dishes solves the problem for one load, then back to problem. Dishwasher is about 5 yrs old and worked perfectly for 4 yrs. Any advice would be greatly appreciated. Bruce


... Kenmore 17822 Free-standing Dishwasher

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1736 seconds